Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE International Conference on Electronics Information and Emergency Communication

Non-uniform quantization scheme for the decoding of low-density parity-check codes with the sum-product algorithm

Xinru Qu, Liuguo Yin

Published Jun 1, 2016• 5 citations
Publisher

Abstract

In this paper, a non-uniform quantization scheme is proposed for the decoding of Low-Density Parity-Check (LDPC) codes with the Sum-Product Algorithm (SPA). With the proposed scheme, the quantization-range and quantization-interval for the soft Log-Likelihood-Ratio (LLR) values of the decoder input, the variable nodes, and the check nodes are set separately, and are also adjusted according to the evolution of the probability density distribution of the LLR values in the iterative decoding procedure to minimize the difference between the decoding values before quantization and that after quantization. Simulation results show that decoding with 3-bit non-uniform quantization of the proposed scheme may obtain a BER performance slightly better than that of decoding with 6-bits quantization of the traditional uniform quantization method.

DOI
10.1109/iceiec.2016.7589702

Related papers

Efficient Difference-based Decoding Implementations of LDPC Codes

Zhanji Wu, Peng Mugen, Wang Wenbo +1 more

Efficient implementations of the sum-product algorithm (SPA) for decoding low-density parity-check (LDPC) codes using difference-based messages between bit nodes and check nodes are presented. As for the updates of check nodes, reduced- complexity derivatives are also put forward. As compared with the traditional Log-Likelihood-Ratio(LLR)-based decoding implementations, the proposed method has much lower complexity and latency, while it has no obvious loss of the error performance.

IEEE Communications Letters•May 1, 2008•3 citations

Performance Analysis of Normalized Min-Sum Decoder for LDPC using non-uniform Quantization

K Pargunarajan, R Gandhiraj, Madaswamy Jayakumar

Very high data rates and decoding computational complexity place strict constraints in 5G and 6G communications. In this paper, non-uniform Quantized Decoding algorithm is proposed for Low-density Parity Check codes (LDPC). In the proposed algorithm, the check node updating process is carried out using quantization, which reduces complexity. The Sum Product Algorithm (SPA) is iterative message passing decoding techniques offer the optimal performance for LDPC codes. Implementations use message-passing decoding with more precision, results extremely high complexity. In Iterative, message-passing (MP), trapping sets and absorbing sets causes low error floor. In this article non-uniform quantization proposed to overcome dynamic range of values over uniform quantization. Simulation results provide coding gain increases closer to of 0.5 dB in higher SNR and has good error floor at 10−5.

International Conference on Wireless Communications, Signal Processing and Networking (WiSPNET)•Mar 20, 2025•2 citations

A low-complex Min-Sum decoding algorithm for irregular LDPC codes

Michaelraj Kingston Roberts, Maria Falaq

This paper presents a low complexity Min-Sum algorithm for decoding irregular Low-Density Parity-Check (LDPC) codes. In the proposed algorithm, the significant improvement in the error correcting performance without enhancing the hardware complexity is achieved by employing adaptive and optimized normalization factors for both the extrinsic information and log-likelihood ratio data bits respectively. The experimental results demonstrate that the proposed algorithm with 6-bit non-uniform quantization achieves reasonable decoding performance in terms of Frame Error Rate (FER) and Bit Error Rate (BER) without increasing the hardware complexity by avoiding finite word length effects of soft information.

International Conference on Wireless Communications, Signal Processing and Networking (WiSPNET)•Mar 1, 2016•3 citations

An improved implementation of sum-product algorithm for LDPC decoder

Zhou Wang, Bin Wu, Tianchun Ye

An improved decoding algorithm for low-density parity-check (LDPC) codes is presented. By taking advantages of the first-term Taylor’s series multiple expansion to approximate the correction term of the Jacobian logarithm used in LLR-SPA (log-likelihood ratio sum-product algorithm), we propose an algorithm which significantly simplifies the check node update computation of the optimal LLR-SPA. Besides, the parameter δ is introduced to determine suitable expansion points. The simulation result shows that the proposed method with ten expansion points when δ is set to 0.01 has almost identical performance compared with ideal SPA algorithm and outperforms both the min-sum algorithm (MS), the offset min-sum algorithm (OMS) and the normalised min-sum algorithm (NMS). The architecture of proposed method is also presented for implementation, which has reduced computational complexity and is feasible for hardware implementation.

IEICE Electronics Express•Jan 1, 2019•3 citations

Design and Implementation of Low Bit Error Rate of LDPC Decoder

Ashlesha P. Kshirsagar, Sandeep Kakde, Manish Devendra Chawhan +1 more

Many classes of high-performance Low-density parity check codes are based on parity check matrices composed of permutation sub matrices. The emulation-simulation framework further allows the algorithm and implementation to be iteratively redefined to improve the error floor performance of message passing decoder. Log-Like hood-Ratio (LLR) based Belief-Propagation (BP) algorithm is presented for Low Density Parity Check codes. Numerically accurate representation of check node update computation used in LLR-BP decoding is described. The implementation of Sum-Product algorithm (SPA) within Low Density Parity Check Code (LDPC) decoder is described in this paper and the correction term is used to improve the decoding performance of min-sum algorithm (MSA). Quantization and log-tanh function approximation in sum-product decoder strongly affect which absorbing set dominates in error floor region. For LDPC decoder, bit error rate (BER) decreases with increase in the signal to noise ratio.

International Conference on Communication Systems and Network Technologies•Apr 1, 2015•1 citation

A Relaxed Half-Stochastic Iterative Decoder for LDPC Codes

François Leduc-Primeau, Saied Hemati, Warren J. Gross +1 more

This paper presents a Relaxed Half-Stochastic (RHS) low-density parity-check (LDPC) decoding algorithm that uses some elements of the sum-product algorithm (SPA) in its variable nodes, but maintains the low-complexity interleaver and check node structures characteristic of stochastic decoders. The algorithm relies on the principle of successive relaxation to convert binary stochastic streams to a log-likelihood ratio (LLR) representation. Simulations of a (2048, 1723) RS-LDPC code show that the RHS algorithm can outperform 100-iterations floating-point SPA decoding. We describe approaches for low-complexity implementation of the RHS algorithm. Furthermore, we show how the stochastic nature of the belief representation can be exploited to lower the error floor.

Globecom•Nov 1, 2009•20 citations
In this paper, a non-uniform quantization scheme is proposed for the decoding of Low-Density Parity-Check (LDPC) codes with the Sum-Product Algorithm (SPA). With the proposed scheme, the quantization-range and quantization-interval for the soft Log-Likelihood-Ratio (LLR) values of the decoder input, the variable nodes, and the check nodes are set separately, and are also adjusted according to the evolution of the probability density distribution of the LLR values in the iterative decoding procedure to minimize the difference between the decoding values before quantization and that after quantization. Simulation results show that decoding with 3-bit non-uniform quantization of the proposed scheme may obtain a BER performance slightly better than that of decoding with 6-bits quantization of the traditional uniform quantization method.
Very high data rates and decoding computational complexity place strict constraints in 5G and 6G communications. In this paper, non-uniform Quantized Decoding algorithm is proposed for Low-density Parity Check codes (LDPC). In the proposed algorithm, the check node updating process is carried out using quantization, which reduces complexity. The Sum Product Algorithm (SPA) is iterative message passing decoding techniques offer the optimal performance for LDPC codes. Implementations use message-passing decoding with more precision, results extremely high complexity. In Iterative, message-passing (MP), trapping sets and absorbing sets causes low error floor. In this article non-uniform quantization proposed to overcome dynamic range of values over uniform quantization. Simulation results provide coding gain increases closer to of 0.5 dB in higher SNR and has good error floor at 10−5.
This paper presents a low complexity Min-Sum algorithm for decoding irregular Low-Density Parity-Check (LDPC) codes. In the proposed algorithm, the significant improvement in the error correcting performance without enhancing the hardware complexity is achieved by employing adaptive and optimized normalization factors for both the extrinsic information and log-likelihood ratio data bits respectively. The experimental results demonstrate that the proposed algorithm with 6-bit non-uniform quantization achieves reasonable decoding performance in terms of Frame Error Rate (FER) and Bit Error Rate (BER) without increasing the hardware complexity by avoiding finite word length effects of soft information.
An improved decoding algorithm for low-density parity-check (LDPC) codes is presented. By taking advantages of the first-term Taylor’s series multiple expansion to approximate the correction term of the Jacobian logarithm used in LLR-SPA (log-likelihood ratio sum-product algorithm), we propose an algorithm which significantly simplifies the check node update computation of the optimal LLR-SPA. Besides, the parameter δ is introduced to determine suitable expansion points. The simulation result shows that the proposed method with ten expansion points when δ is set to 0.01 has almost identical performance compared with ideal SPA algorithm and outperforms both the min-sum algorithm (MS), the offset min-sum algorithm (OMS) and the normalised min-sum algorithm (NMS). The architecture of proposed method is also presented for implementation, which has reduced computational complexity and is feasible for hardware implementation.
Many classes of high-performance Low-density parity check codes are based on parity check matrices composed of permutation sub matrices. The emulation-simulation framework further allows the algorithm and implementation to be iteratively redefined to improve the error floor performance of message passing decoder. Log-Like hood-Ratio (LLR) based Belief-Propagation (BP) algorithm is presented for Low Density Parity Check codes. Numerically accurate representation of check node update computation used in LLR-BP decoding is described. The implementation of Sum-Product algorithm (SPA) within Low Density Parity Check Code (LDPC) decoder is described in this paper and the correction term is used to improve the decoding performance of min-sum algorithm (MSA). Quantization and log-tanh function approximation in sum-product decoder strongly affect which absorbing set dominates in error floor region. For LDPC decoder, bit error rate (BER) decreases with increase in the signal to noise ratio.
This paper presents a Relaxed Half-Stochastic (RHS) low-density parity-check (LDPC) decoding algorithm that uses some elements of the sum-product algorithm (SPA) in its variable nodes, but maintains the low-complexity interleaver and check node structures characteristic of stochastic decoders. The algorithm relies on the principle of successive relaxation to convert binary stochastic streams to a log-likelihood ratio (LLR) representation. Simulations of a (2048, 1723) RS-LDPC code show that the RHS algorithm can outperform 100-iterations floating-point SPA decoding. We describe approaches for low-complexity implementation of the RHS algorithm. Furthermore, we show how the stochastic nature of the belief representation can be exploited to lower the error floor.