Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Physics Conference Series

Different ways to active optical frequency standards

Duo Pan, Xiaobo Xue, Xiaogang Zhang, Jingbiao Chen

Published Jun 1, 2016• 1 citation
Publisher

Abstract

Active optical frequency standard, or active optical clock, is a new concept of optical frequency standard, where a weak feedback with phase coherence information in optical bad-cavity limitation is formed, and the continuous self-sustained coherent stimulated emission between two atomic transition levels with population inversion is realized. Through ten years of both theoretical and experimental exploration, the narrow linewidth and suppression of cavity pulling effect of active optical frequency standard have been initially proved. In this paper, after a simple review, we will mainly present the most recent experimental progresses of active optical frequency standards in Peking University, including 4-level cesium active optical frequency standards and active Faraday optical frequency standards. The future development of active optical frequency standards is also discussed.

DOI
10.1088/1742-6596/723/1/012028

Related papers

Research progress on active optical clocks

Jingbiao Chen, Wei Zhang

Active optical clocks, a new class of optical atomic clocks, work through stimulated emission lasing, a unique mechanism that is distinct from laser absorption spectroscopy of conventional optical clocks. With coherent weak optical feedback from a Fabry-Perot resonator operating in the bad-cavity regime, active optical clocks sustain a lasing oscillation at an atomic transition frequency. They are used directly as quantum optical frequency standards with expected stability better by about two orders of magnitude than that of the best clocks. This review starts with a simplified account of historical developments and the limitations of critical techniques in optical atomic clocks. After an introduction of the basic mechanism underlying active optical clocks, we discuss the most recent experimental results for several configurations and experimental set-ups of active optical clocks. These include those based on a 2-level atomic beam and 3-level laser-cooled trapped-atom system, those based on a 4-level atom scheme, and the Faraday active optical clock. Moreover, following the successful lasing and preliminary results on a Faraday active optical frequency standard with Faraday atomic filter using thermal Cs cell, we describe an experimental scheme of a Faraday active optical clock with a Faraday atomic filter using magic-lattice-trapped Sr atoms at the 689-nm transition, and Faraday optical clocks operating in the good-cavity regime. We conclude with a comprehensive comparison of the different active optical clocks, prospects for active Faraday optical clocks, and potential applications of active optical clocks.

Chinese Science Bulletin (Chinese Version)•Jul 1, 2015•4 citations

Active Faraday optical frequency standard

Wei Zhuang, Jingbiao Chen

We propose the mechanism of an active Faraday optical clock, and experimentally demonstrate an active Faraday optical frequency standard based on narrow bandwidth Faraday atomic filter by the method of velocity-selective optical pumping of cesium vapor. The center frequency of the active Faraday optical frequency standard is determined by the cesium 6 (2)S(1/2) F=4 to 6 (2)P(3/2) F'=4 and 5 crossover transition line. The optical heterodyne beat between two similar independent setups shows that the frequency linewidth reaches 281(23) Hz, which is 1.9×10(4) times smaller than the natural linewidth of the cesium 852-nm transition line. The maximum emitted light power reaches 75 μW. The active Faraday optical frequency standard reported here has advantages of narrow linewidth and reduced cavity pulling, which can readily be extended to other atomic transition lines of alkali and alkaline-earth metal atoms trapped in optical lattices at magic wavelengths, making it useful for new generation of optical atomic clocks.

arXiv:1407.3428•Optics Letters•Oct 29, 2014•60 citations

Active optical clock: seventeen years of progress and next steps

Jia Zhang, Tiantian Shi, Jianxiang Miao +3 more

Abstract The concept of the active optical clock (AOC) was proposed seventeen years ago by prof. Jingbiao Chen. After early calculations and experiments that demonstrated the advantages of “cavity-pulling suppression” and “narrower linewidth”, the development of AOCs soon became an active competition involving many research groups that proposed schemes based on different atomic species, and different energy-level structures. In this paper, after a brief background introduction, we will mainly focus on the most recent experimental and theoretical progress of AOCs in Peking University. In addition, we give an outlook on AOCs based on cold atoms that can be operated continuously, and report a novel AOC scheme based on diffuse laser cooling that can be operated continuously for the first time, which is proposed and performed by Peking University. The AOC has great promise for applications in quantum metrology, as it can overcome the thermal noise of the reference cavity that limits conventional lasers, making AOC a promising candidate for future atomic optical clocks.

Journal of Physics Conference Series•Nov 1, 2024•1 citation

Advances in active optical clocks: Past decade developments and future outlook

Chen Wang, Shougang Zhang, Jingbiao Chen +1 more

Atomic clocks can be broadly classified into passive and active types according to their mode of operation. In the microwave domain, active hydrogen masers provide excellent short-term stability and are widely used as flywheel oscillators in timekeeping systems along with the cesium fountain standards. In the optical domain, passive optical clocks have achieved unprecedented accuracy and stability, but at the cost of large and complex infrastructures associated with ultrastable cavities and the preparation of atoms in optical lattices or ion traps. By contrast, active optical clocks generate coherent clock light directly from an atomic transition in the bad-cavity regime, where cavity pulling is strongly suppressed, thereby reducing sensitivity to cavity fluctuations and potentially simplifying optical clock architectures. Over the past decade, active optical clocks have developed from a conceptual proposal into a rapidly advancing field that includes pulsed superradiant systems based on cold atoms and continuous-wave bad-cavity systems based on thermal atomic vapors. This review summarizes recent progress in active optical clocks and discusses future directions of the field.

Quantum Review Letters•Jan 1, 2026•0 citations

Research on Cs active Faraday optical frequency standard with 459 nm laser pumping

Xiaogang Zhang, Zhaojie Jiang, Zhiming Tao +3 more

Known as a unique optical clock, active optical clock has prior advantages to surpass the limitation of the conventional optical clock in potential stability. In this paper, we proposed an improved Cesium active Faraday optical frequency standard with 459 nm laser pumping. This scheme reduces the residual Doppler broadening in previous results with 852 nm laser pumping. The transmission is 2.4% and the bandwidth of the transmission peak is 12.3 MHz. It greatly narrows the bandwidth of Faraday anomalous dispersion optical filter and decreases the length of the bad cavity used in Cesium active Faraday optical frequency standard. This will be very helpful for further suppression of cavity pulling effect.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•May 1, 2016•1 citation

The Lasing Realization of Rb Four-Level Active Optical Clock

Pengyuan Chang, Shengnan Zhang, Haosen Shang +1 more

Since the concept of active optical clock has been proposed, the experimental research of Rb four-level active optical clock has never been carried out, but it has great value in research and application. First the Rb atoms are pumped from ground state 5S1/2to 6P3/2excited state by a narrow-linewidth 420 nm laser, and then decay to lower energy levels by spontaneous transitions, and immediately are pumped by pumping laser again. This process continues until the population inversion is established between 6 S and 5P states. Once the population inversion is built up, a Fabry-Perot type resonator, at a bad cavity regime whose cavity mode linewidth is much wider than that of the laser gain profile, is used to realize 1367 nm active optical clock laser output. As Rb atom 1367 nm 5P-6S excited state transition is in the communication E band, it can be used as a narrow-linewidth communication band optical frequency standard, which greatly improves the communication rate and accuracy.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•May 1, 2018•0 citations
Active optical frequency standard, or active optical clock, is a new concept of optical frequency standard, where a weak feedback with phase coherence information in optical bad-cavity limitation is formed, and the continuous self-sustained coherent stimulated emission between two atomic transition levels with population inversion is realized. Through ten years of both theoretical and experimental exploration, the narrow linewidth and suppression of cavity pulling effect of active optical frequency standard have been initially proved. In this paper, after a simple review, we will mainly present the most recent experimental progresses of active optical frequency standards in Peking University, including 4-level cesium active optical frequency standards and active Faraday optical frequency standards. The future development of active optical frequency standards is also discussed.
Active optical clocks, a new class of optical atomic clocks, work through stimulated emission lasing, a unique mechanism that is distinct from laser absorption spectroscopy of conventional optical clocks. With coherent weak optical feedback from a Fabry-Perot resonator operating in the bad-cavity regime, active optical clocks sustain a lasing oscillation at an atomic transition frequency. They are used directly as quantum optical frequency standards with expected stability better by about two orders of magnitude than that of the best clocks. This review starts with a simplified account of historical developments and the limitations of critical techniques in optical atomic clocks. After an introduction of the basic mechanism underlying active optical clocks, we discuss the most recent experimental results for several configurations and experimental set-ups of active optical clocks. These include those based on a 2-level atomic beam and 3-level laser-cooled trapped-atom system, those based on a 4-level atom scheme, and the Faraday active optical clock. Moreover, following the successful lasing and preliminary results on a Faraday active optical frequency standard with Faraday atomic filter using thermal Cs cell, we describe an experimental scheme of a Faraday active optical clock with a Faraday atomic filter using magic-lattice-trapped Sr atoms at the 689-nm transition, and Faraday optical clocks operating in the good-cavity regime. We conclude with a comprehensive comparison of the different active optical clocks, prospects for active Faraday optical clocks, and potential applications of active optical clocks.
We propose the mechanism of an active Faraday optical clock, and experimentally demonstrate an active Faraday optical frequency standard based on narrow bandwidth Faraday atomic filter by the method of velocity-selective optical pumping of cesium vapor. The center frequency of the active Faraday optical frequency standard is determined by the cesium 6 (2)S(1/2) F=4 to 6 (2)P(3/2) F'=4 and 5 crossover transition line. The optical heterodyne beat between two similar independent setups shows that the frequency linewidth reaches 281(23) Hz, which is 1.9×10(4) times smaller than the natural linewidth of the cesium 852-nm transition line. The maximum emitted light power reaches 75 μW. The active Faraday optical frequency standard reported here has advantages of narrow linewidth and reduced cavity pulling, which can readily be extended to other atomic transition lines of alkali and alkaline-earth metal atoms trapped in optical lattices at magic wavelengths, making it useful for new generation of optical atomic clocks.
Abstract The concept of the active optical clock (AOC) was proposed seventeen years ago by prof. Jingbiao Chen. After early calculations and experiments that demonstrated the advantages of “cavity-pulling suppression” and “narrower linewidth”, the development of AOCs soon became an active competition involving many research groups that proposed schemes based on different atomic species, and different energy-level structures. In this paper, after a brief background introduction, we will mainly focus on the most recent experimental and theoretical progress of AOCs in Peking University. In addition, we give an outlook on AOCs based on cold atoms that can be operated continuously, and report a novel AOC scheme based on diffuse laser cooling that can be operated continuously for the first time, which is proposed and performed by Peking University. The AOC has great promise for applications in quantum metrology, as it can overcome the thermal noise of the reference cavity that limits conventional lasers, making AOC a promising candidate for future atomic optical clocks.
Atomic clocks can be broadly classified into passive and active types according to their mode of operation. In the microwave domain, active hydrogen masers provide excellent short-term stability and are widely used as flywheel oscillators in timekeeping systems along with the cesium fountain standards. In the optical domain, passive optical clocks have achieved unprecedented accuracy and stability, but at the cost of large and complex infrastructures associated with ultrastable cavities and the preparation of atoms in optical lattices or ion traps. By contrast, active optical clocks generate coherent clock light directly from an atomic transition in the bad-cavity regime, where cavity pulling is strongly suppressed, thereby reducing sensitivity to cavity fluctuations and potentially simplifying optical clock architectures. Over the past decade, active optical clocks have developed from a conceptual proposal into a rapidly advancing field that includes pulsed superradiant systems based on cold atoms and continuous-wave bad-cavity systems based on thermal atomic vapors. This review summarizes recent progress in active optical clocks and discusses future directions of the field.
Known as a unique optical clock, active optical clock has prior advantages to surpass the limitation of the conventional optical clock in potential stability. In this paper, we proposed an improved Cesium active Faraday optical frequency standard with 459 nm laser pumping. This scheme reduces the residual Doppler broadening in previous results with 852 nm laser pumping. The transmission is 2.4% and the bandwidth of the transmission peak is 12.3 MHz. It greatly narrows the bandwidth of Faraday anomalous dispersion optical filter and decreases the length of the bad cavity used in Cesium active Faraday optical frequency standard. This will be very helpful for further suppression of cavity pulling effect.
Since the concept of active optical clock has been proposed, the experimental research of Rb four-level active optical clock has never been carried out, but it has great value in research and application. First the Rb atoms are pumped from ground state 5S1/2to 6P3/2excited state by a narrow-linewidth 420 nm laser, and then decay to lower energy levels by spontaneous transitions, and immediately are pumped by pumping laser again. This process continues until the population inversion is established between 6 S and 5P states. Once the population inversion is built up, a Fabry-Perot type resonator, at a bad cavity regime whose cavity mode linewidth is much wider than that of the laser gain profile, is used to realize 1367 nm active optical clock laser output. As Rb atom 1367 nm 5P-6S excited state transition is in the communication E band, it can be used as a narrow-linewidth communication band optical frequency standard, which greatly improves the communication rate and accuracy.