Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)

Wideband paramps for the millimeter and submillimeter bands

Peter K. Day, Byeong Ho Eom, Henry George LeDuc, Jonas Stasys Zmuidzinas, Christopher Groppi, Philip D. Mauskopf, James W. Lamb, D. P. Woody

Published Sep 1, 2014• 2 citations
Publisher

Abstract

The traveling-wave kinetic inductance parametric (TKIP) amplifier is a new amplifier technology capable of near quantum-limited sensitivity over a wide instantaneous bandwidth. Microwave frequency versions of these amplifiers, which are based on four-wave mixing in an NbTiN coplanar waveguide transmission line, have demonstrated high gain and noise corresponding to a few photons at several GHz. Their simple design is easily scalable to higher frequency, allowing for operation up to near the (> 1 THz) gap frequency of NbTiN. We will discuss the current state of the art of the TKIP operating at microwave frequencies and the potential use of these amplifiers as front ends for receivers in the millimeter and submillimeter bands. As an example, we describe the design of a TKIP tuned for the W-band.

DOI
10.1109/irmmw-thz.2014.6956218

Related papers

Superconducting parametric amplifiers: The next big thing in (Sub)millimeter-wave receivers

Omid Noroozian, Anthony R. Kerr, Jeffrey G. Mangum +7 more

We are developing a new superconducting amplifier technology for radio astronomy instruments called the Traveling-Wave Kinetic Inductance Parametric (TKIP) amplifier. Invented at Caltech/JPL, recent laboratory demonstrations have resulted in near quantum-limited noise performance over more than an octave of microwave bandwidth and operating temperatures as high as 3 Kelvin. These amplifiers have the potential to be used as front-end replacements for ALMA's mm/sub-mm SIS receivers and intermediate frequency (IF) amplifiers, and for multiplexing faint signals from focal-plane arrays of single-photon detectors on space telescopes such as NASA's Origins Space Telescope (OST). The enhanced observational capabilities that would be enabled by TKIP front-end amplifiers on ALMA would tremendously benefit ALMA science across all bands.

United States National Committee of URSI National Radio Science Meeting•Jan 1, 2018•2 citations

A 4–8 GHz kinetic inductance traveling-wave parametric amplifier using four-wave mixing with near quantum-limited noise performance

Farzad Faramarzi, Ryan Stephenson, Sasha Sypkens +3 more

Kinetic inductance traveling-wave parametric amplifiers (KI-TWPAs) have a wide instantaneous bandwidth with a near quantum-limited noise performance and a relatively high dynamic range. Because of this, they are suitable readout devices for cryogenic detectors and superconducting qubits and have a variety of applications in quantum sensing. This work discusses the design, fabrication, and performance of a KI-TWPA based on four-wave mixing in a NbTiN microstrip transmission line. This device amplifies a signal band from 4 to 8 GHz without contamination from image tones, which are produced in a separate higher frequency band. The 4–8 GHz band is commonly used to read out cryogenic detectors, such as microwave kinetic inductance detectors and Josephson junction-based qubits. We report a measured maximum gain of over 20 dB using four-wave mixing with a 1 dB gain compression point of −58 dBm at 15 dB of gain over that band. The bandwidth and peak gain are tunable by adjusting the pump-tone frequency and power. Using a Y-factor method, we measure an amplifier-added noise of 0.5 ≤ Nadded ≤ 1.5 photons from 4.5 to 8 GHz.

arXiv:2402.11751•APL Quantum•Jul 11, 2024•25 citations

Wideband superconducting parametric amplifiers based on kinetic inductance (Conference Presentation)

Peter K. Day, Byeong Ho Eom, Henry George LeDuc

Traveling-wave parametric amplifiers based on superconducting NbTiN films are being developed that provide gain over nearly an octave of bandwidth at microwave frequencies. The amplifiers are non-linear transmission lines, where the nonlinearity comes from the current dependence of the kinetic inductance. Amplification results from three and four-wave mixing processes, and phase matching over a wide frequency range is achieved by engineering the dispersion characteristics of the transmission line. Recent noise measurements over a wide frequency band demonstrate that the added noise of these amplifiers is close to one half photon, consistent with the quantum limit for a phase preserving amplifier. We will discuss applications of this class of amplifier to astronomical instruments.

Millimeter, Submillimeter, and Far-Infrared Detectors and Instrumentation for Astronomy XI•Jul 10, 2018•1 citation

Kinetic Inductance Traveling Wave Parametric Amplifiers Near the Quantum Limit: Methodology and Characterization

Logan A. Howe, Andrea Giachero, Michael R. Vissers +7 more

We present a detailed simulation and design framework for realizing traveling wave parametric amplifiers (TWPAs) using the nonlinear kinetic inductance of disordered superconductors -- in our case niobium-titanium-nitride (NbTiN). These kinetic inductance TWPAs (KITs) operate via three-wave mixing (3WM) to achieve high broadband gain and near-quantum-limited (nQL) noise. Representative fabricated devices -- realized using an inverted microstrip (IMS), dispersion-engineered, artificial transmission line -- demonstrate power gains above 25 dB, bandwidths beyond 3 GHz, and achieve ultimate system noise levels of 1.1 quanta even when operated with no magnetic shielding. These performance metrics are competitive with state-of-the-art Josephson-junction-based TWPAs but involve simpler fabrication and able to providing three orders of magnitude higher dynamic range ($IIP_1 = -68$ dBm, $IIP_3 = -55$ dBm), and high magnetic field resilience -- making KITs an attractive technology for highly multiplexed readout of quantum information and superconducting detector systems.

arXiv:2507.07706•Jul 10, 2025•0 citations

Operation of kinetic-inductance travelling wave parametric amplifiers at millimetre wavelengths

Boon-Kok Tan, Nikita S. Klimovich, R Stephenson +2 more

Abstract It is expected that the operation of microwave kinetic inductance travelling wave parametric amplifiers (KITWPAs) can be extended to the millimetre (mm) and the sub-mm wavelength range as long as the frequency is below the gap frequency of the superconducting film. This paper presents possible mm-wave designs for KITWPAs based on microstrip transmission lines. Our device is designed based on the BCS (Bardeen–Cooper–Schrieffer) model which successfully reproduces the measured transmission profile, gain, bandwidth, and nonlinear response of a fabricated KITWPA operating in the Ka-band, and includes the millimetre-wave dielectric loss determined by fitting the quality factor of a W-band microstrip resonator. We suggest a layout for a KITWPA operating near 220 GHz that can be fabricated using the same superconducting properties as the Ka-band device and can be coupled to a waveguide system. We conclude the paper by extending the 220 GHz design to higher frequency regimes approaching 1 THz.

Superconductor Science and Technology•Jan 22, 2024•12 citations

Low-noise kinetic inductance traveling-wave amplifier using three-wave mixing

Michael R. Vissers, R. P. Erickson, H. S. Ku +4 more

We have fabricated a wide-bandwidth, high dynamic range, low-noise cryogenic amplifier based on a superconducting kinetic inductance traveling-wave device. The device was made from NbTiN and consisted of a long, coplanar waveguide on a silicon chip. By adding a DC current and an RF pump tone we are able to generate parametric amplification using three-wave mixing. The devices exhibit gain of more than 15 dB across an instantaneous bandwidth from 4 to 8 GHz. The total usable gain bandwidth, including both sides of the signal-idler gain region, is more than 6 GHz. The noise referred to the input of the devices approaches the quantum limit, with less than 1 photon excess noise. Compared to similarly constructed four-wave mixing amplifiers, these devices operate with the RF pump at ~20 dB lower power and at frequencies far from the signal. This will permit easier integration into large scale qubit and detector applications.

arXiv:1509.09280•Applied Physics Letters•Jan 4, 2016•128 citations
The traveling-wave kinetic inductance parametric (TKIP) amplifier is a new amplifier technology capable of near quantum-limited sensitivity over a wide instantaneous bandwidth. Microwave frequency versions of these amplifiers, which are based on four-wave mixing in an NbTiN coplanar waveguide transmission line, have demonstrated high gain and noise corresponding to a few photons at several GHz. Their simple design is easily scalable to higher frequency, allowing for operation up to near the (> 1 THz) gap frequency of NbTiN. We will discuss the current state of the art of the TKIP operating at microwave frequencies and the potential use of these amplifiers as front ends for receivers in the millimeter and submillimeter bands. As an example, we describe the design of a TKIP tuned for the W-band.
We are developing a new superconducting amplifier technology for radio astronomy instruments called the Traveling-Wave Kinetic Inductance Parametric (TKIP) amplifier. Invented at Caltech/JPL, recent laboratory demonstrations have resulted in near quantum-limited noise performance over more than an octave of microwave bandwidth and operating temperatures as high as 3 Kelvin. These amplifiers have the potential to be used as front-end replacements for ALMA's mm/sub-mm SIS receivers and intermediate frequency (IF) amplifiers, and for multiplexing faint signals from focal-plane arrays of single-photon detectors on space telescopes such as NASA's Origins Space Telescope (OST). The enhanced observational capabilities that would be enabled by TKIP front-end amplifiers on ALMA would tremendously benefit ALMA science across all bands.
Kinetic inductance traveling-wave parametric amplifiers (KI-TWPAs) have a wide instantaneous bandwidth with a near quantum-limited noise performance and a relatively high dynamic range. Because of this, they are suitable readout devices for cryogenic detectors and superconducting qubits and have a variety of applications in quantum sensing. This work discusses the design, fabrication, and performance of a KI-TWPA based on four-wave mixing in a NbTiN microstrip transmission line. This device amplifies a signal band from 4 to 8 GHz without contamination from image tones, which are produced in a separate higher frequency band. The 4–8 GHz band is commonly used to read out cryogenic detectors, such as microwave kinetic inductance detectors and Josephson junction-based qubits. We report a measured maximum gain of over 20 dB using four-wave mixing with a 1 dB gain compression point of −58 dBm at 15 dB of gain over that band. The bandwidth and peak gain are tunable by adjusting the pump-tone frequency and power. Using a Y-factor method, we measure an amplifier-added noise of 0.5 ≤ Nadded ≤ 1.5 photons from 4.5 to 8 GHz.
Traveling-wave parametric amplifiers based on superconducting NbTiN films are being developed that provide gain over nearly an octave of bandwidth at microwave frequencies. The amplifiers are non-linear transmission lines, where the nonlinearity comes from the current dependence of the kinetic inductance. Amplification results from three and four-wave mixing processes, and phase matching over a wide frequency range is achieved by engineering the dispersion characteristics of the transmission line. Recent noise measurements over a wide frequency band demonstrate that the added noise of these amplifiers is close to one half photon, consistent with the quantum limit for a phase preserving amplifier. We will discuss applications of this class of amplifier to astronomical instruments.
We present a detailed simulation and design framework for realizing traveling wave parametric amplifiers (TWPAs) using the nonlinear kinetic inductance of disordered superconductors -- in our case niobium-titanium-nitride (NbTiN). These kinetic inductance TWPAs (KITs) operate via three-wave mixing (3WM) to achieve high broadband gain and near-quantum-limited (nQL) noise. Representative fabricated devices -- realized using an inverted microstrip (IMS), dispersion-engineered, artificial transmission line -- demonstrate power gains above 25 dB, bandwidths beyond 3 GHz, and achieve ultimate system noise levels of 1.1 quanta even when operated with no magnetic shielding. These performance metrics are competitive with state-of-the-art Josephson-junction-based TWPAs but involve simpler fabrication and able to providing three orders of magnitude higher dynamic range (IIP1=−68IIP_1 = -68IIP1​=−68 dBm, IIP3=−55IIP_3 = -55IIP3​=−55 dBm), and high magnetic field resilience -- making KITs an attractive technology for highly multiplexed readout of quantum information and superconducting detector systems.
Abstract It is expected that the operation of microwave kinetic inductance travelling wave parametric amplifiers (KITWPAs) can be extended to the millimetre (mm) and the sub-mm wavelength range as long as the frequency is below the gap frequency of the superconducting film. This paper presents possible mm-wave designs for KITWPAs based on microstrip transmission lines. Our device is designed based on the BCS (Bardeen–Cooper–Schrieffer) model which successfully reproduces the measured transmission profile, gain, bandwidth, and nonlinear response of a fabricated KITWPA operating in the Ka-band, and includes the millimetre-wave dielectric loss determined by fitting the quality factor of a W-band microstrip resonator. We suggest a layout for a KITWPA operating near 220 GHz that can be fabricated using the same superconducting properties as the Ka-band device and can be coupled to a waveguide system. We conclude the paper by extending the 220 GHz design to higher frequency regimes approaching 1 THz.
We have fabricated a wide-bandwidth, high dynamic range, low-noise cryogenic amplifier based on a superconducting kinetic inductance traveling-wave device. The device was made from NbTiN and consisted of a long, coplanar waveguide on a silicon chip. By adding a DC current and an RF pump tone we are able to generate parametric amplification using three-wave mixing. The devices exhibit gain of more than 15 dB across an instantaneous bandwidth from 4 to 8 GHz. The total usable gain bandwidth, including both sides of the signal-idler gain region, is more than 6 GHz. The noise referred to the input of the devices approaches the quantum limit, with less than 1 photon excess noise. Compared to similarly constructed four-wave mixing amplifiers, these devices operate with the RF pump at ~20 dB lower power and at frequencies far from the signal. This will permit easier integration into large scale qubit and detector applications.