Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Frontiers in Optics

Optical Bistability with Two Serially Integrated InP-SOAs on a Single Chip

Michael E. Plascak, Jukka Viheriälä, Mircea D. Guina, Azad Z. Siahmakoun

Published Jan 1, 2015• 0 citations
Publisher

Abstract

Optical bistability has been achieved with two serially integrated MQW-InP SOAs in reverse-bias on a single chip. We demonstrate that switching speed in GHz range is possible and discuss performance limitations of the bistable device.
DOI
10.1364/fio.2015.jw2a.18

Related papers

All-optical flip-flop based on optical bistability in an integrated SOA/DFB-SOA

Young‐Il Kim, Jae Hun Kim, Young Min Jeon +3 more

We have demonstrated for the first time an all-optical flip-flop based on optical bistability of an integrated SOA/DFB-SOA by applying an input signal with the period of 25.2 ns. An all-optical flip-flop based on optical bistability is expected to process the signal at an ultra-high speed in a light-wave communication. All-optical flip-flop has various applications such as all optical memory, demultiplexing, packet-header buffering, and retiming. Moreover, an integrated SOA/DFBSOA can perform all-optical logic operation and wavelength conversion by cross gain modulation.

Optical Fiber Communication Conference•Jan 1, 2002•6 citations

Optical Bistability in a VCSEL Connected Across Serially-Coupled PIN Photodiodes

Sanaz Faryadras, Azad Z. Siahmakoun

Two serially-coupled PIN photodiodes connected to a 1550nm VCSEL is theoretically modeled and experimentally demonstrated to exhibit optical bistability. The bistable device operates in megahertz range mainly due to parasitic inductance and capacitance of the circuit.

Frontiers in Optics•Jan 1, 2016•0 citations

Optical bistability in a SOA/DFB-LD feedback scheme

Wouter D’Oosterlinck, Geert I. Morthier, Roel Baets +1 more

Optical bistability is investigated using a DFB laser diode connected with a SOA. Broadband operation and tunability of the domain of bistable responses is shown. The device can readily serve as an all-optical flip-flop.

Conference on Lasers and Electro-Optics•Jan 1, 2006•1 citation

Optical bistability in a nonlinear SOA-based fiber ring resonator

Pablo A. Costanzo‐Caso, Yiye Jin, Sergio Granieri +1 more

A novel optical inverted bistable switch based on a nonlinear fiber ring resonator (FRR), which contains a semiconductor optical amplifier (SOA) in the loop, have been analyzed and experimentally demonstrated. The optical bistability phenomenon is obtained due to the combined nonlinear effects of the transmission characteristics of the resonator and the SOA's gain property. A complete theoretical analysis and supporting simulations are presented. A working prototype is build using commercial optical components. Experimental results show switching speed in tens of MHz with rising and falling times lower than 10 ns. Limitations in switching speed are caused by the length of the fiber loop. Therefore, improvements in operating frequencies can be increased up to GHz range if the length of the loop is reduced to the order of centimeters.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Aug 19, 2010•4 citations

Broad-Band All-Optical Flip–Flop Based on Optical Bistability in an Integrated SOA/DFB-SOA

Young‐Il Kim, J.H. Kim, S. Lee +3 more

We have demonstrated a broad-band all-optical flip-flop for wavelength-division-multiplexing system based on optical bistability in a semiconductor optical amplifier (SOA)/distributed feedback (DFB)-SOA with wide gain bandwidth for both SOA and DFB-SOA regions. Input signal with two different wavelength selections of 1530.45 and 1578.12 nm and the repetition ration of about 6 ns is injected into the SOA/DFB-SOA.

IEEE Photonics Technology Letters•Feb 1, 2004•39 citations

Submilliwatt optical bistability in a coated InGaAs/InP multiquantum well waveguide Fabry–Perot cavity

David T. Neilson, Jeffrey E. Ehrlich, Paul Meredith +7 more

The observation of submilliwatt switching and optical bistability in an InGaAs/InP MQW waveguide Fabry–Perot cavity using diode laser sources is reported. Second-order bistability was also observed, with a higher power colour-centre laser source, showing that optically-induced phase shifts of greater than 2π can be achieved at power levels of less than 5mW. A switch contrast of ̃3:1 was observed.

Electronics Letters•Aug 19, 1993•4 citations
We have demonstrated for the first time an all-optical flip-flop based on optical bistability of an integrated SOA/DFB-SOA by applying an input signal with the period of 25.2 ns. An all-optical flip-flop based on optical bistability is expected to process the signal at an ultra-high speed in a light-wave communication. All-optical flip-flop has various applications such as all optical memory, demultiplexing, packet-header buffering, and retiming. Moreover, an integrated SOA/DFBSOA can perform all-optical logic operation and wavelength conversion by cross gain modulation.
A novel optical inverted bistable switch based on a nonlinear fiber ring resonator (FRR), which contains a semiconductor optical amplifier (SOA) in the loop, have been analyzed and experimentally demonstrated. The optical bistability phenomenon is obtained due to the combined nonlinear effects of the transmission characteristics of the resonator and the SOA's gain property. A complete theoretical analysis and supporting simulations are presented. A working prototype is build using commercial optical components. Experimental results show switching speed in tens of MHz with rising and falling times lower than 10 ns. Limitations in switching speed are caused by the length of the fiber loop. Therefore, improvements in operating frequencies can be increased up to GHz range if the length of the loop is reduced to the order of centimeters.