Abstract We have designed and mass-produced low-noise sideband separating superconductor–insulator–superconductor (SIS) mixers for the Atacama Large Millimeter/submillimeter Array (ALMA) band 4 over the frequency range of 125–163 GHz. An integrated design was adopted for the band 4 sideband separating (2SB) mixer block because of the advantages it offers in terms of compactness, reduced testing time and lower cost. The mixer chip was designed to be robust for handling errors to avoid performance degradation caused by generation of the higher order mode in the mixer chip slot. Detailed analyses revealed its robustness and ability to ensure mass production of the 2SB mixers. Using the robust mixer design in addition to well-established waveguide technologies, all of the 2SB mixers met ALMA specifications for noise temperature and image rejection ratio.
Abstract We have designed and mass-produced low-noise sideband separating superconductor–insulator–superconductor (SIS) mixers for the Atacama Large Millimeter/submillimeter Array (ALMA) band 4 over the frequency range of 125–163 GHz. An integrated design was adopted for the band 4 sideband separating (2SB) mixer block because of the advantages it offers in terms of compactness, reduced testing time and lower cost. The mixer chip was designed to be robust for handling errors to avoid performance degradation caused by generation of the higher order mode in the mixer chip slot. Detailed analyses revealed its robustness and ability to ensure mass production of the 2SB mixers. Using the robust mixer design in addition to well-established waveguide technologies, all of the 2SB mixers met ALMA specifications for noise temperature and image rejection ratio.
We developed SIS mixers for Atacama large millimeter/submillimeter array (ALMA) Band 8 (385-500 GHz) receiver cartridges and evaluated their performance. DC IV curves of the SIS mixers showed small leakage current at the high current density. The current density and quality factor (Rsg/Rn) of the Band 8 SIS junction were 13 kA/cm2and approximately 20, respectively. Double-sideband noise temperature of the 266 SIS mixers was 92.8 K at 4.0 K bath temperature on the average from 385 to 500 GHz with a standard deviation of 7.0%. A couple of sideband-separating (2SB) mixers for dual polarizations were used in the Band 8 receiver cartridge. The 73 receivers have met ALMA specifications of the noise temperature. Single-sideband noise temperature and image rejection ratio of the receivers were 139.5 K and 20.5 dB on the average from 385 to 500 GHz, respectively. These test results of the receivers indicate high quality and uniformity of the 2SB mixers.
The Atacama Large Millimeter Array (ALMA) is the largest radio astronomical enterprise ever proposed. When completed, each of its 64 constituting radio-telescopes will be able to hold 10 heterodyne receivers covering the spectroscopic windows allowed by the atmospheric transmission at the construction site, the altiplanos of the northern Chilean Andes. In contrast to the sideband-separating (2SB) receivers being developed at low frequencies, double-side-band (DSB) receivers are being developed for the highest two spectroscopic windows (bands 9 and 10). Despite of the well known advantages of 2SB mixers over their DSB counterparts, they have not been implemented at the highest-frequency bands as the involved dimensions for some of the radio frequency components are prohibitory small. However, the current state-of-the-art micromachining technology has proved that the structures necessary for this development are attainable. Here we report the design, modeling, realization, and characterization of a 2SB mixer for band 9 of ALMA (600 to 720 GHz). At the heart of the mixer, two superconductor-insulator-superconductor (SIS) junctions are used as mixing elements. The constructed instrument presents an excellent performance as shown by two important figures of merit: noise temperature of the system and side band ratio, both of them within ALMA specifications.
This licentiate is focused on the design and development of Superconductor-Insulator-Superconductor (SIS) junction mixer for ALMA Band 5, one of the ten frequency bands of the Atacama Large Millimeter Array (ALMA) project. ALMA Band 5 is a dual polarisation sideband separation heterodyne receiver covering radio frequencies (RF) from 163 GHz to 211 GHz, with 4-8 GHz intermediate frequency (IF). Amongst the other ALMA bands, Band 5 is the lowest frequency band, which uses all-cold optics. That puts strong constrains on the dimensions of all the receiver components. For the SIS mixer, we employ a MMIC-like approach where most of the DSB mixer components, including LO injection circuitry with novel directional coupler, are integrated on the same crystal quartz substrate. The mixer uses a lumped filter technique to extract the IF frequencies, which is non-traditional for SIS mixers. A custom made superconducting Lange coupler with suspended air bridges to connect the fingers of Lange coupler is used. Experimental measurements of the double sideband mixer show state of the art performance with the receiver noise temperature below 30 Kelvin across the entire band. The noise temperature for sideband separation mixer is below 60 Kelvin with sideband rejection better than 12 dB over most of the band.
We present the design and results of characterization of a new sideband separating (2SB) mixer for 800-950 GHz, based on superconductor-insulator-superconductor (SIS) junctions. This is the first waveguide 2SB SIS mixer demonstrated at such a high frequency. The design is following the classical quadrature hybrid architecture, meanwhile additional attention was put on the reduction of reflections in the RF structure in order to minimize the RF imbalance, to achieve a high image rejection ratio (IRR). The RF waveguide block was manufactured by micromilling and populated by single-ended SIS mixers developed earlier for upgrade of the CHAMP+ high-band array on the APEX telescope. These SIS mixers have double-sideband (DSB) noise temperatures from 210 to 400 K. The assembled 2SB mixer yields a SSB noise temperature from 450 to 900 K, with an IRR above 15 dB in 95% of the band. Comparing the DSB and the SSB sensitivities, we find that the waveguide losses are as low as expected and do not exceed 0.6 dB. The presented mixer is a prototype for use in a 2SB dual polarization receiver planned for deployment on the APEX telescope.
We present performance of the first ALMA Band 5 production cartridge, covering frequencies from 163 to 211 GHz. Atacama Large Millimeter/sub-millimeter Array (ALMA) Band 5 is a dual polarization, sideband separation (2SB) receiver based on all Niobium (Nb) superconductor–insulator–superconductor (SIS) tunnel junction mixers, providing 16 GHz of instantaneous RF bandwidth for astronomy observations. The 2SB mixer for each polarization employs a quadrature configuration. The sideband separation occurs at the output of the IF hybrid that has integrated bias-T for biasing the mixers, and is produced using superconducting thin-film technology. Experimental verification of the Band 5 cold cartridge performed together with warm cartridge assembly, confirms that the system noise temperature is below 45 K over most of the RF band, which is less than 5 photon noise (5 hf/k). This is to our knowledge, the best results reported at these frequencies. The measurement of the sideband rejection indicates that the sideband rejection is better than 10 dB over 90% of the observational band.
Abstract We developed a low-noise, compact, balanced superconductor–insulator–superconductor (SIS) mixer, operating in the 787–950 GHz radio frequency range. A waveguide mixer block was designed to integrate all the key components, such as a radio frequency (RF) 90° hybrid coupler, two identical SIS mixer chips, bias-tees, and an intermediate frequency power-combiner. The RF waveguide 90° hybrid coupler consists of branch lines with wide slots optimized by numerical simulation, for ease of fabrication. The balanced mixer was installed into a cartridge type receiver, originally developed for the Atacama Large Millimeter/submillimeter Array Band 10 (787–950 GHz). The receiver demonstrated double sideband noise temperatures of approximately 200 K for most of the band, without any correction for loss in front of the receiver. The local oscillator noise rejection ratio was estimated to be more than 15 dB within the measured frequency range.