IEEE MTT-S International Microwave Symposium digest

Superconductor analog-to-digital converters and their applications

Deepnarayan Gupta, Amol Inamdar, Dmitri E. Kirichenko, Alan M. Kadin, Oleg A. Mukhanov

Published Jun 1, 2011• 21 citations

Abstract

A wide variety of applications, ranging from radio-frequency (RF) receivers for broadband communications and signal detection, on earth and in space, would benefit from high-performance superconductor analog-to-digital converters (ADCs), based on magnetic flux quantization and fast switching Josephson junctions. Superconductor ADCs are capable of very high sample rates (100 GHz or more), very high linearity, and high sensitivity. Nyquist-rate ADCs use the high sample rate to digitize a wide instantaneous bandwidth (tens of GHz) and are useful for wideband spectrum monitoring as well as high-end scientific instrumentation. Delta and delta-sigma oversampling ADCs use the high linearity to achieve programmable trade-off between dynamic range and instantaneous bandwidth. These lowpass and bandpass ADCs have been used for direct digitization of narrower (tens to hundreds of MHz) RF bands in the 1-20 GHz range for a variety of communications, intelligence, electronic warfare, and radar applications. Another application area of these cryogenic ADCs is for outputs of cryogenic sensor arrays and terahertz mixers. Recent advances in various classes of ADCs for different applications are described.

DOI: 10.1109/mwsym.2011.5972910

Related papers

Superconductor analog-to-digital converters

Oleg A. Mukhanov, Deepnarayan Gupta, Alan M. Kadin +1 more

Ultrafast switching speed, low power, natural quantization of magnetic flux, quantum accuracy, and low noise of cryogenic superconductor circuits enable fast and accurate data conversion between the analog and digital domains. Based on rapid single-flux quantum (RSFQ) logic, these integrated circuits are capable of achieving performance levels unattainable by any other technology. Two major classes of superconductor analog-to-digital converters (ADCs) are being developed - Nyquist sampling and oversampling converters. Complete systems with digital sampling at rates of /spl sim/20 GHz and above have been demonstrated using low-temperature superconductor device technology. Some ADC components have also been implemented using high-temperature superconductors. Superconductor ADCs have unique applications in true digital-RF communications, broadband instrumentation, and digital sensor readout. Their designs, test results, and future development trends are reviewed.

Proceedings of the IEEESep 20, 2004185 citations

Superconductor analog to digital converter for sigint applications

Amol Inamdar, Deepnarayan Gupta, Timur V. Filippov +6 more

Superconductor analog-to-digital converters (ADC) offer high sensitivity and large dynamic range. We report recent advances in the low-pass phase-modulation-demodulation (PMD) oversampled analog-to-digital converter (ADC). The oversampled data from the PMD front-end are passed along with sampling clock to an on-chip digital filter. In the past, the maximum frequency of operation of such chips were limited by that of the digital decimation filter (DDF) to about 30 GHz. Recently, we have designed a chip that allows the PMD front-end to be clocked twice as fast as the DDF, resulting in sampling rates of 46.08 GHz and 29.44 GHz for chips with critical current densities of 4.5 and 1 kA/cm2respectively. We have also designed a new PMD front-end, with a quarter-rate quantizer (QRQ) that allows 18-20 dB extension of dynamic range. We are also pursuing a subranging ADC design with two PMD front-ends connected with fluxon amplifier and subtractor circuitry that promises a dynamic range extension by 25-30 dB. We report signal-to-noise ratio and spur-free dynamic range measurement results for various ADC chips, and project performance for future improvements.

IEEE Military Communications Conference (MILCOM)Nov 1, 20088 citations

Flux quantum sigma-delta analog-to-digital converters for rf signals

Donald L. Miller, John X. Przybysz, A. Hodge Worsham +1 more

The sigma-delta architecture is the method of choice for analog-to-digital converters (ADCs) for high dynamic range applications. This architecture uses oversampling and precise feedback to generate a shaped spectral distribution of the quantization noise. Subsequent digital filtering suppresses out-of-band quantization noise, yielding a large signal to in-band noise ratio. A unique advantage of superconducting electronics is the availability of the flux quantum to provide quantum mechanically accurate feedback at GHz rates. Josephson digital technology extends sigma-delta ADCs from MHz sampling rates to GHz sampling rates, from kHz signal bandwidths to MHz signal bandwidths, with comparable or better dynamic range when compared to semiconductor implementations. This paper presents circuits for Josephson sigma-delta ADCs, including single-loop and double-loop modulators operating at sampling rates up to 2 GHz, and circuits for quantized feedback. The first demonstration of double-loop noise shaping is also presented.

IEEE Transactions on Applied SuperconductivityJun 1, 199925 citations

Superconductor Digital-RF Receiver Systems

Oleg A. Mukhanov, Dmitri E. Kirichenko, I. V. Vernik +12 more

Digital superconductor electronics has been experiencing rapid maturation with the emergence of smaller-scale, lower-cost communications applications which became the major technology drivers. These applications are primarily in the area of wireless communications, radar, and surveillance as well as in imaging and sensor systems. In these areas, the fundamental advantages of superconductivity translate into system benefits through novel Digital-RF architectures with direct digitization of wide band, high frequency radio frequency (RF) signals. At the same time the availability of relatively small 4K cryocoolers has lowered the foremost market barrier for cryogenically-cooled digital electronic systems. Recently, we have achieved a major breakthrough in the development, demonstration, and successful delivery of the cryocooled superconductor digital-RF receivers directly digitizing signals in a broad range from kilohertz to gigahertz. These essentially hybrid-technology systems combine a variety of superconductor and semiconductor technologies packaged with two-stage commercial cryocoolers: cryogenic Nb mixed-signal and digital circuits based on Rapid Single Flux Quantum (RSFQ) technology, room-temperature amplifiers, FPGA processing and control circuitry. The demonstrated cryocooled digital-RF systems are the world's first and fastest directly digitizing receivers operating with live satellite signals in X-band and performing signal acquisition in HF to L-band at ∼30GHz clock frequencies.

IEICE Transactions on ElectronicsMar 1, 2008130 citations

Superconducting Analog-to-Digital Converters

Alan M. Kadin, Oleg A. Mukhanov

Analog-to-digital converters (ADCs) are electronic circuits that convert an electrical signal from the analog domain to the digital domain of binary numbers, which can then be processed by computers. A digital-to-analog converter (DAC) functions in the reverse direction, converting a sequence of binary numbers into a continuous electrical signal, and high-performance superconducting DACs are still being developed. A time-to-digital converter (TDC) digitizes time and resembles in some ways ADCs. Superconducting TDCs are simpler than ADCs and are being developed mostly for integration with cryogenic sensor arrays. Quantization refers to the selection of a discrete value for the magnitude when the signal is sampled, and is carried out by a quantizer. A high sampling rate with good linearity is necessary for high fidelity to the desired signal, and a DAC can be characterized by parameters of SNR and SFDR in much the same way as an ADC.

CRC Press eBooksMay 17, 20220 citations

High Performance HF-VHF All Digital RF Receiver Tested at 20 GHz Clock Frequencies

Anna De Escobar, Richard Hitt, Oleg A. Mukhanov +1 more

Wireless applications would be less expensive, more flexible, and more robust if they had more digital and less analog circuitry. The problem is implementing digital signal processing at radio frequencies. Conventional data converters (ADCs and DACs) and digital circuits are simply not fast enough. However, superconductors can provide ultra fast mixed signal and digital circuits with the linearity and dynamic range required for true direct, digital-RF processing. These superconducting circuits are digital ICs based on Josephson junctions and "rapid-single-flux-quantum" logic (RSFQ), where switching speeds up to 750 GHz have been demonstrated enabling true digital-RF architecture at clock speeds eventually up to 160 GHz. This permits direct conversion between analog RF and digital baseband signals, replacing frequency and protocol-specific analog hardware with flexible digital processors. Data conversion in high frequency wireless applications at frequencies up to 50 GHz will soon become practical. Hypres recently delivered a HF-VHF all digital RF receiver (ADR) prototype to ONR. Testing of this ADR has demonstrated the superior performance of superconducting ICs in cryocooled systems. A US Navy laboratory is now evaluating the world's first complete prototype digital RF receiver capable of direct digitization from DC to 2 GHz

IEEE Military Communications Conference (MILCOM)Oct 1, 20067 citations