We investigate the effect of tuning of the signal frequency in Brillouin induced four-wave mixing. We verify a number of theoretical predictions, and show that in the unstable regime the frequency of the phase conjugate is independent of the signal frequency.
It has previously been shown that Brillouin enhanced four-wave mixing can lead to large phase conjugate reflectivities for moderate laser powers.1,2 However, in the geometry considered by previous workers the pumps have equal frequency and hence the conjugate signal is shifted in frequency with respect to the probe. We have conducted an experimental and theoretical study of Brillouin-enhanced four-wave mixing for the different case in which the two pump waves differ in frequency by twice the Brillouin frequency of the four-wave mixing medium, and in which the probe wave frequency is halfway between those of the pump waves. In this case, the phase conjugate wave has the same frequency as the probe. Reflectivities > 100 % have been measured. Experimental results are compared to those of a theory that includes the effects of phase mismatch, pump depletion, and the finite response time of the medium.
We present a theoretical treatment of four-wave mixing (FWM) in a Brillouin-active medium for the case in which the pump waves differ in frequency by approximately twice the Brillouin frequency shift of the medium and in which the probe-wave frequency is approximately the arithmetic mean of the frequencies of the two pump waves. Under these conditions, the conjugate wave produced by the FWM process has the desirable property of being at the same frequency as the probe. We derive the coupled amplitude equations describing this interaction. We solve these equations analytically in the limit of negligible pump depletion and find that large phase conjugate reflectivities are readily achievable. The coupled amplitude equations are solved numerically for the general case, and it is found that large power transfer from the pumps to the output wave is possible. The output wave is shown to be a nearly perfect phase conjugate of the probe wave, even far into the regime where pump depletion effects are important. Our formalism predicts the existence of a parametric instability in the propagation of the pump waves, but good performance is predicted before the onset of this instability.
We report on a theoretical and modeling study of self-pumped four-wave mixing in a Brillouin medium. A theoretical analysis gives expressions for the threshold intensity and for the steady-state reflectivity at small input intensities. Operation over a range of input intensities is also investigated by using a computer model that predicts that, for high input intensities, the conjugate can become unstable and oscillate chaotically in time. Experimentally we observe phase conjugation with an input threshold 25 times less than that required for phase conjugation by stimulated Brillouin scattering.
Four-wave mixing mediated by Brillouin scattering in the transient regime exhibits an instability which results in large phase conjugate reflectivities [A. M. Scott and K. D. Ridley, IEEE J Quantum Electron. QE-25, 438 (1989)]. In this paper we compare measurements of the threshold for the instability both as a function of the ratio of the second pump beam to the first pump beam and as a function of the phase mismatch. Phase conjugation in Brillouin enhanced four-wave mixing occurs through the interaction of a signal with two counterpropagating pump beams. In our experiments, the frequencies of all three input beams are different, and a small phase mismatch results. The magnitude of this mismatch was varied both by changing one of the input frequencies and the interaction length. The frequency of the second pump beam was changed by using stimulated Brillouin scattering in various mixtures. Thus we were able to vary the phase mismatch from four to thirteen resulting in a 50% change in the threshold intensity, in agreement with theoretical models. The ratio of the backward-to-forward pump beam intensities also affects the threshold, and measurements of this agree with the model.