Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Shot noise and photon-induced correlations in 500 GHz SIS detectors

Noshir Dubash, Michael J. Wengler, Jonas Stasys Zmuidzinas

Published Jun 1, 1995• 6 citations
Publisher

Abstract

Photon-induced current correlations in SIS detectors can result in an output noise that is greater or less than shot noise. Evidence of these correlations had been observed for 100 GHz rf by accurate noise measurements as reported in our previous work. We now present a detailed analysis of these current correlations for frequencies between 100 and 500 GHz. We also report new measurements of photon-induced noise in a 490 GHz SIS mixer, and discuss the Gaussian beam techniques used to eliminate the thermal background radiation. For small 490 GHz rf power, the output noise is equal to shot noise. The results of the 100 and 490 GHz photon noise measurement are summarized in context to shot noise and the effect of the current correlations predicted by the theoretical model.>

DOI
10.1109/77.403299

Related papers

Photon induced noise in the SIS detector

Noshir Dubash, G. Pance, Michael J. Wengler

The dominant source of noise in an SIS mixer is the noise in the photon-induced current. We have made accurate measurements of noise induced in SIS junctions by 95 GHz photons. The noise is measured at 1.5 GHz using a low-noise cryogenic measurement system. The measured photon-induced noise is compared to the noise predicted by Tucker's theory augmented by a vacuum/thermal noise term. For small to moderate rf powers, at which SIS mixers are operated, the measured noise is nearly perfectly predicted by this theory for all the devices measured. Measurements of series arrays of SIS junctions also agree with this theory showing that the noise of each SIS junction in the array is independent. At large rf powers, the measured noise was higher than the predicted noise, in devices with smaller capacitance. We also measured the noise in single junctions and arrays with no rf radiation. These measurements agreed very well with the predicted shot noise for most bias conditions.>

IEEE Transactions on Microwave Theory and Techniques•Apr 1, 1994•15 citations

Shot noise in NbN SIS junctions suitable for THz radiation detection

Pieter Dieleman, Herman van de Stadt, T. M. Klapwijk +2 more

We study the behavior of NbN SIS junctions as radiation detectors with emphasis on the shot noise generated at voltages below the gap voltage. The intrinsically large subgap current of NbN junctions is carried by pinholes with a conduction attributed to multiple Andreev reflection, leading to transported charges q much greater than e. Using this charge enhancement mechanism we explain the junction shot noise characteristics in the unpumped case as well as in the pumped case. The measured mixer noise temperature in the pumped case is more than twice that calculated with standard Tucker theory. The measured double side band noise temperatures are 1450 K at 600 GHz and 2800 K at 950 GHz.

•Jan 1, 1997•1 citation

Measurements of noise in Josephson-effect mixers

R. J. Schoelkopf, Jonas Stasys Zmuidzinas, Tom G. Phillips +2 more

We present new heterodyne receiver results obtained at 100 GHz using resistively-shunted Nb and NbN tunnel junctions. In addition, we have carried out accurate measurements of the available noise power of these devices at the L-band (1.5 GHz) IF frequency. Both the heterodyne and the output noise measurements show that the noise of these devices can be a factor of five or more higher than that predicted by the simple current-biased RSJ model. The noise approaches the appropriate thermal or thermal and shot noise limits for bias voltages where the nonlinearity is not strong (i.e., V>I/sub C/R/sub N/), but as expected from the RSJ model, can be significantly higher at the low voltages where the mixers are typically biased. The bias voltage dependence of the noise shows structure which is associated with resonances in the RF embedding circuit. Surprisingly, we find that changes in the high-frequency (100 GHz) impedance presented to the junction can dramatically affect the magnitude and voltage dependence of the low-frequency (1.5 GHz) noise. This emphasizes the necessity of very closely matching the junction to free space over a wide frequency range.>

IEEE Transactions on Microwave Theory and Techniques•Apr 1, 1995•15 citations

Sensitivity improvements of SIS photon detectors

Hiroshi Matsuo, Sheng-Cai Shi, Takashi Noguchi +2 more

Development of two types of submillimeter-wave superconducting direct detectors are described. One is the SIS video detector and the other is the SIS photon detector. Using 500 GHz parallel connected twin junction device, video detector performance is eluted. High quantum efficiency in wide frequency range in submillimeter-wave and low noise performance is achieved. Noise equivalent power of 6 X 10-14 W/(root)Hz is measured at operating temperature of 1.5 K and bias voltage of 0.5 mV. Further improvements using distributed junction array is addressed. Large area niobium SIS junction (100 micrometer X 50 micrometer X 2) is used as a photon detection device and their thermal, electrical and optical performance is evaluated. Leakage current decrease more than three orders of magnitude at 0.5 K compared to that at 4.2 K. Noise of the device is limited by the shot noise.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jul 31, 1998•4 citations

Josephson effect gain and noise in SIS mixers

Michael J. Wengler, Noshir Dubash, G. Pance +1 more

The authors report measurements of gain and noise in SIS mixers at 230 and 492 GHz. Measurements were made of relatively high gain and noise associated with Josephson currents that have not been previously reported. These measurements show that Josephson currents are increasingly important as operating frequencies are raised. The techniques used to make these measurements are discussed. Measurements made with hot and cold black-bodies are shown to be inaccurate at high frequencies. The problem is that SIS mixers do not always respond linearly to the signal power incident on them. This is particularly important when (1) very broad band mixers are used and (2) Josephson effect currents are important. Both of these circumstances are present in the quasioptical SIS mixers favored for 500 GHz and higher. Monochromatic signals were used to measure gain and noise to get around these problems.>

IEEE Transactions on Microwave Theory and Techniques•May 1, 1992•21 citations

Shot noise beyond the Tucker theory in niobium tunnel junction mixers

Pieter Dieleman, T. M. Klapwijk

The electrical and shot-noise characteristics of high-current-density niobium superconductor–insulator–superconductor (SIS) tunnel junctions suitable for heterodyne detection of THz radiation are studied. It is found that a significant part of the current at voltages V<2Δ/e is carried via barrier defects (pinholes). Due to the transport mechanism in these pinholes, the shot noise is considerably increased. The data presented clarify an often-observed discrepancy between measured and expected heterodyne mixer noise temperatures and predict a 25% increase in the receiver noise temperature of Nb SIS heterodyne detectors at 1 THz.

Applied Physics Letters•Mar 30, 1998•15 citations
Photon-induced current correlations in SIS detectors can result in an output noise that is greater or less than shot noise. Evidence of these correlations had been observed for 100 GHz rf by accurate noise measurements as reported in our previous work. We now present a detailed analysis of these current correlations for frequencies between 100 and 500 GHz. We also report new measurements of photon-induced noise in a 490 GHz SIS mixer, and discuss the Gaussian beam techniques used to eliminate the thermal background radiation. For small 490 GHz rf power, the output noise is equal to shot noise. The results of the 100 and 490 GHz photon noise measurement are summarized in context to shot noise and the effect of the current correlations predicted by the theoretical model.>
The dominant source of noise in an SIS mixer is the noise in the photon-induced current. We have made accurate measurements of noise induced in SIS junctions by 95 GHz photons. The noise is measured at 1.5 GHz using a low-noise cryogenic measurement system. The measured photon-induced noise is compared to the noise predicted by Tucker's theory augmented by a vacuum/thermal noise term. For small to moderate rf powers, at which SIS mixers are operated, the measured noise is nearly perfectly predicted by this theory for all the devices measured. Measurements of series arrays of SIS junctions also agree with this theory showing that the noise of each SIS junction in the array is independent. At large rf powers, the measured noise was higher than the predicted noise, in devices with smaller capacitance. We also measured the noise in single junctions and arrays with no rf radiation. These measurements agreed very well with the predicted shot noise for most bias conditions.>
We study the behavior of NbN SIS junctions as radiation detectors with emphasis on the shot noise generated at voltages below the gap voltage. The intrinsically large subgap current of NbN junctions is carried by pinholes with a conduction attributed to multiple Andreev reflection, leading to transported charges q much greater than e. Using this charge enhancement mechanism we explain the junction shot noise characteristics in the unpumped case as well as in the pumped case. The measured mixer noise temperature in the pumped case is more than twice that calculated with standard Tucker theory. The measured double side band noise temperatures are 1450 K at 600 GHz and 2800 K at 950 GHz.
We present new heterodyne receiver results obtained at 100 GHz using resistively-shunted Nb and NbN tunnel junctions. In addition, we have carried out accurate measurements of the available noise power of these devices at the L-band (1.5 GHz) IF frequency. Both the heterodyne and the output noise measurements show that the noise of these devices can be a factor of five or more higher than that predicted by the simple current-biased RSJ model. The noise approaches the appropriate thermal or thermal and shot noise limits for bias voltages where the nonlinearity is not strong (i.e., V>I/sub C/R/sub N/), but as expected from the RSJ model, can be significantly higher at the low voltages where the mixers are typically biased. The bias voltage dependence of the noise shows structure which is associated with resonances in the RF embedding circuit. Surprisingly, we find that changes in the high-frequency (100 GHz) impedance presented to the junction can dramatically affect the magnitude and voltage dependence of the low-frequency (1.5 GHz) noise. This emphasizes the necessity of very closely matching the junction to free space over a wide frequency range.>
Development of two types of submillimeter-wave superconducting direct detectors are described. One is the SIS video detector and the other is the SIS photon detector. Using 500 GHz parallel connected twin junction device, video detector performance is eluted. High quantum efficiency in wide frequency range in submillimeter-wave and low noise performance is achieved. Noise equivalent power of 6 X 10-14 W/(root)Hz is measured at operating temperature of 1.5 K and bias voltage of 0.5 mV. Further improvements using distributed junction array is addressed. Large area niobium SIS junction (100 micrometer X 50 micrometer X 2) is used as a photon detection device and their thermal, electrical and optical performance is evaluated. Leakage current decrease more than three orders of magnitude at 0.5 K compared to that at 4.2 K. Noise of the device is limited by the shot noise.
The authors report measurements of gain and noise in SIS mixers at 230 and 492 GHz. Measurements were made of relatively high gain and noise associated with Josephson currents that have not been previously reported. These measurements show that Josephson currents are increasingly important as operating frequencies are raised. The techniques used to make these measurements are discussed. Measurements made with hot and cold black-bodies are shown to be inaccurate at high frequencies. The problem is that SIS mixers do not always respond linearly to the signal power incident on them. This is particularly important when (1) very broad band mixers are used and (2) Josephson effect currents are important. Both of these circumstances are present in the quasioptical SIS mixers favored for 500 GHz and higher. Monochromatic signals were used to measure gain and noise to get around these problems.>
The electrical and shot-noise characteristics of high-current-density niobium superconductor–insulator–superconductor (SIS) tunnel junctions suitable for heterodyne detection of THz radiation are studied. It is found that a significant part of the current at voltages V<2Δ/e is carried via barrier defects (pinholes). Due to the transport mechanism in these pinholes, the shot noise is considerably increased. The data presented clarify an often-observed discrepancy between measured and expected heterodyne mixer noise temperatures and predict a 25% increase in the receiver noise temperature of Nb SIS heterodyne detectors at 1 THz.