Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)

Fibre assisted single photon spectrograph

Malte Avenhaus, A. Eckstein, Peter J. Mosley, Christine Silberhorn

Published Jun 1, 2009• 0 citations
Publisher

Abstract

An experimental detection scheme is demonstrated for directly measuring the spectrum of a parametric down-conversion (PDC) source by the use of a highly dispersive fibre. A temporally narrow pulse envelope is spectrally stretched in time by chromatic group velocity dispersion. In order to maximise this effect the high group velocity dispersion of a commercially available dispersion compensating fibre is employed. If the pulse contains only a single photon on average, detection with a conventional APD yields precise information about the arrival time of the photon at the end of the fiber. When carefully calibrated one can accurately reconstruct the original spectral distribution from the measured temporal distribution. Harnessing a single mode fiber for this type of spectrometer brings the benefits of low loss due to efficient guidance, simplicity of alignment and the necessity of only a single detector to scan the spectrum. A fibre assisted single photon spectrograph is employed to measure the correlation spectrum of a bi-photonic state. State generation is achieved by a type-II parametric downconversion process at 1550 nm in a KTP waveguide structure.

DOI
10.1109/cleoe-eqec.2009.5191656

Related papers

Fiber-assisted Single Photon Spectrograph

Malte Avenhaus, A. Eckstein, Peter J. Mosley +1 more

We demonstrate the implementation of a fiber-integrated spectrograph utilizing chromatic group velocity dispersion (GVD) in a single-mode fiber. By means of GVD we stretch an ultrafast pulse in time in order to spectrally resolve single photons in the time domain, detected by single-photon counting modules with very accurate temporal resolution. As a result, the spectrum of a very weak pulse is recovered from a precise time measurement with high signal-to-noise ratio. We demonstrate the potential of our technique by applying our scheme to analyzing the joint spectral intensity distribution of a parametric downconversion source at a telecommunication wavelength. (C) 2009 Optical Society of America

•Jan 1, 2009•92 citations

Fiber-assisted single-photon spectrograph

Malte Avenhaus, A. Eckstein, Peter J. Mosley +1 more

We demonstrate the implementation of a fiber-integrated spectrograph utilizing chromatic group velocity dispersion (GVD) in a single-mode fiber. By means of GVD we stretch an ultrafast pulse in time in order to spectrally resolve single photons in the time domain, detected by single-photon counting modules with very accurate temporal resolution. As a result, the spectrum of a very weak pulse is recovered from a precise time measurement with high signal-to-noise ratio. We demonstrate the potential of our technique by applying our scheme to analyzing the joint spectral intensity distribution of a parametric downconversion source at a telecommunication wavelength.

arXiv:0902.3364•Optics Letters•Sep 14, 2009•177 citations

Fast time-domain measurements on telecom single photons

Markus Allgaier, Gesche Vigh, Vahid Ansari +5 more

Abstract Direct measurements on the temporal envelope of quantum light are a challenging task and not many examples are known because most classical pulse characterisation methods do not work on the single-photon level. Knowledge of both spectrum and timing can, however, give insights on properties that cannot be determined by the spectral intensity alone. While temporal measurements on single photons on timescales of tens of picoseconds are possible with superconducting photon detectors, and picosecond measurements have been performed using streak cameras, there are no commercial single-photon sensitive devices with femtosecond resolution available. While time-domain sampling using sum-frequency generation has already been exploited for such a measurement, inefficient conversion has necessitated long integration times to build the temporal profile. We demonstrate a highly efficient waveguided sum-frequency generation process in Lithium Niobate to measure the temporal envelope of single photons with femtosecond resolution with short enough acquisition time to provide a live-view of the measurement. We demonstrate the measurement technique and combine it with spectral measurements using a dispersive-fibre time-of-flight spectrometer to determine upper and lower bounds for the spectral purity of heralded single photons. The approach complements the joint spectral intensity measurements as a measure on the purity can be given without knowledge of the spectral phase.

arXiv:1702.03240•Quantum Science and Technology•Jul 24, 2017•26 citations

A versatile single-photon spectrograph for the spectral measurement of the two-photon state

Xiao Xiang, Ruifang Dong, Runai Quan +3 more

A new type of single-photon spectrograph combining a tunable optical filter and a dispersive element is presented for measurement of the spectral properties of the two-photon state. In comparison with the previous single-photon spectrograph which is merely based on the dispersive Fourier transformation (DFT) technique, this scheme avoids the need for additional wavelength calibration and the electronic laser trigger for coincidence measurement; therefore, its application is extended to continuous wave (CW) pumped two-photon sources. The achievable precision of the spectrum measurement has also been discussed in theory and demonstrated experimentally with a CW pumped periodically poled lithium niobate (PPLN) waveguide-based spontaneous parametric down conversion photon source. Such a device is expected to be a versatile tool for the characterization of the frequency entangled two-photon state.

Real-time Photonic Measurements, Data Management, and Processing•Oct 9, 2020•0 citations

Pulsed single-photon spectrometer by frequency-to-time mapping using chirped fiber Bragg gratings

Alex O. C. Davis, Paul M. Saulnier, Michał Karpiński +1 more

A fiber-integrated spectrometer for single-photon pulses outside the telecommunications wavelength range based upon frequency-to-time mapping, implemented by chromatic group delay dispersion (GDD), and precise temporally-resolved single-photon counting, is presented. A chirped fiber Bragg grating provides low-loss GDD, mapping the frequency distribution of an input pulse onto the temporal envelope of the output pulse. Time-resolved detection with fast single-photon-counting modules enables monitoring of a wavelength range from 825 nm to 835 nm with nearly uniform efficiency at 55 pm resolution (24 GHz at 830 nm). To demonstrate the versatility of this technique, spectral interference of heralded single photons and the joint spectral intensity distribution of a photon-pair source are measured. This approach to single-photon-level spectral measurements provides a route to realize applications of time-frequency quantum optics at visible and near-infrared wavelengths, where multiple spectral channels must be simultaneously monitored.

arXiv:1610.03040•Optics Express•May 24, 2017•69 citations

Detection and spectral measurement of single photons in communication bands using up-conversion technology

Long Ma, Oliver Slattery, Xiao Hong Tang

Quantum information systems are commonly operated in conventional communication bands (1310 and 1550 nm) over an optical fiber to take advantage of low transmission loss. However, the detection and spectral measurement of single photons in these communication bands are limited due to high noise and low sensitivity of single photon detectors in the wavelength ranges. To demonstrate high efficiency detection and high sensitivity spectral measurement, we have implemented a single photon detector and a spectrometer based on frequency up-conversion technology. This detector and spectrometer uses a 5-cm periodically poled lithium niobate (PPLN) waveguide and a tunable pump laser around 1550 nm, to convert signal photons around 1310 to 710 nm. The converted photons are then detected by a silicon-based avalanche photodiode (APD). The overall detection efficiency of the single photon detector is as high as 32%, which is three times higher than commercial InGaAs APDs. The sensitivity of the spectrometer is measured to be −126 dBm, which is at least three orders-of-magnitude better than any commercial optical spectrum analyzer in this wavelength range.

Laser Physics•Apr 2, 2010•11 citations
An experimental detection scheme is demonstrated for directly measuring the spectrum of a parametric down-conversion (PDC) source by the use of a highly dispersive fibre. A temporally narrow pulse envelope is spectrally stretched in time by chromatic group velocity dispersion. In order to maximise this effect the high group velocity dispersion of a commercially available dispersion compensating fibre is employed. If the pulse contains only a single photon on average, detection with a conventional APD yields precise information about the arrival time of the photon at the end of the fiber. When carefully calibrated one can accurately reconstruct the original spectral distribution from the measured temporal distribution. Harnessing a single mode fiber for this type of spectrometer brings the benefits of low loss due to efficient guidance, simplicity of alignment and the necessity of only a single detector to scan the spectrum. A fibre assisted single photon spectrograph is employed to measure the correlation spectrum of a bi-photonic state. State generation is achieved by a type-II parametric downconversion process at 1550 nm in a KTP waveguide structure.
We demonstrate the implementation of a fiber-integrated spectrograph utilizing chromatic group velocity dispersion (GVD) in a single-mode fiber. By means of GVD we stretch an ultrafast pulse in time in order to spectrally resolve single photons in the time domain, detected by single-photon counting modules with very accurate temporal resolution. As a result, the spectrum of a very weak pulse is recovered from a precise time measurement with high signal-to-noise ratio. We demonstrate the potential of our technique by applying our scheme to analyzing the joint spectral intensity distribution of a parametric downconversion source at a telecommunication wavelength. (C) 2009 Optical Society of America
We demonstrate the implementation of a fiber-integrated spectrograph utilizing chromatic group velocity dispersion (GVD) in a single-mode fiber. By means of GVD we stretch an ultrafast pulse in time in order to spectrally resolve single photons in the time domain, detected by single-photon counting modules with very accurate temporal resolution. As a result, the spectrum of a very weak pulse is recovered from a precise time measurement with high signal-to-noise ratio. We demonstrate the potential of our technique by applying our scheme to analyzing the joint spectral intensity distribution of a parametric downconversion source at a telecommunication wavelength.
Abstract Direct measurements on the temporal envelope of quantum light are a challenging task and not many examples are known because most classical pulse characterisation methods do not work on the single-photon level. Knowledge of both spectrum and timing can, however, give insights on properties that cannot be determined by the spectral intensity alone. While temporal measurements on single photons on timescales of tens of picoseconds are possible with superconducting photon detectors, and picosecond measurements have been performed using streak cameras, there are no commercial single-photon sensitive devices with femtosecond resolution available. While time-domain sampling using sum-frequency generation has already been exploited for such a measurement, inefficient conversion has necessitated long integration times to build the temporal profile. We demonstrate a highly efficient waveguided sum-frequency generation process in Lithium Niobate to measure the temporal envelope of single photons with femtosecond resolution with short enough acquisition time to provide a live-view of the measurement. We demonstrate the measurement technique and combine it with spectral measurements using a dispersive-fibre time-of-flight spectrometer to determine upper and lower bounds for the spectral purity of heralded single photons. The approach complements the joint spectral intensity measurements as a measure on the purity can be given without knowledge of the spectral phase.
A new type of single-photon spectrograph combining a tunable optical filter and a dispersive element is presented for measurement of the spectral properties of the two-photon state. In comparison with the previous single-photon spectrograph which is merely based on the dispersive Fourier transformation (DFT) technique, this scheme avoids the need for additional wavelength calibration and the electronic laser trigger for coincidence measurement; therefore, its application is extended to continuous wave (CW) pumped two-photon sources. The achievable precision of the spectrum measurement has also been discussed in theory and demonstrated experimentally with a CW pumped periodically poled lithium niobate (PPLN) waveguide-based spontaneous parametric down conversion photon source. Such a device is expected to be a versatile tool for the characterization of the frequency entangled two-photon state.
A fiber-integrated spectrometer for single-photon pulses outside the telecommunications wavelength range based upon frequency-to-time mapping, implemented by chromatic group delay dispersion (GDD), and precise temporally-resolved single-photon counting, is presented. A chirped fiber Bragg grating provides low-loss GDD, mapping the frequency distribution of an input pulse onto the temporal envelope of the output pulse. Time-resolved detection with fast single-photon-counting modules enables monitoring of a wavelength range from 825 nm to 835 nm with nearly uniform efficiency at 55 pm resolution (24 GHz at 830 nm). To demonstrate the versatility of this technique, spectral interference of heralded single photons and the joint spectral intensity distribution of a photon-pair source are measured. This approach to single-photon-level spectral measurements provides a route to realize applications of time-frequency quantum optics at visible and near-infrared wavelengths, where multiple spectral channels must be simultaneously monitored.
Quantum information systems are commonly operated in conventional communication bands (1310 and 1550 nm) over an optical fiber to take advantage of low transmission loss. However, the detection and spectral measurement of single photons in these communication bands are limited due to high noise and low sensitivity of single photon detectors in the wavelength ranges. To demonstrate high efficiency detection and high sensitivity spectral measurement, we have implemented a single photon detector and a spectrometer based on frequency up-conversion technology. This detector and spectrometer uses a 5-cm periodically poled lithium niobate (PPLN) waveguide and a tunable pump laser around 1550 nm, to convert signal photons around 1310 to 710 nm. The converted photons are then detected by a silicon-based avalanche photodiode (APD). The overall detection efficiency of the single photon detector is as high as 32%, which is three times higher than commercial InGaAs APDs. The sensitivity of the spectrometer is measured to be −126 dBm, which is at least three orders-of-magnitude better than any commercial optical spectrum analyzer in this wavelength range.