Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

A low-power, high-sensitivity micromachined optical magnetometer

Rahul R. Mhaskar, Svenja A. Knappe, John E. Kitching

Published Dec 10, 2012• 172 citations
Publisher

Abstract

We demonstrate an optical magnetometer based on a microfabricated 87Rb vapor cell in a micromachined silicon sensor head. The alkali atom density in the vapor cell is increased by heating the cell with light brought to the sensor through an optical fiber, and absorbed by colored filters attached to the cell windows. A second fiber-optically coupled beam optically pumps and interrogates the atoms. The magnetometer operates on 140 mW of heating power and achieves a sensitivity below 20 fT/√Hz throughout most of the frequency band from 15 Hz to 100 Hz. Such a sensor can measure magnetic fields from the human heart and brain.

DOI
10.1063/1.4770361

Related papers

A microfabricated photonic magnetometer

Jan Preusser, Svenja A. Knappe, Vladislav P. Gerginov +1 more

An integrated optically-controlled sensor, suitable for remote, high-sensitivity detection of magnetic fields is presented. The operation of the sensor both in earth field in a Bell-Bloom type configuration is demonstrated as well as in a spin-exchange relaxation-free mode (SERF) and reach sensitivities better than 500 fT/radicHz at 10 Hz. The design and initial measurements of a small atomic magnetometer that has no electrical connections near the sensor head is presented. The sensor is fabricated by use of methods derived from microelectromechanical (MEMS) systems and integrated with off-the-shelf micro-optical components. Light is coupled through fibers to and from the sensor head for interrogation of the atoms. Heating of the atomic vapor is achieved by a second fiber-coupled laser source, utilizing the absorption properties of the vapor cell.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 1, 2009•10 citations

A microfabricated photonic magnetometer

Jan Preusser, Svenja A. Knappe, John E. Kitching +1 more

We present initial measurements of an atomic magnetometer in which the microfabricated sensor head is coupled to the control system by optical fibers. Because there are no electrical connections, the sensor head is largely non-magnetic, and degradation of the magnetometer performance due to internal magnetic fields is avoided. The sensor head is fabricated by use of methods derived from micro-electromechanical (MEMS) systems and integrated with off-the-shelf micro-optical components. Light is coupled through fibers to and from the sensor head for interrogation of the atoms as well as temperature stabilization of the vapor cell.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Apr 1, 2009•20 citations

A microfabricated optically-pumped magnetic gradiometer

D. Sheng, Abigail R. Perry, Sean Krzyzewski +3 more

We report on the development of a microfabricated atomic magnetic gradiometer based on optical spectroscopy of alkali atoms in the vapor phase. The gradiometer, which operates in the spin-exchange relaxation free regime, has a length of 60 mm and cross sectional diameter of 12 mm, and consists of two chip-scale atomic magnetometers which are interrogated by a common laser light. The sensor can measure differences in magnetic fields, over a 20 mm baseline, of 10 fT/[Formula: see text] at frequencies above 20 Hz. The maximum rejection of magnetic field noise is 1000 at 10 Hz. By use of a set of compensation coils wrapped around the sensor, we also measure the sensor sensitivity at several external bias field strengths up to 150 mG. This device is useful for applications that require both sensitive gradient field information and high common-mode noise cancellation.

arXiv:1701.03236•Applied Physics Letters•Jan 16, 2017•179 citations

Femtotesla atomic magnetometry in a microfabricated vapor cell

W. C. Griffith, Svenja A. Knappe, John E. Kitching

We describe an optically pumped 87Rb magnetometer with 5 fT/Hz(1/2) sensitivity when operated in the spin-exchange relaxation free (SERF) regime. The magnetometer uses a microfabricated vapor cell consisting of a cavity etched in a 1 mm thick silicon wafer with anodically bonded Pyrex windows. The measurement volume of the magnetometer is 1 mm3, defined by the overlap region of a circularly polarized pump laser and a linearly polarized probe laser, both operated near 795 nm. Sensitivity limitations unique to the use of microfabricated cells are discussed.

Optics Express•Dec 9, 2010•183 citations

Femtotesla atomic magnetometry in a microfabricated vapor cell

W. C. Griffith, Svenja A. Knappe, John E. Kitching

We describe an optically pumped 87Rb magnetometer with 5 fT/Hz(1/2) sensitivity when operated in the spin-exchange relaxation free (SERF) regime. The magnetometer uses a microfabricated vapor cell consisting of a cavity etched in a 1 mm thick silicon wafer with anodically bonded Pyrex windows. The measurement volume of the magnetometer is 1 mm3, defined by the overlap region of a circularly polarized pump laser and a linearly polarized probe laser, both operated near 795 nm. Sensitivity limitations unique to the use of microfabricated cells are discussed.

APS•Mar 1, 2010•0 citations

A simple spin-exchange-relaxation-free atomic magnetometer using microfabricated vapor cell

Vishal Shah, Peter D. D. Schwindt, Svenja A. Knappe +1 more

We demonstrate an atomic magnetometer with a sensitivity below 100 fT/√Hz, using a millimeter-scale microfabricated alkali vapor cell and a single low-power diode laser. This work suggests that compact, low-power, highly sensitive magnetometers are feasible.

Quantum Electronics and Laser Science Conference•May 6, 2007•1 citation
We demonstrate an optical magnetometer based on a microfabricated 87Rb vapor cell in a micromachined silicon sensor head. The alkali atom density in the vapor cell is increased by heating the cell with light brought to the sensor through an optical fiber, and absorbed by colored filters attached to the cell windows. A second fiber-optically coupled beam optically pumps and interrogates the atoms. The magnetometer operates on 140 mW of heating power and achieves a sensitivity below 20 fT/√Hz throughout most of the frequency band from 15 Hz to 100 Hz. Such a sensor can measure magnetic fields from the human heart and brain.
An integrated optically-controlled sensor, suitable for remote, high-sensitivity detection of magnetic fields is presented. The operation of the sensor both in earth field in a Bell-Bloom type configuration is demonstrated as well as in a spin-exchange relaxation-free mode (SERF) and reach sensitivities better than 500 fT/radicHz at 10 Hz. The design and initial measurements of a small atomic magnetometer that has no electrical connections near the sensor head is presented. The sensor is fabricated by use of methods derived from microelectromechanical (MEMS) systems and integrated with off-the-shelf micro-optical components. Light is coupled through fibers to and from the sensor head for interrogation of the atoms. Heating of the atomic vapor is achieved by a second fiber-coupled laser source, utilizing the absorption properties of the vapor cell.
We present initial measurements of an atomic magnetometer in which the microfabricated sensor head is coupled to the control system by optical fibers. Because there are no electrical connections, the sensor head is largely non-magnetic, and degradation of the magnetometer performance due to internal magnetic fields is avoided. The sensor head is fabricated by use of methods derived from micro-electromechanical (MEMS) systems and integrated with off-the-shelf micro-optical components. Light is coupled through fibers to and from the sensor head for interrogation of the atoms as well as temperature stabilization of the vapor cell.
We report on the development of a microfabricated atomic magnetic gradiometer based on optical spectroscopy of alkali atoms in the vapor phase. The gradiometer, which operates in the spin-exchange relaxation free regime, has a length of 60 mm and cross sectional diameter of 12 mm, and consists of two chip-scale atomic magnetometers which are interrogated by a common laser light. The sensor can measure differences in magnetic fields, over a 20 mm baseline, of 10 fT/[Formula: see text] at frequencies above 20 Hz. The maximum rejection of magnetic field noise is 1000 at 10 Hz. By use of a set of compensation coils wrapped around the sensor, we also measure the sensor sensitivity at several external bias field strengths up to 150 mG. This device is useful for applications that require both sensitive gradient field information and high common-mode noise cancellation.
We describe an optically pumped 87Rb magnetometer with 5 fT/Hz(1/2) sensitivity when operated in the spin-exchange relaxation free (SERF) regime. The magnetometer uses a microfabricated vapor cell consisting of a cavity etched in a 1 mm thick silicon wafer with anodically bonded Pyrex windows. The measurement volume of the magnetometer is 1 mm3, defined by the overlap region of a circularly polarized pump laser and a linearly polarized probe laser, both operated near 795 nm. Sensitivity limitations unique to the use of microfabricated cells are discussed.
We describe an optically pumped 87Rb magnetometer with 5 fT/Hz(1/2) sensitivity when operated in the spin-exchange relaxation free (SERF) regime. The magnetometer uses a microfabricated vapor cell consisting of a cavity etched in a 1 mm thick silicon wafer with anodically bonded Pyrex windows. The measurement volume of the magnetometer is 1 mm3, defined by the overlap region of a circularly polarized pump laser and a linearly polarized probe laser, both operated near 795 nm. Sensitivity limitations unique to the use of microfabricated cells are discussed.