Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Modern Optics

Optical Amplification and Spontaneous Emission in an Ar + Discharge

Michael Harris, R. Loudon, Terence J. Shepherd, J. Michael Vaughan

Published Jun 1, 1992• 11 citations
Publisher

Abstract

The relationship between optical amplification and spontaneous emission noise has been studied in an argon ion travelling wave amplifier by beat spectrum analysis. Different optical arrangements have been examined with both single and double pass amplification. The results establish that when coherent light travels through a gain tube, the amplified beam acquires intensity fluctuation noise which is greater than that of a Poissonian distribution (shot noise). The noise power is shown to be the same as that of an equivalent unamplified beam mixed with the amplified spontaneous emission from the gain tube. It is shown that such measurements provide a practical technique for the otherwise difficult determination of the degree of population inversion in the gain medium. They also give insight into the potential of optical amplifiers for enhancement of lidar and system performance.

DOI
10.1080/713823552

Related papers

Quantum noise in photonics

CHARLES H. HENRY, Rudolf F. Kazarinov

The basic equations governing noise phenomena are derived from first principles and applied to examples in optical communications. Quantum noise arises from two sources, the momentum fluctuations of electrons at optical frequencies and the uncertainty-related fluctuations of the electromagnetic field. Shot noise results from the beating of the noise sources with the signal field. In high-gain amplifiers, the spontaneous-emission noise dominates shot noise and results in a noise figure of at least 3 dB. It is shown explicitly how, at high power, both the laser field and the laser noise source become classical. The increase in noise in lasers with open cavities is not due to enhanced spontaneous emission as once thought, but to single-pass amplification. The noise fields and spontaneous currents have Gaussian distributions, while nonlasing modes have exponential photon-number distributions. Low-frequency intensity fluctuations arise from the electric current driving the laser and can be sub-Poissonian, in contrast to shot noise, which has a Poissonian distribution. The calculational tools are a wave equation for the field operator and a rate equation for the carrier-number operator, each containing spontaneous current noise sources. The correlation functions of these sources are determined by the fluctuation-dissipation theorem. [S0034-6861(96)00503-X]

Reviews of Modern Physics•Jul 1, 1996•220 citations

Principles of light amplification

Stefano Bottacchi

Introduction Most of the lightwave transmission systems operating today benefit fully from extensive deployment of optical amplifiers (OA). These components perform the amplification of optical intensity directly in the optical domain, without resorting to any electrical-domain regeneration. Optical amplifiers increase the average number of output photons per unit time by several orders of magnitude compared with the incoming signal intensity. However, as with every amplifying process, optical amplification cannot be achieved without paying back for the unavoidable noise power added to the signal intensity. As we will see in detail in Chapter 6, the optical amplification process comes with optical noise generated by spontaneous emission inside the active medium. The intensity of the optical signal is represented by the flux of the signal photon population. Conversely, the photons generated by the spontaneous emission process inside the optical cavity represent the noise photon population. The fundamental phenomenon supporting optical amplification is stimulated emission. The basic property of stimulated emission, making the great difference from spontaneous emission and enabling optical amplification, is the coherent nature of the photon generation process. Accordingly, both signal and noise photons go through the same multiplication process by means of stimulated emission. Unless the optical cavity where the stimulated emission takes place (the active cavity) presents selective features for enhancing the signal photon population relative to the spontaneous one, there is no way to avoid noise photons going through stimulated emission, filling most of the cavity population. As a consequence, both photon populations increase, leading respectively to amplified signal intensity and to amplified spontaneous emission intensity. It should be apparent that every noise photon can create a new identical noise photon as a result of stimulated emission, effectively increasing the noise intensity in the active optical cavity. This is the well-known mechanism of amplified spontaneous emission (ASE) noise in optical amplification. Any improvement in the optical amplifier structure devoted to increasing stimulated over spontaneous emission will probably increase the optical signal-to-noise ratio (OSNR) at the cavity output. The spectrum of gain characteristic of the optical active medium is usually wide enough to support an efficient amplification of the broadband spontaneous emission spectrum, leading to the broadband ASE noise power spectral density.

Cambridge University Press eBooks•Sep 6, 2014•0 citations

Amplified-spontaneous-emission intensity fluctuations

N. B. Abraham, John C. Huang, David A. Kranz +1 more

Intensity fluctuation characteristics of amplified-spontaneous emission are found using intensity rate equations and the noise-amplifier approximation for saturation coupling between two and four competing modes. The existence of more than one mode leads to the retention of relatively large fluctuations in each mode even as the amplifier gain is saturated, an operating regime which by contrast has been shown to reduce significantly the fluctuations when only a single beam is present. The noise-amplifier approximation is found to be an adequate approximation of the effects of the spontaneous emission distributed along the length of a laser amplifier. The intensity fluctuations in all cases approach limiting distributions functions as the amplifier becomes heavily saturated. Characteristics of these limiting distributions are found for one, two, and four beams; for combinations of beams copropagating and counterpropagating; in the presence and absence of loss; for differences in gain; and for saturation of the sources due to high intensities.

Physical Review A•Nov 1, 1981•14 citations

Laser-amplifier gain and noise

R. Loudon, Michael Harris, Terence J. Shepherd +1 more

A theoretical study is presented of the gain and the noise spectra of laser amplifiers at pumping rates both above and below the oscillation threshold. The theory is valid for both class-A and class-B laser systems, where the decay rate of the collective atomic dipole moment greatly exceeds the decay rates of the atomic population inversion and the laser cavity. The gain and the noise properties are shown to be strongly influenced by a four-wave mixing of the signal and image frequencies via a modulation of the population inversion. Particular attention is paid to the residual noise flux that persists in the laser output above threshold and to the typical characteristics of a second-order phase transition displayed by the gain in the threshold region. The results for the above-threshold laser amplifier are compared with experimental measurements of both gain and noise for the argon-ion (class-A) and ${\mathrm{CO}}_{2}$ (class-B) lasers. The signal-to-noise ratios for both heterodyne and direct-detection measurements are evaluated, and the conditions are determined under which optical amplification can lead to an enhancement of sensitivity.

Physical Review A•Jul 1, 1993•37 citations

Intrinsic spontaneous emission-induced fluctuations of the output optical beam power and phase in a diode amplifier

Alexander P. Bogatov, Alexander E. Drakin, N V D'yachkov +1 more

Output optical beam intensity and phase fluctuations are analysed in a classical approach to describing the propagation and amplification of spontaneous emission in the active region of a laser diode with a gain saturated by input monochromatic light. We find their spectral densities and dispersion and the correlation coefficient of the two-dimensional probability distribution function of the fluctuations.

Quantum Electronics•Aug 22, 2016•1 citation

Statistical noise properties of an optical pulse propagating in a nonlinear semiconductor optical amplifier

A. Bilenca, G. Eisenstein

We present a theoretical analysis and an experimental study of the statistical properties of the noise accompanying an optical pulse propagating in a nonlinear semiconductor optical amplifier. Several degrees of gain saturation corresponding to different levels of optical signal-to-noise ratios (OSNRs) are examined. We employ the Heun numerical procedure to ensure proper convergence to the Stratonovich solution of the multiplicative propagation equation. This algorithm takes also into account the effect of gain saturation due to the amplified spontaneous emission noise. Moreover, the multicanonical Monte Carlo algorithm is used to efficiently calculate the probability density functions (pdfs), including the tails, of the peak of a pulse which emerges at the output of a saturated semiconductor optical amplifier. The results are compared to the corresponding pdfs obtained in a linear amplification system (where the optical noise is additive and Gaussian) having the same gain and under identical OSNR levels. We demonstrate that the pdf of the saturated amplifier is shifted toward lower power levels and is narrower, or equivalently, the mean and variance for the saturated amplifier case are smaller. Also, the difference between the two configurations increases with the degree of gain saturation. The theoretical predictions are confirmed by a series of experiments in which the pdfs at the output of the linear amplification scheme and saturated semiconductor optical amplifier are measured for an optical pulse of /spl sim/ 70-ps duration.

IEEE Journal of Quantum Electronics•Jan 1, 2005•21 citations
The relationship between optical amplification and spontaneous emission noise has been studied in an argon ion travelling wave amplifier by beat spectrum analysis. Different optical arrangements have been examined with both single and double pass amplification. The results establish that when coherent light travels through a gain tube, the amplified beam acquires intensity fluctuation noise which is greater than that of a Poissonian distribution (shot noise). The noise power is shown to be the same as that of an equivalent unamplified beam mixed with the amplified spontaneous emission from the gain tube. It is shown that such measurements provide a practical technique for the otherwise difficult determination of the degree of population inversion in the gain medium. They also give insight into the potential of optical amplifiers for enhancement of lidar and system performance.
The basic equations governing noise phenomena are derived from first principles and applied to examples in optical communications. Quantum noise arises from two sources, the momentum fluctuations of electrons at optical frequencies and the uncertainty-related fluctuations of the electromagnetic field. Shot noise results from the beating of the noise sources with the signal field. In high-gain amplifiers, the spontaneous-emission noise dominates shot noise and results in a noise figure of at least 3 dB. It is shown explicitly how, at high power, both the laser field and the laser noise source become classical. The increase in noise in lasers with open cavities is not due to enhanced spontaneous emission as once thought, but to single-pass amplification. The noise fields and spontaneous currents have Gaussian distributions, while nonlasing modes have exponential photon-number distributions. Low-frequency intensity fluctuations arise from the electric current driving the laser and can be sub-Poissonian, in contrast to shot noise, which has a Poissonian distribution. The calculational tools are a wave equation for the field operator and a rate equation for the carrier-number operator, each containing spontaneous current noise sources. The correlation functions of these sources are determined by the fluctuation-dissipation theorem. [S0034-6861(96)00503-X]
Introduction Most of the lightwave transmission systems operating today benefit fully from extensive deployment of optical amplifiers (OA). These components perform the amplification of optical intensity directly in the optical domain, without resorting to any electrical-domain regeneration. Optical amplifiers increase the average number of output photons per unit time by several orders of magnitude compared with the incoming signal intensity. However, as with every amplifying process, optical amplification cannot be achieved without paying back for the unavoidable noise power added to the signal intensity. As we will see in detail in Chapter 6, the optical amplification process comes with optical noise generated by spontaneous emission inside the active medium. The intensity of the optical signal is represented by the flux of the signal photon population. Conversely, the photons generated by the spontaneous emission process inside the optical cavity represent the noise photon population. The fundamental phenomenon supporting optical amplification is stimulated emission. The basic property of stimulated emission, making the great difference from spontaneous emission and enabling optical amplification, is the coherent nature of the photon generation process. Accordingly, both signal and noise photons go through the same multiplication process by means of stimulated emission. Unless the optical cavity where the stimulated emission takes place (the active cavity) presents selective features for enhancing the signal photon population relative to the spontaneous one, there is no way to avoid noise photons going through stimulated emission, filling most of the cavity population. As a consequence, both photon populations increase, leading respectively to amplified signal intensity and to amplified spontaneous emission intensity. It should be apparent that every noise photon can create a new identical noise photon as a result of stimulated emission, effectively increasing the noise intensity in the active optical cavity. This is the well-known mechanism of amplified spontaneous emission (ASE) noise in optical amplification. Any improvement in the optical amplifier structure devoted to increasing stimulated over spontaneous emission will probably increase the optical signal-to-noise ratio (OSNR) at the cavity output. The spectrum of gain characteristic of the optical active medium is usually wide enough to support an efficient amplification of the broadband spontaneous emission spectrum, leading to the broadband ASE noise power spectral density.
Intensity fluctuation characteristics of amplified-spontaneous emission are found using intensity rate equations and the noise-amplifier approximation for saturation coupling between two and four competing modes. The existence of more than one mode leads to the retention of relatively large fluctuations in each mode even as the amplifier gain is saturated, an operating regime which by contrast has been shown to reduce significantly the fluctuations when only a single beam is present. The noise-amplifier approximation is found to be an adequate approximation of the effects of the spontaneous emission distributed along the length of a laser amplifier. The intensity fluctuations in all cases approach limiting distributions functions as the amplifier becomes heavily saturated. Characteristics of these limiting distributions are found for one, two, and four beams; for combinations of beams copropagating and counterpropagating; in the presence and absence of loss; for differences in gain; and for saturation of the sources due to high intensities.
A theoretical study is presented of the gain and the noise spectra of laser amplifiers at pumping rates both above and below the oscillation threshold. The theory is valid for both class-A and class-B laser systems, where the decay rate of the collective atomic dipole moment greatly exceeds the decay rates of the atomic population inversion and the laser cavity. The gain and the noise properties are shown to be strongly influenced by a four-wave mixing of the signal and image frequencies via a modulation of the population inversion. Particular attention is paid to the residual noise flux that persists in the laser output above threshold and to the typical characteristics of a second-order phase transition displayed by the gain in the threshold region. The results for the above-threshold laser amplifier are compared with experimental measurements of both gain and noise for the argon-ion (class-A) and CO2{\mathrm{CO}}_{2}CO2​ (class-B) lasers. The signal-to-noise ratios for both heterodyne and direct-detection measurements are evaluated, and the conditions are determined under which optical amplification can lead to an enhancement of sensitivity.
We present a theoretical analysis and an experimental study of the statistical properties of the noise accompanying an optical pulse propagating in a nonlinear semiconductor optical amplifier. Several degrees of gain saturation corresponding to different levels of optical signal-to-noise ratios (OSNRs) are examined. We employ the Heun numerical procedure to ensure proper convergence to the Stratonovich solution of the multiplicative propagation equation. This algorithm takes also into account the effect of gain saturation due to the amplified spontaneous emission noise. Moreover, the multicanonical Monte Carlo algorithm is used to efficiently calculate the probability density functions (pdfs), including the tails, of the peak of a pulse which emerges at the output of a saturated semiconductor optical amplifier. The results are compared to the corresponding pdfs obtained in a linear amplification system (where the optical noise is additive and Gaussian) having the same gain and under identical OSNR levels. We demonstrate that the pdf of the saturated amplifier is shifted toward lower power levels and is narrower, or equivalently, the mean and variance for the saturated amplifier case are smaller. Also, the difference between the two configurations increases with the degree of gain saturation. The theoretical predictions are confirmed by a series of experiments in which the pdfs at the output of the linear amplification scheme and saturated semiconductor optical amplifier are measured for an optical pulse of /spl sim/ 70-ps duration.