Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physica Scripta

Efficient extension of the trapping lifetime of single atoms in an optical tweezer by laser cooling

Jun He, Baodong Yang, Tiancai Zhang, Junmin Wang

Published Jul 19, 2011• 9 citations
Publisher

Abstract

Optical tweezers have become powerful tools for the confinement and manipulation of neutral atoms, molecules, mesoscopic biological molecules and living cells. In our experiment, a single caesium atom was prepared in a large-magnetic-gradient magneto-optical trap (MOT). It was then efficiently transferred back and forth between the MOT and a 1064 nm microscopic optical tweezer. The atomic transfer between the MOT and the tweezer can be employed to measure the trapping lifetime and the energy distribution of the single atom in the tweezer. In order to extend the trapping lifetime, laser cooling is used to decrease the atom's kinetic energy. The trapping lifetime was extended from ∼75 to ∼130 s by applying a 10 ms laser cooling phase just after the single atom is transferred into the tweezer.

DOI
10.1088/0031-8949/84/02/025302

Related papers

Long lifetime of single atom in optical tweezer with laser cooling

Junmin Wang, Jun He, Baodong Yang +2 more

Single cesium atom prepared in a large-magnetic-gradient magneto-optical trap (MOT) has been efficiently loaded into a microscopic far-off-resonance optical trap (FORT, or optical tweezer), and the atom can be transferred back and forth between two traps with high efficiency. The intensity noise spectra of tweezer laser are measured and the heating mechanisms in optical tweezer are analyzed. To prolong the lifetime of single atom trapped in optical tweezer, laser cooling technique is utilized to decrease atom's kinetic energy, and the effective temperature of single atom in tweezer is estimated by the release-and-recapture (R&R) method. Thanks to laser cooling, typical lifetime of ~ 130.6 ± 1.8 s for single atom in tweezer is obtained. These works provides a good starting point for coherent manipulation of single atom.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 30, 2010•2 citations

Extending the trapping lifetime of single atom in a microscopic far-off-resonance optical dipole trap

Jun He, Baodong Yang, Yongjie Cheng +2 more

In our experiment, a single cesium atom prepared in a large-magnetic-gradient magneto-optical trap (MOT) can be efficiently transferred into a 1064-nm far-off-resonance microscopic optical dipole trap (FORT). The efficient transfer of the single atom between the two traps is used to determine the trapping lifetime and the effective temperature of the single atom in FORT. The typical trapping lifetime has been improved from ∼ 6.9 s to ∼ 130 s by decreasing the background pressure from ∼ 1 × 10 −10 Torr to ∼ 2 × 10 −11 Torr and applying one-shot 10-ms laser cooling phase. We also theoretically investigate the dependence of trapping lifetimes of a single atom in a FORT on trap parameters based on the FORT beam’s intensity noise induced heating. Numerical simulations show that the heating depends on the FORT beam’s waist size and the trap depth. The trapping time can be predicted based on effective temperature measurement of a single atom in the FORT and the intensity noise spectra of the FORT beam. These experimental results are found to be in agreement with the predictions of the heating model.

Frontiers of Physics•Apr 13, 2011•15 citations

Extending a release-and-recapture scheme to single atom optical tweezer for effective temperature evaluation

Jun He, Baodong Yang, Tiancai Zhang +1 more

By recording the fluorescence fraction of the cold atoms remaining in the magneto-optical trap (MOT) as a function of the release time, the release-and-recapture (R&R) method is utilized to evaluate the effective temperature of the cold atomic ensemble. We prepare a single atom in a large-magnetic-gradient MOT and then transfer the trapped single atom into a 1064-nm microscopic optical tweezer. The energy of the single atom trapped in the tweezer is further reduced by polarization gradient cooling (PGC) and the effective temperature is evaluated by extending the R&R technique to a single atom tweezer. The typical effective temperature of a single atom in the tweezer is improved from about 105 μK to about 17 μK by applying the optimum PGC phase.

Chinese Physics B•Jul 1, 2011•9 citations

Efficient loading of a single neutral atom into an optical microscopic tweezer

Jun He, Bei Liu, Wen-Ting Diao +3 more

A single atom in a magneto–optical trap (MOT) with trap size (hundreds of micrometers) can be transferred into an optical microscopic tweezer with a probability of ~ 100%. The ability to transfer a single atom into two traps back and forth allows us to study the loading process. The loading probability is found to be insensitive to the geometric overlap of the MOT and the tweezer. It is therefore possible to perform simultaneously loading of a single atom into all sites of the tweezer array for many qubits. In particular, we present a simulation of the one-dimensional and two-dimensional arrays of an optical microscopic tweezer. We find the same qualitative behavior for all of the trap parameters.

Chinese Physics B•Mar 31, 2015•2 citations

Eliminating light shifts for single atom trapping

Nicholas R. Hutzler, Lee R. Liu, Yichao Yu +1 more

Microscopically controlled neutral atoms in optical tweezers and lattices have led to exciting advances in the study of quantum information and quantum many-body systems. The light shifts of atomic levels from the trapping potential in these systems can result in detrimental effects such as fluctuating dipole force heating, inhomogeneous detunings, and inhibition of laser cooling, which limits the atomic species that can be manipulated. In particular, these light shifts can be large enough to prevent loading into optical tweezers directly from a magneto-optical trap. We implement a general solution to these limitations by loading, as well as cooling and imaging the atoms with temporally alternating beams, and present an analysis of the role of heating and required cooling for single atom tweezer loading. Because this technique does not depend on any specific spectral properties, it should enable the optical tweezer platform to be extended to nearly any atomic or molecular species that can be laser cooled and optically trapped.

arXiv:1605.09422•New Journal of Physics•Feb 2, 2017•50 citations

Optical Trapping and Cooling of Single Atoms

D.A. van der Flier

Single atoms are a promising candidate for the creation of a scalable quantum computer. Neutral atoms trapped by optical fields are especially encouraging due to the full controllability of the trap potential. Single neutral atoms trapped within a fibre-fibre cavity allow us to strongly couple atoms and photons. This creates an efficient atom-photon interface which can compensate for the short state transfer distance inherent of neutral atoms. A spatial light modulator allows for the creation and manipulation of an array of these single atom traps.\n\nIn this research we create a setup to cool and trap neutral rubidium-87 atoms by a combination of a magneto-optical trap (MOT) and a dipole trap. The dipole trap uses a strongly focused, far red-detuned laser, which enables us to trap single atoms via the collisional blockade regime. These traps are realised within a novel glass cell, allowing for great optical access.\n\nThe MOT in this setup is able to trap (4.27 +/- 0.10) * 10^3 atoms with a density of (7.89 +/- 0.56) * 10^9 atoms cm^-3 . The MOT temperature is in the order of 100 μK. We also show the manipulation of these properties, allowing us to tailor the MOT. The dipole trap is created with a trap waist of 37 μm, allowing us to trap a cloud of atoms. With the dipole trap we achieve a lifetime of atoms of (34.8 +/- 2.0) ms.

•Jan 1, 2017•0 citations
Optical tweezers have become powerful tools for the confinement and manipulation of neutral atoms, molecules, mesoscopic biological molecules and living cells. In our experiment, a single caesium atom was prepared in a large-magnetic-gradient magneto-optical trap (MOT). It was then efficiently transferred back and forth between the MOT and a 1064 nm microscopic optical tweezer. The atomic transfer between the MOT and the tweezer can be employed to measure the trapping lifetime and the energy distribution of the single atom in the tweezer. In order to extend the trapping lifetime, laser cooling is used to decrease the atom's kinetic energy. The trapping lifetime was extended from ∼75 to ∼130 s by applying a 10 ms laser cooling phase just after the single atom is transferred into the tweezer.
Single cesium atom prepared in a large-magnetic-gradient magneto-optical trap (MOT) has been efficiently loaded into a microscopic far-off-resonance optical trap (FORT, or optical tweezer), and the atom can be transferred back and forth between two traps with high efficiency. The intensity noise spectra of tweezer laser are measured and the heating mechanisms in optical tweezer are analyzed. To prolong the lifetime of single atom trapped in optical tweezer, laser cooling technique is utilized to decrease atom's kinetic energy, and the effective temperature of single atom in tweezer is estimated by the release-and-recapture (R&R) method. Thanks to laser cooling, typical lifetime of ~ 130.6 ± 1.8 s for single atom in tweezer is obtained. These works provides a good starting point for coherent manipulation of single atom.
In our experiment, a single cesium atom prepared in a large-magnetic-gradient magneto-optical trap (MOT) can be efficiently transferred into a 1064-nm far-off-resonance microscopic optical dipole trap (FORT). The efficient transfer of the single atom between the two traps is used to determine the trapping lifetime and the effective temperature of the single atom in FORT. The typical trapping lifetime has been improved from ∼ 6.9 s to ∼ 130 s by decreasing the background pressure from ∼ 1 × 10 −10 Torr to ∼ 2 × 10 −11 Torr and applying one-shot 10-ms laser cooling phase. We also theoretically investigate the dependence of trapping lifetimes of a single atom in a FORT on trap parameters based on the FORT beam’s intensity noise induced heating. Numerical simulations show that the heating depends on the FORT beam’s waist size and the trap depth. The trapping time can be predicted based on effective temperature measurement of a single atom in the FORT and the intensity noise spectra of the FORT beam. These experimental results are found to be in agreement with the predictions of the heating model.
By recording the fluorescence fraction of the cold atoms remaining in the magneto-optical trap (MOT) as a function of the release time, the release-and-recapture (R&R) method is utilized to evaluate the effective temperature of the cold atomic ensemble. We prepare a single atom in a large-magnetic-gradient MOT and then transfer the trapped single atom into a 1064-nm microscopic optical tweezer. The energy of the single atom trapped in the tweezer is further reduced by polarization gradient cooling (PGC) and the effective temperature is evaluated by extending the R&R technique to a single atom tweezer. The typical effective temperature of a single atom in the tweezer is improved from about 105 μK to about 17 μK by applying the optimum PGC phase.
A single atom in a magneto–optical trap (MOT) with trap size (hundreds of micrometers) can be transferred into an optical microscopic tweezer with a probability of ~ 100%. The ability to transfer a single atom into two traps back and forth allows us to study the loading process. The loading probability is found to be insensitive to the geometric overlap of the MOT and the tweezer. It is therefore possible to perform simultaneously loading of a single atom into all sites of the tweezer array for many qubits. In particular, we present a simulation of the one-dimensional and two-dimensional arrays of an optical microscopic tweezer. We find the same qualitative behavior for all of the trap parameters.
Microscopically controlled neutral atoms in optical tweezers and lattices have led to exciting advances in the study of quantum information and quantum many-body systems. The light shifts of atomic levels from the trapping potential in these systems can result in detrimental effects such as fluctuating dipole force heating, inhomogeneous detunings, and inhibition of laser cooling, which limits the atomic species that can be manipulated. In particular, these light shifts can be large enough to prevent loading into optical tweezers directly from a magneto-optical trap. We implement a general solution to these limitations by loading, as well as cooling and imaging the atoms with temporally alternating beams, and present an analysis of the role of heating and required cooling for single atom tweezer loading. Because this technique does not depend on any specific spectral properties, it should enable the optical tweezer platform to be extended to nearly any atomic or molecular species that can be laser cooled and optically trapped.
Single atoms are a promising candidate for the creation of a scalable quantum computer. Neutral atoms trapped by optical fields are especially encouraging due to the full controllability of the trap potential. Single neutral atoms trapped within a fibre-fibre cavity allow us to strongly couple atoms and photons. This creates an efficient atom-photon interface which can compensate for the short state transfer distance inherent of neutral atoms. A spatial light modulator allows for the creation and manipulation of an array of these single atom traps.\n\nIn this research we create a setup to cool and trap neutral rubidium-87 atoms by a combination of a magneto-optical trap (MOT) and a dipole trap. The dipole trap uses a strongly focused, far red-detuned laser, which enables us to trap single atoms via the collisional blockade regime. These traps are realised within a novel glass cell, allowing for great optical access.\n\nThe MOT in this setup is able to trap (4.27 +/- 0.10) * 10^3 atoms with a density of (7.89 +/- 0.56) * 10^9 atoms cm^-3 . The MOT temperature is in the order of 100 μK. We also show the manipulation of these properties, allowing us to tailor the MOT. The dipole trap is created with a trap waist of 37 μm, allowing us to trap a cloud of atoms. With the dipole trap we achieve a lifetime of atoms of (34.8 +/- 2.0) ms.