Single atoms are a promising candidate for the creation of a scalable quantum computer. Neutral atoms trapped by optical fields are especially encouraging due to the full controllability of the trap potential. Single neutral atoms trapped within a fibre-fibre cavity allow us to strongly couple atoms and photons. This creates an efficient atom-photon interface which can compensate for the short state transfer distance inherent of neutral atoms. A spatial light modulator allows for the creation and manipulation of an array of these single atom traps.\n\nIn this research we create a setup to cool and trap neutral rubidium-87 atoms by a combination of a magneto-optical trap (MOT) and a dipole trap. The dipole trap uses a strongly focused, far red-detuned laser, which enables us to trap single atoms via the collisional blockade regime. These traps are realised within a novel glass cell, allowing for great optical access.\n\nThe MOT in this setup is able to trap (4.27 +/- 0.10) * 10^3 atoms with a density of (7.89 +/- 0.56) * 10^9 atoms cm^-3 . The MOT temperature is in the order of 100 μK. We also show the manipulation of these properties, allowing us to tailor the MOT. The dipole trap is created with a trap waist of 37 μm, allowing us to trap a cloud of atoms. With the dipole trap we achieve a lifetime of atoms of (34.8 +/- 2.0) ms.
Single atoms are a promising candidate for the creation of a scalable quantum computer. Neutral atoms trapped by optical fields are especially encouraging due to the full controllability of the trap potential. Single neutral atoms trapped within a fibre-fibre cavity allow us to strongly couple atoms and photons. This creates an efficient atom-photon interface which can compensate for the short state transfer distance inherent of neutral atoms. A spatial light modulator allows for the creation and manipulation of an array of these single atom traps.\n\nIn this research we create a setup to cool and trap neutral rubidium-87 atoms by a combination of a magneto-optical trap (MOT) and a dipole trap. The dipole trap uses a strongly focused, far red-detuned laser, which enables us to trap single atoms via the collisional blockade regime. These traps are realised within a novel glass cell, allowing for great optical access.\n\nThe MOT in this setup is able to trap (4.27 +/- 0.10) * 10^3 atoms with a density of (7.89 +/- 0.56) * 10^9 atoms cm^-3 . The MOT temperature is in the order of 100 μK. We also show the manipulation of these properties, allowing us to tailor the MOT. The dipole trap is created with a trap waist of 37 μm, allowing us to trap a cloud of atoms. With the dipole trap we achieve a lifetime of atoms of (34.8 +/- 2.0) ms.
Hybrid quantum devices, incorporating both atoms and photons, are able to exploit the benefits of both systems. Compact, robust atom-photon interfaces will enable scalable architectures for quantum computing and quantum communication, as well as chip-scale sensors and single-photon sources. We demonstrate a new type of interface and show the interaction of cold cesium atoms with resonant photons. For this atoms are cooled in a magneto-optical trap, transferred to an optical dipole trap and positioned inside a transverse, 30 µm diameter through-hole in an optical fibre, created via laser micromachining. The intersection is orthogonal to the propagation direction of the light mode. We trap about 300 atoms at a temperature of 120µK. When the guided light is on resonance with the caesium D2 line, up to 87% of it is absorbed by the atoms. Our technique can be applied in 2-dimensional systems, i.e. in optical waveguide chips and other existing photonic systems. We also discuss the influence of hole shapes on transmission and prospects of adding a micro-cavity.
A leading strategy for the creation of a scalable quantum computer is through a networked architecture. This would comprise stationary nodes for quantum information processing and photonic channels for their communication and entanglement distribution. In this scheme a coherent interface between light and matter is a critical component, facilitating the deterministic and reversible transfer of quantum information between stationary and travelling qubits. This requirement may be fulfilled by a high finesse optical cavity, whose radiation field is strongly coupled to a trapped quantised emitter. Neutral atoms are an ideal species for the development of such a device, given their inherent compatibility with dielectric mirror surfaces. However, an outstanding challenge in building an elementary network of neutral atom-cavity systems is in establishing a single atom dipole trap within each cavity mode. This thesis presents the development of an open-access cavity suitable for single atom localisation, whilst maintaining strong atom-cavity coupling, {g0,κ,γ} = {11,2.1,3} × 2πMHz, and the efficient extraction of generated photons, η=0.5. We consider cavity design methodology, deriving a connection between the physical properties of the optical resonator and its intended role in the production of single photons. An experimental platform is developed for the creation of cavity mirrors by laser ablation, with a high degree of geometrical control. This is used to produce a set of pyramidal micro-mirrors, demonstrated to represent a favourable alternative to the widespread adoption of fibre-tip cavities. These pyramidal mirrors are shown to support multi-feature resonators, allowing several atom-cavity interfaces to be formed using a pair of substrates. By developing a novel procedure for mirror alignment, a hybrid mirror cavity is fabricated and integrated into an experimental architecture tailored for atomic trapping. Suitability of the cavity for future experimentation is demonstrated by frequency stabilisation to an atomic resonance of 87Rb.
Constructing a quantum network comprising of matter-based stationary qubits and photonic flying qubits is a key goal towards scalable quantum computing. Individually trapped neutral atoms are amongst the most promising candidates for stationary qubits, while single photons emitted from optical cavities appears to be the best approach to forming flying qubits. This thesis presents a fast and versatile method to trap and transport an array of neutral atoms, with the aid of a spatial light modulator (SLM). We demonstrate trapped 87Rb atoms adapting to the arbitrary and dynamic potential landscapes imposed by the SLM. On top of this we also investigate the inclusion of fibre-tip cavities into the experiment. In these microcavities, the mirrors are replaced by ablated fibre-tip faces, coated in a highly reflective dielectric stack. These have the benefit of small geometries, increasing their scalability; which in turns leads to extremely small mode volumes, allowing for strong coupling with atoms inside the cavity modes. We construct and characterise a high finesse ℱ = 120, 000 fibre-tip cavity constructed from two single mode fibres.
In this thesis, the development of an experimental system for microscopic dipole trapping of ultracold neutral rubidium atoms is presented. The purpose of this system is to advance towards the experimental realisation of a quantum computational protocol utilising neutral atoms as qubits. It is intended that the quantum gate operations between qubits will be implemented by a scheme using Rydberg blockade, imposing a restriction on the maximum size of the dipole-trapped atom cloud; the spatial extent of the atomic ensemble contained in this trap must be smaller than the blockade radius to ensure that one single collective Rydberg state per qubit can be achieved. Therefore the experiment was designed with the intent of fulfilling these challenging requirements. This project involved the design and construction of an improved ultra-high vacuum chamber containing the optical setup for the experiment, successfully achieving pressures below 5 x 10-10 mbar. A magneto-optical trap was produced to act as a background reservoir of atoms from which to load the dipole trap. Numerous experimental measurements were done to characterise the physical properties of the trapped atoms, including the number, density and temperature of atoms, as well as the lifetime of the trap. The results of these measurements led to the conclusion that a suitable reservoir for loading the dipole trap had been produced. Significant work was carried out to set up and obtain the dipole trap in the laboratory. Measurements of the characteristic properties of the trap and the atoms confined in the trap were carried out to investigate the behaviour of the atoms and to validate our design. Ultimately a trap containing tens of atoms was achieved, with an atom cloud diameter of ~1.2 µm in two dimensions, being well within the estimated Rydberg blockade radius of ~4.4 µm for n ~ 60 as intended. The two-photon excitation laser system for the probing of Rydberg states, for future applications in Rydberg blockade-based quantum gate operations, was also developed during the course of this work. Different Rydberg states were detected experimentally by the observation of Autler-Townes splitting in a three-level atom scheme. Overall, the work presented in this thesis provides a strong groundwork for the advancement towards neutral atom-based quantum gates, including the development of the experimental system and the production of standard procedures to carry out characterisation measurements of the traps efficiently in the future. The main achievements of this work are the establishment of the experimental apparatus, the achievement of a microscopic dipole trap which conforms to the requirements of an atomic qubit, and the significant growth in the knowledge of atom trapping specific to our system.
Cavity quantum electrodynamic system with strongly coupled single atoms provides a good platform for studying quantum information processing, quantum simulation, quantum network, and distributed quantum computing. Cooling and trapping single atoms is a crucial technique in the quantum technology. At present, in a high-finesse cavity with finite space, cooling and trapping single atoms is a big challenge, even though it is a mature technique for free space. Great efforts have been made to cool and trap single atoms inside a cavity, and for a trapped atom its lifetime has reached as long as tens of seconds. Developing a more flexible method of cooling and trapping single atoms in a cavity is still essential for a strongly coupled cavity quantum electrodynamic system. In this work, we demonstrate experimentally that a single cesium atom in a cavity can be trapped by utilizing a single optical tweezer settled in cavity mode, and its lifetime is (2.60 ± 0.18) s. The experiment is carried out in a Fabry-Perot cavity, which is assembled by two concave mirrors each with a curvature radius of 100 mm, and cavity length of 335 μm. The concave surfaces are highly reflective, and the cavity has a finesse of 6.1 × 104. The 1080 nm optical tweezer with a waist of 2 μm is formed by an achromatic lens group with a numerical aperture of 0.4. At first, the precooled atomic assemble released from the magneto-optical trap (MOT) is transferred into cavity mode by an optical dipole trap with a waist of 36 μm. Then, one of the successfully transferred atoms is captured by the optical tweezer with the aid of cavity cooling mechanism. A blue detuned cavity locking laser is used as a standing-wave optical trap along the cavity axis. The signal of successfully trapped one atom is obtained by recording transmission of the cavity that will decrease owing to the strong coupling induced vacuum Rabi splitting. Finally, we demonstrate the precise manipulation of the atom-cavity coupling strength, which is achieved by scanning the position of the trapped atom step by step by using a high-precision translation stage. The system realized in this work can be used to study the dynamics of single atom-photon interactions with adjustable coupling strength. In addition, the mechanism adopted in this work is compatible with constructing tweezer arrays inside cavity mode, and thus possesses more flexibility and great potentials in cavity-based quantum entanglement and quantum simulation.
Ultracold atoms are a desirable substrate for experiments in quantum optics due to their highly coherent nature. Magneto-Optical Traps (MOTs) are a commonly used apparatus for producing clouds of cold, neutrally charged atoms such as Rubidium. The method relies on the effect of Doppler cooling, where laser light that has been detuned slightly below an atomic resonance results in a net cooling effect on the atoms, and magnetic trapping, where a linear magnetic field gradient results in a position dependent restoring force that traps the desired atoms at a central point. In the UVic AMO lab, we aim to build a MOT that is capable of producing ultracold rubidium clouds with temperatures on the order of 10μK.