Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Single-photon detector in the microwave range

O. V. Astafiev, Susumu Komiyama, Takeshi Kutsuwa, Vladimir N Antonov, Y. Kawaguchi, Kazuhiko Hirakawa

Published Jun 3, 2002• 104 citations
Publisher

Abstract

Single-photon counting at microwave frequencies around 500 GHz is demonstrated by using a single-electron transistor (SET) formed by two capacitively coupled GaAs/AlxGa1−xAs parallel quantum dots (QDs). A point contact separating the double QDs allows the prompt escape of an excited electron from one of the QDs to another. The resulting long-lived photoinduced ionization of the QD is detected as a change in the SET current.

DOI
10.1063/1.1482787

Related papers

Real-time electron counting in semiconductor nanostructures

A. J. Rimberg, Madhu Thalakulam, Wei Dong Lu +3 more

By coupling a radio-frequency single-electron transistor (RF-SET) to a quantum dot (QD) in a GaAs/AlGaAs heterostructure, we have succeeded in detecting the tunneling of individual electrons on and off the QD on time scales as short as one microsecond. Using charge detection to probe the state of the QD allows us to nearly isolate the dot from its leads, thereby minimizing decoherence-inducing effects of the environment. We have extended these charge detection techniques to double quantum dots (DQDs) that can simultaneously be used to characterize the backaction of the RF-SET. The combined RF-SET/DQD system is well-suited to the development of charge- or spin-based quantum bits, and to investigation of the quantum measurement problem.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 18, 2005•0 citations

Frequency-Selective Single-Photon Detection Using a Double Quantum Dot

Simon Gustavsson, M. Studer, Renaud Leturcq +4 more

We use a double quantum dot as a frequency-tunable on-chip microwave detector to investigate the radiation from electron shot-noise in a near-by quantum point contact. The device is realized by monitoring the inelastic tunneling of electrons between the quantum dots due to photon absorption. The frequency of the absorbed radiation is set by the energy separation between the dots, which is easily tuned with gate voltages. Using time-resolved charge-detection techniques, we can directly relate the detection of a tunneling electron to the absorption of a single photon.

arXiv:0705.3166•Physical Review Letters•Nov 14, 2007•170 citations

Pick a Color

The ability to detect single photons makes it possible to investigate the quantum properties of light and to implement strategies for quantum cryptography and quantum communications with single photons as the information carriers. To date, photon detectors have come in two guises: They can be designed either for sensitivity at a single energy or over a broad range of energies, but neither option has offered on-chip tunability of the detected wavelength. Gustavsson et al. now describe a frequency-tunable single-photon detector for the microwave regime using a double quantum dot structure. They are able to shift the discrete energy levels of one dot with respect to the other by application of appropriate gate voltages. Using time-resolved charge detection techniques, they can then directly relate the detection of a tunneling electron to the absorption of a single photon, the energy of which corresponds to the tuned energy-level separation between the two dots. — ISO

Science•Dec 6, 2007•0 citations

The single-electron transistor as an ultrasensitive microwave detector

J. M. Hergenrother, Jia Grace Lu, M. Tinkham

We have measured single-electron tunneling transistors with superconducting islands and conclude that they may be used as ultrasensitive detectors of microwave radiation for frequencies /spl ges/80 GHz. These devices contain a small superconducting Al island that is weakly coupled to a bias circuit through two small-capacitance tunnel junctions and a capacitive gate. At low bias voltages and temperatures, a single quasiparticle may only be introduced to the island through photon-assisted tunneling. Once this occurs, the quasiparticle is trapped on the island for /spl sim/1 /spl mu/s because it takes a relatively long time for this specific quasiparticle to tunnel off. While it is trapped, charge is transported through the system two electrons at a time. Since the photon-assisted transition merely switches the detector current on, this device is not limited to one electron tunneled through the system per absorbed photon. Measurements indicate that at least 100 electrons can tunnel for every absorbed photon, which corresponds to a noise-equivalent power of 3/spl times/10/sup -20/ W//spl radic/Hz at 80 GHz if the current is measured with a commercial current amplifier.>

IEEE Transactions on Applied Superconductivity•Jun 1, 1995•7 citations

Single photo-electron trapping, storage, and detection in a one-electron quantum dot

Rao, D S, Szkopek, T, Hans D. Robinson +2 more

There has been considerable progress in electro-statically emptying, and re-filling, quantum dots with individual electrons. Typically the quantum dot is defined by electrostatic gates on a GaAs/AlGaAs modulation doped heterostructure. We report the filling of such a quantum dot by a single photo-electron, originating from an individual photon. The electrostatic dot can be emptied and reset in a controlled fashion before the arrival of each photon. The trapped photo-electron is detected by a point contact transistor integrated adjacent to the electrostatic potential trap. Each stored photo-electron causes a persistent negative step in the transistor channel current. Such a controllable, benign, single photo-electron detector could allow for information transfer between flying photon qubits and stored electron qubits.

•Oct 13, 2004•20 citations

Microwave manipulation of electrons in silicon quantum dots

T. Ferrus, Alessandro Rossi, Tetsuo Kodera +4 more

Here we present the results of an investigation on microwave-induced effects that we have observed in silicon devices, including phosphorous doped and Metal-Oxide-Semiconductor Single Electron Transistors (SET) as well as IDQD. Continuous pulsed microwave and single shot measurements are used to demonstrate that photons in the range of 10-15 GHz allow manipulation of the electron number in the island of a doped SET, despite the high value for the charging energy and in a regime where photon assisted tunnelling is not observable. The method is applied to a device made of a SET with a capacitively coupled IDQD. Partial control of the qubit is obtained and results in the possibility of manipulating charge states in an isolated structure with GHz photons.

IEEE Silicon Nanoelectronics Workshop•Jun 1, 2012•0 citations
Single-photon counting at microwave frequencies around 500 GHz is demonstrated by using a single-electron transistor (SET) formed by two capacitively coupled GaAs/AlxGa1−xAs parallel quantum dots (QDs). A point contact separating the double QDs allows the prompt escape of an excited electron from one of the QDs to another. The resulting long-lived photoinduced ionization of the QD is detected as a change in the SET current.
By coupling a radio-frequency single-electron transistor (RF-SET) to a quantum dot (QD) in a GaAs/AlGaAs heterostructure, we have succeeded in detecting the tunneling of individual electrons on and off the QD on time scales as short as one microsecond. Using charge detection to probe the state of the QD allows us to nearly isolate the dot from its leads, thereby minimizing decoherence-inducing effects of the environment. We have extended these charge detection techniques to double quantum dots (DQDs) that can simultaneously be used to characterize the backaction of the RF-SET. The combined RF-SET/DQD system is well-suited to the development of charge- or spin-based quantum bits, and to investigation of the quantum measurement problem.
We use a double quantum dot as a frequency-tunable on-chip microwave detector to investigate the radiation from electron shot-noise in a near-by quantum point contact. The device is realized by monitoring the inelastic tunneling of electrons between the quantum dots due to photon absorption. The frequency of the absorbed radiation is set by the energy separation between the dots, which is easily tuned with gate voltages. Using time-resolved charge-detection techniques, we can directly relate the detection of a tunneling electron to the absorption of a single photon.
The ability to detect single photons makes it possible to investigate the quantum properties of light and to implement strategies for quantum cryptography and quantum communications with single photons as the information carriers. To date, photon detectors have come in two guises: They can be designed either for sensitivity at a single energy or over a broad range of energies, but neither option has offered on-chip tunability of the detected wavelength. Gustavsson et al. now describe a frequency-tunable single-photon detector for the microwave regime using a double quantum dot structure. They are able to shift the discrete energy levels of one dot with respect to the other by application of appropriate gate voltages. Using time-resolved charge detection techniques, they can then directly relate the detection of a tunneling electron to the absorption of a single photon, the energy of which corresponds to the tuned energy-level separation between the two dots. — ISO
We have measured single-electron tunneling transistors with superconducting islands and conclude that they may be used as ultrasensitive detectors of microwave radiation for frequencies /spl ges/80 GHz. These devices contain a small superconducting Al island that is weakly coupled to a bias circuit through two small-capacitance tunnel junctions and a capacitive gate. At low bias voltages and temperatures, a single quasiparticle may only be introduced to the island through photon-assisted tunneling. Once this occurs, the quasiparticle is trapped on the island for /spl sim/1 /spl mu/s because it takes a relatively long time for this specific quasiparticle to tunnel off. While it is trapped, charge is transported through the system two electrons at a time. Since the photon-assisted transition merely switches the detector current on, this device is not limited to one electron tunneled through the system per absorbed photon. Measurements indicate that at least 100 electrons can tunnel for every absorbed photon, which corresponds to a noise-equivalent power of 3/spl times/10/sup -20/ W//spl radic/Hz at 80 GHz if the current is measured with a commercial current amplifier.>
There has been considerable progress in electro-statically emptying, and re-filling, quantum dots with individual electrons. Typically the quantum dot is defined by electrostatic gates on a GaAs/AlGaAs modulation doped heterostructure. We report the filling of such a quantum dot by a single photo-electron, originating from an individual photon. The electrostatic dot can be emptied and reset in a controlled fashion before the arrival of each photon. The trapped photo-electron is detected by a point contact transistor integrated adjacent to the electrostatic potential trap. Each stored photo-electron causes a persistent negative step in the transistor channel current. Such a controllable, benign, single photo-electron detector could allow for information transfer between flying photon qubits and stored electron qubits.
Here we present the results of an investigation on microwave-induced effects that we have observed in silicon devices, including phosphorous doped and Metal-Oxide-Semiconductor Single Electron Transistors (SET) as well as IDQD. Continuous pulsed microwave and single shot measurements are used to demonstrate that photons in the range of 10-15 GHz allow manipulation of the electron number in the island of a doped SET, despite the high value for the charging energy and in a regime where photon assisted tunnelling is not observable. The method is applied to a device made of a SET with a capacitively coupled IDQD. Partial control of the qubit is obtained and results in the possibility of manipulating charge states in an isolated structure with GHz photons.