We have measured single-electron tunneling transistors with superconducting islands and conclude that they may be used as ultrasensitive detectors of microwave radiation for frequencies /spl ges/80 GHz. These devices contain a small superconducting Al island that is weakly coupled to a bias circuit through two small-capacitance tunnel junctions and a capacitive gate. At low bias voltages and temperatures, a single quasiparticle may only be introduced to the island through photon-assisted tunneling. Once this occurs, the quasiparticle is trapped on the island for /spl sim/1 /spl mu/s because it takes a relatively long time for this specific quasiparticle to tunnel off. While it is trapped, charge is transported through the system two electrons at a time. Since the photon-assisted transition merely switches the detector current on, this device is not limited to one electron tunneled through the system per absorbed photon. Measurements indicate that at least 100 electrons can tunnel for every absorbed photon, which corresponds to a noise-equivalent power of 3/spl times/10/sup -20/ W//spl radic/Hz at 80 GHz if the current is measured with a commercial current amplifier.>
We have measured single-electron tunneling transistors with superconducting islands and conclude that they may be used as ultrasensitive detectors of microwave radiation for frequencies /spl ges/80 GHz. These devices contain a small superconducting Al island that is weakly coupled to a bias circuit through two small-capacitance tunnel junctions and a capacitive gate. At low bias voltages and temperatures, a single quasiparticle may only be introduced to the island through photon-assisted tunneling. Once this occurs, the quasiparticle is trapped on the island for /spl sim/1 /spl mu/s because it takes a relatively long time for this specific quasiparticle to tunnel off. While it is trapped, charge is transported through the system two electrons at a time. Since the photon-assisted transition merely switches the detector current on, this device is not limited to one electron tunneled through the system per absorbed photon. Measurements indicate that at least 100 electrons can tunnel for every absorbed photon, which corresponds to a noise-equivalent power of 3/spl times/10/sup -20/ W//spl radic/Hz at 80 GHz if the current is measured with a commercial current amplifier.>
The present work addresses quantum interaction phenomena of microwave radiation with a single-electron tunneling system. For this study, an integrated circuit is implemented, combining on the same chip a Josephson junction (Al/AlO x /Al) oscillator and a single-electron transistor (SET) with the superconducting island (Al) and normal-conducting leads (AuPd). The transistor is demonstrated to operate as a very sensitive photon detector, sensing down to a few tens of photons per second in the microwave frequency range around f ∼ 100 GHz. On the other hand, the Josephson oscillator, realized as a two-junction SQUID and coupled to the detector via a coplanar transmission line (Al), is shown to provide a tunable source of microwave radiation: controllable variations in power or in frequency were accompanied by significant changes in the detector output, when applying magnetic flux or adjusting the voltage across the SQUID, respectively. It was also shown that the effect of substrate-mediated phonons, generated by our microwave source, on the detector output was negligibly small.
We discuss the design for a submillimeter-wave photometer, using a combination of superconducting and single-electron devices, which would have high quantum efficiency, very low noise-equivalent powers, and eventually even submicrosecond timing resolution. The absorption of above-gap photons occurs in a small strip of superconducting Al, whose normal-state resistance can be matched efficiently to an antenna of a higher gap (Nb) superconductor. The quasiparticles produced by photon absorption are then confined via Andreev reflection, and forced to tunnel through a small SIS tunnel junction. The tunneling time is much shorter than the known (>10 /spl mu/s) quasiparticle recombination time, so collection efficiency will be high. The device sensitivity would be limited by the small subgap current in the high-quality Al/AlO/sub x//Al tunnel junction at temperatures (100 mK) well below T/sub c/. Scaling based on the larger junctions used in X-ray detector applications suggests that the total dark current can be <0.1 pA, or of order 10/sup 5/ electrons/second, corresponding to an NEP of less than 10/sup -19/ W//spl radic/Hz at 500 microns (600 GHz). The photocurrent will be measured using a fast single-electron transistor (RF-SET), which allows a shot-noise-limited performance even for the very small currents delivered from this low capacitance and high impedance SIS junction. Results of initial fabrication and dc characterization of an integrated photodetector are also given.
For high resolution imaging and spectroscopy in the FIR and submillimeter, space observatories will demand sensitive, fast, compact, low-power detector arrays with 104 pixels and sensitivity less than 10(exp -20) W/Hz(sup 0.5). Antenna-coupled superconducting tunnel junctions with integrated rf single-electron transistor readout amplifiers have the potential for achieving this high level of sensitivity, and can take advantage of an rf multiplexing technique. The device consists of an antenna to couple radiation into a small superconducting volume and cause quasiparticle excitations, and a single-electron transistor to measure current through junctions contacting the absorber. We describe optimization of device parameters, and results on fabrication techniques for producing devices with high yield for detector arrays. We also present modeling of expected saturation power levels, antenna coupling, and rf multiplexing schemes.
Antenna-coupled superconducting tunnel junction detectors have the potential for photon-counting sensitivity at sub-mm wavelengths. The device consists of an antenna structure to couple radiation into a small superconducting volume and cause quasiparticle excitations, and a single-electron transistor to measure currents through tunnel junction contacts to the absorber volume. We will describe optimization of device parameters, and recent results on fabrication techniques for producing devices with high yield for detector arrays. We will also present modeling of expected saturation power levels, antenna coupling, and rf multiplexing schemes.
According to a proposal, a phenomenon associated with excitation of quasiparticles in certain superconducting quantum devices would be exploited as a means of detecting photons with exquisite sensitivity. The phenomenon could also be exploited to perform medium-resolution spectroscopy. The proposal was inspired by the observation that Coulomb blockade devices upon which some quantum logic gates are based are extremely sensitive to quasiparticles excited above the superconducting gaps in their leads. The presence of quasiparticles in the leads can be easily detected via the charge states. If quasiparticles could be generated in the leads by absorption of photons, then the devices could be used as very sensitive detectors of electromagnetic radiation over the spectral range from x-rays to submillimeter waves. The devices in question are single-Cooper-pair boxes (SCBs), which are mesoscopic superconducting devices developed for quantum computing. An SCB consists of a small superconducting island connected to a reservoir via a small tunnel junction and connected to a voltage source through a gate capacitor. An SCB is an artificial two-level quantum system, the Hamiltonian of which can be controlled by the gate voltage. One measures the expected value of the charge of the eigenvectors of this quantum system by use of a radio-frequency single-electron transistor. A plot of this expected value of charge as a function of gate voltage resembles a staircase that, in the ideal case, consists of steps of height 2 e (where e is the charge of one electron). Experiments have shown that depending on the parameters of the device, quasiparticles in the form of "broken" Cooper pairs present in the reservoir can tunnel to the island, giving rise to steps of 1 e. This effect is sometimes called "poisoning." Simulations have shown that an extremely small average number of quasiparticles can generate a 1-e periodic signal. In a device according to the proposal, this poisoning would be turned to advantage. Depending on the wavelength, an antenna or other component would be used to couple radiation into the reservoir, wherein the absorption of photons would break Cooper pairs, thereby creating quasiparticles that, in turn, would tunnel to the island, creating a 1-e signal. On the basis of conservative estimates of device parameters derived from experimental data and computational simulations that fit the data, it has been estimated that the noise equivalent power of a device according to the proposal could be as low as 6 10(exp -22) W/Hz(exp 1/2). It has also been estimated that the spectroscopic resolution (photon energy divided by increment of photon energy) of such a device in visible light would exceed 100.
Using a Josephson junction interferometer (DC SQUID) as a microwave source for irradiating a single-electron trap, both devices fabricated on the same chip, we study the process of photon-assisted tunneling as an effective mechanism of single photon detection. High sensitivity down to a very small oscillation amplitude vJ∼10 nV≪Eact≲hfJ and down to low photon absorption rates Γph ∼ (1–50) Hz, as well as a clear threshold type of operation with an activation energy Eact ∼ 400 μeV, is demonstrated for the trap with respect to the microwave photons of frequency fJ ∼ (100–200) GHz. Tunable generation is demonstrated with respect to the power and frequency of the microwave signal produced by the SQUID source biased within the subgap voltage range. A much weaker effect is observed at the higher junction voltages along the quasiparticle branch of the I–V curve; this response mostly appears due to the recombination phonons.