Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Japanese Journal of Applied Physics

A Broadband and Higher-Power Superconducting Quantum Magnetometer for the Small Signal A-D Converter

Hideaki Takayanagi, Taizō Masumi

Published Jun 1, 1978• 4 citations
Publisher

Abstract

We describe several types of wide operations and performances of a Superconducting Quantum Magnetometer at 10 GHz and higher output power levels (a microwave SQUID) for a fast and small signal A-D converter. Direct exhibition and counting of the high-speed Q-patterns from a higher-power SQUID have benn demonstrated up to a frequency region above 10 MHz by improving the post-detection system. These results give the best figure of merit so far reported far a microwave SQUID.

DOI
10.1143/jjap.17.1117

Related papers

High sensitivity microwave SQUID

J. N. Hollenhorst, R. P. Giffard

We have measured the characteristics of a novel SQUID magnetometer pumped at 9 GHz. The device comprises a niobium point-contact shunting a low impedance superconducting microwave transmission line which isolates the junction at high frequencies from a toroidal input transformer. The junction is matched to a 50 Ω coaxial transmission line and the SQUID is operated in a reflection mode. For low values of the weak link critical current we observe a modulation of the phase of the reflected microwave signal periodic in the applied flux. The modulation persists at high microwave power levels indicating that the junction response is maintained to at least 200 GHz. For large values of critical current, amplitude modulation is observed. We have obtained a differential sideband power of 230 pW/(\Phi_{0})^{2}which is close to the value predicted by a simple model. In flux-locked loop operation we have obtained an energy sensitivity referred to the input terminals of 7 × 10-31J/Hz, which is superior to that so far reported for any other SQUID.

IEEE Transactions on Magnetics•Jan 1, 1979•36 citations

Direct Observations of the 500 MHz Q-Patterns from the 10 and 35 GHz SQUID's

Yukinobu Miki, Hiroo Fuma, Taizō Masumi

The 500 MHz Quantum Interference patterns (Q-patterns) beyond 100 MHz previously reported have been directly observed for the first time from 10 and 35 GHz Superconducting Quantum Interference Devices (SQUID's). The observation was made by improving the bandwidth of the detection circuits, which was supposed to be the cause of the previous limitation on Q-patterns from the 10 and 35 GHz SQUID's. An improved system including a 10 or 35 GHz SQUID has possible applications to the measurement of signals due to even faster magnetic flux changes.

Japanese Journal of Applied Physics•May 1, 1982•3 citations

Dispersive magnetometry with a quantum limited SQUID parametric amplifier

Michael J. Hatridge, Rajamani Vijay, D. H. Slichter +2 more

There is currently fundamental and technological interest in measuring and manipulating nanoscale magnets, particularly in the quantum coherent regime. To observe the dynamics of such systems one requires a magnetometer with not only exceptional sensitivity but also high gain, wide bandwidth, and low backaction. We demonstrate a dispersive magnetometer consisting of a two-junction superconducting quantum interference device (SQUID) in parallel with an integrated, lumped-element capacitor. Input flux signals are encoded as a phase modulation of the microwave drive tone applied to the magnetometer, resulting in a single quadrature voltage signal. For strong drive power, the nonlinearity of the resonator results in quantum limited, phase sensitive parametric amplification of this signal, which improves flux sensitivity at the expense of bandwidth. Depending on the drive parameters, the device performance ranges from an effective flux noise of 0.29 $\ensuremath{\mu}{\ensuremath{\Phi}}_{0}$Hz${}^{\ensuremath{-}1/2}$ and 20 MHz of signal bandwidth to a noise of 0.14 $\ensuremath{\mu}{\ensuremath{\Phi}}_{0}$Hz${}^{\ensuremath{-}1/2}$ and a bandwidth of 0.6 MHz. These results are in excellent agreement with our theoretical model.

arXiv:1003.2466•Physical Review B•Apr 4, 2011•270 citations

Broadband Superconducting Quantum Magnetometer

R.A. Kamper, M. B. Simmonds

We describe the design, operation, and performance of a superconducting quantum interference device (SQUID) which operates at a frequency of 9 GHz. It is sensitive to variations of magnetic field in a frequency band from 0 to 1 GHz.

Applied Physics Letters•Apr 15, 1972•62 citations

Performance of Digital SQUID with Sub-Flux Quantum Feedback Resolution Fabricated using 10 kA/cm2 Nb Process

Kohki Itagaki, Itta Oshima, Yuichi Hasegawa +4 more

Abstract Digital superconducting quantum interference device (SQUID with Single Flux Quantum (SFQ) feedback operates as a Δ-type oversampling A/D converter. Magnetic flux resolution at Nyquist frequency can be improved by taking sub SFQ feedback resolution and large oversampling ratio. Using high critical current density Nb process for fabricating SFQ circuits, we expected more higher operation speed for the digital SQUID and resulting to higher magnetic flux resolutions. We expected a performance of the digital SQUID magnetometer fabricated using 10 kA/cm2 Nb process based on CAD layout, with an up/down counter using T2FF cells and parallel SFQ feedback. For the clock frequency of 13 GHz and the Nyquist frequency of 1.587 MHz, the magnetic field noise was lower than 1.5 fT / Hz and the slew rate was exceeded 500 mT/s.

Journal of Physics Conference Series•Jul 1, 2020•0 citations

Detection of Far-Field Radio-Frequency Signals by Niobium Superconducting Quantum Interference Device Arrays

Marcio C. de Andrade, Anna Leese de Escobar, B. J. Taylor +7 more

The capability of an all-niobium superconducting quantum interference device (SQUID) array to operate as an electrically small antenna capable of detecting radio frequency from distant sources was demonstrated. The measurements were performed in three different arrays, with each array consisting of 2400 identical cells. The intrinsic broadband characteristics of the device were confirmed by the flat frequency response of the ratio of the output and input voltages (the S21 parameter) of the array between 300 kHz and 1 GHz. Setting the device to its optimal operating parameters allowed the detection of signals from local frequency-modulation stations.

IEEE Transactions on Applied Superconductivity•Aug 31, 2015•32 citations
We describe several types of wide operations and performances of a Superconducting Quantum Magnetometer at 10 GHz and higher output power levels (a microwave SQUID) for a fast and small signal A-D converter. Direct exhibition and counting of the high-speed Q-patterns from a higher-power SQUID have benn demonstrated up to a frequency region above 10 MHz by improving the post-detection system. These results give the best figure of merit so far reported far a microwave SQUID.
We have measured the characteristics of a novel SQUID magnetometer pumped at 9 GHz. The device comprises a niobium point-contact shunting a low impedance superconducting microwave transmission line which isolates the junction at high frequencies from a toroidal input transformer. The junction is matched to a 50 Ω coaxial transmission line and the SQUID is operated in a reflection mode. For low values of the weak link critical current we observe a modulation of the phase of the reflected microwave signal periodic in the applied flux. The modulation persists at high microwave power levels indicating that the junction response is maintained to at least 200 GHz. For large values of critical current, amplitude modulation is observed. We have obtained a differential sideband power of 230 pW/(\Phi_{0})^{2}which is close to the value predicted by a simple model. In flux-locked loop operation we have obtained an energy sensitivity referred to the input terminals of 7 × 10-31J/Hz, which is superior to that so far reported for any other SQUID.
The 500 MHz Quantum Interference patterns (Q-patterns) beyond 100 MHz previously reported have been directly observed for the first time from 10 and 35 GHz Superconducting Quantum Interference Devices (SQUID's). The observation was made by improving the bandwidth of the detection circuits, which was supposed to be the cause of the previous limitation on Q-patterns from the 10 and 35 GHz SQUID's. An improved system including a 10 or 35 GHz SQUID has possible applications to the measurement of signals due to even faster magnetic flux changes.
There is currently fundamental and technological interest in measuring and manipulating nanoscale magnets, particularly in the quantum coherent regime. To observe the dynamics of such systems one requires a magnetometer with not only exceptional sensitivity but also high gain, wide bandwidth, and low backaction. We demonstrate a dispersive magnetometer consisting of a two-junction superconducting quantum interference device (SQUID) in parallel with an integrated, lumped-element capacitor. Input flux signals are encoded as a phase modulation of the microwave drive tone applied to the magnetometer, resulting in a single quadrature voltage signal. For strong drive power, the nonlinearity of the resonator results in quantum limited, phase sensitive parametric amplification of this signal, which improves flux sensitivity at the expense of bandwidth. Depending on the drive parameters, the device performance ranges from an effective flux noise of 0.29 $\ensuremath{\mu}{\ensuremath{\Phi}}_{0}$Hz${}^{\ensuremath{-}1/2}$ and 20 MHz of signal bandwidth to a noise of 0.14 $\ensuremath{\mu}{\ensuremath{\Phi}}_{0}$Hz${}^{\ensuremath{-}1/2}$ and a bandwidth of 0.6 MHz. These results are in excellent agreement with our theoretical model.
Abstract Digital superconducting quantum interference device (SQUID with Single Flux Quantum (SFQ) feedback operates as a Δ-type oversampling A/D converter. Magnetic flux resolution at Nyquist frequency can be improved by taking sub SFQ feedback resolution and large oversampling ratio. Using high critical current density Nb process for fabricating SFQ circuits, we expected more higher operation speed for the digital SQUID and resulting to higher magnetic flux resolutions. We expected a performance of the digital SQUID magnetometer fabricated using 10 kA/cm2 Nb process based on CAD layout, with an up/down counter using T2FF cells and parallel SFQ feedback. For the clock frequency of 13 GHz and the Nyquist frequency of 1.587 MHz, the magnetic field noise was lower than 1.5 fT / Hz and the slew rate was exceeded 500 mT/s.
The capability of an all-niobium superconducting quantum interference device (SQUID) array to operate as an electrically small antenna capable of detecting radio frequency from distant sources was demonstrated. The measurements were performed in three different arrays, with each array consisting of 2400 identical cells. The intrinsic broadband characteristics of the device were confirmed by the flat frequency response of the ratio of the output and input voltages (the S21 parameter) of the array between 300 kHz and 1 GHz. Setting the device to its optimal operating parameters allowed the detection of signals from local frequency-modulation stations.