Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Low Temperature Physics

Quantum detector based on a superposition of macroscopic states in a phase qubit

V. I. Shnyrkov, Сергей Иванович Мельник

Published Jan 1, 2007• 10 citations
Publisher

Abstract

A quantum detector whose working principle is based on magnetic-field modulation of a circulating supercurrent in the quantum ground state of a macroscopic superconducting loop with a Josephson junction. Under the influence of an external magnetic flux equal to Φ0∕2 (or Φ0), two (or three) classical states are coupled to each other by quantum tunneling through a potential barrier, and therefore the detector is a two-level (or three-level) system. In the low-temperature region and under the condition of very weak damping, the mean value of the circulating supercurrent reflects the character of the variation of the quantum superposition of macroscopic states, which is sensitive to the symmetry of the potential. The variations of the current are amplified and detected in a measurement scheme similar to the signal registration in a nonhysteretic rf SQUID. It is shown by a numerical analysis that in comparison with a qubit detector based on an SIS junction, a detector with an ScS junction is faster and has much larger amplitudes of energy splitting at the same parameters. The results presented for double- and triple-well potentials clearly indicate that a qubit with an ScS junction can act as a detector with a sensitivity determined by the quantum noise of the amplifier.

DOI
10.1063/1.2409630

Related papers

Quantum superposition of three macroscopic states and superconducting qutrit detector

V. I. Shnyrkov, A. A. Soroka, Oleg G. Turutanov

Superconducting quantum coherent circuits have opened up a novel area of fundamental low-temperature science since they could potentially be the element base for future quantum computers. Here we report a quasi-three-level coherent system, the so-called superconducting qutrit, which has some advantages over a two-level information cell (qubit) and is based on the qutrit readout circuit intended to measure individually the states of each qubit in a quantum computer. The designed and implemented radio-frequency superconducting qutrit detector (rf SQUTRID) with atomic-size ScS-type contact utilizes the coherent-state superposition in the three-well potential with energy splitting $\ensuremath{\Delta}{E}_{01}/{k}_{B}\ensuremath{\approx}1.5\phantom{\rule{0.16em}{0ex}}$K at the 30th quantized energy level with good isolation from the electromagnetic environment. The reason why large values of $\ensuremath{\Delta}{E}_{01}$ (and thus using atomic-size Nb-Nb contact) are required is to ensure an adiabatic limit for the quantum dynamics of magnetic flux in the rf SQUTRID.

arXiv:1111.6571•Physical Review B•Jun 11, 2012•13 citations

Studies of Quantum Transitions of Magnetic Flux in a RF Squid Qubit

Luigi Longobardi

At low temperature and low damping, the magnetic flux of a rf Superconducting QUantum Interference Device (SQUID) acts as a macroscopic quantum variable whose dynamic is described by a double well potential. A rf SQUID consists of a superconducting loop interrupted by a thin insulating barrier, known as a Josephson junction. The modified rf SQUID design discussed in this thesis has independent, in situ, controls that allow varying the barrier height between the potential wells and their relative tilt. This high level of control of the potential together with the capability to implement an experimental setup optimized to reduce coupling to external sources of noise, made this system ideal not only for tests of quantum transition at a macroscopic level, but also as a scalable solid state device for quantum computation. A variety of measurements of quantum phenomena are reported in this thesis, including microwave level spectroscopy, coherent oscillations, and macroscopic resonant tunneling (MRT). These measurements are compared with theoretical models to study the possible sources of decoherence in a rf SQUID qubit. The analysis confirmed that the main source of decoherence is not due to coupling to the external environment, but it can be linked to intrinsic low frequency flux noise. Work from many groups over the last several years has shown that the performance of a superconductive qubit is limited by coupling to spurious defects in the materials used for the device fabrication. In this work we analyze the possibility of using the MRT as a tool for future studies of effects of materials and fabrication process in the realization of improved qubits, and we also explore the feasibility for measurements of quantum phenomena that involve fast pulsing of the potential barrier height.

•Oct 22, 2010•0 citations

The two-Josephson-junction flux qubit with large tunneling amplitude

V. I. Shnyrkov, A. A. Soroka, S. I. Melnyk

In this paper we discuss solid-state nanoelectronic realizations of Josephson flux qubits with large tunneling amplitude between the two macroscopic states. The latter can be controlled via the height and form of the potential barrier, which is determined by quantum-state engineering of the flux qubit circuit. The simplest circuit of the flux qubit is a superconducting loop interrupted by a Josephson nanoscale tunnel junction. The tunneling amplitude between two macroscopically different states can be increased substantially by engineering of the qubit circuit if the tunnel junction is replaced by a ScS contact. However, only Josephson tunnel junctions are particularly suitable for large-scale integration circuits and quantum detectors with present-day technology. To overcome this difficulty we consider here a flux qubit with high energy-level separation between the “ground” and “excited” states, consisting of a superconducting loop with two low-capacitance Josephson tunnel junctions in series. We demonstrate that for real parameters of resonant superposition between the two macroscopic states the tunneling amplitude can reach values greater than 1K. Analytical results for the tunneling amplitude obtained within the semiclassical approximation by the instanton technique show good correlation with a numerical solution.

arXiv:0706.2965•Low Temperature Physics•Aug 1, 2008•5 citations

Macroscopic quantum superposition of current states in a Josephson-junction loop

Frank K. Wilhelm, Caspar H. van der Wal, A. C. J. ter Haar +5 more

Abstract. Superconducting circuits with Josephson tunnel junctions are interesting systems for research on quantummechanical behavior of macroscopic degrees of freedom. A particular realization is a small superconducting loop containing three Josephson junctions. Close to magnetic frustration 1=2, the physics of this system corresponds to a double well, whose minima correspond to persistent currents of opposite sign. We present DC measurements of the flux indicating a smooth transition close to the degeneracy point even at very low temperatures. Furthermore, microwavespectroscopy experiments allow for the excitation to the next excited state. The dependence of the energy of the resonance on the applied flux clearly indicates the nature of these states as tunneling-splitted superpositions of flux states. We theoretically analyze the system using a generalized master-equation formulation of the spin-boson model. We address the nature of the measuring process by a switching DC SQUID and the possible interpretation of the spectroscopy data in terms of quantum coherence. We discuss these aspects in the context of further applications as a quantum bit.

Physics-Uspekhi•Oct 1, 2001•4 citations

Single-Shot Readout of Macroscopic Quantum Superposition State in a Superconducting Flux Qubit

Hirotaka Tanaka, Shiro Saito, Hayato Nakano +3 more

Single-shot readout experiments were performed on the two lowest-energy states of a superconducting qubit with three Josephson junctions embedded in a superconducting loop. We measured the qubit state via switching current Isw of a current-biased dc-SQUID, a quantum detector surrounding the qubit loop. The qubit signals were measured in a small Isw regime of the SQUID, typically less than 100 nA, where the Isw distribution is particularly narrow. The obtained single-shot data indicate that the qubit state is readout, through the flux generated by the qubit persistent-current, as energy eigenstates rather than current eigenstates.

arXiv:cond-mat/0407299•Jul 12, 2004•8 citations

Macroscopic quantum behavior of superconducting quantum interference devices

Maria Gabriella Castellano

Abstract Superconducting quantum interference devices (SQUIDs) are made by a superconducting loop interrupted by one or more Josephson junctions. They are described in terms of a macroscopic variable, the magnetic flux, which shows quantum effects such as tunnelling through a potential barrier. Besides making up the source of a quantum state, SQUIDs also provide the instruments necessary for its probing: as a fact, SQUID based magnetometers have a sensitivity approaching the quantum limit. In this paper I will review the working principle of these devices and illustrate the system of SQUIDs realized in my group to test the quantum behavior at a macroscopic level.

Fortschritte der Physik•Apr 24, 2003•3 citations
A quantum detector whose working principle is based on magnetic-field modulation of a circulating supercurrent in the quantum ground state of a macroscopic superconducting loop with a Josephson junction. Under the influence of an external magnetic flux equal to Φ0∕2 (or Φ0), two (or three) classical states are coupled to each other by quantum tunneling through a potential barrier, and therefore the detector is a two-level (or three-level) system. In the low-temperature region and under the condition of very weak damping, the mean value of the circulating supercurrent reflects the character of the variation of the quantum superposition of macroscopic states, which is sensitive to the symmetry of the potential. The variations of the current are amplified and detected in a measurement scheme similar to the signal registration in a nonhysteretic rf SQUID. It is shown by a numerical analysis that in comparison with a qubit detector based on an SIS junction, a detector with an ScS junction is faster and has much larger amplitudes of energy splitting at the same parameters. The results presented for double- and triple-well potentials clearly indicate that a qubit with an ScS junction can act as a detector with a sensitivity determined by the quantum noise of the amplifier.
Superconducting quantum coherent circuits have opened up a novel area of fundamental low-temperature science since they could potentially be the element base for future quantum computers. Here we report a quasi-three-level coherent system, the so-called superconducting qutrit, which has some advantages over a two-level information cell (qubit) and is based on the qutrit readout circuit intended to measure individually the states of each qubit in a quantum computer. The designed and implemented radio-frequency superconducting qutrit detector (rf SQUTRID) with atomic-size ScS-type contact utilizes the coherent-state superposition in the three-well potential with energy splitting $\ensuremath{\Delta}{E}_{01}/{k}_{B}\ensuremath{\approx}1.5\phantom{\rule{0.16em}{0ex}}$K at the 30th quantized energy level with good isolation from the electromagnetic environment. The reason why large values of $\ensuremath{\Delta}{E}_{01}$ (and thus using atomic-size Nb-Nb contact) are required is to ensure an adiabatic limit for the quantum dynamics of magnetic flux in the rf SQUTRID.
At low temperature and low damping, the magnetic flux of a rf Superconducting QUantum Interference Device (SQUID) acts as a macroscopic quantum variable whose dynamic is described by a double well potential. A rf SQUID consists of a superconducting loop interrupted by a thin insulating barrier, known as a Josephson junction. The modified rf SQUID design discussed in this thesis has independent, in situ, controls that allow varying the barrier height between the potential wells and their relative tilt. This high level of control of the potential together with the capability to implement an experimental setup optimized to reduce coupling to external sources of noise, made this system ideal not only for tests of quantum transition at a macroscopic level, but also as a scalable solid state device for quantum computation. A variety of measurements of quantum phenomena are reported in this thesis, including microwave level spectroscopy, coherent oscillations, and macroscopic resonant tunneling (MRT). These measurements are compared with theoretical models to study the possible sources of decoherence in a rf SQUID qubit. The analysis confirmed that the main source of decoherence is not due to coupling to the external environment, but it can be linked to intrinsic low frequency flux noise. Work from many groups over the last several years has shown that the performance of a superconductive qubit is limited by coupling to spurious defects in the materials used for the device fabrication. In this work we analyze the possibility of using the MRT as a tool for future studies of effects of materials and fabrication process in the realization of improved qubits, and we also explore the feasibility for measurements of quantum phenomena that involve fast pulsing of the potential barrier height.
In this paper we discuss solid-state nanoelectronic realizations of Josephson flux qubits with large tunneling amplitude between the two macroscopic states. The latter can be controlled via the height and form of the potential barrier, which is determined by quantum-state engineering of the flux qubit circuit. The simplest circuit of the flux qubit is a superconducting loop interrupted by a Josephson nanoscale tunnel junction. The tunneling amplitude between two macroscopically different states can be increased substantially by engineering of the qubit circuit if the tunnel junction is replaced by a ScS contact. However, only Josephson tunnel junctions are particularly suitable for large-scale integration circuits and quantum detectors with present-day technology. To overcome this difficulty we consider here a flux qubit with high energy-level separation between the “ground” and “excited” states, consisting of a superconducting loop with two low-capacitance Josephson tunnel junctions in series. We demonstrate that for real parameters of resonant superposition between the two macroscopic states the tunneling amplitude can reach values greater than 1K. Analytical results for the tunneling amplitude obtained within the semiclassical approximation by the instanton technique show good correlation with a numerical solution.
Abstract. Superconducting circuits with Josephson tunnel junctions are interesting systems for research on quantummechanical behavior of macroscopic degrees of freedom. A particular realization is a small superconducting loop containing three Josephson junctions. Close to magnetic frustration 1=2, the physics of this system corresponds to a double well, whose minima correspond to persistent currents of opposite sign. We present DC measurements of the flux indicating a smooth transition close to the degeneracy point even at very low temperatures. Furthermore, microwavespectroscopy experiments allow for the excitation to the next excited state. The dependence of the energy of the resonance on the applied flux clearly indicates the nature of these states as tunneling-splitted superpositions of flux states. We theoretically analyze the system using a generalized master-equation formulation of the spin-boson model. We address the nature of the measuring process by a switching DC SQUID and the possible interpretation of the spectroscopy data in terms of quantum coherence. We discuss these aspects in the context of further applications as a quantum bit.
Single-shot readout experiments were performed on the two lowest-energy states of a superconducting qubit with three Josephson junctions embedded in a superconducting loop. We measured the qubit state via switching current Isw of a current-biased dc-SQUID, a quantum detector surrounding the qubit loop. The qubit signals were measured in a small Isw regime of the SQUID, typically less than 100 nA, where the Isw distribution is particularly narrow. The obtained single-shot data indicate that the qubit state is readout, through the flux generated by the qubit persistent-current, as energy eigenstates rather than current eigenstates.
Abstract Superconducting quantum interference devices (SQUIDs) are made by a superconducting loop interrupted by one or more Josephson junctions. They are described in terms of a macroscopic variable, the magnetic flux, which shows quantum effects such as tunnelling through a potential barrier. Besides making up the source of a quantum state, SQUIDs also provide the instruments necessary for its probing: as a fact, SQUID based magnetometers have a sensitivity approaching the quantum limit. In this paper I will review the working principle of these devices and illustrate the system of SQUIDs realized in my group to test the quantum behavior at a macroscopic level.