Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Low power electronic optical bistability in single quantum well InP/InGaAsP Fabry–Perot waveguide resonators

B. Hübner, Roland Zengerle, A. Forchel

Published Jun 5, 1995• 9 citations
Publisher

Abstract

Optical bistability in a single quantum well waveguide resonator in the InP/InGaAsP material system is demonstrated. High contrast ratio (≳3:1) and switching at low power (≊1.5 mW) was obtained by using a single quantum well at a wavelength near the maximum nonlinear refractive index change and by depositing a reflective coating on the rear end of the waveguide. Clear optical bistability is observed in a wide wavelength range of 1480–1525 nm. Due to the low input power, cw operation of the device was possible at room temperature.

DOI
10.1063/1.113405

Related papers

Optical bistability in InGaAsP amplifiers and implications for passive devices

Wayne F. Sharfin, M. Dagenais

We demonstrate optically bistable (light switching light) operation in a room-temperature InGaAsP Fabry-Perot amplifier. The amplifier is an InGaAsP/InP laser structure biased at ~95% of its lasing threshold. It is switched with <3 μW of optical power provided by the mechanically chopped output of a quasi-single-mode InGaAsP/InP laser. The experimental apparatus is depicted in Fig, 1. A change in the refractive Index in the amplifier of only 5 × 10−4 is sufficient to cause switching. Input and output pulses from the nonlinear amplifier are shown in Fig. 2 when the source frequency is initially detuned by 14 GHz from the closest Fabry-Perot mode of the amplifier. Smaller switching powers are required at lesser detunings. The physical mechanism of the intensity-dependent change of the refractive index is thought to be the change in carrier density resulting from stimulated recombination of free carriers.

Conference on Lasers and Electro-Optics•Jan 1, 1985•0 citations

All-Optical Bistability in Photonic Crystal Resonators based on InGaAsP Quantum-Wells

Myung‐Ki Kim, In-Kag Hwang, Yong-hee Lee

We demonstrate extremely low-power all-optical bistability by using photonic crystal linear resonators based on InGaAsP quantum-wells. Since the photonic crystal cavity has a high quality-factor and a small mode-volume, the photon density in the cavity is extremely high, which makes it possible to reduce the bistable power. The measured minimum bistable threshold power was 37 muW by using a fiber coupling technique, and the estimated nonlinear refractive index (n2) was -6.84times10-14m2/W at a wavelength of 1610.8 nm which is near the resonant wavelength of quantum-well. The low-power optical bistable operations in a single photonic crystal cavity open the possibility of integrated optical devices such as an all-optical memory and switch, based on photonic crystals

IEEE Lasers and Electro-Optics Society Annual Meeting (LEOS)•Oct 1, 2006•4 citations

Optical bistability in an InGaAs/InP multiple quantum well waveguide Fabry–Perot cavity

Jeffrey E. Ehrlich, David T. Neilson, Andy C. Walker +5 more

We report measurements of quasi-cw optical bistability in an InGaAs/InP multiple quantum well waveguide Fabry–Perot cavity at 1.47 μm wavelength. This operating wavelength is detuned from the band-edge resonance by 0.07 μm, where an enhanced free-carrier contribution to the nonlinear refractive index due to 2D confinement of carriers in the quantum wells accounts for the large index variations. The effect of any thermally induced nonlinear response is negligible.

Applied Physics Letters•Sep 20, 1993•8 citations

Room-temperature optical bistability in InGaAsP/InP amplifiers and implications for passive devices

Wayne F. Sharfin, M. Dagenais

Optical bistability has been observed for the first time in a room-temperature InGaAsP/InP amplifier. Switching occurred at an optical input power of about 3 μW, corresponding to a change in the refractive index of 5×10−4. The results are discussed in terms of a light-induced change in carrier concentration. Implications for bistability in passive devices are also discussed.

Applied Physics Letters•May 1, 1985•52 citations

Submilliwatt optical bistability in a coated InGaAs/InP multiquantum well waveguide Fabry–Perot cavity

David T. Neilson, Jeffrey E. Ehrlich, Paul Meredith +7 more

The observation of submilliwatt switching and optical bistability in an InGaAs/InP MQW waveguide Fabry–Perot cavity using diode laser sources is reported. Second-order bistability was also observed, with a higher power colour-centre laser source, showing that optically-induced phase shifts of greater than 2π can be achieved at power levels of less than 5mW. A switch contrast of ̃3:1 was observed.

Electronics Letters•Aug 19, 1993•4 citations

Submilliwatt optical bistability in wafer fused vertical cavity at 1.55-μm wavelength

F. Jeannès, Gilles Patriarche, Rozette Azoulay +3 more

We report on low-power optical bistability in a vertical cavity structure at 1.55-μm wavelength due to the bandgap resonant dispersive optical nonlinearity of InGaAsP. In this structure, a GaAs-AlAs Bragg reflector grown on GaAs and the nonlinear medium grown on InP are bonded through wafer-fusion, leading to a high-quality vertical cavity after deposition of a top dielectric mirror. This device shows interesting characteristics for optical switching applications at fiber communication wavelengths, such as a switching contrast higher than 8:1 in the reflective mode and a bistability threshold power as low as 0.6 mW. True steady-state memory effect is observed with continuous-wave input, and the device switching time is in the ns range.

IEEE Photonics Technology Letters•Apr 1, 1996•12 citations
Optical bistability in a single quantum well waveguide resonator in the InP/InGaAsP material system is demonstrated. High contrast ratio (≳3:1) and switching at low power (≊1.5 mW) was obtained by using a single quantum well at a wavelength near the maximum nonlinear refractive index change and by depositing a reflective coating on the rear end of the waveguide. Clear optical bistability is observed in a wide wavelength range of 1480–1525 nm. Due to the low input power, cw operation of the device was possible at room temperature.
We demonstrate optically bistable (light switching light) operation in a room-temperature InGaAsP Fabry-Perot amplifier. The amplifier is an InGaAsP/InP laser structure biased at ~95% of its lasing threshold. It is switched with <3 μW of optical power provided by the mechanically chopped output of a quasi-single-mode InGaAsP/InP laser. The experimental apparatus is depicted in Fig, 1. A change in the refractive Index in the amplifier of only 5 × 10−4 is sufficient to cause switching. Input and output pulses from the nonlinear amplifier are shown in Fig. 2 when the source frequency is initially detuned by 14 GHz from the closest Fabry-Perot mode of the amplifier. Smaller switching powers are required at lesser detunings. The physical mechanism of the intensity-dependent change of the refractive index is thought to be the change in carrier density resulting from stimulated recombination of free carriers.
We demonstrate extremely low-power all-optical bistability by using photonic crystal linear resonators based on InGaAsP quantum-wells. Since the photonic crystal cavity has a high quality-factor and a small mode-volume, the photon density in the cavity is extremely high, which makes it possible to reduce the bistable power. The measured minimum bistable threshold power was 37 muW by using a fiber coupling technique, and the estimated nonlinear refractive index (n2) was -6.84times10-14m2/W at a wavelength of 1610.8 nm which is near the resonant wavelength of quantum-well. The low-power optical bistable operations in a single photonic crystal cavity open the possibility of integrated optical devices such as an all-optical memory and switch, based on photonic crystals
We report on low-power optical bistability in a vertical cavity structure at 1.55-μm wavelength due to the bandgap resonant dispersive optical nonlinearity of InGaAsP. In this structure, a GaAs-AlAs Bragg reflector grown on GaAs and the nonlinear medium grown on InP are bonded through wafer-fusion, leading to a high-quality vertical cavity after deposition of a top dielectric mirror. This device shows interesting characteristics for optical switching applications at fiber communication wavelengths, such as a switching contrast higher than 8:1 in the reflective mode and a bistability threshold power as low as 0.6 mW. True steady-state memory effect is observed with continuous-wave input, and the device switching time is in the ns range.