Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Lasers and Electro-Optics Society Annual Meeting (LEOS)

All-Optical Bistability in Photonic Crystal Resonators based on InGaAsP Quantum-Wells

Myung‐Ki Kim, In-Kag Hwang, Yong-hee Lee

Published Oct 1, 2006• 4 citations
Publisher

Abstract

We demonstrate extremely low-power all-optical bistability by using photonic crystal linear resonators based on InGaAsP quantum-wells. Since the photonic crystal cavity has a high quality-factor and a small mode-volume, the photon density in the cavity is extremely high, which makes it possible to reduce the bistable power. The measured minimum bistable threshold power was 37 muW by using a fiber coupling technique, and the estimated nonlinear refractive index (n2) was -6.84times10-14m2/W at a wavelength of 1610.8 nm which is near the resonant wavelength of quantum-well. The low-power optical bistable operations in a single photonic crystal cavity open the possibility of integrated optical devices such as an all-optical memory and switch, based on photonic crystals

DOI
10.1109/leos.2006.278976

Related papers

All-optical memories based on photonic crystal nanocavities

Akihiko Shinya, Shinji Matsuo, Kengo Nozaki +5 more

We demonstrate all-optical bistable memory operation with InGaAsP photonic crystal nanocavities based on refractive index modulation caused by carrier-induced nonlinearity. The minimum bias power for bistability is extremely low at 40 muW and the operating energy required for switching is only 30 fJ.

International Conference on Photonics in Switching•Sep 1, 2009•3 citations

All-optical on-chip memory based on ultra high Q InGaAsP photonic crystal nanocavity

Akihiko Shinya, Shinji Matsuo, Yosia Yosia +5 more

We demonstrate all-optical bistable memory operation with 1.3 Q-InGaAsP photonic crystal nanocavities based on refractive index modulation caused by carrier-induced nonlinearity. The minimum bias power for bistability is extremely low at a few tens of muW and the operating energy required for switching is only 30 fJ.

Conference on Lasers and Electro-Optics•May 1, 2008•2 citations

Optical Bistability in 2D Photonic Crystal Slab Resonators

Myung‐Ki Kim, In-Kag Hwang, Yong-Hee Lee

We report the low-power optical bistability under the continuous wave pumping conditions in photonic crystal linear resonators containing the InGaAsP quantum well active medium. The threshold bistable power is measured to be 35 muW at the normalized detuning of -1.724, by employing fiber coupling techniques.

International Nano-Optoelectronics Workshop•Jul 1, 2007•0 citations

Fast bistable all-optical switch and memory on a silicon photonic crystal on-chip

Takasumi Tanabe, Masaya Notomi, Satoshi Mitsugi +2 more

We demonstrate extremely low-power all-optical bistability by utilizing silicon photonic crystal nanocavities, based on the plasma effect of carriers generated by two-photon absorption. Owing to the high quality factor and the small volume of the nanocavities, the photon density inside the cavity becomes extremely high, which leads to a large reduction in operation power. Optical bistable operation in a single nanocavity permits optical read-write memory operation, which opens the possibility of an integrated optical logic circuit on a single chip, based on photonic crystals. The demonstrated bistable threshold power is 0.4 mW with a set pulse energy of 74 fJ, at a switching speed of <100 ps.

Optics Letters•Oct 1, 2005•325 citations

All-optical bistable switching in curved microfiber-coupled photonic crystal resonators

Myung-Ki Kim, In-Kag Hwang, Se-Heon Kim +2 more

The authors report low-power optical bistability under continuous wave pumping conditions in five-cell photonic crystal linear resonators containing InGaAsP quantum wells, by employing the fiber-coupling technique. The threshold bistable power is measured to be 35μW at the normalized detuning of −1.724. Owing to the high band-edge nonlinearities of quantum wells and the efficient fiber coupling, minimal instability is observed. In addition, all-optical switching is demonstrated with switching energy less than 75.4fJ.

Applied Physics Letters•Apr 16, 2007•42 citations

Low power electronic optical bistability in single quantum well InP/InGaAsP Fabry–Perot waveguide resonators

B. Hübner, Roland Zengerle, A. Forchel

Optical bistability in a single quantum well waveguide resonator in the InP/InGaAsP material system is demonstrated. High contrast ratio (≳3:1) and switching at low power (≊1.5 mW) was obtained by using a single quantum well at a wavelength near the maximum nonlinear refractive index change and by depositing a reflective coating on the rear end of the waveguide. Clear optical bistability is observed in a wide wavelength range of 1480–1525 nm. Due to the low input power, cw operation of the device was possible at room temperature.

Applied Physics Letters•Jun 5, 1995•9 citations
We demonstrate extremely low-power all-optical bistability by using photonic crystal linear resonators based on InGaAsP quantum-wells. Since the photonic crystal cavity has a high quality-factor and a small mode-volume, the photon density in the cavity is extremely high, which makes it possible to reduce the bistable power. The measured minimum bistable threshold power was 37 muW by using a fiber coupling technique, and the estimated nonlinear refractive index (n2) was -6.84times10-14m2/W at a wavelength of 1610.8 nm which is near the resonant wavelength of quantum-well. The low-power optical bistable operations in a single photonic crystal cavity open the possibility of integrated optical devices such as an all-optical memory and switch, based on photonic crystals
We demonstrate extremely low-power all-optical bistability by utilizing silicon photonic crystal nanocavities, based on the plasma effect of carriers generated by two-photon absorption. Owing to the high quality factor and the small volume of the nanocavities, the photon density inside the cavity becomes extremely high, which leads to a large reduction in operation power. Optical bistable operation in a single nanocavity permits optical read-write memory operation, which opens the possibility of an integrated optical logic circuit on a single chip, based on photonic crystals. The demonstrated bistable threshold power is 0.4 mW with a set pulse energy of 74 fJ, at a switching speed of <100 ps.
The authors report low-power optical bistability under continuous wave pumping conditions in five-cell photonic crystal linear resonators containing InGaAsP quantum wells, by employing the fiber-coupling technique. The threshold bistable power is measured to be 35μW at the normalized detuning of −1.724. Owing to the high band-edge nonlinearities of quantum wells and the efficient fiber coupling, minimal instability is observed. In addition, all-optical switching is demonstrated with switching energy less than 75.4fJ.
Optical bistability in a single quantum well waveguide resonator in the InP/InGaAsP material system is demonstrated. High contrast ratio (≳3:1) and switching at low power (≊1.5 mW) was obtained by using a single quantum well at a wavelength near the maximum nonlinear refractive index change and by depositing a reflective coating on the rear end of the waveguide. Clear optical bistability is observed in a wide wavelength range of 1480–1525 nm. Due to the low input power, cw operation of the device was possible at room temperature.