Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Japanese Journal of Applied Physics

85Rb D1-Line Coherent-Population-Trapping Atomic Clock for Low-Power Operation

Shigeyoshi Goka

Published Jun 1, 2010• 7 citations
Publisher

Abstract

A 85Rb D1-line coherent-population-trapping (CPT) atomic clock with a natural-mixture Rb gas cell is demonstrated. D1-line excitation can generate a larger CPT resonance amplitude, and the choice of 85Rb rather than conventional 87Rb is because of its lower ground-state hyperfine-splitting frequency. The frequency deviation for the D1 line was measured using the same experimental setup as that for the D2 line except for the vertical-cavity surface-emitting laser (VCSEL) wavelength and RF power. In the case of D1-line excitation, the CPT resonance amplitude was 1.5 times that for the D2 line, and the light shift sensitivity was one-half that for the D2 line. The Allan standard deviations for the 85Rb D1 line, estimated from the frequency deviations, are <2.5×10-12 per day. In addition, the required RF is 1.5 GHz and its power is only -8.0 dBm.

DOI
10.1143/jjap.49.062801

Related papers

85Rb D1-line CPT atomic clock with low power consumption

Shigeyoshi Goka

This paper describes the investigation of a85Rb D1-line coherent population trapping (CPT) atomic clock with a Rb gas-cell containing a natural mixture of Rb atoms and buffer gas. The choice of85Rb rather than conventional87Rb is dictated by the lower ground-state hyperfine-splitting frequency, which leads to less than one-half the required RF power and more effective RF-related circuit designs. In this paper, the modulation profiles, the CPT resonances, and the long-term frequency stabilities of the CPT resonance for85Rb D1 and D2 lines are presented. The frequency deviations for D1 and D2 lines are measured using a same experimental setup except for VCSEL wavelength and RF power. The Allan deviations, estimated from the frequency deviations, are-12/day for D1 line and-12/day for D2 line. In the case of D1 excitation, required RF frequency is 1.5 GHz and its power is only -8.0 dBm.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Apr 1, 2009•0 citations

85Rb Coherent-Population-Trapping Atomic Clock with Low Power Consumption

Shigeyoshi Goka

In this paper, the investigation of a 85 Rb coherent-population-trapping (CPT) atomic clock for low-power operation is described. The modulation profiles and CPT resonances for both 85 Rb and 87 Rb, the long-term frequency stabilities of the CPT resonance for both, and the feasibility of switching between low-power and high-stability operation modes are presented. The choice of 85 Rb rather than conventional 87 Rb is dictated by the lower ground-state hyperfine-splitting frequency, which leads to less than one-half the required RF power and more effective RF-related circuit designs. CPT resonances for both 85 Rb and 87 Rb can be observed separately in the same natural mixture Rb gas cell, and the linewidth is less than 120 Hz in both cases. The long-term frequency stabilities are <4.0 ×10 -12 /day for 85 Rb and <3.5 ×10 -12 /day for 87 Rb. These results indicate that a 85 Rb CPT atomic clock has a long-term stability of ∼4.0 ×10 -12 /day and consumes about one-half the RF power of a 87 Rb equivqlent. In addition, it is possible to switch between low-power and high-stability operation modes by changing the RF frequency and power.

Japanese Journal of Applied Physics•Aug 20, 2009•8 citations

Low power 85Rb CPT atomic clock

Shigeyoshi Goka, Okura Taisuke, Moroyama Munetake +1 more

This paper outlines the features of the85Rb vapor cell atomic clock, the coherent population trapping (CPT) resonance in an85Rb/87Rb mixed vapor cell, and the results of the frequency stabilities of a pilot system. The experiments were performed with a sealed vapor cell containing a natural mixture of Rb isotopes and a buffer gas. Excitation of the CPT resonance was accomplished using a vertical-cavity surface-emitting laser modulated at 1.5, 3.0, 3.4 and 6.8 GHz, which corresponded to the full- and half-ground-state hyperfine frequencies of85Rb and87Rb. The results show that the CPT resonances at both85Rb and87Rb can be observed separately. The frequency stabilities of the output signals for each CPT resonance were ≪ 10x10−12/day for85Rb and ≪ 6x10−12/day for87Rb. In addition, the RF modulation signal power for85Rb was 1.1 dB less than that of87Rb, which was 3.4GHz.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•May 1, 2008•2 citations

Performance of a prototype atomic clock based on lin‖lin coherent population trapping resonances in Rb atomic vapor

Eugeniy E. Mikhailov, Travis Horrom, Nathan Belcher +1 more

We report on the performance of the first table-top prototype atomic clock based on coherent population trapping (CPT) resonances with parallel linearly polarized optical fields (lin‖lin configuration). Our apparatus uses a vertical-cavity surface-emitting laser (VCSEL) tuned to the D1 line of 87Rb with the current modulation at the 87Rb hyperfine frequency. We demonstrate cancellation of the first-order light shift by the proper choice of rf modulation power and further improve our prototype clock stability by optimizing the parameters of the microwave lock loop. Operating in these optimal conditions, we measured a short-term fractional frequency stability (Allan deviation) 2×10−11τ−1/2 for observation times 1 s ≤ τ ≤ 20 s. This value is limited by large VCSEL phase noise and environmental temperature fluctuation. Further improvements in frequency stability should be possible with an apparatus designed as a dedicated lin‖lin CPT resonance clock with environmental impacts minimized.

arXiv:0910.5881•Journal of the Optical Society of America B•Feb 3, 2010•53 citations

VCSELs for atomic clocks

Darwin K. Serkland, Gregory M. Peake, K.M. Geib +4 more

The spectroscopic technique of coherent population trapping (CPT) enables an all-optical interrogation of the groundstate hyperfine splitting of cesium (or rubidium), compared to the optical-microwave double resonance technique conventionally employed in atomic frequency standards. All-optical interrogation enables the reduction of the size and power consumption of an atomic clock by two orders of magnitude, and vertical-cavity surface-emitting lasers (VCSELs) are preferred optical sources due to their low power consumption and circular output beam. Several research teams are currently using VCSELs for DARPA's chip-scale atomic clock (CSAC) program with the goal of producing an atomic clock having a volume < 1 cm^3, a power consumption < 30 mW, and an instability (Allan deviation) < 1x10^-11 during a 1-hour averaging interval. This paper describes the VCSEL requirements for CPT-based atomic clocks, which include single mode operation, single polarization operation, modulation bandwidth > 4 GHz, low power consumption (for the CSAC), narrow linewidth, and low relative intensity noise (RIN). A significant manufacturing challenge is to reproducibly obtain the required wavelength at the specified VCSEL operating temperature and drive current. Data are presented that show the advantage of operating at the D1 (rather than D2) resonance of the alkali atoms. Measurements of VCSEL linewidth will be discussed in particular, since atomic clock performance is especially sensitive to this parameter.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 9, 2006•60 citations

Theoretical and experimental study of Rb coherent population trapping atomic clock with phase modulation detection

Yuichiro Yano, Motoaki Hara, Masatoshi Kajita +1 more

We theoretically and experimentally study Coherent Population Trapping (CPT) resonance with phase modulation detection. We measured the time response behavior of CPT resonance using an87Rb gas cell and the D1-line vertical-cavity surface-emitting laser(VCSEL) and calculated the periodic behavior of the density matrix based on eigenvector algorithm. Experiment results are good agreement with calculation results.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Jul 1, 2017•0 citations
A 85Rb D1-line coherent-population-trapping (CPT) atomic clock with a natural-mixture Rb gas cell is demonstrated. D1-line excitation can generate a larger CPT resonance amplitude, and the choice of 85Rb rather than conventional 87Rb is because of its lower ground-state hyperfine-splitting frequency. The frequency deviation for the D1 line was measured using the same experimental setup as that for the D2 line except for the vertical-cavity surface-emitting laser (VCSEL) wavelength and RF power. In the case of D1-line excitation, the CPT resonance amplitude was 1.5 times that for the D2 line, and the light shift sensitivity was one-half that for the D2 line. The Allan standard deviations for the 85Rb D1 line, estimated from the frequency deviations, are <2.5×10-12 per day. In addition, the required RF is 1.5 GHz and its power is only -8.0 dBm.
This paper describes the investigation of a85Rb D1-line coherent population trapping (CPT) atomic clock with a Rb gas-cell containing a natural mixture of Rb atoms and buffer gas. The choice of85Rb rather than conventional87Rb is dictated by the lower ground-state hyperfine-splitting frequency, which leads to less than one-half the required RF power and more effective RF-related circuit designs. In this paper, the modulation profiles, the CPT resonances, and the long-term frequency stabilities of the CPT resonance for85Rb D1 and D2 lines are presented. The frequency deviations for D1 and D2 lines are measured using a same experimental setup except for VCSEL wavelength and RF power. The Allan deviations, estimated from the frequency deviations, are-12/day for D1 line and-12/day for D2 line. In the case of D1 excitation, required RF frequency is 1.5 GHz and its power is only -8.0 dBm.
In this paper, the investigation of a 85 Rb coherent-population-trapping (CPT) atomic clock for low-power operation is described. The modulation profiles and CPT resonances for both 85 Rb and 87 Rb, the long-term frequency stabilities of the CPT resonance for both, and the feasibility of switching between low-power and high-stability operation modes are presented. The choice of 85 Rb rather than conventional 87 Rb is dictated by the lower ground-state hyperfine-splitting frequency, which leads to less than one-half the required RF power and more effective RF-related circuit designs. CPT resonances for both 85 Rb and 87 Rb can be observed separately in the same natural mixture Rb gas cell, and the linewidth is less than 120 Hz in both cases. The long-term frequency stabilities are <4.0 ×10 -12 /day for 85 Rb and <3.5 ×10 -12 /day for 87 Rb. These results indicate that a 85 Rb CPT atomic clock has a long-term stability of ∼4.0 ×10 -12 /day and consumes about one-half the RF power of a 87 Rb equivqlent. In addition, it is possible to switch between low-power and high-stability operation modes by changing the RF frequency and power.
This paper outlines the features of the85Rb vapor cell atomic clock, the coherent population trapping (CPT) resonance in an85Rb/87Rb mixed vapor cell, and the results of the frequency stabilities of a pilot system. The experiments were performed with a sealed vapor cell containing a natural mixture of Rb isotopes and a buffer gas. Excitation of the CPT resonance was accomplished using a vertical-cavity surface-emitting laser modulated at 1.5, 3.0, 3.4 and 6.8 GHz, which corresponded to the full- and half-ground-state hyperfine frequencies of85Rb and87Rb. The results show that the CPT resonances at both85Rb and87Rb can be observed separately. The frequency stabilities of the output signals for each CPT resonance were ≪ 10x10−12/day for85Rb and ≪ 6x10−12/day for87Rb. In addition, the RF modulation signal power for85Rb was 1.1 dB less than that of87Rb, which was 3.4GHz.
We report on the performance of the first table-top prototype atomic clock based on coherent population trapping (CPT) resonances with parallel linearly polarized optical fields (lin‖lin configuration). Our apparatus uses a vertical-cavity surface-emitting laser (VCSEL) tuned to the D1 line of 87Rb with the current modulation at the 87Rb hyperfine frequency. We demonstrate cancellation of the first-order light shift by the proper choice of rf modulation power and further improve our prototype clock stability by optimizing the parameters of the microwave lock loop. Operating in these optimal conditions, we measured a short-term fractional frequency stability (Allan deviation) 2×10−11τ−1/2 for observation times 1 s ≤ τ ≤ 20 s. This value is limited by large VCSEL phase noise and environmental temperature fluctuation. Further improvements in frequency stability should be possible with an apparatus designed as a dedicated lin‖lin CPT resonance clock with environmental impacts minimized.
The spectroscopic technique of coherent population trapping (CPT) enables an all-optical interrogation of the groundstate hyperfine splitting of cesium (or rubidium), compared to the optical-microwave double resonance technique conventionally employed in atomic frequency standards. All-optical interrogation enables the reduction of the size and power consumption of an atomic clock by two orders of magnitude, and vertical-cavity surface-emitting lasers (VCSELs) are preferred optical sources due to their low power consumption and circular output beam. Several research teams are currently using VCSELs for DARPA's chip-scale atomic clock (CSAC) program with the goal of producing an atomic clock having a volume < 1 cm^3, a power consumption < 30 mW, and an instability (Allan deviation) < 1x10^-11 during a 1-hour averaging interval. This paper describes the VCSEL requirements for CPT-based atomic clocks, which include single mode operation, single polarization operation, modulation bandwidth > 4 GHz, low power consumption (for the CSAC), narrow linewidth, and low relative intensity noise (RIN). A significant manufacturing challenge is to reproducibly obtain the required wavelength at the specified VCSEL operating temperature and drive current. Data are presented that show the advantage of operating at the D1 (rather than D2) resonance of the alkali atoms. Measurements of VCSEL linewidth will be discussed in particular, since atomic clock performance is especially sensitive to this parameter.