Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Journal of Quantum Electronics

Generalization of the Modeling Analysis of Optical Bistability in Quasi-Three-Level Lasers

Junhai Liu, Xueping Tian

Published Jan 9, 2013• 5 citations
Publisher

Abstract

In this paper, we generalize a previously developed model describing the behavior of optical bistability in the operation of a quasi-three-level laser by taking into account a Gaussian transverse distribution for the laser mode and including inhomogeneous line broadening for the laser medium. The results show that apart from some quantitative modifications, the primary characteristics of bistability predicted by the simplified model remain correct; in particular, the fundamental condition for the existence of bistability,fxa/(xa+1), turns out to hold universally. It is also revealed that in comparison with the results obtained in the simplified model, the intensities at the up- and down-threshold will be increased, whereas the bistability range will be reduced.

DOI
10.1109/jqe.2013.2238658

Related papers

Optical bistability in the oscillation of an inhomogeneously broadened quasi-three-level laser

Junhai Liu, Xueping Tian

A theoretical modeling analysis is presented to study the optical bistability exhibited in the oscillation of an inhomogeneously broadened quasi-three-level laser. All the major characteristics of optical bistability depend on two normalized parameters, f and xa, which are defined by f = Isat,a/Isat,m and xa = 2αa0pa/δ and are related to measurable properties of the laser medium. In comparison with the case of a homogeneously broadened laser, the essential condition for the occurrence of such bistability, f < xa/(xa + 1), turns out to be the same, whereas the intensities at the up- and down-thresholds are substantially increased and the bistability range is reduced.

Laser Physics•Mar 15, 2013•0 citations

Modeling Analysis of Optical Bistability in Continuous-Wave Operation of Quasi-Three-Level Lasers

Junhai Liu

In this paper, an analytical model is developed for a quasi-three-level laser exhibiting optical bistability in its continuous-wave operation. This model gives the necessary conditions for the formation of such bistability, which are directly connected to measurable parameters of the laser medium, and reveals most of the primary characteristics of optical bistablity demonstrated experimentally with quasi-three-lasers based on Yb-doped vanadates. The principal parameters characterizing such bistability,xth\mathchar"702Dup,xth\mathchar"702Ddown, Δxbr,Ith\mathchar"702Dup, andIth\mathchar"702Ddown, can be expressed explicitly in terms of two normalized parameters,xa= 2αa0pa/δ andf=Isat,a/Isat,m. To confirm its validity and demonstrate its usefulness, this model is applied to a typical Yb:LuVO4laser displaying sizable optical bistability in its operation, giving very good agreement between theoretical prediction and experimental measurement.

IEEE Journal of Quantum Electronics•Jan 1, 2011•12 citations

A General Model for Continuous-wave Quasi-three-level Lasers Exhibiting Optical Bistability

Linhua Xia

In this Letter we report briefly the major results derived froma simple model developedfor a quasi-three-level laser exhibiting optical bistability.This model correctly predicts the existence of hysteresis loopin the laser operation under some certain conditions,and can explain most of the primary characteristics of the optical bistability occurring in continuous-wave laser operation of Yb-doped vanadate crystals.

Journal of Qingdao University•Jan 1, 2010•0 citations

Conditions for the appearance of an optical instability of a laser with a saturable absorber and an inhomogeneously broadened line

Dinh Van Hoang, Vo Duc Luong

An analysis is made of the operation of a laser with a saturable absorber and dominant inhomogeneous line broadening. A four-level model is used to determine the characteristics of mode intensities and conditions for the appearance of an optical bistability. By analogy with a two-level model, the results obtained demonstrate that in single-mode operation this bistability appears only if the relaxation coefficients of the upper levels of atomic or molecular systems are different in the amplifying and absorbing parts of a laser. Moreover, a change in the inhomogeneous broadening alters greatly the optical bistability interval. The calculation method used in the present study can be readily extended to analyze a multimode laser.

Soviet Journal of Quantum Electronics•Sep 30, 1987•2 citations

TRANSVERSE FIELD AND INHOMOGENEOUS BROADENING EFFECTS ON OPTICAL BISTABILITY IN MIXED SPECIES

Mona Ali, S. M. A. Maize, M. A. El-Deberky

The steady state behavior of a bistable system of a homogeneously or inhomogeneously broadened two sorts of two-level atoms placed in a ring cavity and driven by a coherent field is analyzed within the mean field limit where the transverse effect of the radiation field is taken into account within the single-transverse-mode model. Effects on the input–output relation, due to the transverse parameter and the Lorentzian and the Gaussian line widths which measure the inhomogeneous broadening of the atoms, are examined. The enlargement of the optical bistable (tristable) region according to the previously mentioned parameters is explained.

International Journal of Modern Physics B•Aug 20, 2008•1 citation

Characteristics of the mode intensity and optical bistability in multimode lasers with a saturable absorber. I. Single-mode operator

Dinh Van Hoang, Phan N Ha

The characteristics of the mode intensity and conditions for occurrence of optical bistability in a ring laser with a saturable absorber are considered. The rate equation approximation method is used to find analytic expressions for these characteristics. It is shown that changes in such physical parameters as the homogeneous and inhomogeneous broadening, coefficients of relaxation of amplifying and absorbing cells, etc. cause changes in the range of existence of optical bistability or a hysteresis cycle. The influence of inhomogeneous broadening and of spontaneous emission near the lasing threshold on the appearance of optical bistability is demonstrated for the single-mode regime.

Soviet Journal of Quantum Electronics•Mar 31, 1986•1 citation
In this paper, we generalize a previously developed model describing the behavior of optical bistability in the operation of a quasi-three-level laser by taking into account a Gaussian transverse distribution for the laser mode and including inhomogeneous line broadening for the laser medium. The results show that apart from some quantitative modifications, the primary characteristics of bistability predicted by the simplified model remain correct; in particular, the fundamental condition for the existence of bistability,fxa/(xa+1), turns out to hold universally. It is also revealed that in comparison with the results obtained in the simplified model, the intensities at the up- and down-threshold will be increased, whereas the bistability range will be reduced.
A theoretical modeling analysis is presented to study the optical bistability exhibited in the oscillation of an inhomogeneously broadened quasi-three-level laser. All the major characteristics of optical bistability depend on two normalized parameters, f and xa, which are defined by f = Isat,a/Isat,m and xa = 2αa0pa/δ and are related to measurable properties of the laser medium. In comparison with the case of a homogeneously broadened laser, the essential condition for the occurrence of such bistability, f < xa/(xa + 1), turns out to be the same, whereas the intensities at the up- and down-thresholds are substantially increased and the bistability range is reduced.
In this paper, an analytical model is developed for a quasi-three-level laser exhibiting optical bistability in its continuous-wave operation. This model gives the necessary conditions for the formation of such bistability, which are directly connected to measurable parameters of the laser medium, and reveals most of the primary characteristics of optical bistablity demonstrated experimentally with quasi-three-lasers based on Yb-doped vanadates. The principal parameters characterizing such bistability,xth\mathchar"702Dup,xth\mathchar"702Ddown, Δxbr,Ith\mathchar"702Dup, andIth\mathchar"702Ddown, can be expressed explicitly in terms of two normalized parameters,xa= 2αa0pa/δ andf=Isat,a/Isat,m. To confirm its validity and demonstrate its usefulness, this model is applied to a typical Yb:LuVO4laser displaying sizable optical bistability in its operation, giving very good agreement between theoretical prediction and experimental measurement.
An analysis is made of the operation of a laser with a saturable absorber and dominant inhomogeneous line broadening. A four-level model is used to determine the characteristics of mode intensities and conditions for the appearance of an optical bistability. By analogy with a two-level model, the results obtained demonstrate that in single-mode operation this bistability appears only if the relaxation coefficients of the upper levels of atomic or molecular systems are different in the amplifying and absorbing parts of a laser. Moreover, a change in the inhomogeneous broadening alters greatly the optical bistability interval. The calculation method used in the present study can be readily extended to analyze a multimode laser.
The steady state behavior of a bistable system of a homogeneously or inhomogeneously broadened two sorts of two-level atoms placed in a ring cavity and driven by a coherent field is analyzed within the mean field limit where the transverse effect of the radiation field is taken into account within the single-transverse-mode model. Effects on the input–output relation, due to the transverse parameter and the Lorentzian and the Gaussian line widths which measure the inhomogeneous broadening of the atoms, are examined. The enlargement of the optical bistable (tristable) region according to the previously mentioned parameters is explained.
The characteristics of the mode intensity and conditions for occurrence of optical bistability in a ring laser with a saturable absorber are considered. The rate equation approximation method is used to find analytic expressions for these characteristics. It is shown that changes in such physical parameters as the homogeneous and inhomogeneous broadening, coefficients of relaxation of amplifying and absorbing cells, etc. cause changes in the range of existence of optical bistability or a hysteresis cycle. The influence of inhomogeneous broadening and of spontaneous emission near the lasing threshold on the appearance of optical bistability is demonstrated for the single-mode regime.