Ghost imaging and ghost diffraction can be realized by using the spatial correlations between signal and idler photons produced by spontaneous parametric down-conversion. If an object is placed in the signal (idler) path, the spatial correlations between the transmitted photons as measured by a single, non-imaging, "bucket" detector and a scanning detector placed in the idler (signal) path can reveal either the image or diffraction pattern of the object, whereas neither detector signal on its own can. The details of the bucket detector, such as its collection area and numerical aperture, set the number of transverse modes supported by the system. For ghost imaging these details are less important, affecting mostly the sampling time required to produce the image. For ghost diffraction, however, the bucket detector must be filtered to a single, spatially coherent mode. We examine this difference in behavour by using either a multi-mode or single-mode fibre to define the detection aperture. Furthermore, instead of a scanning detector we use a heralded camera so that the image or diffraction pattern produced can be measured across the full field of view. The importance of a single mode detection in the observation of ghost diffraction is equivalent to the need within a classical diffraction experiment to illuminate the aperture with a spatially coherent mode.
Ghost imaging and ghost diffraction can be realized by using the spatial correlations between signal and idler photons produced by spontaneous parametric down-conversion. If an object is placed in the signal (idler) path, the spatial correlations between the transmitted photons as measured by a single, non-imaging, "bucket" detector and a scanning detector placed in the idler (signal) path can reveal either the image or diffraction pattern of the object, whereas neither detector signal on its own can. The details of the bucket detector, such as its collection area and numerical aperture, set the number of transverse modes supported by the system. For ghost imaging these details are less important, affecting mostly the sampling time required to produce the image. For ghost diffraction, however, the bucket detector must be filtered to a single, spatially coherent mode. We examine this difference in behavour by using either a multi-mode or single-mode fibre to define the detection aperture. Furthermore, instead of a scanning detector we use a heralded camera so that the image or diffraction pattern produced can be measured across the full field of view. The importance of a single mode detection in the observation of ghost diffraction is equivalent to the need within a classical diffraction experiment to illuminate the aperture with a spatially coherent mode.
Correlated-photon imaging, popularly known as ghost imaging, is a technique whereby an image is formed from light that has never interacted with the object. In ghost imaging experiments two correlated light fields are produced. One of these fields illuminates the object, and the other field is measured by a spatially resolving detector. In the quantum regime, these correlated light fields are produced by entangled photons created by spontaneous parametric down-conversion. To date, all correlated-photon ghost-imaging experiments have scanned a single-pixel detector through the field of view to obtain the spatial information. However, scanning leads to a poor sampling efficiency, which scales inversely with the number of pixels, N, in the image. In this work we overcome this limitation by using a time-gated camera to record the single-photon events across the full scene. We obtain high-contrast images, 90%, in either the image plane or the far-field of the photon pair source, taking advantage of the EPR-like correlations in position and momentum of the photon pairs. Our images contain a large number of modes, >500, creating opportunities in low-light-level imaging and in quantum information processing.
Entangled photons can be exploited for single-photon imaging: photons are accumulated one by one to form an image on a camera. To improve the signal-to-noise ratio, one can use “heralded imaging,” where camera data is only accepted if a partner (entangled) photon is detected in coincidence, at a second detector. A secondary consequence of the strong correlations between entangled photons is that we can place the object into the path of the second detector, and yet still create an image on the original camera, using only photons that never interacted with the viewed object. This configuration is called “ghost imaging.” To reduce cost, we designed and implemented a modified version, replacing the fast-gated camera with single-photon sensitivity with a single-pixel detector that scans the image plane. Our design had to carefully preserve optical alignment so that the detector is always pointing at the source of entangled photons. Our next step will be to use ghost diffraction to demonstrate that entangled phone pairs are correlated in ways that extend beyond what is allowed by classical physics.
Pairs of entangled photos are used to reconstruct an image in the application area known as quantum ghost imaging. It is the correlation between the photon pair that allows for the reconstruction of the image, as opposed to single photon detection. The entangled photons are spatially separated into two independent paths, one to illuminate the object and the other which is collected by a spatially resolving detector. Initially, ghost imaging experiments accomplished spatially resolving detectors by moving a single-pixel detector throughout a transverse scanning area. Advancements consisted of using ultra-sensitive cameras to avoid a system consisting of physically moving detectors. Ultra-sensitive cameras are, however, expensive and have limited spectral sensitivity. Here we demonstrate an alternative by utilising a spatial light modulator and a bucket detector to spatially resolve what is detected. Importantly, the masks displayed on the spatial light modulator must constitute a complete basis to acquire a completely reconstructed image. Historically, imaging speeds have been slow and inefficient due to the quadratic increase in the scanning capability for spatially resolved detectors and the low light levels associated with quantum experiments. Here we additionally utilise machine and deep learning algorithms to improve both image reconstruction time and resolution. We demonstrate this with a non-degenerate ghost imaging setup where the physical parameters such as the mask type and resolution are varied and controlled on a spatial light modulator. Thereby answering the question: can we image an object without using a camera?
Quantum ghost diffraction enables the measurement of the spatial diffraction pattern of an object without measuring the spatial distribution of the photons that actually interacted with the object [1]. It uses photon pairs generated e.g. by spontaneous parametric down conversion (SPDC) in a nonlinear optical crystal, and relies on the correlation of the generated signal and idler photons in their spatial and temporal degrees of freedom. This measurement scheme is sketched in Fig. 1 (a). After the source, the two photons are separated into two different paths. The object, here we consider a grating, is located only in the signal path and thus interacts only with the signal photons. To measure the diffraction pattern, two detectors of small cross sections are used in the signal and idler arms. The signal detector is usually at a fixed position, collecting photons that interacted with the object. The idler detector can have varying positions, allowing to spatially resolve the collected photons that never interacted with the object. Through measuring the two-photon coincidence counting rate p, there exists the potential for recovering the diffraction pattern of the object, which allows to retrieve the grating period.
One of the most surprising consequences of quantum mechanics is entanglement of two or more distance particles. The two-particle entangled state was mathematically formulated by Schrodinger. Based on this unusual quantum behavior, EPR defined their 'physical reality' and then asked the question: 'Can Quantum-Mechanical Description of Physical Reality Be Considered Complete?' One may not appreciate EPR's criterion of physical reality and insist that 'no elementary quantum phenomenon is a phenomenon until it is a recorded phenomenon'. Optical spontaneous parametric down conversion (SPDC) is the most effective mechanism to generate an EPR type entangled two-photon state. In SPDC, an optical beam, called the pump, is incident on a birefringent crystal. The pump is intense enough so that nonlinear effects lead to the conversion of pump photons into pairs of photons, historically called signal and idler. Technically, the SPDC is said to be type-1 or type-2, depending on whether the signal and idler beams have parallel or orthogonal polarization. The SPDC conversion efficiency is typically on the order of 10(exp -9) to 10(exp -11), depending on the SPDC nonlinear material. The signal and idler intensities are extremely low, only single photon detection devices can register them. The quantum entanglement nature of SPDC has been demonstrated in EPR-Bohm experiments and Bell's inequality measurements. The following two experiments were recently performed in our laboratory, which are more closely related to the original 1935 EPR gedankenezperiment. The first experiment is a two-photon optical imaging type experiment, which has been named 'ghost image' by the physics community. The signal and idler beams of SPDC are sent in different directions, so that the detection of the signal and idler photons can be performed by two distant photon counting detectors. An aperture object (mask) is placed in front of the signal photon detector and illuminated by the signal beam through a convex lens. Surprisingly, an image of this aperture is observed in the idler beam, by scanning the idler photon detector in the transverse plane of the idler beam, if we are sure that the idler photon detector 'catches' the 'twin brother' of the signal, which can be easily performed by a coincidence measurement. This effect is even more striking when we found that the object-lens-image relationship satisfies the Gaussian thin lens equation. The second experiment demonstrates two-photon 'ghost' interference-diffraction. The experimental set up is similar to the image experiment, except that rather than a lens and an aperture it is a Young's double-slit (or a single-slit) inserted into the path of the signal beam. We could not find any interference (or diffraction) pattern behind the slit. Surprisingly, an interference (or diffraction) pattern is observed when scanning the detector in the idler beam, if we are sure that the idler photon detector 'catches' the 'twin brother' of the signal.
Correlated photon imaging, popularly known as ghost imaging, is a technique whereby an image is formed from light that has never interacted with the object. In ghost imaging experiments, two correlated light fields are produced. One of these fields illuminates the object, and the other field is measured by a spatially resolving detector. In the quantum regime, these correlated light fields are produced by entangled photons created by spontaneous parametric down-conversion. To date, all correlated photon ghost imaging experiments have scanned a single-pixel detector through the field of view to obtain spatial information. However, scanning leads to poor sampling efficiency, which scales inversely with the number of pixels, N , in the image. In this work, we overcome this limitation by using a time-gated camera to record the single-photon events across the full scene. We obtain high-contrast images, 90%, in either the image plane or the far field of the photon pair source, taking advantage of the Einstein–Podolsky–Rosen-like correlations in position and momentum of the photon pairs. Our images contain a large number of modes, >500, creating opportunities in low-light-level imaging and in quantum information processing.