Entangled photons can be exploited for single-photon imaging: photons are accumulated one by one to form an image on a camera. To improve the signal-to-noise ratio, one can use “heralded imaging,” where camera data is only accepted if a partner (entangled) photon is detected in coincidence, at a second detector. A secondary consequence of the strong correlations between entangled photons is that we can place the object into the path of the second detector, and yet still create an image on the original camera, using only photons that never interacted with the viewed object. This configuration is called “ghost imaging.” To reduce cost, we designed and implemented a modified version, replacing the fast-gated camera with single-photon sensitivity with a single-pixel detector that scans the image plane. Our design had to carefully preserve optical alignment so that the detector is always pointing at the source of entangled photons. Our next step will be to use ghost diffraction to demonstrate that entangled phone pairs are correlated in ways that extend beyond what is allowed by classical physics.
Entangled photons can be exploited for single-photon imaging: photons are accumulated one by one to form an image on a camera. To improve the signal-to-noise ratio, one can use “heralded imaging,” where camera data is only accepted if a partner (entangled) photon is detected in coincidence, at a second detector. A secondary consequence of the strong correlations between entangled photons is that we can place the object into the path of the second detector, and yet still create an image on the original camera, using only photons that never interacted with the viewed object. This configuration is called “ghost imaging.” To reduce cost, we designed and implemented a modified version, replacing the fast-gated camera with single-photon sensitivity with a single-pixel detector that scans the image plane. Our design had to carefully preserve optical alignment so that the detector is always pointing at the source of entangled photons. Our next step will be to use ghost diffraction to demonstrate that entangled phone pairs are correlated in ways that extend beyond what is allowed by classical physics.
Correlated photon imaging, popularly known as ghost imaging, is a technique whereby an image is formed from light that has never interacted with the object. In ghost imaging experiments, two correlated light fields are produced. One of these fields illuminates the object, and the other field is measured by a spatially resolving detector. In the quantum regime, these correlated light fields are produced by entangled photons created by spontaneous parametric down-conversion. To date, all correlated photon ghost imaging experiments have scanned a single-pixel detector through the field of view to obtain spatial information. However, scanning leads to poor sampling efficiency, which scales inversely with the number of pixels, N , in the image. In this work, we overcome this limitation by using a time-gated camera to record the single-photon events across the full scene. We obtain high-contrast images, 90%, in either the image plane or the far field of the photon pair source, taking advantage of the Einstein–Podolsky–Rosen-like correlations in position and momentum of the photon pairs. Our images contain a large number of modes, >500, creating opportunities in low-light-level imaging and in quantum information processing.
Correlated-photon imaging, popularly known as ghost imaging, is a technique whereby an image is formed from light that has never interacted with the object. In ghost imaging experiments two correlated light fields are produced. One of these fields illuminates the object, and the other field is measured by a spatially resolving detector. In the quantum regime, these correlated light fields are produced by entangled photons created by spontaneous parametric down-conversion. To date, all correlated-photon ghost-imaging experiments have scanned a single-pixel detector through the field of view to obtain the spatial information. However, scanning leads to a poor sampling efficiency, which scales inversely with the number of pixels, N, in the image. In this work we overcome this limitation by using a time-gated camera to record the single-photon events across the full scene. We obtain high-contrast images, 90%, in either the image plane or the far-field of the photon pair source, taking advantage of the EPR-like correlations in position and momentum of the photon pairs. Our images contain a large number of modes, >500, creating opportunities in low-light-level imaging and in quantum information processing.
Pairs of entangled photos are used to reconstruct an image in the application area known as quantum ghost imaging. It is the correlation between the photon pair that allows for the reconstruction of the image, as opposed to single photon detection. The entangled photons are spatially separated into two independent paths, one to illuminate the object and the other which is collected by a spatially resolving detector. Initially, ghost imaging experiments accomplished spatially resolving detectors by moving a single-pixel detector throughout a transverse scanning area. Advancements consisted of using ultra-sensitive cameras to avoid a system consisting of physically moving detectors. Ultra-sensitive cameras are, however, expensive and have limited spectral sensitivity. Here we demonstrate an alternative by utilising a spatial light modulator and a bucket detector to spatially resolve what is detected. Importantly, the masks displayed on the spatial light modulator must constitute a complete basis to acquire a completely reconstructed image. Historically, imaging speeds have been slow and inefficient due to the quadratic increase in the scanning capability for spatially resolved detectors and the low light levels associated with quantum experiments. Here we additionally utilise machine and deep learning algorithms to improve both image reconstruction time and resolution. We demonstrate this with a non-degenerate ghost imaging setup where the physical parameters such as the mask type and resolution are varied and controlled on a spatial light modulator. Thereby answering the question: can we image an object without using a camera?
“Ghost” imaging is a process utilizing entangled photon pairs, by which an image is produced indirectly, using photons that have never interacted with the object being imaged. We can do this by taking advantage of correlations inherent in Spontaneous Parametric Down Conversion (SPDC), which is used to produce these entangled photon pairs. SPDC is a classically forbidden process in which a photon of a high frequency is converted into a pair of photons. The change in frequency makes this a nonlinear process. Processes like absorption, reflection, refraction, and polarization are linear processes. These can affect the properties of a light field but cannot change the frequency. SPDC allows us to produce a pair of correlated photons. By utilizing a coincidence-counter, we will be able to measure photon pairs from the source beam arriving within a narrow time interval. With this restriction, we can limit our attention to these correlated photons. One of these photons, which does interact with the object to be imaged, is used to turn on a “camera” detecting the other photon. It is the correlations between these photons that allow for ghost imaging, the reconstruction of the image of an object, even though the object never interacts directly with those single photons that are going to our camera.
In this work, pairs of entangled photons are aimed at two spatially separated detectors: the path to one detector contains a physical object, while the path to the second detector does not. Yet, the second detector can be used to create an image of the object, even though none of the photons arriving at that detector have ever interacted with the object! This “ghost” imaging takes advantage of information that is shared between entangled photon pairs. This work aims to explore the underlying principles in a ghost imaging system that utilizes spontaneous parametric down-conversion (SPDC) as the source of entangled photons, with the larger goal of understanding the principles and operation of key parts of the system.
Quantum Ghost Imaging (QGI) is a scheme using entangled pairs of photons (signal and idler) in order to perform imaging with both single photons and with only a single-element detector in the spectrum of interest. It utilises the temporal coincidence of the photons to identify associated pairs, while their spatial correlation allows to obtain image information from of the idler photon from the measurement of the signal photon. It is especially useful when using nondegenerate photon pairs, allowing to keep the signal photon in the silicon detection window, while the interacting wavelength can be freely chosen.However, current schemes are limited, as they rely on time-gating and heralding. Recent advances in single photon avalanche diodes (SPADs) allow the design of new single photon cameras, which can be outfitted with dedicated in-pixel timing circuitry. This allows to register single photons in both time and space. These detectors allowed us to design a new scheme for QGI, in which the coincidence is evaluated after the measurement. It also allows us to perform depth-resolved 3D imaging based on the time-of-flight of photons, first results of which are presented here.