Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Japanese Journal of Applied Physics

Ultra-Low Noise Photonic Local Oscillator at 100 GHz

Akitoshi Ueda, Takashi Noguchi, Shin’ichiro Asayama, Hiroyuki Iwashita, Yutaro Sekímoto, Masato Ishiguro, Hiroshi Itô, Tadao Nagatsuma, Akihiko Hirata, Bill Shillue

Published Jun 15, 2003• 13 citations
Publisher

Abstract

Noise at millimeter wavelengths from a photonic local oscillator (LO) is compared with that from a Gunn oscillator using a low-noise superconductor-insulator-superconductor (SIS) receiver. No significant additional noise is added to the receiver by the photonic LO in the frequency range of 96–110 GHz.
DOI
10.1143/jjap.42.l704

Related papers

Fabrication and Evaluation of Waveguide Josephson Array Oscillators at Millimeter-Wave Lengths for SIS Mixer-Based Amplifiers

Yosuke Murayama, Akira Kawakami, Wenlei Shan +5 more

In this study, a 150 GHz waveguide Josephson array oscillator was designed, fabricated, and evaluated as a local oscillator (LO) source for superconductor-insulator-superconductor (SIS) mixer-based amplifiers. These amplifiers aim to reduce the power consumption of microwave amplifiers used in large-scale multi-pixel heterodyne receivers for radio astronomy and superconducting quantum computers. We fabricated a Josephson array oscillator of 11 Nb/Al–AlOx/Nb Josephson junctions with Cu shunt resistors, each of which is placed on the center of a half-wavelength microstrip line resonator. When the LO signal from the oscillator was introduced into the balanced SIS mixers via a waveguide, the oscillator successfully pumped four SIS mixers simultaneously, delivering a total estimated LO power of 0.22 µW at 146.7 GHz. The SIS mixers operated without a millimeter-wave isolator at an LO noise temperature of 4–6 K. These results indicate the Josephson array oscillator's potential as an LO source for SIS mixer-based amplifiers.

IEEE Transactions on Applied Superconductivity•Dec 12, 2024•3 citations

A Photonic Local Oscillator for an SIS Mixer in the 100 GHz Band

Takashi Noguchi, Akitoshi Ueda, Hiroyuki Iwashita +5 more

We have developed a waveguide-mounted photomixer in the 75-115 GHz band with a uni-traveling carrier photodiode which is optically-pumped by two 1.55-gm lasers. We have suc-cessfully demonstrated to produce an output power of,2 rnW at 100 GHz with an input laser power of-400 mW. An SIS mixer has been pumped by the photomixer as a local oscillator. It is found that in this configuration the photomixer can provide a sufficient local oscillator power required for optimum operation of the SIS mixer in the frequency band from 85 to 110 GHz. We have carried out similar experiment using a Gunn-diode local oscillator source and carefully compared the receiver noise temperature of the SIS mixer with those pumped by the photomixer. It is found that the receiver noise temperatures of the SIS mixer pumped by the photomixer is a little higher than those pumped by the Gunn oscillator.

Softwaretechnik-Trends•Mar 1, 2002•2 citations

Local oscillator noise suppression by a balanced SIS mixer in the 0.9 THz band

Takafumi Kojima, Y. Fujii, Shin’ichiro Asayama +1 more

Local oscillator (LO) sideband noise suppression by a balanced superconductor-insulator-superconductor (SIS) mixer was investigated in the 0.9 THz band. An LO signal in the 0.9 THz band was generated by using fixed tuned x9 (x3 by x3) multipliers located in the cryostat 4-K stage. Despite the huge LO noise of about 1000 K of a YIG driven LO, the measured receiver noise temperature for YIG and Gunn driven LOs was similar because of the high LO sideband noise rejection ratio (LNR) of the balanced mixer.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Sep 1, 2013•0 citations

Low-noise integrated balanced SIS mixer for 787–950 GHz

Yasunori Fujii, Takafumi Kojima, Álvaro González +5 more

Abstract We developed a low-noise, compact, balanced superconductor–insulator–superconductor (SIS) mixer, operating in the 787–950 GHz radio frequency range. A waveguide mixer block was designed to integrate all the key components, such as a radio frequency (RF) 90° hybrid coupler, two identical SIS mixer chips, bias-tees, and an intermediate frequency power-combiner. The RF waveguide 90° hybrid coupler consists of branch lines with wide slots optimized by numerical simulation, for ease of fabrication. The balanced mixer was installed into a cartridge type receiver, originally developed for the Atacama Large Millimeter/submillimeter Array Band 10 (787–950 GHz). The receiver demonstrated double sideband noise temperatures of approximately 200 K for most of the band, without any correction for loss in front of the receiver. The local oscillator noise rejection ratio was estimated to be more than 15 dB within the measured frequency range.

Superconductor Science and Technology•Nov 30, 2016•13 citations

Characterization of a low-noise superconductor–insulator–superconductor-based microwave amplifier with local oscillator phase-adjusting architecture

Takafumi Kojima, Sho Masui, Wenlei Shan +1 more

This paper describes a low-noise microwave amplifier based on up- and down-frequency-conversion processes in quasiparticle superconductor–insulator–superconductor (SIS) tunnel junctions. The SIS amplifier was configured with two SIS frequency-converter modules and a cryogenic millimeter-wave isolator inserted between them. Moreover, a local oscillator (LO) using millimeter-wave attenuators and a phase shifter was considered. This setup allowed the control of individual LO power and differential phase in these SIS frequency converters to optimize the amplifier performance. The SIS amplifier showed noise temperatures as low as 11 K and a 6–8 dB gain from nearly DC to 5 GHz. The attained microwave performance is promising for obtaining large-format arrays, such as multibeam heterodyne receivers. Moreover, this two-frequency-converter concept based on SIS junctions might enable microwave applications, such as wideband non-reciprocal circuits in isolators, gyrators, and circulators, which are essential devices in the quantum computing and radio astronomy fields.

Applied Physics Letters•Feb 13, 2023•9 citations

A Low-noise Balanced SIS Mixer for the 790-950 GHz Band

Takafumi Kojima, Yasunori FUJII, Yoshinori Uzawa

We have developed a low-noise balanced superconductor-insulator-superconductor (SIS) mixer using a waveguide 3-dB 90-degree hybrid coupler over the radio frequency (RF) range of 790-950 GHz and intermediate frequency range of 4-12 GHz at an operating temperature of 4 K. The RF coupler was carefully designed in regards to machining errors so that the entire amplitude imbalance including the mixer gain became smaller. The fabricated coupler was characterized at both room and cryogenic temperature. The receiver noise temperature of the balanced SIS mixer was below 350 K over the entire frequency band and the local oscillator (LO) noise rejection ratio was estimated to be more than 15 dB. This result is equivalent to state-ofthe-art mixer performance at this frequency range.

TEION KOGAKU (Journal of Cryogenics and Superconductivity Society of Japan)•Jan 1, 2014•2 citations
In this study, a 150 GHz waveguide Josephson array oscillator was designed, fabricated, and evaluated as a local oscillator (LO) source for superconductor-insulator-superconductor (SIS) mixer-based amplifiers. These amplifiers aim to reduce the power consumption of microwave amplifiers used in large-scale multi-pixel heterodyne receivers for radio astronomy and superconducting quantum computers. We fabricated a Josephson array oscillator of 11 Nb/Al–AlOx/Nb Josephson junctions with Cu shunt resistors, each of which is placed on the center of a half-wavelength microstrip line resonator. When the LO signal from the oscillator was introduced into the balanced SIS mixers via a waveguide, the oscillator successfully pumped four SIS mixers simultaneously, delivering a total estimated LO power of 0.22 µW at 146.7 GHz. The SIS mixers operated without a millimeter-wave isolator at an LO noise temperature of 4–6 K. These results indicate the Josephson array oscillator's potential as an LO source for SIS mixer-based amplifiers.
We have developed a waveguide-mounted photomixer in the 75-115 GHz band with a uni-traveling carrier photodiode which is optically-pumped by two 1.55-gm lasers. We have suc-cessfully demonstrated to produce an output power of,2 rnW at 100 GHz with an input laser power of-400 mW. An SIS mixer has been pumped by the photomixer as a local oscillator. It is found that in this configuration the photomixer can provide a sufficient local oscillator power required for optimum operation of the SIS mixer in the frequency band from 85 to 110 GHz. We have carried out similar experiment using a Gunn-diode local oscillator source and carefully compared the receiver noise temperature of the SIS mixer with those pumped by the photomixer. It is found that the receiver noise temperatures of the SIS mixer pumped by the photomixer is a little higher than those pumped by the Gunn oscillator.
Local oscillator (LO) sideband noise suppression by a balanced superconductor-insulator-superconductor (SIS) mixer was investigated in the 0.9 THz band. An LO signal in the 0.9 THz band was generated by using fixed tuned x9 (x3 by x3) multipliers located in the cryostat 4-K stage. Despite the huge LO noise of about 1000 K of a YIG driven LO, the measured receiver noise temperature for YIG and Gunn driven LOs was similar because of the high LO sideband noise rejection ratio (LNR) of the balanced mixer.
Abstract We developed a low-noise, compact, balanced superconductor–insulator–superconductor (SIS) mixer, operating in the 787–950 GHz radio frequency range. A waveguide mixer block was designed to integrate all the key components, such as a radio frequency (RF) 90° hybrid coupler, two identical SIS mixer chips, bias-tees, and an intermediate frequency power-combiner. The RF waveguide 90° hybrid coupler consists of branch lines with wide slots optimized by numerical simulation, for ease of fabrication. The balanced mixer was installed into a cartridge type receiver, originally developed for the Atacama Large Millimeter/submillimeter Array Band 10 (787–950 GHz). The receiver demonstrated double sideband noise temperatures of approximately 200 K for most of the band, without any correction for loss in front of the receiver. The local oscillator noise rejection ratio was estimated to be more than 15 dB within the measured frequency range.
This paper describes a low-noise microwave amplifier based on up- and down-frequency-conversion processes in quasiparticle superconductor–insulator–superconductor (SIS) tunnel junctions. The SIS amplifier was configured with two SIS frequency-converter modules and a cryogenic millimeter-wave isolator inserted between them. Moreover, a local oscillator (LO) using millimeter-wave attenuators and a phase shifter was considered. This setup allowed the control of individual LO power and differential phase in these SIS frequency converters to optimize the amplifier performance. The SIS amplifier showed noise temperatures as low as 11 K and a 6–8 dB gain from nearly DC to 5 GHz. The attained microwave performance is promising for obtaining large-format arrays, such as multibeam heterodyne receivers. Moreover, this two-frequency-converter concept based on SIS junctions might enable microwave applications, such as wideband non-reciprocal circuits in isolators, gyrators, and circulators, which are essential devices in the quantum computing and radio astronomy fields.
We have developed a low-noise balanced superconductor-insulator-superconductor (SIS) mixer using a waveguide 3-dB 90-degree hybrid coupler over the radio frequency (RF) range of 790-950 GHz and intermediate frequency range of 4-12 GHz at an operating temperature of 4 K. The RF coupler was carefully designed in regards to machining errors so that the entire amplitude imbalance including the mixer gain became smaller. The fabricated coupler was characterized at both room and cryogenic temperature. The receiver noise temperature of the balanced SIS mixer was below 350 K over the entire frequency band and the local oscillator (LO) noise rejection ratio was estimated to be more than 15 dB. This result is equivalent to state-ofthe-art mixer performance at this frequency range.