Orthogonal optical detection and excitation of quantum dots embedded in a microcavity allows, for the first time, for background-free measurement of their resonance fluorescence. The spectra and photon statistics of single dots were obtained.
The ability to perform simultaneous resonant excitation and fluorescence detection is important for quantum optical measurements of quantum dots (QDs). Resonant excitation without fluorescence detection – for example, a differential transmission measurement – can determine some properties of the emitting system, but does not allow applications or measurements based on the emitted photons. For example, the measurement of photon correlations, observation of the Mollow triplet, and realization of single photon sources all require collection of the fluorescence. Incoherent excitation with fluorescence detection – for example, above band-gap excitation – can be used to create single photon sources, but the disturbance of the environment due to the excitation reduces the indistinguishability of the photons. Single photon sources based on QDs will have to be resonantly excited to have high photon indistinguishability, and simultaneous collection of the photons will be necessary to make use of them. We demonstrate a method to resonantly excite a single QD embedded in a planar cavity by coupling the excitation beam into this cavity from the cleaved face of the sample while collecting the fluorescence along the sample's surface normal direction. By carefully matching the excitation beam to the waveguide mode of the cavity, the excitation light can couple into the cavity and interact with the QD. The scattered photons can couple to the Fabry-Perot mode of the cavity and escape in the surface normal direction. This method allows complete freedom in the detection polarization, but the excitation polarization is restricted by the propagation direction of the excitation beam. The fluorescence from the wetting layer provides a guide to align the collection path with respect to the excitation beam. The orthogonality of the excitation and detection modes enables resonant excitation of a single QD with negligible laser scattering background.
The ability to perform simultaneous resonant excitation and fluorescence detection is important for quantum optical measurements of quantum dots (QDs). Resonant excitation without fluorescence detection - for example, a differential transmission measurement - can determine some properties of the emitting system, but does not allow applications or measurements based on the emitted photons. For example, the measurement of photon correlations, observation of the Mollow triplet, and realization of single photon sources all require collection of the fluorescence. Incoherent excitation with fluorescence detection - for example, above band-gap excitation - can be used to create single photon sources, but the disturbance of the environment due to the excitation reduces the indistinguishability of the photons. Single photon sources based on QDs will have to be resonantly excited to have high photon indistinguishability, and simultaneous collection of the photons will be necessary to make use of them. We demonstrate a method to resonantly excite a single QD embedded in a planar cavity by coupling the excitation beam into this cavity from the cleaved face of the sample while collecting the fluorescence along the sample's surface normal direction. By carefully matching the excitation beam to the waveguide mode of the cavity, the excitation light can couple into the cavity and interact with the QD. The scattered photons can couple to the Fabry-Perot mode of the cavity and escape in the surface normal direction. This method allows complete freedom in the detection polarization, but the excitation polarization is restricted by the propagation direction of the excitation beam. The fluorescence from the wetting layer provides a guide to align the collection path with respect to the excitation beam. The orthogonality of the excitation and detection modes enables resonant excitation of a single QD with negligible laser scattering background.
Single semiconductor quantum dots, which are considered as two-level systems in the artificial atom model, are promising structures for the realization of integrated devices such as single photon sources for quantum information applications. However, contrary to genuine atoms, they are condensed matter systems which suffer from the coupling to their solid environment, leading to a degradation of the coherence of the emitted photons. One possibility to avoid this coupling, thereby improving the coherence of the photons until the one imposed by the radiative limit T2 = 2T1, is to perform strictly resonant excitation of a quantum dot at low temperature. Using an experimental setup that spatially decouples the excitation and detection paths, we showed that a fine control of the electrostatic environment related to the nanostructures residual doping remains a major challenge to answer the widely encountered problem of the inhibition of the resonance fluorescence of a quantum dot. Meanwhile, thanks to quantum optics experiments and high resolution optical spectroscopy, we demonstrated that the resonant Rayleigh scattering regime where quantum dots emit single photons with the laser coherence time, paves the way to the development of "ultra-coherent" sources of single photons with high degrees of indistinguishability. In this regime where the laser tailors the coherence of the photons and where the radiative limit becomes a secondary requirement, two photons emitted successively by the same quantum dot are indistinguishable on time scales never obtained before for a solid nano-emitter (up to ten nanoseconds, comparing to the carriers lifetime and decoherence time of about a hundred of picoseconds).
Introduction Quantum optics provides a complete description of the resonant interaction of light and a material system. The light scattered as a result of this interaction – the resonance fluorescence – provides a means to monitor and affect the material system's dynamics and also allows for the generation of nonclassical states of the electromagnetic field. Initial theoretical studies characterizing resonance fluorescence addressed fundamental questions regarding the necessity of quantizing the electromagnetic field. This is a particularly illustrative period in optical physics where multiple theories existed that might describe resonance fluorescence – semi-classical optical Bloch equations [1, 2] or quantum electrodynamics [4, 3] – and experimental evidence was necessary to identify the appropriate theoretical framework. Indeed, experiments in 1974 and 1977 investigating the resonance fluorescence lineshape [5, 6] and the photon statistics of the scattered light [7] vindicated the full quantum electrodynamical description of light-matter interaction over other models. In the subsequent 30 years, resonance fluorescence has been used as a high-resolution spectroscopic probe of a variety of physical systems, as a means to investigate quantum coherence in atomic gases and, with the current interest in quantum information science (QIS), as a tool for quantum-state preparation, measurement and control in trapped ions [8]. During this same time period, advances in material science have ushered in an era where it is possible to grow and fabricate solid-state devices at length scales commensurate with the quantum confinement of electrons and holes. It is only recently that resonance fluorescence has been observed from the prototypical artificial nanostructure exhibiting three-dimensional quantum confinement – a single semiconductor quantum dot (QD) [9].
Semiconductor nanostructures such as quantum dots (QDs) have offered unique opportunities to investigate quantum optical effects in solid-state systems. These include quantum interference, Rabi oscillations, as well as photon antibunching, and were previously observable only in isolated atoms or ions. In addition, QDs can be integrated into optical microcavities, making them attractive for applications in quantum information processing and high efficiency quantum light sources. Despite much progress towards these goals, one area that was little explored is coherent control of such solid-state quantum emitters in cavities. The main technical hurdle lies in overcoming the laser background scattering. By using a sample structure in which QDs are embedded in a planar Fabry-Perot cavity and by using an orthogonal excitation geometry, we have achieved a nearly complete elimination of laser background scattering. This in turn allows us to show resonantly controlled light emission of quantum dots in the cavity including (a) Rabi flopping using pulse control, (b) direct observation of Mollow triplets in the frequency domain, and (c) simultaneously measured first-order and second order photon-photon correlations.