The ability to perform simultaneous resonant excitation and fluorescence detection is important for quantum optical measurements of quantum dots (QDs). Resonant excitation without fluorescence detection - for example, a differential transmission measurement - can determine some properties of the emitting system, but does not allow applications or measurements based on the emitted photons. For example, the measurement of photon correlations, observation of the Mollow triplet, and realization of single photon sources all require collection of the fluorescence. Incoherent excitation with fluorescence detection - for example, above band-gap excitation - can be used to create single photon sources, but the disturbance of the environment due to the excitation reduces the indistinguishability of the photons. Single photon sources based on QDs will have to be resonantly excited to have high photon indistinguishability, and simultaneous collection of the photons will be necessary to make use of them. We demonstrate a method to resonantly excite a single QD embedded in a planar cavity by coupling the excitation beam into this cavity from the cleaved face of the sample while collecting the fluorescence along the sample's surface normal direction. By carefully matching the excitation beam to the waveguide mode of the cavity, the excitation light can couple into the cavity and interact with the QD. The scattered photons can couple to the Fabry-Perot mode of the cavity and escape in the surface normal direction. This method allows complete freedom in the detection polarization, but the excitation polarization is restricted by the propagation direction of the excitation beam. The fluorescence from the wetting layer provides a guide to align the collection path with respect to the excitation beam. The orthogonality of the excitation and detection modes enables resonant excitation of a single QD with negligible laser scattering background.
The ability to perform simultaneous resonant excitation and fluorescence detection is important for quantum optical measurements of quantum dots (QDs). Resonant excitation without fluorescence detection - for example, a differential transmission measurement - can determine some properties of the emitting system, but does not allow applications or measurements based on the emitted photons. For example, the measurement of photon correlations, observation of the Mollow triplet, and realization of single photon sources all require collection of the fluorescence. Incoherent excitation with fluorescence detection - for example, above band-gap excitation - can be used to create single photon sources, but the disturbance of the environment due to the excitation reduces the indistinguishability of the photons. Single photon sources based on QDs will have to be resonantly excited to have high photon indistinguishability, and simultaneous collection of the photons will be necessary to make use of them. We demonstrate a method to resonantly excite a single QD embedded in a planar cavity by coupling the excitation beam into this cavity from the cleaved face of the sample while collecting the fluorescence along the sample's surface normal direction. By carefully matching the excitation beam to the waveguide mode of the cavity, the excitation light can couple into the cavity and interact with the QD. The scattered photons can couple to the Fabry-Perot mode of the cavity and escape in the surface normal direction. This method allows complete freedom in the detection polarization, but the excitation polarization is restricted by the propagation direction of the excitation beam. The fluorescence from the wetting layer provides a guide to align the collection path with respect to the excitation beam. The orthogonality of the excitation and detection modes enables resonant excitation of a single QD with negligible laser scattering background.
The ability to perform simultaneous resonant excitation and fluorescence detection is important for quantum optical measurements of quantum dots (QDs). Resonant excitation without fluorescence detection – for example, a differential transmission measurement – can determine some properties of the emitting system, but does not allow applications or measurements based on the emitted photons. For example, the measurement of photon correlations, observation of the Mollow triplet, and realization of single photon sources all require collection of the fluorescence. Incoherent excitation with fluorescence detection – for example, above band-gap excitation – can be used to create single photon sources, but the disturbance of the environment due to the excitation reduces the indistinguishability of the photons. Single photon sources based on QDs will have to be resonantly excited to have high photon indistinguishability, and simultaneous collection of the photons will be necessary to make use of them. We demonstrate a method to resonantly excite a single QD embedded in a planar cavity by coupling the excitation beam into this cavity from the cleaved face of the sample while collecting the fluorescence along the sample's surface normal direction. By carefully matching the excitation beam to the waveguide mode of the cavity, the excitation light can couple into the cavity and interact with the QD. The scattered photons can couple to the Fabry-Perot mode of the cavity and escape in the surface normal direction. This method allows complete freedom in the detection polarization, but the excitation polarization is restricted by the propagation direction of the excitation beam. The fluorescence from the wetting layer provides a guide to align the collection path with respect to the excitation beam. The orthogonality of the excitation and detection modes enables resonant excitation of a single QD with negligible laser scattering background.
Semiconductor quantum dots (QDs) are commonly considered as artificial atoms due to the 3D confinement of the electrons. These nanostructures are very promising for the realization of integrated devices such as single photon sources for quantum cryptography applications [1,2]. However, contrarily to genuine atoms, QDs are condensed matter systems and they consequently suffer from the coupling to their environment [3] which degrades the quality of the emitted photons in view of quantum cryptography applications. One way to circumvent this coupling is to excite strictly resonantly the QD at low temperature [4-10]. This difficult task has been achieved by designing an original excitation scheme to spatially decouple the excitation and detection paths. We first report that experimental studies of the resonant emission (RE) of single QDs can be strongly limited, even impossible, since most of the QDs show a very strong quenching of the RE of the fundamental transition. This issue is a broadly met experimental situation which is highly problematic for cavity quantum electrodynamics experiments in single QDs. We propose an efficient way to overcome this issue based on the use of an ultra-weak non-resonant laser that optically gates the QD RE [8] which controls the residual doping inherent to the QDs fabrication. It induces a complete recovery of the properties of an artificial atom, and the single QDs behave as quasi-ideal two-level systems. Up to now [7,9], the measurements on the QDs RE reported in the literature mainly focus on the incoherent fluorescence signal for achieving efficient single photon emission. In this regime, the spectrum linewidth is always limited to the radiative limit. We present experimental studies on the coherent laser light scattering by a single QD [7]. Besides the antibunching effect showing the non-classical nature of the emitted light, we observe that the QD emission spectrum is determined by the spectrum of the resonant excitation laser. By reducing the resonant excitation power, the so-called Mollow triplet shrinks to a single narrow Lorentzian line, while the relative intensity of this narrow peak increases and tends to overwhelm the RE spectrum. This implies that single QDs can produce single photons with a coherence time that is not limited anymore by the QD electronic properties, resulting in what we name an " ultra-coherent " character [7]. In conclusion, the resulting ultra-coherent single photon source promises high degrees of indistinguishability of the emitted photons which is a crucial requirement for quantum information applications. References [1] P. Michler et al., Science 290 (2000). [6] S. Ates et al., PRL 103 (2009). [2] C. Santori et al., Nature 419 (2002). [7] H. S. Nguyen et al., APL 99 (2011). [3] A. Berthelot et al., Nat. Phys. 2 (2006). [8] H. S. Nguyen et al., PRL 108 (2012). [4] A. Muller et al., PRL 99 (2007). [9] C. Matthiesen et al., PRL 1082 (2012). [5] R. Melet et al., PRB 78 (2008). [10] A. Reinhard et al., Nat. Phot. 6 (2012).
Combining resonant excitation with Purcell-enhanced single quantum dots (QDs) stands out as a prominent strategy for realizing high-performance solid-state single-photon sources. However, optimizing photon extraction efficiency requires addressing the challenge of effectively separating the excitation laser from the QDs’ emission. Traditionally, this involves polarization filtering, limiting the achievable polarization directions and the scalability of polarized photonic states. In this study, we have successfully tackled this challenge by employing spatially orthogonal resonant excitation of QDs, deterministically coupled to monolithic Fabry–Perot microcavities. Leveraging the planar microcavity structure, we have achieved spectral filter-free single-photon resonant fluorescence. The resulting source produces single photons with a high extraction efficiency of 0.87 and an indistinguishability of 0.963(4).
Single photon emission is one of the most striking optical properties of semiconductor quantum dots (QDs), and the corresponding photon anti-bunching effect was observed by non-resonant and resonant photoluminescence experiments in single QDs [1,2,3,4]. Other experiments demonstrated the possibility to use single QDs for the generation of indistinguishable single photons [3]. An important general issue is to reach the so-called fundamental radiative limit. Several strategies have been followed in that sense such as the shortening of population lifetime induced by the Purcell effect [5] or the reduction of pure dephasing by resonant excitation [2,3,4]. Up to now, all the measurements reported in the literature focus on the incoherent photoluminescence signal for achieving single photon emission. In this regime, the linewidth of the photoluminescence spectrum is always limited to the radiative limit. In this paper, we report on the resonant emission (RE) of the exciton in single InAs/GaAs QDs embedded in a planar microcavity, in an orthogonal excitation-detection geometry [4]. We present an original type of single photon source based on the coherent laser light scattering by a single QD [6]. Besides the antibunching effect showing the non-classical nature of the emitted light, we observe that the QD emission spectrum is determined by the spectrum of the resonant excitation laser. We present high-resolution measurements by Fourier transform spectroscopy of the RE where the data are fitted to the first-order correlation function g(1)(τ) of the RE of a two-level system. The inverse Fourier transform of the g(1)(τ) function allows a direct comparison of the different RE emission profiles. We show that, by reducing the resonant excitation power, the so-called Mollow triplet shrinks to a single narrow Lorentzian line, while the relative intensity of this narrow peak increases and tends to overwhelm the RE spectrum. This implies that single QDs can produce single photons with a coherence time that is not limited anymore by the QD electronic properties, resulting in an ultra-coherent character [6]. In conclusion, the resulting " ultra-coherent single photon source " promises high degrees of indistinguishability of the emitted photons which is a crucial requirement for quantum information applications. [1] P. Michler et al., Science 290, 2282 (2000). [2] A. Muller et al., Phys. Rev. Lett. 99, 187402 (2007). [3] S. Ates et al., Phys. Rev. Lett. 103, 167402 (2009). [4] H. S. Nguyen et al., Phys. Rev. Lett. 108, 057401 (2012). [5] C. Santori et al., Nature 419, 594 (2002). [6] H. S. Nguyen et al., Appl. Phys. Lett. 99, 261904 (2011).
Combining resonant excitation with Purcell-enhanced single quantum dots (QDs) stands out as a prominent strategy for realizing high performance solid-state single photon sources. However, optimizing photon efficiency requires addressing challenges associated with effectively separating the excitation laser from QDs' emission. Traditionally, this involves polarization filtering, which limits the achievable polarization directions and the scalability of photonic states. In this study, we have successfully tackled this challenge by employing spatially-orthogonal resonant excitation of QDs, deterministically coupled to monolithic Fabry-Perot microcavities. Leveraging the membrane cavity structures, we have achieved filter-free single photon resonant fluorescence. The resulting source produces single photons with a simultaneous high extraction efficiency of 0.87, purity of 0.9045(4), and indistinguishability of 0.963(4).