Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Japanese Journal of Applied Physics

Squeezed Light Generation with 1.064 µm Nd:YAG Laser and 0.85 µm Single-Mode Fiber

Norihiko Nishizawa, Satoshi Kume Satoshi Kume, Masakazu Mori, Toshio Goto, Akira Miyauchi

Published Jan 1, 1994• 18 citations
Publisher

Abstract

Efficient squeezing at low pump light power is demonstrated with a mode-locked 1.064 µm Nd:YAG laser and a fiber ring reflector made of 0.85 µm single-mode fiber. Noise reduction of about 2.0 dB below the shot noise level is observed. The squeezing process by the optical Kerr effect is calculated with a simple model. The experimental results are in good agreement with the calculated ones.

DOI
10.1143/jjap.33.138

Related papers

Quadrature-squeezed light generation with a fiber ring reflector

Masakazu Mori, Norihiko Nishizawa, Toshio Goto

Hie generation and detection of quadrature squeezed states of light with a fiber ring reflector is reviewed. A 0.85µm polarization maintaining (PM) fiber is used as the nonlinear medium, and it is pumped by a 1.064µm mode-locked Nd:YAG laser. By the optical Kerr effect in the PM fiber, the input 1.064 mm light is squeezed. The combination of the smaller core diameter and the shorter source wavelength is effective in obtaining a higher peak power density, and consequently, a larger squeezing parameter at a low pump power. The squeezed vacuum is generated by combining the 50m long PM fiber ring with a 1:1 PM fiber coupler, and is detected by a balanced homodyne detector. The squeezed light noise is measured at 200kHz, and a squeezing parameter of 3.7dB is obtained at the input peak power of 5W. A simple calculation model based on the wave optics is used to estimate the squeezing parameter as a function of the input peak power. The calculated results agree well with the experimental ones. The squeezing in PM fibers is limited by the polarized guided acoustic wave Brillouin scattering (GAWBS), which is the phase noise originated from thermally induced fluctuations in the refractive index of the fiber. To avoid the noise due to GAWBS, a shorter PM fiber is preferable.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jan 2, 1998•0 citations

Generation and Detection of Squeezed Light with Phase Tunable Fiber Loop Mirror using Polarization Beam Splitter

Norihiko Nishizawa, Masaki Hashiura Masaki Hashiura, Takeo Horio Takeo Horio +3 more

Squeezed light generation is demonstrated using a new scheme of nonlinear fiber loop mirror. The squeezed light can be generated stably in a compact setup and the phase difference can be changed arbitrarily. Using a 100 ps mode-locked pulse laser at 1.064 µm and 0.85 µm single-mode fiber, the quantum noise reduction of 2.0 dB below the shot noise level is observed in the frequency range of 25–35 MHz. Accounting for the detection efficiency, this corresponds to 2.9 dB squeezing.

Japanese Journal of Applied Physics•Jul 1, 1998•5 citations

Squeezed optical solitons

M. Rosenbluh, Robert M. Shelby

We have experimentally demonstrated the squeezing of optical solitons, resulting in a detected photocurrent noise power (32\ifmmode\pm\else\textpm\fi{}3)% (1.7 dB) below the shot-noise limit over a broadband of frequencies. The squeezing is accomplished using the Kerr nonlinearity of a polarization-preserving single-mode optical fiber at liquid-nitrogen temperature. Squeezed solitons, 1.1 dB below the shot-noise limit, were observed at room temperature.

Physical Review Letters•Jan 14, 1991•298 citations

Generation of strongly squeezed continuous-wave light at 1064 nm

Klaus Schneider, M. Lang, J. Mlynek +1 more

A compact and effcient source of amplitude-squeezed light is described. It employs a semi-monolithic degenerate MgO:LiNbO(3) optical parametric amplifier pumped by a frequency-doubled Nd:YAG laser at 532 nm. Injection-seeding of the amplifier by a 1064 nm wave permits active stabilization of the cavity length and stable operation. At a pump power of 380 mW, a maximum noise reduction of 6.5 dB in the amplitude fluctuations of the 0.2 mW 1064 nm wave was detected. The average detected noise reduction in continuous operation over 14 minutes was 6.2 dB. Taking the detection effciency into account, this corresponds to a squeezing of 7.2 dB in the emitted wave.

Optics Express•Feb 2, 1998•71 citations

Experiments with Lasers and Frequency Doublers

Hans‐A. Bachor, Matthew S. Taubman, Andrew G. White +2 more

Solid state laser sources, such as diode-pumped Nd:YAG lasers, have given us CW laser light of high power with unprecedented stability and low noise performance. In these lasers most of the technical sources of noise can be eliminated allowing them to be operated close to the theoretical noise limit set by the quantum properties of light. The next step of reducing the noise below the standard limit is known as squeezing. We present experimental progress in generating reliably squeezed light using the process of frequency doubling. We emphasize the long term stability that makes this a truly practical source of squeezed light. Our experimental results match noise spectra calculated with our recently developed models of coupled systems which include the noise generated inside the laser and its interaction with the frequency doubler. We conclude with some observations on evaluating quadrature squeezed states of light.

•Jan 1, 1996•0 citations

Squeezed pulsed light from a fiber ring interferometer

K. Bergman, H. A. Haus

Observation of squeezed noise, 5 +/- 0.3 dB below the shot noise level, generated with pulses in a fiber ring interferometer is reported. The interferometric geometry is used to separate the pump pulse from the squeezed vacuum radiation. A portion of the pump is reused as the local oscillator in a homodyne detection. The pump fluctuations are successfully subtracted and shot noise limited performance is achieved at low frequencies (35-85 KHz). A possible utilization of the generated squeezed vacuum in improving a fiber gyro's signal to noise ratio is discussed.

•Feb 1, 1992•1 citation
Efficient squeezing at low pump light power is demonstrated with a mode-locked 1.064 µm Nd:YAG laser and a fiber ring reflector made of 0.85 µm single-mode fiber. Noise reduction of about 2.0 dB below the shot noise level is observed. The squeezing process by the optical Kerr effect is calculated with a simple model. The experimental results are in good agreement with the calculated ones.
Hie generation and detection of quadrature squeezed states of light with a fiber ring reflector is reviewed. A 0.85µm polarization maintaining (PM) fiber is used as the nonlinear medium, and it is pumped by a 1.064µm mode-locked Nd:YAG laser. By the optical Kerr effect in the PM fiber, the input 1.064 mm light is squeezed. The combination of the smaller core diameter and the shorter source wavelength is effective in obtaining a higher peak power density, and consequently, a larger squeezing parameter at a low pump power. The squeezed vacuum is generated by combining the 50m long PM fiber ring with a 1:1 PM fiber coupler, and is detected by a balanced homodyne detector. The squeezed light noise is measured at 200kHz, and a squeezing parameter of 3.7dB is obtained at the input peak power of 5W. A simple calculation model based on the wave optics is used to estimate the squeezing parameter as a function of the input peak power. The calculated results agree well with the experimental ones. The squeezing in PM fibers is limited by the polarized guided acoustic wave Brillouin scattering (GAWBS), which is the phase noise originated from thermally induced fluctuations in the refractive index of the fiber. To avoid the noise due to GAWBS, a shorter PM fiber is preferable.
A compact and effcient source of amplitude-squeezed light is described. It employs a semi-monolithic degenerate MgO:LiNbO(3) optical parametric amplifier pumped by a frequency-doubled Nd:YAG laser at 532 nm. Injection-seeding of the amplifier by a 1064 nm wave permits active stabilization of the cavity length and stable operation. At a pump power of 380 mW, a maximum noise reduction of 6.5 dB in the amplitude fluctuations of the 0.2 mW 1064 nm wave was detected. The average detected noise reduction in continuous operation over 14 minutes was 6.2 dB. Taking the detection effciency into account, this corresponds to a squeezing of 7.2 dB in the emitted wave.
Solid state laser sources, such as diode-pumped Nd:YAG lasers, have given us CW laser light of high power with unprecedented stability and low noise performance. In these lasers most of the technical sources of noise can be eliminated allowing them to be operated close to the theoretical noise limit set by the quantum properties of light. The next step of reducing the noise below the standard limit is known as squeezing. We present experimental progress in generating reliably squeezed light using the process of frequency doubling. We emphasize the long term stability that makes this a truly practical source of squeezed light. Our experimental results match noise spectra calculated with our recently developed models of coupled systems which include the noise generated inside the laser and its interaction with the frequency doubler. We conclude with some observations on evaluating quadrature squeezed states of light.
Observation of squeezed noise, 5 +/- 0.3 dB below the shot noise level, generated with pulses in a fiber ring interferometer is reported. The interferometric geometry is used to separate the pump pulse from the squeezed vacuum radiation. A portion of the pump is reused as the local oscillator in a homodyne detection. The pump fluctuations are successfully subtracted and shot noise limited performance is achieved at low frequencies (35-85 KHz). A possible utilization of the generated squeezed vacuum in improving a fiber gyro's signal to noise ratio is discussed.