Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Communications

Quantum noise in optical beam propagation in distributed amplifiers

Min Kim, Nobuyuki Imoto, Kyuman Cho, Myung Shik Kim

Published Oct 1, 1996• 7 citations
Publisher
DOI
10.1016/0030-4018(96)00248-9

Related papers

Quantum noise of optical oscillators and amplifiers

Izo I. Abram

Annals of Telecommunications•Jul 1, 1996•3 citations

Quantum optical repeaters

Philippe Grangier, J.-Ph. Poizat, Jean-François Roch +5 more

We demonstrate experimentally two devices that can manipulate an information‐carrying light beam below the usual shot‐noise limit. The first one is a type II pulsed optical parametric amplifier, which can duplicate (or, clone) the signal it amplifies. The second one uses semiconductor emitters and receivers, and is able to ‘‘re‐create’’ a light beam after direct detection. Although both devices are amplifiers with large gain, they meet the quantitative criteria for Quantum Non‐Demolition measurements and, thus, operate in the non‐classical regime. They can be used as noiseless amplifying optical taps which, at the same time, can overcome the noise introduced by downstream propagation and detection losses.

AIP conference proceedings•Jan 1, 1993•0 citations

Quantum noise of a modulation optical amplifier

Anatoly Viktorovich Masalov, A. A. Putilin

OptSp•Jun 1, 1997•2 citations

Quantum Theory of Light Propagation in Amplifying Media

Thomas Von Foerster, Roy J. Glauber

A simple model of a traveling-wave parametric amplifier is discussed in quantum-mechanical terms. The amplifier consists of a slab of Raman-active material, illuminated on one face by an intense laser beam that serves as the pump mode; an optical-phonon oscillation serves as the idler mode, and the scattered Stokes light occupies the signal mode. With only a few simplifying assumptions, it is possible to solve the equation of motion for the signal field operator exactly. For large times, both an amplified steady signal and the quantum noise contributed by the material assume simple steady states in an amplifier of finite length. The transient and asymptotic behaviors of the signal and noise intensities are found, together with the corresponding first-order correlation functions. The quasiprobability distribution which specifies the complete density operator for the electric field strength of the amplified signal is also derived.

Physical Review A•Apr 1, 1971•56 citations

Quantum effects and noise in optical communications

Monte Ross

Proceedings of the IEEE•Apr 1, 1963•2 citations

Optical Amplification and Spontaneous Emission in an Ar + Discharge

Michael Harris, R. Loudon, Terence J. Shepherd +1 more

The relationship between optical amplification and spontaneous emission noise has been studied in an argon ion travelling wave amplifier by beat spectrum analysis. Different optical arrangements have been examined with both single and double pass amplification. The results establish that when coherent light travels through a gain tube, the amplified beam acquires intensity fluctuation noise which is greater than that of a Poissonian distribution (shot noise). The noise power is shown to be the same as that of an equivalent unamplified beam mixed with the amplified spontaneous emission from the gain tube. It is shown that such measurements provide a practical technique for the otherwise difficult determination of the degree of population inversion in the gain medium. They also give insight into the potential of optical amplifiers for enhancement of lidar and system performance.

Journal of Modern Optics•Jun 1, 1992•11 citations
We demonstrate experimentally two devices that can manipulate an information‐carrying light beam below the usual shot‐noise limit. The first one is a type II pulsed optical parametric amplifier, which can duplicate (or, clone) the signal it amplifies. The second one uses semiconductor emitters and receivers, and is able to ‘‘re‐create’’ a light beam after direct detection. Although both devices are amplifiers with large gain, they meet the quantitative criteria for Quantum Non‐Demolition measurements and, thus, operate in the non‐classical regime. They can be used as noiseless amplifying optical taps which, at the same time, can overcome the noise introduced by downstream propagation and detection losses.
A simple model of a traveling-wave parametric amplifier is discussed in quantum-mechanical terms. The amplifier consists of a slab of Raman-active material, illuminated on one face by an intense laser beam that serves as the pump mode; an optical-phonon oscillation serves as the idler mode, and the scattered Stokes light occupies the signal mode. With only a few simplifying assumptions, it is possible to solve the equation of motion for the signal field operator exactly. For large times, both an amplified steady signal and the quantum noise contributed by the material assume simple steady states in an amplifier of finite length. The transient and asymptotic behaviors of the signal and noise intensities are found, together with the corresponding first-order correlation functions. The quasiprobability distribution which specifies the complete density operator for the electric field strength of the amplified signal is also derived.
The relationship between optical amplification and spontaneous emission noise has been studied in an argon ion travelling wave amplifier by beat spectrum analysis. Different optical arrangements have been examined with both single and double pass amplification. The results establish that when coherent light travels through a gain tube, the amplified beam acquires intensity fluctuation noise which is greater than that of a Poissonian distribution (shot noise). The noise power is shown to be the same as that of an equivalent unamplified beam mixed with the amplified spontaneous emission from the gain tube. It is shown that such measurements provide a practical technique for the otherwise difficult determination of the degree of population inversion in the gain medium. They also give insight into the potential of optical amplifiers for enhancement of lidar and system performance.