Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Philosophical Transactions of the Royal Society A Mathematical Physical and Engineering Sciences

Quantum information with neutral atoms as qubits

J. V. Porto, S. L. Rolston, B. Laburthe-Tolra, Carl J. Williams, William D. Phillips

Published Jul 15, 2003• 59 citations
Publisher

Abstract

One of the essential features of a quantum computer is a quantum 'register' of well-characterized qubits. Neutral atoms in optical lattices are a natural candidate for such a register. We have demonstrated a patterned-loading technique that can be used to load atoms into large arrays of tightly confined but optically resolvable lattice sites. We have also seen preliminary indications of the Mott-insulator transition, which provides a route for single-atom initialization of the individual sites. Combining the two experiments should allow for large arrays of individually addressable single atoms, a system which provides a starting point for further quantum computation studies.

DOI
10.1098/rsta.2003.1211

Related papers

Robust, reusable qubits for quantum information applications

Michael J. Gibbons

Most neutral atom quantum computing experiments rely on destructive state detection techniques that eject the detected qubits from the trap. These techniques limit the repetition rate of these experiments due to the necessity of reloading a new quantum register for each operation. \n \nWe address this problem by developing reusable neutral atom qubits. Individual Rubidium 87 atoms are trapped in an optical lattice and are held for upwards of 300 s. Each atom is prepared in an initial quantum state and then the state is subsequently detected with 95% fidelity with less than a 1% probability of losing it from the trap. This combination of long storage times and nondestructive state detection will facilitate the development of faster and more complex quantum systems that will enable future advancements in the field of quantum information.

•Jan 21, 2011•1 citation

Quantum Information Processing in Optical Lattices and Magnetic Microtraps

Philipp Treutlein, T. Steinmetz, Yves Colombe +9 more

We review our experiments on quantum information processing with neutral atoms in optical lattices and magnetic microtraps. Atoms in an optical lattice in the Mott insulator regime serve as a large qubit register. A spin-dependent lattice is used to split and delocalize the atomic wave functions in a controlled and coherent way over a defined number of lattice sites. This is used to experimentally demonstrate a massively parallel quantum gate array, which allows the creation of a highly entangled many-body cluster state through coherent collisions between atoms on neighbouring lattice sites. In magnetic microtraps on an atom chip, we demonstrate coherent manipulation of atomic qubit states and measure coherence lifetimes exceeding one second at micron-distance from the chip surface. We show that microwave near-fields on the chip can be used to create state-dependent potentials for the implementation of a quantum controlled phase gate with these robust qubit states. For single atom detection and preparation, we have developed high finesse fiber Fabry-Perot cavities and integrated them on the atom chip. We present an experiment in which we detected a very small number of cold atoms magnetically trapped in the cavity using the atom chip.

•May 18, 2006•64 citations

Quantum Information Processing with Double-Well Optical Lattices

Nathan E. Lundblad, J. V. Porto

We demonstrate a technique to address a spatially dense field-insensitive qubit register composed of neutral atoms held in a double-well optical lattice. We robustly perform single-qubit rotation on qubits located at addressed lattice sites.

Conference on Lasers and Electro-Optics•Jan 1, 2009•0 citations

Addressing Individual Atoms in Optical Lattices with Standing-Wave Driving Fields

Jaeyoon Cho

A scheme for addressing individual atoms in one- or two-dimensional optical lattices loaded with one atom per site is proposed. The scheme is based on position-dependent atomic population transfer induced by several standing-wave driving fields. This allows various operations important in quantum-information processing, such as manipulation and measurement of any single-atom, two-qubit operations between any pair of adjacent atoms, and patterned loading of the lattice with one atom per every nth site for arbitrary n. The proposed scheme is robust against considerable imperfections and actually within reach of current technology.

arXiv:quant-ph/0703185•Physical Review Letters•Jul 13, 2007•50 citations

Advancing neutral atom quantum computing: Studies of one-dimensional and two-dimensional optical lattices on a chip

Katharina Christandl

In this work we present the results of studies of one-dimensional (1D) and twodimensional (2D) optical lattices on a chip.We have developed a method to create 1D and 2D optical lattices above an optical waveguide.The method is based on the destructive interference of the evanescent waves of two modes of the waveguide, resulting in a periodic array of nodes above the waveguide surface.For blue-detuned light, this constitutes an array of optical dipole traps for neutral atoms.One pair of modes coupled into a ridge waveguide creates a 1D array of nodes in this manner, and two orthogonal pairs of modes in a slab waveguide result in a 2D array of nodes.Computational analysis of our method showed that these optical atom chips may be suitable for use as a quantum register, and for studies of atom-surface interactions between the trapped atoms and the waveguide surface.Using realistic waveguide materials and laboratory laser parameters we found that for a laser power of ~100 mW nodes can be created ~100 nm above the waveguide surface.The nodes constitute atom traps that are ~1mK deep, and have trap frequencies ~1MHz and ground state sizes of ~10 nm.The spacing between traps is ~1 µm enabling individual addressing with a focused laser beam.iii With the implementation of two-qubit gates in mind, initial investigations of extensions of the basic 2D optical lattice were conducted.Computational results for a counter-propagating 2D optical lattice with very close trap spacing (~λ/4) in one dimension, and for a 2D optical lattice with adjustable spacing between pairs of traps in one dimension are presented.An experimental setup for the realization of the proposed 2D optical lattices on a chip was designed and built.Several cooling and trapping steps necessary to prepare a cold atom sample for loading of the 2D optical lattice have been implemented successfully.In the course of previous studies of atom-surface interactions, a novel surfaceionization detector for 2D imaging of neutral atom samples was built and characterized.We find a detection efficiency ~50 %, a spatial resolution of 20 µm and a time response < 1/30 s. iv To my family.v ACKNOWLEDGMENTS First and foremost I would like to thank my advisor Greg Lafyatis for everything that he taught me.I also want to thank Frank DeLucia for always being there with his advice when I needed it.I appreciate Eric Herbst and Junko Shigemitsu for being willing to serve on

•Jan 1, 2005•2 citations

Scalable register initialization for quantum computing in an optical lattice

Gavin K. Brennen, Guido Pupillo, Ana Maria Rey +2 more

The Mott insulator state created by loading an atomic Bose–Einstein condensate (BEC) into an optical lattice may be used as a means to prepare a register of atomic qubits in a quantum computer. Such architecture requires a lattice commensurately filled with atoms, which corresponds to the insulator state only in the limit of zero inter-well tunnelling. We show that a lattice with spatial inhomogeneity created by a quadratic magnetic trapping potential can be used to isolate a subspace in the centre which is impervious to hole-hoping. Components of the wavefunction with more than one atom in any well can be projected out by selective measurement on a molecular photo-associative transition. Maintaining the molecular coupling can sustain a commensurately filled register for the duration of a quantum computation.

arXiv:quant-ph/0312069•Journal of Physics B Atomic Molecular and Optical Physics•May 20, 2005•22 citations
One of the essential features of a quantum computer is a quantum 'register' of well-characterized qubits. Neutral atoms in optical lattices are a natural candidate for such a register. We have demonstrated a patterned-loading technique that can be used to load atoms into large arrays of tightly confined but optically resolvable lattice sites. We have also seen preliminary indications of the Mott-insulator transition, which provides a route for single-atom initialization of the individual sites. Combining the two experiments should allow for large arrays of individually addressable single atoms, a system which provides a starting point for further quantum computation studies.
Most neutral atom quantum computing experiments rely on destructive state detection techniques that eject the detected qubits from the trap. These techniques limit the repetition rate of these experiments due to the necessity of reloading a new quantum register for each operation. \n \nWe address this problem by developing reusable neutral atom qubits. Individual Rubidium 87 atoms are trapped in an optical lattice and are held for upwards of 300 s. Each atom is prepared in an initial quantum state and then the state is subsequently detected with 95% fidelity with less than a 1% probability of losing it from the trap. This combination of long storage times and nondestructive state detection will facilitate the development of faster and more complex quantum systems that will enable future advancements in the field of quantum information.
We review our experiments on quantum information processing with neutral atoms in optical lattices and magnetic microtraps. Atoms in an optical lattice in the Mott insulator regime serve as a large qubit register. A spin-dependent lattice is used to split and delocalize the atomic wave functions in a controlled and coherent way over a defined number of lattice sites. This is used to experimentally demonstrate a massively parallel quantum gate array, which allows the creation of a highly entangled many-body cluster state through coherent collisions between atoms on neighbouring lattice sites. In magnetic microtraps on an atom chip, we demonstrate coherent manipulation of atomic qubit states and measure coherence lifetimes exceeding one second at micron-distance from the chip surface. We show that microwave near-fields on the chip can be used to create state-dependent potentials for the implementation of a quantum controlled phase gate with these robust qubit states. For single atom detection and preparation, we have developed high finesse fiber Fabry-Perot cavities and integrated them on the atom chip. We present an experiment in which we detected a very small number of cold atoms magnetically trapped in the cavity using the atom chip.
A scheme for addressing individual atoms in one- or two-dimensional optical lattices loaded with one atom per site is proposed. The scheme is based on position-dependent atomic population transfer induced by several standing-wave driving fields. This allows various operations important in quantum-information processing, such as manipulation and measurement of any single-atom, two-qubit operations between any pair of adjacent atoms, and patterned loading of the lattice with one atom per every nth site for arbitrary n. The proposed scheme is robust against considerable imperfections and actually within reach of current technology.
In this work we present the results of studies of one-dimensional (1D) and twodimensional (2D) optical lattices on a chip.We have developed a method to create 1D and 2D optical lattices above an optical waveguide.The method is based on the destructive interference of the evanescent waves of two modes of the waveguide, resulting in a periodic array of nodes above the waveguide surface.For blue-detuned light, this constitutes an array of optical dipole traps for neutral atoms.One pair of modes coupled into a ridge waveguide creates a 1D array of nodes in this manner, and two orthogonal pairs of modes in a slab waveguide result in a 2D array of nodes.Computational analysis of our method showed that these optical atom chips may be suitable for use as a quantum register, and for studies of atom-surface interactions between the trapped atoms and the waveguide surface.Using realistic waveguide materials and laboratory laser parameters we found that for a laser power of ~100 mW nodes can be created ~100 nm above the waveguide surface.The nodes constitute atom traps that are ~1mK deep, and have trap frequencies ~1MHz and ground state sizes of ~10 nm.The spacing between traps is ~1 µm enabling individual addressing with a focused laser beam.iii With the implementation of two-qubit gates in mind, initial investigations of extensions of the basic 2D optical lattice were conducted.Computational results for a counter-propagating 2D optical lattice with very close trap spacing (~λ/4) in one dimension, and for a 2D optical lattice with adjustable spacing between pairs of traps in one dimension are presented.An experimental setup for the realization of the proposed 2D optical lattices on a chip was designed and built.Several cooling and trapping steps necessary to prepare a cold atom sample for loading of the 2D optical lattice have been implemented successfully.In the course of previous studies of atom-surface interactions, a novel surfaceionization detector for 2D imaging of neutral atom samples was built and characterized.We find a detection efficiency ~50 %, a spatial resolution of 20 µm and a time response < 1/30 s. iv To my family.v ACKNOWLEDGMENTS First and foremost I would like to thank my advisor Greg Lafyatis for everything that he taught me.I also want to thank Frank DeLucia for always being there with his advice when I needed it.I appreciate Eric Herbst and Junko Shigemitsu for being willing to serve on
The Mott insulator state created by loading an atomic Bose–Einstein condensate (BEC) into an optical lattice may be used as a means to prepare a register of atomic qubits in a quantum computer. Such architecture requires a lattice commensurately filled with atoms, which corresponds to the insulator state only in the limit of zero inter-well tunnelling. We show that a lattice with spatial inhomogeneity created by a quadratic magnetic trapping potential can be used to isolate a subspace in the centre which is impervious to hole-hoping. Components of the wavefunction with more than one atom in any well can be projected out by selective measurement on a molecular photo-associative transition. Maintaining the molecular coupling can sustain a commensurately filled register for the duration of a quantum computation.