Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Magnetics

Quantum flux type logic circuits utilizing Josephson junction transmission lines

Michitada Morisue, M. Satoh, Kenji Araki

Published Mar 1, 1989• 1 citation
Publisher

Abstract

A quantum-flux-type logic circuit is proposed which is composed of Josephson junction transmission lines, along which localized magnetic flux can propagate. By choosing bias current properly, the duplication of magnetic flux and a variety of logical functions can be obtained without changing the circuit topology. Computer simulation results are presented on AND and OR operations with two and three inputs for the same circuit topology, confirming that these circuits can be used as logic circuits. The simulations demonstrate the high-speed operation and low power consumption of this circuit.>

DOI
10.1109/20.92420

Related papers

Proposal of unilateral single-flux-quantum logic gate

Hidetaka MIYAKE, N. Fukaya, Yoji Okabe +1 more

A new type of single flux quantum logic gate is proposed, which can perform unilateral propagation of signal without using three-phase clock. This gate is designed to be built with bridge-type Josephson junctions. A basic logic gate consists of two one-junction interferometers coupled by superconducting interconnecting lines, and the logical states are represented by zero or one quantized fluxoid in one of one-junction interferometers. The bias current of the unequal magnitude to each of the two one-junction interferometers results in unilateral signal flow. By adjusting design parameters such as the ratio of the critical current of Josephson junctions and the inductances, circuits with the noise immunity of greater than 50% with respect to the bias current have been designed. Three cascaded gates were modeled and simulated on a computer, and the unilateral signal flow was confirmed. The simulation also shows that a switching delay about 2 picoseconds is feasible.

IEEE Transactions on Magnetics•Mar 1, 1985•4 citations

Design Approach of Dynamically Reconfigurable Single Flux Quantum Logic Gates

Yuki Yamanashi, 一朗 大河, Nobuyuki Yoshikawa

Novel reconfigurable superconductive single flux quantum (SFQ) logic devices, the functions of which can be dynamically reconfigured by inputting control signals, have been investigated. The characteristics of single flux quantum circuits can be easily modulated by applying currents or magnetic fields because of the high sensitivity of superconductive circuits. We investigated several design approaches for the realization of dynamically reconfigurable SFQ logic devices. We employed direct current injection to the logic gate using a non-destructive read-out flip-flop. By changing the internal state of the non-destructive read-out flip-flop, the logic function can be dynamically reconfigured. We have designed and tested a dynamically reconfigurable Josephson transmission line (JTL)/delay flip-flop (DFF) circuit. The measured dc bias margin was 72.5-107.2%. Furthermore, we have demonstrated the operation of a variable bit-length shift register, composed of the dynamically reconfigurable JTL/DFF circuits. The investigated design approach can be applied to more sophisticated dynamically reconfigurable single flux quantum logic gates.

IEEE Transactions on Applied Superconductivity•Dec 14, 2010•11 citations

Design and Fabrication of Low-Power Single-Flux-Quantum Circuits Toward Quantum Bit Control

Masamitsu Tanaka, Yoshihiro Kitagawa, T. Satoh +1 more

We report low-power single-flux-quantum (SFQ) circuits fabricated with a lowered critical current density process and low-voltage design. We selected 250 A/cm$^{2}$to obtain 2–10 μA Josephson junctions (JJs) easily using conventional facilities. Our numerical simulation shows that the expected operating frequency is 10 GHz and that we can reduce the bias voltage to 0.1–0.5 mV; power consumption can be reduced to around 1 nW per JJ. We newly developed a fabrication process featuring four planarized Nb layers and a Pd resistor layer. We obtained the correct operation of several basic SFQ circuit elements designed with the lowered critical currents to 1/2 of the conventional circuits at 4.2 K. We also evaluated the Josephson junction critical currents, specific capacitance, resistance, and inductance at 3 K and 300 mK. We observed an increase of 7% in the critical currents at 300 mK, while the other parameters were unchanged. We demonstrated a 0.5-mV Josephson transmission line where we lowered the critical currents to 1/10. We expect such low-power SFQ circuits to operate at 20 mK, providing classical, general-purpose digital processing near quantum bits.

IEEE Transactions on Applied Superconductivity•Mar 2, 2023•13 citations

Low-power high-speed half-flux-quantum circuits driven by low bias voltages

Feng Li, Yuto Takeshita, Daiki Hasegawa +3 more

Abstract Half-flux-quantum (HFQ) circuits store and propagate half-flux quanta. The basic circuit element is a 0-π SQUID, which is a superconducting quantum interference device with a conventional Josephson junction (0-junction) and a π-shifted ferromagnetic junction (π-junction). A 0-π SQUID achieves a small critical current in the absence of an external magnetic field, thus reducing power consumption. It is easy to set up 0-0-π SQUIDs with two 0-junctions and a π-junction which serves as a π phase-shifter. We simulated 0-0-π SQUID-based HFQ circuits driven by low bias voltages, referred to as LV-HFQ circuits. In these circuits, shunt resistors are not required for switching junctions because there is no hysteresis in the current–voltage characteristics of 0-0-π SQUIDs. We estimated the power consumption and maximum operating frequency of an HFQ Josephson transmission line based on 0-0-π SQUIDs. When operating at 43.5 GHz, the power dissipation of a single element composed of a 0-0-π SQUID and a bias resistor fell to about 0.165 nW when biased at 60 μV. The LV-HFQ circuit is potentially more power-efficient than all other currently available superconducting logic circuits.

Superconductor Science and Technology•Nov 16, 2020•34 citations

An elementary logic circuit employing superconducting Josephson tunneling gates

W.H. Henkels

The design and experimental investigation of a simple logic circuit employing Josephson tunnel junctions as the switching elements is described. The design utilized matched transmission lines as signal carriers. The physical layout was simulated on a computer with a model consisting of 3 Josephson gates and 28 transmission line segments. Results of both quasi-static and high speed testing were found to be in essential agreement with theoretical expectations; only dynamic results are presented here in detail. The experimental circuit had gates with 165 ps risetimes, and in the high speed investigation, was operated with bursts of 700 ps risetime pulses tightly spaced so as to simulate a repetition rate of ∼1 GHz.

IEEE Transactions on Magnetics•Sep 1, 1974•29 citations

Reduction of power consumption of RSFQ circuits by inductance-load biasing

Nobuyuki Yoshikawa, Yuichi Kato

We propose an inductance-load-biasing method in order to reduce power consumption of rapid single flux quantum (SFQ) logic circuits. The main idea arises from the fact that a current source can be made of a large inductor accompanied by a large flux. In our proposal, the current source is composed of a large inductor L b , a small resistor R b and a small voltage source V b . Computer simulations of inductance-load-biased Josephson transmission lines (JTLs) show that an SFQ pulse propagates correctly when L b is large enough even if R b is very small. In order to implement the inductance-load-biased JTL, we have made two different layouts: one uses a large bias inductance L b of a typical stripline structure on a ground plane which occupies a rather large area; the other uses L b in the shape of a coplanar stripline, which costs a smaller area.

Superconductor Science and Technology•Nov 1, 1999•80 citations
A quantum-flux-type logic circuit is proposed which is composed of Josephson junction transmission lines, along which localized magnetic flux can propagate. By choosing bias current properly, the duplication of magnetic flux and a variety of logical functions can be obtained without changing the circuit topology. Computer simulation results are presented on AND and OR operations with two and three inputs for the same circuit topology, confirming that these circuits can be used as logic circuits. The simulations demonstrate the high-speed operation and low power consumption of this circuit.>
A new type of single flux quantum logic gate is proposed, which can perform unilateral propagation of signal without using three-phase clock. This gate is designed to be built with bridge-type Josephson junctions. A basic logic gate consists of two one-junction interferometers coupled by superconducting interconnecting lines, and the logical states are represented by zero or one quantized fluxoid in one of one-junction interferometers. The bias current of the unequal magnitude to each of the two one-junction interferometers results in unilateral signal flow. By adjusting design parameters such as the ratio of the critical current of Josephson junctions and the inductances, circuits with the noise immunity of greater than 50% with respect to the bias current have been designed. Three cascaded gates were modeled and simulated on a computer, and the unilateral signal flow was confirmed. The simulation also shows that a switching delay about 2 picoseconds is feasible.
Novel reconfigurable superconductive single flux quantum (SFQ) logic devices, the functions of which can be dynamically reconfigured by inputting control signals, have been investigated. The characteristics of single flux quantum circuits can be easily modulated by applying currents or magnetic fields because of the high sensitivity of superconductive circuits. We investigated several design approaches for the realization of dynamically reconfigurable SFQ logic devices. We employed direct current injection to the logic gate using a non-destructive read-out flip-flop. By changing the internal state of the non-destructive read-out flip-flop, the logic function can be dynamically reconfigured. We have designed and tested a dynamically reconfigurable Josephson transmission line (JTL)/delay flip-flop (DFF) circuit. The measured dc bias margin was 72.5-107.2%. Furthermore, we have demonstrated the operation of a variable bit-length shift register, composed of the dynamically reconfigurable JTL/DFF circuits. The investigated design approach can be applied to more sophisticated dynamically reconfigurable single flux quantum logic gates.
We report low-power single-flux-quantum (SFQ) circuits fabricated with a lowered critical current density process and low-voltage design. We selected 250 A/cm2^{2}2to obtain 2–10 μA Josephson junctions (JJs) easily using conventional facilities. Our numerical simulation shows that the expected operating frequency is 10 GHz and that we can reduce the bias voltage to 0.1–0.5 mV; power consumption can be reduced to around 1 nW per JJ. We newly developed a fabrication process featuring four planarized Nb layers and a Pd resistor layer. We obtained the correct operation of several basic SFQ circuit elements designed with the lowered critical currents to 1/2 of the conventional circuits at 4.2 K. We also evaluated the Josephson junction critical currents, specific capacitance, resistance, and inductance at 3 K and 300 mK. We observed an increase of 7% in the critical currents at 300 mK, while the other parameters were unchanged. We demonstrated a 0.5-mV Josephson transmission line where we lowered the critical currents to 1/10. We expect such low-power SFQ circuits to operate at 20 mK, providing classical, general-purpose digital processing near quantum bits.
Abstract Half-flux-quantum (HFQ) circuits store and propagate half-flux quanta. The basic circuit element is a 0-π SQUID, which is a superconducting quantum interference device with a conventional Josephson junction (0-junction) and a π-shifted ferromagnetic junction (π-junction). A 0-π SQUID achieves a small critical current in the absence of an external magnetic field, thus reducing power consumption. It is easy to set up 0-0-π SQUIDs with two 0-junctions and a π-junction which serves as a π phase-shifter. We simulated 0-0-π SQUID-based HFQ circuits driven by low bias voltages, referred to as LV-HFQ circuits. In these circuits, shunt resistors are not required for switching junctions because there is no hysteresis in the current–voltage characteristics of 0-0-π SQUIDs. We estimated the power consumption and maximum operating frequency of an HFQ Josephson transmission line based on 0-0-π SQUIDs. When operating at 43.5 GHz, the power dissipation of a single element composed of a 0-0-π SQUID and a bias resistor fell to about 0.165 nW when biased at 60 μV. The LV-HFQ circuit is potentially more power-efficient than all other currently available superconducting logic circuits.
The design and experimental investigation of a simple logic circuit employing Josephson tunnel junctions as the switching elements is described. The design utilized matched transmission lines as signal carriers. The physical layout was simulated on a computer with a model consisting of 3 Josephson gates and 28 transmission line segments. Results of both quasi-static and high speed testing were found to be in essential agreement with theoretical expectations; only dynamic results are presented here in detail. The experimental circuit had gates with 165 ps risetimes, and in the high speed investigation, was operated with bursts of 700 ps risetime pulses tightly spaced so as to simulate a repetition rate of ∼1 GHz.
We propose an inductance-load-biasing method in order to reduce power consumption of rapid single flux quantum (SFQ) logic circuits. The main idea arises from the fact that a current source can be made of a large inductor accompanied by a large flux. In our proposal, the current source is composed of a large inductor L b , a small resistor R b and a small voltage source V b . Computer simulations of inductance-load-biased Josephson transmission lines (JTLs) show that an SFQ pulse propagates correctly when L b is large enough even if R b is very small. In order to implement the inductance-load-biased JTL, we have made two different layouts: one uses a large bias inductance L b of a typical stripline structure on a ground plane which occupies a rather large area; the other uses L b in the shape of a coplanar stripline, which costs a smaller area.