Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

1.5 μm band efficient broadband wavelength conversion by difference frequency generation in a periodically domain-inverted LiNbO3 channel waveguide

Chang Qing Xu, Hideaki Okayama, M. Kawahara

Published Dec 27, 1993• 123 citations
Publisher

Abstract

Efficient 1.5 μm band wavelength conversion by difference frequency generation (DFG) in a periodically domain-inverted LiNbO3 channel waveguide is demonstrated, and DFG efficiency as high as 40% W−1 cm−2 is obtained. Nearly constant wavelength conversion efficiency has been confirmed over a broad wavelength range of 30 nm, which is the largest value ever reported.

DOI
10.1063/1.110096

Related papers

All-Optical Wavelength Conversion Based on the Cascaded Sum and Difference Frequency Generation in a Periodically Poled Lithium-Niobate Waveguide

Jian Wang

The principle of all-optical wavelength conversion based on the cascaded sum and difference frequency generation (SFG+DFG) in quasi-phase-matched (QPM) periodically poled LiNbO3 (PPLN) waveguides is introduced. The conversion efficiency of the wavelength converter is calculated. The influences of the powers and span of two pumps on the conversion efficiency are analyzed. Bandwidth of one pump wavelength is discussed. The tuning is about 0.5 nm. The signal pulse width is compressed about 0.68 times.

Optics & Optoelectronic Technology•Jan 1, 2007•0 citations

Channel-selective wavelength conversion and tuning in periodically poled Ti:LiNbO3 waveguides

Yeung Lak Lee, Changsoo Jung, Young-Chul Noh +4 more

All-optical wavelength-selective single- and dual-channel wavelength conversion and tuning has been demonstrated in a periodically poled Ti:LiNbO(3) waveguide that has two second-harmonic phase-matching peaks by cascaded sum and difference frequency generation (cSFG/DFG). The wavelength conversion efficiency was measured to be -7 dB with coupled pump power of 233 mW.

Optics Express•Jan 1, 2004•35 citations

Comparison of difference-frequency generation and cascaded χ^(2) based wavelength conversions in LiNbO_3 quasi-phase-matched waveguides

Bing Zhou, Chang‐Qing Xu, Bo Chen

Difference-frequency generation (DFG) and cascaded second-order nonlinear interaction (χ(2)) based wavelength conversions in LiNbO3 quasi-phase-matched waveguides were studied systematically. The characteristics of the two conversion methods, such as conversion efficiency, conversion bandwidth, pump-wavelength tolerance, and temperature stability, were compared with both experimental and theoretical results of MgO-doped quasi-phase-matched waveguides. It was found that for shorter device length and lower pump power, DFG based wavelength converters had higher conversion efficiency, and the cascaded χ(2) based wavelength conversions had slightly wider 3-dB signal-conversion bandwidth. The 3-dB signal wavelength-conversion bandwidth decreased exponentially with an increase in device length. For long devices and high pump power, however, the efficiency difference between the cascaded χ(2) based conversions and DFG based ones was minor. Tolerance of pump wavelength for the cascaded χ(2) based wavelength conversions was approximately two times that of DFG-based ones, which decreases with the increase of device length. In both cases, the tolerance of pump wavelength exponentially decreased with an increase of device length. It was found that the temperature stability of the cascaded χ(2) based conversions was identical to that of DFG based conversions. These results are very helpful in choosing suitable wavelength converters for practical optical communication systems.

Journal of the Optical Society of America B•May 1, 2003•15 citations

Simultaneous observation of inverted and noninverted wavelength conversion of picosecond pulses in LiNbO3 waveguides

Jian Wang, Junqiang Sun

Abstract We propose and demonstrate simultaneously inverted and noninverted wavelength conversion of picosecond pulses in periodically poled LiNbO3 waveguides. By only use of sum‐frequency generation, inverted wavelength conversion from the signal wavelength to pump wavelength both within the 1.5‐μm band is experimentally verified. By exploiting cascaded sum‐ and difference‐frequency generation (SFG + DFG), both inverted and noninverted wavelength conversion are observed in the experiments. © 2006 Wiley Periodicals, Inc. Microwave Opt Technol Lett 49: 295–298, 2007; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.22119

Microwave and Optical Technology Letters•Dec 18, 2006•2 citations

Parametric wavelength conversion with bidirectional utilization of a multiple QPM device

Masaki Asobe, Saroeun Punhavan, Kato Masato +4 more

A configuration for wavelength conversion and optical amplification by parametric interaction using a nonlinear optical device is proposed. It enables pump generation through second harmonic generation (SHG), difference frequency generation (DFG), and optical parametric amplification (OPA) using a multiple-quasi-phase-matched (M-QPM) LiNbO3 waveguide in a bidirectional manner. Wavelength conversion for the 1.4–1.6 µm band is experimentally demonstrated. In addition, it is demonstrated that the parametric gain band can be changed using various detunings between the pump and QPM wavelengths used for the DFG/OPA process. The proposed method would be useful for enabling high-capacity optical transmission outside the 1550-nm band.

Optics Express•Jun 22, 2021•5 citations

Cascaded wavelength conversions based on sum-frequency generation and difference-frequency generation

Chang‐Qing Xu, Bo Chen

A novel wavelength conversion scheme based on cascaded sum-frequency generation (SFG) and difference-frequency generation (DFG) is proposed and demonstrated in a MgO-doped LiNbO3 quasi-phase-matched waveguide. In this scheme, two pump wavelengths are set outside the communication band. It is shown that the same conversion efficiency can be achieved by use of two pump sources with lower output power (P1, P2) in this scheme compared with the conventional cascaded wavelength conversion technique based on second-harmonic generation and DFG with a single higher-power pump beam (P = P1 + P2) that is due to the use of a larger SFG nonlinear coefficient. The results significantly influence the selection of a suitable nonlinear interaction scheme for practical applications.

Optics Letters•Feb 1, 2004•51 citations
Efficient 1.5 μm band wavelength conversion by difference frequency generation (DFG) in a periodically domain-inverted LiNbO3 channel waveguide is demonstrated, and DFG efficiency as high as 40% W−1 cm−2 is obtained. Nearly constant wavelength conversion efficiency has been confirmed over a broad wavelength range of 30 nm, which is the largest value ever reported.
The principle of all-optical wavelength conversion based on the cascaded sum and difference frequency generation (SFG+DFG) in quasi-phase-matched (QPM) periodically poled LiNbO3 (PPLN) waveguides is introduced. The conversion efficiency of the wavelength converter is calculated. The influences of the powers and span of two pumps on the conversion efficiency are analyzed. Bandwidth of one pump wavelength is discussed. The tuning is about 0.5 nm. The signal pulse width is compressed about 0.68 times.
Difference-frequency generation (DFG) and cascaded second-order nonlinear interaction (χ(2)) based wavelength conversions in LiNbO3 quasi-phase-matched waveguides were studied systematically. The characteristics of the two conversion methods, such as conversion efficiency, conversion bandwidth, pump-wavelength tolerance, and temperature stability, were compared with both experimental and theoretical results of MgO-doped quasi-phase-matched waveguides. It was found that for shorter device length and lower pump power, DFG based wavelength converters had higher conversion efficiency, and the cascaded χ(2) based wavelength conversions had slightly wider 3-dB signal-conversion bandwidth. The 3-dB signal wavelength-conversion bandwidth decreased exponentially with an increase in device length. For long devices and high pump power, however, the efficiency difference between the cascaded χ(2) based conversions and DFG based ones was minor. Tolerance of pump wavelength for the cascaded χ(2) based wavelength conversions was approximately two times that of DFG-based ones, which decreases with the increase of device length. In both cases, the tolerance of pump wavelength exponentially decreased with an increase of device length. It was found that the temperature stability of the cascaded χ(2) based conversions was identical to that of DFG based conversions. These results are very helpful in choosing suitable wavelength converters for practical optical communication systems.
Abstract We propose and demonstrate simultaneously inverted and noninverted wavelength conversion of picosecond pulses in periodically poled LiNbO3 waveguides. By only use of sum‐frequency generation, inverted wavelength conversion from the signal wavelength to pump wavelength both within the 1.5‐μm band is experimentally verified. By exploiting cascaded sum‐ and difference‐frequency generation (SFG + DFG), both inverted and noninverted wavelength conversion are observed in the experiments. © 2006 Wiley Periodicals, Inc. Microwave Opt Technol Lett 49: 295–298, 2007; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.22119
A configuration for wavelength conversion and optical amplification by parametric interaction using a nonlinear optical device is proposed. It enables pump generation through second harmonic generation (SHG), difference frequency generation (DFG), and optical parametric amplification (OPA) using a multiple-quasi-phase-matched (M-QPM) LiNbO3 waveguide in a bidirectional manner. Wavelength conversion for the 1.4–1.6 µm band is experimentally demonstrated. In addition, it is demonstrated that the parametric gain band can be changed using various detunings between the pump and QPM wavelengths used for the DFG/OPA process. The proposed method would be useful for enabling high-capacity optical transmission outside the 1550-nm band.
A novel wavelength conversion scheme based on cascaded sum-frequency generation (SFG) and difference-frequency generation (DFG) is proposed and demonstrated in a MgO-doped LiNbO3 quasi-phase-matched waveguide. In this scheme, two pump wavelengths are set outside the communication band. It is shown that the same conversion efficiency can be achieved by use of two pump sources with lower output power (P1, P2) in this scheme compared with the conventional cascaded wavelength conversion technique based on second-harmonic generation and DFG with a single higher-power pump beam (P = P1 + P2) that is due to the use of a larger SFG nonlinear coefficient. The results significantly influence the selection of a suitable nonlinear interaction scheme for practical applications.