Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Letters

Cascaded wavelength conversions based on sum-frequency generation and difference-frequency generation

Chang‐Qing Xu, Bo Chen

Published Feb 1, 2004• 51 citations
Publisher

Abstract

A novel wavelength conversion scheme based on cascaded sum-frequency generation (SFG) and difference-frequency generation (DFG) is proposed and demonstrated in a MgO-doped LiNbO3 quasi-phase-matched waveguide. In this scheme, two pump wavelengths are set outside the communication band. It is shown that the same conversion efficiency can be achieved by use of two pump sources with lower output power (P1, P2) in this scheme compared with the conventional cascaded wavelength conversion technique based on second-harmonic generation and DFG with a single higher-power pump beam (P = P1 + P2) that is due to the use of a larger SFG nonlinear coefficient. The results significantly influence the selection of a suitable nonlinear interaction scheme for practical applications.

DOI
10.1364/ol.29.000292

Related papers

Comparison of cascaded χ2 wavelength conversions in quasi-phase-matched (QPM) waveguides

Bo Chen, Chang‐Qing Xu

Cascaded second-order nonlinear interaction (&chi(2));based wavelength conversion technique has attracted much attention due to its unique characteristics such as low noise and broadband, which are critical in fiber communication networks. In this report, wavelength conversions based on the newly proposed SFG-DFG (sum frequency generation - difference frequency generation) and conventional SHG-DFG (second harmonic generation - difference frequency generation) are studied and compared both experimentally and theoretically in a LiNbO3 quasi-phase matched (QPM) waveguide. It is shown that the same conversion efficiency can be achieved by employing two pump sources with only half power each (P1, P2) in the SFG-DFG scheme as compared with the SHG-DFG scheme with a single higher power pump beam (P=P1+P2). It is shown that the cascaded SFG-DFG based wavelength conversion has a larger 3-dB pump tolerance bandwidth. The theoretical results are consistent well with the experimental ones. It is found that the pump wavelength difference can be separated by a span as large as 75 nm, while 3-dB signal conversion efficiency is retained in a 45 mm-long device. It is also exhibited that tolerance of temperature for the cascaded SFG-DFG remains the same as that of the cascaded SHG-DFG based devices. The results show that the SFG-DFG wavelength conversion scheme is very attractive for practical applications.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Nov 16, 2004•0 citations

Analysis of Novel Cascaded $chi^(2)$ (SFG $+$ DFG) Wavelength Conversions in Quasi-Phase-Matched Waveguides

B. Chen, Chang‐Qing Xu

A novel cascaded second-order nonlinear interaction (/spl chi//sup (2)/), which is simultaneously based on sum frequency generation (SFG) and difference frequency generation (DFG) processes, is proposed and analyzed in quasi-phase-matched wavelength converters. Analytical expressions with clear physical insights are derived for the converted light. It is shown that the same conversion efficiency can be achieved by employing two pump sources with lower output power (P/sub p1/,P/sub p2/) in this novel scheme as compared with the conventional cascaded wavelength conversion technique based on second-harmonic generation and difference frequency generation (SHG+DFG) with a single higher power pump beam (P/sub p/=P/sub p1/+P/sub p2/). The theoretical results are consistent with the experimental ones. It is found that the pump wavelength difference can be separated by a span as large as 75 nm, while large 3-dB signal conversion bandwidth is retained. The results show that the novel cascaded /spl chi//sup (2)/ wavelength conversion scheme is very attractive for practical applications.

IEEE Journal of Quantum Electronics•Mar 1, 2004•47 citations

Comparison of difference-frequency generation and cascaded χ^(2) based wavelength conversions in LiNbO_3 quasi-phase-matched waveguides

Bing Zhou, Chang‐Qing Xu, Bo Chen

Difference-frequency generation (DFG) and cascaded second-order nonlinear interaction (χ(2)) based wavelength conversions in LiNbO3 quasi-phase-matched waveguides were studied systematically. The characteristics of the two conversion methods, such as conversion efficiency, conversion bandwidth, pump-wavelength tolerance, and temperature stability, were compared with both experimental and theoretical results of MgO-doped quasi-phase-matched waveguides. It was found that for shorter device length and lower pump power, DFG based wavelength converters had higher conversion efficiency, and the cascaded χ(2) based wavelength conversions had slightly wider 3-dB signal-conversion bandwidth. The 3-dB signal wavelength-conversion bandwidth decreased exponentially with an increase in device length. For long devices and high pump power, however, the efficiency difference between the cascaded χ(2) based conversions and DFG based ones was minor. Tolerance of pump wavelength for the cascaded χ(2) based wavelength conversions was approximately two times that of DFG-based ones, which decreases with the increase of device length. In both cases, the tolerance of pump wavelength exponentially decreased with an increase of device length. It was found that the temperature stability of the cascaded χ(2) based conversions was identical to that of DFG based conversions. These results are very helpful in choosing suitable wavelength converters for practical optical communication systems.

Journal of the Optical Society of America B•May 1, 2003•15 citations

All-Optical Wavelength Conversion Based on the Cascaded Sum and Difference Frequency Generation in a Periodically Poled Lithium-Niobate Waveguide

Jian Wang

The principle of all-optical wavelength conversion based on the cascaded sum and difference frequency generation (SFG+DFG) in quasi-phase-matched (QPM) periodically poled LiNbO3 (PPLN) waveguides is introduced. The conversion efficiency of the wavelength converter is calculated. The influences of the powers and span of two pumps on the conversion efficiency are analyzed. Bandwidth of one pump wavelength is discussed. The tuning is about 0.5 nm. The signal pulse width is compressed about 0.68 times.

Optics & Optoelectronic Technology•Jan 1, 2007•0 citations

Comparison of DFG and the cascaded X2based wavelength conversions using MgO-doped LiNbO 3 QPM waveguides

Bo Chen, Chang-Qing Xu, Bing Zhou

Different frequency generation (DFG) and the cascaded second-order nonlinear interaction () based wavelength conversions in 5-mol MgO doped LiNbO3 QPM waveguides are studied and compared both experimentally and theoretically for the first time. It is shown that DFG based wavelength conversions have a higher conversion efficiency; while the cascaded based wavelength conversions have a wider 3-dB signal conversion bandwidth. It is also exhibited that the simulations are consistent well with the experimental results. Tolerance of pump wavelength for the cascaded based wavelength conversion is twice as large as that of DFG based devices. These results are very helpful in choosing suitable wavelength converters for practical optical communication systems according to the system requirements.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Oct 29, 2001•0 citations

Flattening of cascaded sum- and difference-frequency generation-based wavelength conversion by pump or period detuning

Shiming Gao, Changxi Yang, Xiaosheng Xiao +3 more

We investigate response flatting of cascaded sum- and difference- frequency generation (SFG/DFG)-based wavelength conversion in quasi-phase-matched (QPM) periodically poled lithium niobate waveguides for wavelength division multiplexing optical communication systems. The cascaded SFG/DFG-based configuration shows more robustly combined properties than conventional DFG-based and cascaded second-harmonic generation and DFG (SHG/DFG)-based configurations. The response fluctuation, generated while enhancing the conversion bandwidth, can be efficiently reduced by the method of pump detuning or QPM period detuning.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Nov 24, 2005•0 citations
A novel wavelength conversion scheme based on cascaded sum-frequency generation (SFG) and difference-frequency generation (DFG) is proposed and demonstrated in a MgO-doped LiNbO3 quasi-phase-matched waveguide. In this scheme, two pump wavelengths are set outside the communication band. It is shown that the same conversion efficiency can be achieved by use of two pump sources with lower output power (P1, P2) in this scheme compared with the conventional cascaded wavelength conversion technique based on second-harmonic generation and DFG with a single higher-power pump beam (P = P1 + P2) that is due to the use of a larger SFG nonlinear coefficient. The results significantly influence the selection of a suitable nonlinear interaction scheme for practical applications.
Cascaded second-order nonlinear interaction (&chi(2));based wavelength conversion technique has attracted much attention due to its unique characteristics such as low noise and broadband, which are critical in fiber communication networks. In this report, wavelength conversions based on the newly proposed SFG-DFG (sum frequency generation - difference frequency generation) and conventional SHG-DFG (second harmonic generation - difference frequency generation) are studied and compared both experimentally and theoretically in a LiNbO3 quasi-phase matched (QPM) waveguide. It is shown that the same conversion efficiency can be achieved by employing two pump sources with only half power each (P1, P2) in the SFG-DFG scheme as compared with the SHG-DFG scheme with a single higher power pump beam (P=P1+P2). It is shown that the cascaded SFG-DFG based wavelength conversion has a larger 3-dB pump tolerance bandwidth. The theoretical results are consistent well with the experimental ones. It is found that the pump wavelength difference can be separated by a span as large as 75 nm, while 3-dB signal conversion efficiency is retained in a 45 mm-long device. It is also exhibited that tolerance of temperature for the cascaded SFG-DFG remains the same as that of the cascaded SHG-DFG based devices. The results show that the SFG-DFG wavelength conversion scheme is very attractive for practical applications.
Analysis of Novel Cascaded chi(2)chi^(2)chi(2) (SFG +++ DFG) Wavelength Conversions in Quasi-Phase-Matched Waveguides
A novel cascaded second-order nonlinear interaction (/spl chi//sup (2)/), which is simultaneously based on sum frequency generation (SFG) and difference frequency generation (DFG) processes, is proposed and analyzed in quasi-phase-matched wavelength converters. Analytical expressions with clear physical insights are derived for the converted light. It is shown that the same conversion efficiency can be achieved by employing two pump sources with lower output power (P/sub p1/,P/sub p2/) in this novel scheme as compared with the conventional cascaded wavelength conversion technique based on second-harmonic generation and difference frequency generation (SHG+DFG) with a single higher power pump beam (P/sub p/=P/sub p1/+P/sub p2/). The theoretical results are consistent with the experimental ones. It is found that the pump wavelength difference can be separated by a span as large as 75 nm, while large 3-dB signal conversion bandwidth is retained. The results show that the novel cascaded /spl chi//sup (2)/ wavelength conversion scheme is very attractive for practical applications.
Difference-frequency generation (DFG) and cascaded second-order nonlinear interaction (χ(2)) based wavelength conversions in LiNbO3 quasi-phase-matched waveguides were studied systematically. The characteristics of the two conversion methods, such as conversion efficiency, conversion bandwidth, pump-wavelength tolerance, and temperature stability, were compared with both experimental and theoretical results of MgO-doped quasi-phase-matched waveguides. It was found that for shorter device length and lower pump power, DFG based wavelength converters had higher conversion efficiency, and the cascaded χ(2) based wavelength conversions had slightly wider 3-dB signal-conversion bandwidth. The 3-dB signal wavelength-conversion bandwidth decreased exponentially with an increase in device length. For long devices and high pump power, however, the efficiency difference between the cascaded χ(2) based conversions and DFG based ones was minor. Tolerance of pump wavelength for the cascaded χ(2) based wavelength conversions was approximately two times that of DFG-based ones, which decreases with the increase of device length. In both cases, the tolerance of pump wavelength exponentially decreased with an increase of device length. It was found that the temperature stability of the cascaded χ(2) based conversions was identical to that of DFG based conversions. These results are very helpful in choosing suitable wavelength converters for practical optical communication systems.
The principle of all-optical wavelength conversion based on the cascaded sum and difference frequency generation (SFG+DFG) in quasi-phase-matched (QPM) periodically poled LiNbO3 (PPLN) waveguides is introduced. The conversion efficiency of the wavelength converter is calculated. The influences of the powers and span of two pumps on the conversion efficiency are analyzed. Bandwidth of one pump wavelength is discussed. The tuning is about 0.5 nm. The signal pulse width is compressed about 0.68 times.
Different frequency generation (DFG) and the cascaded second-order nonlinear interaction () based wavelength conversions in 5-mol MgO doped LiNbO3 QPM waveguides are studied and compared both experimentally and theoretically for the first time. It is shown that DFG based wavelength conversions have a higher conversion efficiency; while the cascaded based wavelength conversions have a wider 3-dB signal conversion bandwidth. It is also exhibited that the simulations are consistent well with the experimental results. Tolerance of pump wavelength for the cascaded based wavelength conversion is twice as large as that of DFG based devices. These results are very helpful in choosing suitable wavelength converters for practical optical communication systems according to the system requirements.
We investigate response flatting of cascaded sum- and difference- frequency generation (SFG/DFG)-based wavelength conversion in quasi-phase-matched (QPM) periodically poled lithium niobate waveguides for wavelength division multiplexing optical communication systems. The cascaded SFG/DFG-based configuration shows more robustly combined properties than conventional DFG-based and cascaded second-harmonic generation and DFG (SHG/DFG)-based configurations. The response fluctuation, generated while enhancing the conversion bandwidth, can be efficiently reduced by the method of pump detuning or QPM period detuning.