Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Japanese Journal of Applied Physics

An Ultrafast Operation of Microwave SQUID's Biased at 35 GHz

Hiroo Fuma, Yukinobu Miki, Taizō Masumi

Published Oct 1, 1980• 2 citations
Publisher

Abstract

A microwave SQUID biased at 35 GHz with a Nb point contact has been improved in its characteristic performance, by changing the configuration of a SQUID, from the 35 GHz size to the 9 GHz size which is oversize for the 35 GHz microwave. About a 10 times larger signal output and higher frequency response up to 100 MHz have been directly obtained. Further, it has been confirmed for the first time that the SQUID biased at 35 GHz does respond up to the 9 GHz input signal by using the Bessel function method.

DOI
10.1143/jjap.19.l637

Related papers

High Bias Frequency Operation of a Microwave SQUID at 35 GHz

Yukinobu Miki, Taizō Masumi

An rf-SQUID with the bias frequency raised to 35 GHz has been successfully operated for the first time. The principle of designing the SQUID is the naive extension of the SQUIDs at 10 GHz previously reported to the millimeter wave region. At present, the SQUID at 35 GHz has a slightly poorer signal-to-noise ratio than the SQUIDs at 10 GHz and also the highest limit of the output band-width is confined to about 1 MHz. However, several possibilities for improving the style and configuration remain for the future.

Japanese Journal of Applied Physics•Aug 1, 1980•0 citations

High sensitivity microwave SQUID

J. N. Hollenhorst, R. P. Giffard

We have measured the characteristics of a novel SQUID magnetometer pumped at 9 GHz. The device comprises a niobium point-contact shunting a low impedance superconducting microwave transmission line which isolates the junction at high frequencies from a toroidal input transformer. The junction is matched to a 50 Ω coaxial transmission line and the SQUID is operated in a reflection mode. For low values of the weak link critical current we observe a modulation of the phase of the reflected microwave signal periodic in the applied flux. The modulation persists at high microwave power levels indicating that the junction response is maintained to at least 200 GHz. For large values of critical current, amplitude modulation is observed. We have obtained a differential sideband power of 230 pW/(\Phi_{0})^{2}which is close to the value predicted by a simple model. In flux-locked loop operation we have obtained an energy sensitivity referred to the input terminals of 7 × 10-31J/Hz, which is superior to that so far reported for any other SQUID.

IEEE Transactions on Magnetics•Jan 1, 1979•36 citations

A Broadband and Higher-Power Superconducting Quantum Magnetometer for the Small Signal A-D Converter

Hideaki Takayanagi, Taizō Masumi

We describe several types of wide operations and performances of a Superconducting Quantum Magnetometer at 10 GHz and higher output power levels (a microwave SQUID) for a fast and small signal A-D converter. Direct exhibition and counting of the high-speed Q-patterns from a higher-power SQUID have benn demonstrated up to a frequency region above 10 MHz by improving the post-detection system. These results give the best figure of merit so far reported far a microwave SQUID.

Japanese Journal of Applied Physics•Jun 1, 1978•4 citations

Direct Observations of the 500 MHz Q-Patterns from the 10 and 35 GHz SQUID's

Yukinobu Miki, Hiroo Fuma, Taizō Masumi

The 500 MHz Quantum Interference patterns (Q-patterns) beyond 100 MHz previously reported have been directly observed for the first time from 10 and 35 GHz Superconducting Quantum Interference Devices (SQUID's). The observation was made by improving the bandwidth of the detection circuits, which was supposed to be the cause of the previous limitation on Q-patterns from the 10 and 35 GHz SQUID's. An improved system including a 10 or 35 GHz SQUID has possible applications to the measurement of signals due to even faster magnetic flux changes.

Japanese Journal of Applied Physics•May 1, 1982•3 citations

Millimeter wave behavior of superconducting point contact SQUID

Helmut Kanter, F. Vernon

A superconducting point contact waveguide SQUID has been operated at 89 GHz. The performance is qualitatively the same as at lower frequencies in agreement with the SQUID model. With the Nb point located across a 0.15 mm high E band waveguide, reflection coefficient measurements were made as a function of both supercurrent phase as controlled by an externally applied magnetic field and millimeter wave power. Large parametric reactance variations were produced by changing the supercurrent phase. As the millimeter wave power is increased flux cycling was observed which involved up to four steps. This behavior corresponds to a flux transition time less than 10-12sec. Implications of the\cos \phiterm and negative resistance effects in the observed behavior of the reflection coefficient will be discussed.

IEEE Transactions on Magnetics•Jan 1, 1977•9 citations

Design and High-Frequency Response of Resistive SQUID Frequency Converters

Alistair A. Fife, Suso Gygax

Several resistive SQUID frequency converters (R-SQUID) have been constructed and their properties studied in the frequency regimes 26.5–40 and 67–73 GHz. A brief outline of the theory of the device is presented together with constructional details for a Nb–Nb point-contact version. The device response is complicated by the effects on the ac Josephson current of distributed circuit elements, and a broad range of complex behavior is presented which is only partially understood. A useful amplification effect for the detected signal has been discovered, which gives the device good broad range sensitivity (∼ 10−7–∼ 10−12 W/Hz1/2) and reasonably narrow linewidths (Q-values of ∼ 104 at 70 GHz).

Journal of Applied Physics•May 1, 1972•19 citations
A microwave SQUID biased at 35 GHz with a Nb point contact has been improved in its characteristic performance, by changing the configuration of a SQUID, from the 35 GHz size to the 9 GHz size which is oversize for the 35 GHz microwave. About a 10 times larger signal output and higher frequency response up to 100 MHz have been directly obtained. Further, it has been confirmed for the first time that the SQUID biased at 35 GHz does respond up to the 9 GHz input signal by using the Bessel function method.
An rf-SQUID with the bias frequency raised to 35 GHz has been successfully operated for the first time. The principle of designing the SQUID is the naive extension of the SQUIDs at 10 GHz previously reported to the millimeter wave region. At present, the SQUID at 35 GHz has a slightly poorer signal-to-noise ratio than the SQUIDs at 10 GHz and also the highest limit of the output band-width is confined to about 1 MHz. However, several possibilities for improving the style and configuration remain for the future.
We have measured the characteristics of a novel SQUID magnetometer pumped at 9 GHz. The device comprises a niobium point-contact shunting a low impedance superconducting microwave transmission line which isolates the junction at high frequencies from a toroidal input transformer. The junction is matched to a 50 Ω coaxial transmission line and the SQUID is operated in a reflection mode. For low values of the weak link critical current we observe a modulation of the phase of the reflected microwave signal periodic in the applied flux. The modulation persists at high microwave power levels indicating that the junction response is maintained to at least 200 GHz. For large values of critical current, amplitude modulation is observed. We have obtained a differential sideband power of 230 pW/(\Phi_{0})^{2}which is close to the value predicted by a simple model. In flux-locked loop operation we have obtained an energy sensitivity referred to the input terminals of 7 × 10-31J/Hz, which is superior to that so far reported for any other SQUID.
The 500 MHz Quantum Interference patterns (Q-patterns) beyond 100 MHz previously reported have been directly observed for the first time from 10 and 35 GHz Superconducting Quantum Interference Devices (SQUID's). The observation was made by improving the bandwidth of the detection circuits, which was supposed to be the cause of the previous limitation on Q-patterns from the 10 and 35 GHz SQUID's. An improved system including a 10 or 35 GHz SQUID has possible applications to the measurement of signals due to even faster magnetic flux changes.
A superconducting point contact waveguide SQUID has been operated at 89 GHz. The performance is qualitatively the same as at lower frequencies in agreement with the SQUID model. With the Nb point located across a 0.15 mm high E band waveguide, reflection coefficient measurements were made as a function of both supercurrent phase as controlled by an externally applied magnetic field and millimeter wave power. Large parametric reactance variations were produced by changing the supercurrent phase. As the millimeter wave power is increased flux cycling was observed which involved up to four steps. This behavior corresponds to a flux transition time less than 10-12sec. Implications of the\cos \phiterm and negative resistance effects in the observed behavior of the reflection coefficient will be discussed.
Several resistive SQUID frequency converters (R-SQUID) have been constructed and their properties studied in the frequency regimes 26.5–40 and 67–73 GHz. A brief outline of the theory of the device is presented together with constructional details for a Nb–Nb point-contact version. The device response is complicated by the effects on the ac Josephson current of distributed circuit elements, and a broad range of complex behavior is presented which is only partially understood. A useful amplification effect for the detected signal has been discovered, which gives the device good broad range sensitivity (∼ 10−7–∼ 10−12 W/Hz1/2) and reasonably narrow linewidths (Q-values of ∼ 104 at 70 GHz).