Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of the Optical Society of America B

Reflectivity of photorefractive cross-polarized four-wave mixing in consideration of pump depletion

Hisashi Matsuoka, Atsushi Okamoto, Mototsugu Takamura, Kunihiro Sato

Published May 1, 1998• 10 citations
Publisher

Abstract

We analyze the phase-conjugate reflectivity and the amplification property of cross-polarized four-wave mixing with a photorefractive BaTiO3 crystal in consideration of the pump-beam depletion. The coupled-wave equations of cross-polarized four-wave mixing with ordinary writing beams and an extraordinary reading beam are derived and solved with the grating-integral method. The results of calculations of the reflectivity and the amplification factors will be compared with the result under the undepleted-pumps approximation. In addition, to achieve high conversion efficiency, the optimum conditions for the intensity ratio and the angle configurations of the probe and pump beams are also discussed.

DOI
10.1364/josab.15.001545

Related papers

Photorefractive phase conjugation with orthogonally polarized pumping beams

Hongzhi Kong, Carl Lin, Anne Marie Biernacki +1 more

We solve the undepleted-pumps photorefractive four-wave mixing equations for the case of orthogonally polarized pump beams. Advantages over the parallel-polarized-pumps case include the potential for reflectivity enhancement and easy isolation of the conjugator from the source. The phase-conjugate reflectivities for both the parallel and orthogonally polarized pump beam cases were measured with a BaTiO3 crystal, and the results support our theoretical predictions.

Optics Letters•Apr 1, 1988•28 citations

Cross-polarized photorefractive four-wave mixing with extraordinary writing beams and an ordinary reading beam

Yoshihisa Takayama, Atsushi Okamoto, Motoki Saito +1 more

In parallel-polarized photorefractive four-wave mixing the phase-matching condition can be achieved automatically if the pump beams are allowed to propagate in directions opposite to each other. However, in cross-polarized photorefractive four-wave mixing, the incident angles of the beams should be adjusted to maintain the phase-matching condition. We analyze the phase-matching properties of cross-polarized four-wave mixing with extraordinary writing beams and an ordinary reading beam and obtain the phase-conjugate reflectivity in consideration of phase mismatching. We also perform an experiment in which a phase-conjugate beam is generated in cross-polarized four-wave mixing and confirm the analyses.

Applied Optics•May 10, 1998•4 citations

A continuous compound four-wave mixing mechanism for self-pumped phase conjugation in BaTiO 3 crystals

Ping Xie, Jian-Hua Dai, Wang Peng-ye +2 more

A continuous compound four-wave mixing mechanism for self-pumped phase conjugation in photorefractive crystals is presented. The coupled-beam equations of this mechanism are solved numerically when depletion of the forward going beam is neglected. The experiment in a Ce-doped BaTiO 3 crystal is performed, with the stable phase conjugate reflectivity of as much as ⩾ 80%. The curved high output phase conjugate intensity are explained using the numerical results.

Acta Physica Sinica (Overseas Edition)•Aug 1, 1995•0 citations

Photorefractive wave mixing with finite beams

Wieslaw Z. Krolikowski, Mark Cronin‐Golomb

While the interaction of optical beams in photorefractive crystals can often be accurately described in terms of 1-D plane-wave approximation, 2-D models are sometimes more suitable, as suggested by recent work.1 Here we discuss some aspects of photorefractive interaction of finite size optical beams. We have solved the system of partial differential equations governing two- and four-wave mixing numerically by using iterative procedures. Simulations of beam amplification in two-beam coupling show strong beam deformation even without any spatial information imposed on them. Spatially nonuniform energy transfer is responsible for this effect. The pump beam loses energy during propagation and at the end of its passage through the beam intersection region (which was completely inside the crystal) it is strongly depleted and cannot contribute significantly to beam amplification. As the pump beam crosses through the probe, it amplifies most strongly that side of the probe that it meets first. By the time the pump has reached the far side of the probe, it is strongly depleted and less effective at probe amplification. In the case of phase conjugation through four-wave mixing, we found that the conjugate beam is strongly deformed only when the coupling constant is negative (corresponding to deamplification of the probe input beam). For positive coupling constants the output conjugate beam is a good replica of the input probe beam.

Annual Meeting Optical Society of America•Jan 1, 1991•1 citation

Parametric amplification of a coherent light wave in photorefractive BaTiO_3 by a single pump beam

Jens Timo Neumann, Serguey G. Odoulov

We demonstrate a new method of light amplification based on forward four-wave mixing in photorefractive BaTiO(3). A single pump beam of combined (ordinary and extraordinary) polarization can be used for an efficient cw amplification of a signal wave with slightly shifted temporal frequency. A signal wave with an initial power of less than 1 nW is amplified ~100 times in a 3.2-mm-thick sample.

Optics Letters•Dec 15, 1997•6 citations

Phase Conjugation by Diffraction Gratings in Photorefractive Crystals

M.H. Majles Ara, Mahdi Esmaeilzadeh

Here we present four wave mixing configuration as one of the most important methods of generation and explanation of process of generation phase conjugation light the coupled equation was solved by three methods: undepleted pump approximation exact solution and two wave mixing approximation. Although exact solutions can be derived for four-wave mixing, the results are difficult to use because of the complicated transcendental equation involved. Solved the coupled equations and introduce an approximation in which two-wave mixing is the dominant process.

Asia-Pacific Microwave Conference (APMC)•Mar 22, 2006•0 citations
We analyze the phase-conjugate reflectivity and the amplification property of cross-polarized four-wave mixing with a photorefractive BaTiO3 crystal in consideration of the pump-beam depletion. The coupled-wave equations of cross-polarized four-wave mixing with ordinary writing beams and an extraordinary reading beam are derived and solved with the grating-integral method. The results of calculations of the reflectivity and the amplification factors will be compared with the result under the undepleted-pumps approximation. In addition, to achieve high conversion efficiency, the optimum conditions for the intensity ratio and the angle configurations of the probe and pump beams are also discussed.
In parallel-polarized photorefractive four-wave mixing the phase-matching condition can be achieved automatically if the pump beams are allowed to propagate in directions opposite to each other. However, in cross-polarized photorefractive four-wave mixing, the incident angles of the beams should be adjusted to maintain the phase-matching condition. We analyze the phase-matching properties of cross-polarized four-wave mixing with extraordinary writing beams and an ordinary reading beam and obtain the phase-conjugate reflectivity in consideration of phase mismatching. We also perform an experiment in which a phase-conjugate beam is generated in cross-polarized four-wave mixing and confirm the analyses.
While the interaction of optical beams in photorefractive crystals can often be accurately described in terms of 1-D plane-wave approximation, 2-D models are sometimes more suitable, as suggested by recent work.1 Here we discuss some aspects of photorefractive interaction of finite size optical beams. We have solved the system of partial differential equations governing two- and four-wave mixing numerically by using iterative procedures. Simulations of beam amplification in two-beam coupling show strong beam deformation even without any spatial information imposed on them. Spatially nonuniform energy transfer is responsible for this effect. The pump beam loses energy during propagation and at the end of its passage through the beam intersection region (which was completely inside the crystal) it is strongly depleted and cannot contribute significantly to beam amplification. As the pump beam crosses through the probe, it amplifies most strongly that side of the probe that it meets first. By the time the pump has reached the far side of the probe, it is strongly depleted and less effective at probe amplification. In the case of phase conjugation through four-wave mixing, we found that the conjugate beam is strongly deformed only when the coupling constant is negative (corresponding to deamplification of the probe input beam). For positive coupling constants the output conjugate beam is a good replica of the input probe beam.
Here we present four wave mixing configuration as one of the most important methods of generation and explanation of process of generation phase conjugation light the coupled equation was solved by three methods: undepleted pump approximation exact solution and two wave mixing approximation. Although exact solutions can be derived for four-wave mixing, the results are difficult to use because of the complicated transcendental equation involved. Solved the coupled equations and introduce an approximation in which two-wave mixing is the dominant process.