The time-dependent characteristics of a radio frequency superconducting quantum interference device (rf SQUID) involving two Josephson junctions connected in series are studied. First the dynamics of the total flux is given. Then the intrinsic flux noises in both nonhysteretic and hysteretic modes are investigated. The result shows that it is necessary to properly reduce the critical current ratio of the two junctions for low intrinsic noise level. When the critical current ratio is properly reduced, the intrinsic flux noise level of a two-junction rf SQUID is generally close to or slightly larger than that of a single junction rf SQUID, but no more than one order-of-magnitude.
The time-dependent characteristics of a radio frequency superconducting quantum interference device (rf SQUID) involving two Josephson junctions connected in series are studied. First the dynamics of the total flux is given. Then the intrinsic flux noises in both nonhysteretic and hysteretic modes are investigated. The result shows that it is necessary to properly reduce the critical current ratio of the two junctions for low intrinsic noise level. When the critical current ratio is properly reduced, the intrinsic flux noise level of a two-junction rf SQUID is generally close to or slightly larger than that of a single junction rf SQUID, but no more than one order-of-magnitude.
We have studied the basic characteristics of a radio frequency superconducting quantum interference device (rf SQUID) involving two Josephson junctions connected in series, the case for the widely used grain boundary junction (GBJ) rf SQUID. It is found that the SQUID properties are determined mainly by the weaker junction when the critical current of the weaker junction is much lower than that of the other junction. Otherwise, the effect of the other junction is not negligible. We also find that only when the hysteresis parameter β is less than 1−α, where α is the critical current ratio of the two junctions, will the SQUID operate in the nonhysteretic mode.
The authors investigated low-frequency noise in RF and DC superconducting quantum interference devices (SQUIDs) with step-edge Josephson junctions (SEJs). The noise properties have been measured as a function of frequency, temperature, bias current, and magnetic field. The low-frequency noise has a telegraph-like character in certain conditions and depends quasi-periodically on flux and temperature. This telegraph noise was also observed in single step-edge junctions. The experimental results were explained by a model of such a junction in which an array of parallel and series connected weak links acts like a two-level fluctuator. This fluctuator arises from the quantum states of a multijunction SQUID with spatially inhomogeneous SEJs resembling a multijunction array.>
We have measured with high accuracy (100 ppm) and high precision (5--10 ppm) the impedance of a rf-driven resistive superconducting quantum interference device (SQUID) as a function of the amplitude and frequency of the radio-frequency (rf) bias, as a function of the current bias, and as a function of several other circuit parameters. We have developed the coupled differential equations for the resistive SQUID and for the rf tank circuit. The fit of the solutions of these equations to the data for nonhysteretic junctions is excellent. We were unable to develop solutions for the hysteretic case and thus simply present examples of typical data obtained in order to illustrate the differences with the nonhysteretic case. The relationship of this study to noise thermometry using resistive SQUID's is indicated.
The dynamics and noise of a dc superconducting quantum interference device (SQUID) with the McCumber parameter βc=2πR2IcC/Φ0 close to the unity (where Ic, R, C are the critical current, the shunt resistance, and the capacitance of the Josephson junctions comprising the SQUID, respectively, and Φ0=2.07×10−15 Wb is the magnetic flux quantum) integrated with a planar spiral input coil have been experimentally studied. The length of the spiral input coil was chosen to match its λ/4 microwave resonance frequency to the plasma resonance frequency of the SQUID. The input coil resonance enhances the overall quality factor Q of the Josephson oscillations in the SQUID and, as a result, increases the dynamic resistance Rd and the gradient of the flux-to-voltage characteristics ∂V/∂Φ without hysteresis. This relaxes the tolerance for the βc parameter, simplifies the technological process, and improves the yield of devices. A dc SQUID with loop inductance L=31.4 pH, βc=0.72, and a six turn input coil has demonstrated a nondistorted quasisinusoidal flux-to-voltage transfer function with an exceptionally large modulation depth of approximately 140 μV peak-to-peak. A spectral density of the intrinsic magnetic flux noise as low as 3.5×10−7 Φ0/Hz1/2 has been measured in the double stage configuration at a temperature of 4.2 K using direct read-out electronics. This corresponds to the intrinsic energy resolution of ε=12.5h. In combination with an intermediary transformer, the current resolution of the SQUID is as low as 1.25 pA/Hz1/2 with an input coil inductance of 58 nH. The coupled energy resolution is εc=45h in the white noise region.
We measured the amplitude–frequency characteristics of radio frequency superconducting quantum interference devices (rf SQUIDs) over a temperature range between 65 and 79 K. Using the expressions derived from the recently developed rf SQUID theory, valid also at large thermal fluctuations, we determined from these data the basic parameters of high-transition-temperature superconductor (HTS) rf SQUIDs. These parameters were: (a) the high-frequency coupling coefficient between the rf SQUID and the tank circuit resonator, k, (b) the SQUIDs hysteretic parameter, β, (c) the critical current of the Josephson junction, Ic, (d) its normal resistance, Rn, and (e) its noise parameter, Γ. We found a good agreement with the values of β(Ic) and Rn determined directly after destructively opening the SQUID loop. In accordance with the theoretical predictions, our experimental results show that at large thermal fluctuation levels (T≅77 K), rf SQUIDs with large loop inductance operate in nonhysteretic mode up to β values exceeding 3. Furthermore, we have shown that the optimal energy sensitivity is attained in the nonhysteretic mode at a value of β distinctly higher than 1. A quantitative comparison of white noise predicted by the theory with that obtained from the experiment showed a reasonable agreement. We also discussed the contribution of the phase information to the SQUID’s signal and noise at optimum operation conditions, when a mixer was used as a signal detector.
The electrical equations of a resonant circuit fed with a radio-frequency current and inductively coupled to a weakly superconducting loop have been derived. The current-voltage characteristic of the rf superconducting quantum interference device can then be calculated and studied as a function of the junction resistance or of the resonance frequency, enabling its behavior to be better understood. As shown by Kurkijärvi, the large positive slope of the steps and the rounding of the characteristic result from thermal noise. However, in order to explain quantitatively the experimental results concerning, namely, point contact weak links which are generally oxidized or which have several contact points, it is useful to remark that the connection between the two superconductors constituting the Josephson junction may be made from n resistive paths. The mean thermal energy of the fluctuating flux is then close to nkbT instead of kbT if the inductances linking the contact points are large enough, that is, on the order of 10−11 H.