The nitrogen-vacancy (NV) center is a point defect in diamond and has been championed as a promising solid-state "artificial atom." NV center properties such as its bright luminescence, room-temperature optical readout of spin states, and long spin decoherence lifetime make it an excellent system for applications in quantum information processing, high sensitivity magnetometry, and biotagging. In all applications, near-surface NVs are desirable. However, it has been found that the favorable properties of the NV center are significantly diminished as the NV center nears the surface. \nThis dissertation presents efforts in understanding the effect of the surface on the luminescence of NV centers less than a wavelength of light from the surface. We use plasma assisted etching to, independently, change the surface termination and bring the NV closer to the surface. We find that treating the surface with CF4 plasma results in a deposited polymerous fluorocarbon which helps stabilize nearby NVs. We propose using a downstream etcher to bring NVs closer to the surface, while minimizing damage and maintaining NV luminescence. Finally, we enhance emission of these near-surface NVs by coupling them into a hybrid diamond plasmonic cavity. The fabricated devices result in a measured Q of 170, higher than other previously fabricated diamond plasmonic devices.
The nitrogen-vacancy (NV) center is a point defect in diamond and has been championed as a promising solid-state "artificial atom." NV center properties such as its bright luminescence, room-temperature optical readout of spin states, and long spin decoherence lifetime make it an excellent system for applications in quantum information processing, high sensitivity magnetometry, and biotagging. In all applications, near-surface NVs are desirable. However, it has been found that the favorable properties of the NV center are significantly diminished as the NV center nears the surface. \nThis dissertation presents efforts in understanding the effect of the surface on the luminescence of NV centers less than a wavelength of light from the surface. We use plasma assisted etching to, independently, change the surface termination and bring the NV closer to the surface. We find that treating the surface with CF4 plasma results in a deposited polymerous fluorocarbon which helps stabilize nearby NVs. We propose using a downstream etcher to bring NVs closer to the surface, while minimizing damage and maintaining NV luminescence. Finally, we enhance emission of these near-surface NVs by coupling them into a hybrid diamond plasmonic cavity. The fabricated devices result in a measured Q of 170, higher than other previously fabricated diamond plasmonic devices.
The Nitrogen-Vacancy (NV) color center is a defect of diamond which behaves as an artificial atom hosted in a solid-state matrix. Due to its electron spin properties which can be read-out and manipulated as an elementary quantum system, the NV center has found a wide panel of applications as a qubit for quantum information and as a magnetic field sensor. However these applications require to control the properties of the NV centers and their localization. This doctoral thesis investigates methods allowing us to tailor the properties of NV centers by combining techniques for the implantation of nitrogen atoms and the plasma-assisted (CVD) synthesis of diamond.The manuscript is divided into six chapters. The first chapter summarizes the properties of the NV center which will set our objectives for the NV engineering. The second chapter will describe how arrays of NV centers can be created using Focused Ion Beam implantation. The results open a wide range of applications for the targeted creation of NV centers in diamond structures such as photonic crystals and tips. However the low kinetic energy which is required for achieving implantation within a spot of 10-nm diameter leads to shallow defects which properties are strongly affected by the sample surface. The third chapter investigates how the overgrowth of a diamond layer over implanted NV centers can remove the detrimental influence of the surface. The fourth and fifth chapters describe effective methods for NV center fabrication through the control of the CVD growth conditions of the hosting crystal. Thin layers with high NV doping can be grown and almost perfect control of the orientation of the NV axis can be achieved. With the goal to optimize the spin coherence properties, the sixth chapter investigates how the electron spin of the NV center can be protected from decoherence effects induced by magnetic noise due to the unpolarized spins in the diamond lattice.
When the word diamond comes up, the majority of people thinks about engagement rings or gemstones. In fact, it is additionally, one of the most promising host materials for the implementation of advanced technology, exploiting the nature of quantum physics. Such quantum technologies have disruptive potential, ones the quantum effects can be applied in macroscopic, commercial products. The nitrogen-vacancy (NV) centre in diamond is a promising candidate to perform such tasks in the fields of quantum computation, quantum cryptography or metrology. Especially in the field of quantum sensing, the NV sensor impresses with nano-scale spatial resolution paired with high sensitivity. The electronic spin of the atomic-sized point defect can be initialised, manipulated and read-out at ambient conditions and coherence lifetimes are comparably long. Diamond magnetometers based on negatively charged NV centres have shown to be very attractive, and the sensitivity goes down to the single-atom level. In order to exploit such a high sensitivity level for sensing prospects, in this thesis, the NV centres are fabricated well confined in a certain distance to the diamond surface, since the detectable field usually decays with the third power of the distance between sensor and target. The surface depicts a fracture of the spin wise protecting diamond lattice and charge fluctuations affect the stability of NV centres, which are overcome by diamond surface termination. In order to improve the sensitivity further, the sensor density, measurement contrast and interaction time are increased. The nitrogen doping technique, which is applied during a plasma-enhanced chemical vapour deposition (PECVD) diamond growth process is used to fabricate NV centre ensembles aligned along one diamond crystal axis, thereby improving the measurement contrast by a factor up to four. The interaction time limiting spin bath is analysed using the sensor capabilities of the NVs, which leads to enhanced growth strategies and the fabrication of sensitivity optimised NV centre ensembles for magnetometry applications.
Scalable realizations of quantum network technologies utilizing the nitrogen vacancy center in diamond require creation of optically coherent NV centers in close proximity to a surface for coupling to optical structures. We create single NV centers by 15N ion implantation and high-temperature vacuum annealing. Origin of the NV centers is established by optically detected magnetic resonance spectroscopy for nitrogen isotope identification. Near lifetime-limited optical linewidths (< 60 MHz) are observed for the majority of the normal-implant (7∘, ≈ 100 nm deep) 15NV centers. Long-term stability of the NV− charge state and emission frequency is demonstrated. The effect of NV-surface interaction is investigated by varying the implantation angle for a fixed ion-energy, and thus lattice damage profile. In contrast to the normal implant condition, NVs from an oblique-implant (85∘, ≈ 20 nm deep) exhibit substantially reduced optical coherence. Our results imply that the surface is a larger source of perturbation than implantation damage for shallow implanted NVs. This work supports the viability of ion implantation for formation of optically stable NV centers. However, careful surface preparation will be necessary for scalable defect engineering.
Nitrogen-vacancy centers (NVs) are an atomic defect in diamond which possess remarkable fluorescence and spin properties which can be used for multiple metrological applications, particularly when the NV is hosted in nanodiamond, which can be easily integrated with a variety of nanoscale systems. A new class of nanodiamond hybrid nanostructures was developed using bottom-up synthesis methods. In this work, coupling between NV centers and plasmonic, excitonic and magnetic nanoparticles in these nanodiamond hybrid nanostructures is investigated using fluorescence lifetime measurements, spin relaxometry measurements and modeled using finite element method (FEM) and Monte Carlo simulations. This work not only characterizes the properties of these nanodiamond-hybrid nanostructures but also facilitates design guidelines for future hybrid structures with enhanced metrological and imaging capabilities.
Diamond is unique. Whether mechanical, thermal, electrical or optical, its properties are within the most extreme compared to those of any other material. This, together with the fact that in the last fifty years the synthesis of artificial diamond has become a reality, makes it very attractive for engineering and technological purposes. The range of diamond-based applications is very diverse and, among the others, includes its use in mechanical machining, high-power high-frequency electronics and high transmissivity optics. -- Diamond is also host to a wide variety of crystallographic defects. Appropriately controlled, they can be used to tune the characteristics of the material, but even more interestingly they often possess attractive optical properties on their own. In particular, nitrogen-vacancy (NV) centres in diamond have been the subject of extensive study in the last few years. They possess unique room-temperature optical and spin properties which make them promising systems for solid-state qubits in quantum information technologies and for emerging applications in biotechnology, nanomedicine and high resolution magnetometry, such as drug delivery, fluorescent biomarking and spin imaging. -- This thesis is focused on NV centres in diamond. I first present an extensive review on diamond as a material, describing in detail its physical properties, the methods that have been developed to synthesise it and some of its possible applications. I then move the attention specifically to NV centres in nanodiamonds (NDs), i.e. diamond crystals in the nanometre size range (0-100 nm). They are a potential candidate for emerging technologies including high-resolution magnetometry and biomedical imaging. For these applications, specific material requirements, such as the small size of the diamond nanocrystals and the optical stability of the hosted NV centres, are crucial. The NV stability with respect to the nanodiamond size and surface is the central theme of this thesis. I analyse the optical behaviour of NV centres in nanodiamond while varying a number of key parameters such as size, surface termination and diamond origin. Based on the measurements, I conclude whether the nanodiamond size and the NV surface proximity are factors that must be taken into consideration in order to control the material and realise nanotechnologies based on NV centres in nanodiamonds.
We investigated the effect of fluorine-terminated diamond surface on the charged state of shallow nitrogen vacancy defect centers (NVs). Fluorination is achieved with CF4 plasma and the surface chemistry is confirmed with x-ray photoemission spectroscopy. Photoluminescence of these ensemble NVs reveal that fluorine-treated surfaces lead to a higher negatively charged nitrogen vacancy (NV-) population than oxygen-terminated surfaces. Using surface chemistry to control NV charges, in particular increasing the density of NV- centers, is an important step towards improving the optical and spin properties of NVs for quantum information processing and magnetic sensing.