Defects in diamond have evolved as unique object for their potential application for Optical imaging and Nano-photonics. High pressure high temperature (HPHT) grown type-Ib diamond particles were milled down to the size of ~ 80 nm and purified to remove iron & graphitic carbon impurities and irradiated with 35 KeV He+ ions to create vacancies in the diamond lattice. Vacancies diffuse close to substitutional nitrogen impurities of nano-diamond particles upon thermal treatment. Characteristic sharp emission of NV centers were observed at 575.5 nm and 637.9 nm corresponding to NV° and NV− charged states in addition to a broad emission in the range 550-750 nm. Structural and photo-physical behavior of these fluorescent diamonds was found to depend on the method of purification adopted. Samples purified through acid reflux were found suitable for bio-imaging applications while, sample purified through air oxidation shows properties desirable for Nano-photonic applications. Photon-correlation measurements of emission from individual diamond nanoparticles using Hanbury Brown and Twiss interferometer (HBT) shows anti-bunching curve with g2(t)= 0 confirming their suitability as single photon source. Such sources of indistinguishable photons are highly desirable for quantum computation and quantum optics applications.
Nitrogen-vacancy (NV) centers in diamonds have been an epicenter of research for diverse applications in quantum technologies. It is therefore imperative that their fabrication techniques are well understood and characterized for the technological scalability of these applications. A comparative study of the optical and spin properties of NVs created by ion implantation and chemical vapor deposition delta-doping is thus presented, combined with an investigation on the impact of annealing in vacuum at different temperatures. In addition, nanopillars are fabricated by electron beam lithography and reactive ion etching for enhanced photon collection efficiency. An extensive combination of characterization techniques is employed. Notably, the smallest nanopillars present fluorescence enhancements of factor around 50, compared to the unstructured regions. Annealing is also demonstrated to increase the optical contrast between the NVs' electronic states, the coherence and relaxation times both in bulk as in pillars. Regarding the NV preparation technique, the delta-doping is shown to create NVs with less lattice defects and strain compared to implantation. • Comparative study of optical and spin properties of implanted and δ-doped CVD NVs • Impact of structuring with nanopillars and annealing on the NV properties • Fluorescence enhancement factors of above 30 in 100–150 nm diameter pillars • 3-Fold increase in ODMR contrast of all samples after annealing • Increase of coherence and relaxation times after annealing
Silicon has turned from a niche laboratory-scale material into the backbone of modern electronics. Diamond functionalized with color centers could follow a similar path and grow from proof-of-concepts experiments to application-oriented quantum technologies. Quantum sensing, communication, and information processing with color centers has been proven to work in scientific experiments and enhanced sensitivities as well as novel functionalities have been reported. While the first generation of diamond quantum devices relied on color centers formed uncontrolled in natural diamond with a high statistical variation in composition and crystallinity, the situation has changed nowadays. With the emergence of high purity monocrystals and the option for isotopic purification of the carbon matrix, technological progress in materials science on the atomic-scale enabled tailoring the spin properties in diamond. But, since many color centers typically require vacancies to combine with impurities in the carbon lattice via diffusion, the generation of color centers underlies a statistical process providing only little control on the center's final position in the crystal lattice. The negatively charged nitrogen-vacancy (NV
−) center is the most studied optically active defect in diamond and exhibits remarkable spin properties and sensing capabilities, even on the nanoscale and at room temperature. The spin properties of NV
− centers close to the surface (1\,nm - 30\,nm) have been thoroughly studied and the deeper the spins are located in diamond the less decoherence from surface defects is observed. Creating NV
− centers at the surface by nitrogen ion implantation and burying them beneath a thin diamond layer via chemical vapor deposition (CVD) of diamond is reported to enhance the coherence times significantly. By separating the color center generation from controlling the resulting depth by an additional diamond layer, narrow depth profiles can be achieved by reducing the ion energy during implantation. Although the coherence properties improve, many of the implanted NV
− center are reported to vanish in the hydrogen-rich plasma of growth CVD chambers. The mechanism responsible for the instability of NV
− centers towards the plasma remains unclear, though. One hypothesis is the formation of nitrogen-vacancy-hydrogen centers from diffusing hydrogen and implanted NV
− centers but is has not been proven, yet. Here, we demonstrate the fabrication of depth confined NV
− centers by combining low energy (1\,keV - 5\,keV) ion implantation and CVD overgrowth. By increasing the thickness of the overgrown layer (6\,nm - 100\,nm) the influence of surface noise is shown to decrease leading to bulk-like coherence properties of up to $450\,\upmu$s (Hahn-echo) and
T2∗ dephasing times around $20\,\upmu$s. Monitoring the NV
− density as a function of the overgrowth time, we analyze the kinetics of the passivation in case of implanting ion doses of 10
11 15N
+/cm
2 and 10
12 15N
+/cm
2. The passivation turns out to occur faster for lower doses offering insights into sub-surface hydrogen diffusion in diamond. Analyzing the spin bath before and after overgrowth reveals a drastic reduction in paramagnetic spins after the CVD process but no NVH
− is found around the surviving NV
− centers. Checking the chemical composition in overgrown implantation sites with secondary-ion-mass-specrometry (SIMS), however, confirms significant amounts of hydrogen in the
15N-implanted layers. Since the concentration found for hydrogen exceeds the one for nitrogen by far, we suggest that diffusing hydrogen interacts also with vacancies forming probably mostly diamagnetic defects. In the last part of this dissertation, NV
− centers are generated with sub-nanometer precision below a thin
13C-enriched layer for quantum simulation. For fabricating the spin architecture starting from a
12C base layer, we overgrow implanted nitrogen with a
13C layer and bury the spins beneath a 30\,nm-thick
12C capping layer. By measuring the coupling strength between the electron and nuclear spins, we deduce a NV
− placement accuracy reaching below one nanometer with respect to the
13C-layer. Regarding the spin properties of the electron spins, no reduction in
T2 is observed despite of the proximity to the dense
13C-bath. As a consequence, the overgrowth of NV
− centers is demonstrated as a bottom-up approach to produce buried spin architectures with sharp isotopic transitions and efficient
13C-NV
− coupling. Together with the potential for bulk-like coherence properties the synergy of implantation and overgrowth is a powerful tool to fabricate reproducible quantum systems with tailored properties and high depth confinement.
The Nitrogen-Vacancy (NV) color center is a defect of diamond which behaves as an artificial atom hosted in a solid-state matrix. Due to its electron spin properties which can be read-out and manipulated as an elementary quantum system, the NV center has found a wide panel of applications as a qubit for quantum information and as a magnetic field sensor. However these applications require to control the properties of the NV centers and their localization. This doctoral thesis investigates methods allowing us to tailor the properties of NV centers by combining techniques for the implantation of nitrogen atoms and the plasma-assisted (CVD) synthesis of diamond.The manuscript is divided into six chapters. The first chapter summarizes the properties of the NV center which will set our objectives for the NV engineering. The second chapter will describe how arrays of NV centers can be created using Focused Ion Beam implantation. The results open a wide range of applications for the targeted creation of NV centers in diamond structures such as photonic crystals and tips. However the low kinetic energy which is required for achieving implantation within a spot of 10-nm diameter leads to shallow defects which properties are strongly affected by the sample surface. The third chapter investigates how the overgrowth of a diamond layer over implanted NV centers can remove the detrimental influence of the surface. The fourth and fifth chapters describe effective methods for NV center fabrication through the control of the CVD growth conditions of the hosting crystal. Thin layers with high NV doping can be grown and almost perfect control of the orientation of the NV axis can be achieved. With the goal to optimize the spin coherence properties, the sixth chapter investigates how the electron spin of the NV center can be protected from decoherence effects induced by magnetic noise due to the unpolarized spins in the diamond lattice.
Abstract Powered by the mutual developments in instrumentation, materials and theoretical descriptions, sensing and imaging capabilities of quantum emitters in solids have significantly increased in the past two decades. Quantum emitters in solids, whose properties resemble those of atoms and ions, provide alternative ways to probing natural and artificial nanoscopic systems with minimum disturbance and ultimate spatial resolution. Among those emerging quantum emitters, the nitrogen vacancy (NV) color center in diamond is an outstanding example due to its intrinsic properties at room temperature (highly-luminescent, photo-stable, biocompatible, highly-coherent spin states). This review article summarizes recent advances and achievements in using NV centers within nano- and single crystal diamonds in sensing and imaging. We also highlight prevalent challenges and material aspects for different types of diamond and outline the main parameters to consider when using color centers as sensors. As a novel sensing resource, we highlight the properties of NV centers as light emitting electrical dipoles and their coupling to other nanoscale dipoles e.g. graphene.