Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Wiley eBooks

Superconductor Microelectronics: A Digital RF Technology for Software Radios

DARREN K. BROCK

Published May 15, 2002• 2 citations
Publisher

Abstract

This chapter contains sections titled: Introduction Superconductivity and the Josephson Effect Established Applications of Superconductors Emerging Applications - Software Defined Radio Rapid Single Flux Quantum Digital Logic Circuit Characteristics Example RSFQ Logic Gate - RS Flip Flop RSFQ Data Converters RSFQ Scaling theory Cryogenic Aspects Superconductor SDR for Commercial Applications Superconductors in Wireless Communications Advantages of Superconductor Receivers Trends in Spread Spectrum Communications High Power Amplifier Linearization Digital RF Transceiver Superconductor SDR for Military Applications Co-Site Interference Digitally Dehopping Spread Spectrum Signals Satellite Communications Accommodating New Waveforms Massive Time Multiplexing Conclusions Acknowledgements References

DOI
10.1002/0470846003.ch5

Related papers

Superconductor Digital-RF Receiver Systems

Oleg A. Mukhanov, Dmitri E. Kirichenko, I. V. Vernik +12 more

Digital superconductor electronics has been experiencing rapid maturation with the emergence of smaller-scale, lower-cost communications applications which became the major technology drivers. These applications are primarily in the area of wireless communications, radar, and surveillance as well as in imaging and sensor systems. In these areas, the fundamental advantages of superconductivity translate into system benefits through novel Digital-RF architectures with direct digitization of wide band, high frequency radio frequency (RF) signals. At the same time the availability of relatively small 4K cryocoolers has lowered the foremost market barrier for cryogenically-cooled digital electronic systems. Recently, we have achieved a major breakthrough in the development, demonstration, and successful delivery of the cryocooled superconductor digital-RF receivers directly digitizing signals in a broad range from kilohertz to gigahertz. These essentially hybrid-technology systems combine a variety of superconductor and semiconductor technologies packaged with two-stage commercial cryocoolers: cryogenic Nb mixed-signal and digital circuits based on Rapid Single Flux Quantum (RSFQ) technology, room-temperature amplifiers, FPGA processing and control circuitry. The demonstrated cryocooled digital-RF systems are the world's first and fastest directly digitizing receivers operating with live satellite signals in X-band and performing signal acquisition in HF to L-band at ∼30GHz clock frequencies.

IEICE Transactions on Electronics•Mar 1, 2008•129 citations

Superconductor Digital-RF Transceiver Components

Oleg A. Mukhanov, Deepnarayan Gupta, Alan M. Kadin +3 more

Superconductive technology offers unparalleled digital and mixed-signal circuit performance, advancing digital processing from baseband to RF stages. This allows elimination of analog filters and mixers with generally poorly controlled phase performance, causing intersymbol interference limiting an overall communication system performance. HYPRES has been developing superconducting circuit components for application to digital RF communication transceivers. The components include low-pass and band-pass analog-to-digital converters, digital decimation and correlation-based filters, digital up/down-converters, and low-time-jitter clock sources. All of these are based on ultra-fast Rapid Single Flux Quantum (RSFQ) digital circuits, with clock rates up to 20 GHz demonstrated with 3-micron technology, and being scaled to 40 GHz and above. In this paper, we will discuss design and performance of some of these components. 1.

•Jan 1, 2006•7 citations

Superconductor digital RF development for software radio

DARREN K. BROCK, Oleg A. Mukhanov, José M. de la Rosa

We review a new "direct digitization" approach for "digital RF" architectures for software radio. Although direct digitization usually implies the simultaneous digitization of all channels in a particular band at a downconverted IF, we use this term to refer exclusively to the direct digitization of all bands, from near DC to RF. Furthermore, we present results on band selection and digitization of RF signals directly at the carrier frequency with high resolution. These novel approaches are enabled by a superconductor analog-to-digital converter technology using an ultra-fast IC logic known as Rapid Single Flux Quantum (RSFQ) logic, with performance capable of enabling envisioned software radios.

IEEE Communications Magazine•Jan 1, 2001•44 citations

Superconductor analog-to-digital converters

Oleg A. Mukhanov, Deepnarayan Gupta, Alan M. Kadin +1 more

Ultrafast switching speed, low power, natural quantization of magnetic flux, quantum accuracy, and low noise of cryogenic superconductor circuits enable fast and accurate data conversion between the analog and digital domains. Based on rapid single-flux quantum (RSFQ) logic, these integrated circuits are capable of achieving performance levels unattainable by any other technology. Two major classes of superconductor analog-to-digital converters (ADCs) are being developed - Nyquist sampling and oversampling converters. Complete systems with digital sampling at rates of /spl sim/20 GHz and above have been demonstrated using low-temperature superconductor device technology. Some ADC components have also been implemented using high-temperature superconductors. Superconductor ADCs have unique applications in true digital-RF communications, broadband instrumentation, and digital sensor readout. Their designs, test results, and future development trends are reviewed.

Proceedings of the IEEE•Sep 20, 2004•182 citations

Advancement of superconductor digital electronics

Akira Fujimaki

Advancement of superconductor digital electronics, especially Rapid Single Flux Quantum (RSFQ) logic circuit is described. Ultra short pulse of a voltage generated across a Josephson junction and release from charging/discharging process for signal transmission in RSFQ circuits enable us to reduce power consumption and gate delay. The power-delay products (PDPs) of RSFQ integrated circuits (ICs) are 4 or 5 orders of magnitude smaller than those of semiconductor ICs. The fabrication process technology and the related designing technology have been advanced, and RSFQ ICs have been applied to software-defined radio receivers, superconductor detector array systems, and supercomputers. Recently, several kinds of energy-efficient single flux quantum circuit have been proposed to obtain further advantage to semiconductor devices. The PDPs of these circuits become at least 1 order smaller than those of conventional RSFQ circuits.

IEICE Electronics Express•Jan 1, 2012•2 citations

Digital Electronics

Oleg A. Mukhanov

This chapter describes developments in digital and mixed-signal applications of superconducting electronics. In the class of mixed-signal circuits, the analog-to-digital converters are the most developed and promising circuits for many applications. Low-temperature superconductors such as Nb are the main superconductor materials for digital and mixed-signal circuits. In order to eliminate or at least significantly reduce the static power dissipation in RSFQ circuits, a number of different logic approaches have been proposed ranging from the simple reduction of the bias resistor resistance to its complete elimination. Contrary to predominantly sequential RSFQ-type circuits described above, RQL logic gates are combinational. To provide a sufficient flux bias signal to the next gate in presence of possible fabrication spread, one has to ensure adequate current flowing through the transformer. The largest superconducting random access memory was demonstrated only at 4 kbit per chip which was not sufficient for applications.

CRC Press eBooks•May 17, 2022•0 citations
This chapter contains sections titled: Introduction Superconductivity and the Josephson Effect Established Applications of Superconductors Emerging Applications - Software Defined Radio Rapid Single Flux Quantum Digital Logic Circuit Characteristics Example RSFQ Logic Gate - RS Flip Flop RSFQ Data Converters RSFQ Scaling theory Cryogenic Aspects Superconductor SDR for Commercial Applications Superconductors in Wireless Communications Advantages of Superconductor Receivers Trends in Spread Spectrum Communications High Power Amplifier Linearization Digital RF Transceiver Superconductor SDR for Military Applications Co-Site Interference Digitally Dehopping Spread Spectrum Signals Satellite Communications Accommodating New Waveforms Massive Time Multiplexing Conclusions Acknowledgements References
Digital superconductor electronics has been experiencing rapid maturation with the emergence of smaller-scale, lower-cost communications applications which became the major technology drivers. These applications are primarily in the area of wireless communications, radar, and surveillance as well as in imaging and sensor systems. In these areas, the fundamental advantages of superconductivity translate into system benefits through novel Digital-RF architectures with direct digitization of wide band, high frequency radio frequency (RF) signals. At the same time the availability of relatively small 4K cryocoolers has lowered the foremost market barrier for cryogenically-cooled digital electronic systems. Recently, we have achieved a major breakthrough in the development, demonstration, and successful delivery of the cryocooled superconductor digital-RF receivers directly digitizing signals in a broad range from kilohertz to gigahertz. These essentially hybrid-technology systems combine a variety of superconductor and semiconductor technologies packaged with two-stage commercial cryocoolers: cryogenic Nb mixed-signal and digital circuits based on Rapid Single Flux Quantum (RSFQ) technology, room-temperature amplifiers, FPGA processing and control circuitry. The demonstrated cryocooled digital-RF systems are the world's first and fastest directly digitizing receivers operating with live satellite signals in X-band and performing signal acquisition in HF to L-band at ∼30GHz clock frequencies.
Superconductive technology offers unparalleled digital and mixed-signal circuit performance, advancing digital processing from baseband to RF stages. This allows elimination of analog filters and mixers with generally poorly controlled phase performance, causing intersymbol interference limiting an overall communication system performance. HYPRES has been developing superconducting circuit components for application to digital RF communication transceivers. The components include low-pass and band-pass analog-to-digital converters, digital decimation and correlation-based filters, digital up/down-converters, and low-time-jitter clock sources. All of these are based on ultra-fast Rapid Single Flux Quantum (RSFQ) digital circuits, with clock rates up to 20 GHz demonstrated with 3-micron technology, and being scaled to 40 GHz and above. In this paper, we will discuss design and performance of some of these components. 1.
We review a new "direct digitization" approach for "digital RF" architectures for software radio. Although direct digitization usually implies the simultaneous digitization of all channels in a particular band at a downconverted IF, we use this term to refer exclusively to the direct digitization of all bands, from near DC to RF. Furthermore, we present results on band selection and digitization of RF signals directly at the carrier frequency with high resolution. These novel approaches are enabled by a superconductor analog-to-digital converter technology using an ultra-fast IC logic known as Rapid Single Flux Quantum (RSFQ) logic, with performance capable of enabling envisioned software radios.
Ultrafast switching speed, low power, natural quantization of magnetic flux, quantum accuracy, and low noise of cryogenic superconductor circuits enable fast and accurate data conversion between the analog and digital domains. Based on rapid single-flux quantum (RSFQ) logic, these integrated circuits are capable of achieving performance levels unattainable by any other technology. Two major classes of superconductor analog-to-digital converters (ADCs) are being developed - Nyquist sampling and oversampling converters. Complete systems with digital sampling at rates of /spl sim/20 GHz and above have been demonstrated using low-temperature superconductor device technology. Some ADC components have also been implemented using high-temperature superconductors. Superconductor ADCs have unique applications in true digital-RF communications, broadband instrumentation, and digital sensor readout. Their designs, test results, and future development trends are reviewed.
Advancement of superconductor digital electronics, especially Rapid Single Flux Quantum (RSFQ) logic circuit is described. Ultra short pulse of a voltage generated across a Josephson junction and release from charging/discharging process for signal transmission in RSFQ circuits enable us to reduce power consumption and gate delay. The power-delay products (PDPs) of RSFQ integrated circuits (ICs) are 4 or 5 orders of magnitude smaller than those of semiconductor ICs. The fabrication process technology and the related designing technology have been advanced, and RSFQ ICs have been applied to software-defined radio receivers, superconductor detector array systems, and supercomputers. Recently, several kinds of energy-efficient single flux quantum circuit have been proposed to obtain further advantage to semiconductor devices. The PDPs of these circuits become at least 1 order smaller than those of conventional RSFQ circuits.
This chapter describes developments in digital and mixed-signal applications of superconducting electronics. In the class of mixed-signal circuits, the analog-to-digital converters are the most developed and promising circuits for many applications. Low-temperature superconductors such as Nb are the main superconductor materials for digital and mixed-signal circuits. In order to eliminate or at least significantly reduce the static power dissipation in RSFQ circuits, a number of different logic approaches have been proposed ranging from the simple reduction of the bias resistor resistance to its complete elimination. Contrary to predominantly sequential RSFQ-type circuits described above, RQL logic gates are combinational. To provide a sufficient flux bias signal to the next gate in presence of possible fabrication spread, one has to ensure adequate current flowing through the transformer. The largest superconducting random access memory was demonstrated only at 4 kbit per chip which was not sufficient for applications.