arXiv:2608.18699

An ultracompact dilution refrigerator for fast quantum device characterization

Clment Geffroy, Dorian Nicolas, Eric Eyraud, Shelender Kumar, Supriya Mandal, Julien Jarreau, Laura Kowalski, Laurent Del-Rey, Didier Dufeu, Nicolas Roch, Wolfgang Wernsdorfer, Quentin Ficheux, Matias Urdampilleta

quant-phcond-mat.mes-hallSubmitted Aug 19, 2026• Announced Aug 20, 2026• 0 citations

arXiv HTML PDF

Abstract

Rapid thermal cycling is a central bottleneck in the development of superconducting quantum devices: conventional dilution refrigerators require cooldowns of a day or more and substantial cryogenic infrastructure, which throttles the fabricate-measure-redesign loop. We present an ultracompact dilution refrigerator (3 kg in mass and 100 mm in diameter) that completes a full cooldown-warm-up cycle to a base temperature of 70 mK in 1.2 hours when unloaded, and in 2.1 hours when fully equipped with the microwave wiring required for qubit measurements, while delivering 20 microW of cooling power at 100 mK. We validate the platform through a complete characterization of a two-fluxonium device: we extract the full circuit Hamiltonian by two-tone spectroscopy, measure energy-relaxation and coherence times, and benchmark single-qubit control. Although the relaxation time is limited by the base temperature of the system, we reach a single-qubit gate fidelity of up to 99%, at the coherence limit set by our operating temperature. These results demonstrate that compact, fast-cycling dilution refrigeration can support state-of-the-art quantum-device characterization without sacrificing measurement quality, offering a practical route to high-throughput quantum-hardware development.

Comments: 8 pages, 5 figures, two appendixes

Related papers

Insertable system for fast turnaround time microwave experiments in a dilution refrigerator

Florian R. Ong, Jean-Luc Orgiazzi, A. de Waard +2 more

Microwave experiments in dilution refrigerators are a central tool in the field of superconducting quantum circuits and other research areas. This type of experiments relied so far on attaching a device to the mixing chamber of a dilution refrigerator. The minimum turnaround time in this case is a few days as required by cooling down and warming up the entire refrigerator. We developed a new approach, in which a suitable sample holder is attached to a cold-insertable probe and brought in contact with transmission lines permanently mounted inside the cryostat. The total turnaround time is 8 h if the target temperature is 80 mK. The lowest attainable temperature is 30 mK. Our system can accommodate up to six transmission lines, with a measurement bandwidth tested from zero frequency to 12 GHz. This bandwidth is limited by low-pass components in the setup; we expect the intrinsic bandwidth to be at least 18 GHz. We present our setup, discuss the experimental procedure, and give examples of experiments enabled by this system. This new measurement method will have a major impact on systematic ultra-low temperature studies using microwave signals, including those requiring quantum coherence.

arXiv:1209.1039Review of Scientific InstrumentsSep 1, 20126 citations

Experimental characterization of superconducting transmon qubits

MOSE' GUERINI

Quantum information processing holds the promise of a paradigm shift in computational power for specific problem classes. While contemporary quantum processors operate in the Noisy Intermediate-Scale Quantum (NISQ) regime and remain highly susceptible to errors, ongoing experimental efforts on these near-term devices are crucial for advancing the underlying technology. Among the various hardware implementations, superconducting quantum circuits stand out as one of the most robust architectures for scalable quantum technologies. Nevertheless, the primary bottleneck in these systems is the fragility of quantum information: interactions with the environment inevitably perturb the quantum states, a phenomenon known as decoherence. This rapid loss of stored information imposes a fundamental limit on the time available to reliably execute computations on these devices. Within this context, this thesis focuses on the comprehensive experimental characterization of a planar chip featuring isolated, fixed-frequency superconducting transmon qubits. The measurements were conducted in a cryogenic environment, relying on a dilution refrigerator to maintain the device at millikelvin temperatures. To probe the quantum system under these conditions, custom measurement scripts were developed to operate state-of-the-art microwave control electronics (Keysight Quantum Control System), establishing full control over pulse generation, signal acquisition, and digital demodulation. The experimental workflow systematically mapped the physical properties of the device through a progressive series of characterization steps. Initial spectroscopic techniques probed the coupled resonator-qubit system, identifying its fundamental transition frequencies and relevant energy scales. Building upon these frequency-domain measurements, coherent control was achieved by calibrating resonant microwave pulses to drive single-qubit rotations, enabling the reliable preparation of the qubit in excited or coherent superposition states. Finally, specific time-domain protocols were implemented to evaluate the operational limits of the device. By executing standard pulse sequences, the characteristic decoherence metrics of the system, namely the longitudinal energy relaxation time (T1) and the inhomogeneous dephasing time (T2*), were successfully extracted, providing a quantitative assessment of the qubit's overall performance and establishing a baseline for future implementations of more advanced quantum control protocols.

Apr 15, 20260 citations

Millikelvin temperature cryo-CMOS multiplexer for scalable quantum device characterisation

Anton Potočnik, S. Brebels, Jeroen Verjauw +11 more

Abstract Quantum computers based on solid state qubits have been a subject of rapid development in recent years. In current noisy intermediate-scale quantum technology, each quantum device is controlled and characterised through a dedicated signal line between room temperature and base temperature of a dilution refrigerator. This approach is not scalable and is currently limiting the development of large-scale quantum system integration and quantum device characterisation. Here we demonstrate a custom designed cryo-CMOS multiplexer operating at 32 mK. The multiplexer exhibits excellent microwave properties up to 10 GHz at room and millikelvin temperatures. We have increased the characterisation throughput with the multiplexer by measuring four high-quality factor superconducting resonators using a single input and output line in a dilution refrigerator. Our work lays the foundation for large-scale microwave quantum device characterisation and has the perspective to address the wiring problem of future large-scale quantum computers.

arXiv:2011.11514Quantum Science and TechnologySep 23, 202125 citations

High-density wiring solution for 500-qubit scale superconducting quantum processors

Jian-Yan Tian, Yipu Song, Pei Liu +3 more

Scaling superconducting quantum processors to hundreds of qubits is essential for demonstrating quantum advantage and implementing quantum error correction codes with larger distances. A key challenge is integrating control and readout wiring without compromising cryogenic or electronic performance. To address this, we performed a systematic analysis of the thermal budget within a dilution refrigerator and developed high-density 0.5 mm SCuNi-CuNi coaxial cable sets optimized for heat load management. This enables the integration of 696 control lines and 40 readout amplification chains into a dilution refrigerator with a cooling power of 1 mW at 100 mK, maintaining a stable base temperature of ∼8 mK for over a year. We validated the platform's performance with two large-scale quantum processors: a 540-qubit processor with an average T1 of 35 μs and a 156-qubit processor with 182 tunable couplers, achieving average fidelities of 99.9% for single-qubit gates and 99.0% for two-qubit gates. This study demonstrates a viable high-density wiring solution for controlling and measuring processors at the 500-qubit scale and provides critical engineering insights for larger-scale quantum computing systems.

Review of Scientific InstrumentsOct 1, 20251 citation

Universal Fast-Flux Control of a Coherent, Low-Frequency Qubit

Helin Zhang, Srivatsan Chakram, Tanay Roy +6 more

The heavy-fluxonium circuit is a promising building block for superconducting quantum processors due to its long relaxation and dephasing time at the flux-frustration point. However, the suppressed charge matrix elements and low transition frequency make it challenging to perform fast single-qubit gates using standard protocols. We report on new protocols for reset, fast coherent control,and readout that allow high-quality operation of the qubit with a 14 MHz transition frequency, an order of magnitude lower in energy than the ambient thermal energy scale. We utilize higher levels of the fluxonium to read out the qubit state and to initialize the qubit with 97% fidelity corresponding to cooling it to 190 μK. Instead of using standard microwave pulses, we control the qubit only with fast-flux pulses, generating control fields much larger than the qubit frequency. We develop a universal set of gates based on nonadiabatic Landau-Zener transitions that act in 20-60 ns, less than the single-qubit Larmor period. We measure qubit coherence of T1,T2e∼300 μs for a fluxonium in a 2D architecture and realize single-qubit gates with an average gate fidelity of 99.8% as characterized by randomized benchmarking.

Jan 15, 2021104 citations

Cryogenic electronics for quantum engineering

Loïck Le Guevel

Thousands to millions of sensitive signals will need to be conveyed through all the temperature stages of a dilution fridge to operate future large-scale quantum processors made of many quantum bits. The exploding number of heat-conductive coaxial cables will overwhelm the fridge cooling capabilities, detrimental to the quantum core. Moving the control electronics down to cryogenic temperatures allows the use of already-available superconducting cables, alleviating heat conduction between low-temperature stages, and appears as a clear path towards scalability in the number of operating qubits.This Ph.D. work aimed to explore the use of the industrial CMOS 28nm Fully-Depleted Silicon-On-Insulator (FD-SOI) technology at cryogenic temperatures for quantum computing applications. Our first objective is to extend the sparse existing knowledge about the FD-SOI 28nm transistors at cryogenic temperatures for practical aspects of circuit design and later for developments of compact models.To speed-up the characterization of single devices with the inherent hour-long cooling cycles, we designed an integrated circuit multiplexing a thousand of transistors for different geometries and gate-stack flavors for low-frequency measurement of the current-voltage characteristics and pair-matching analysis from 300 down to 0.1K. We discuss and analyze the evolution trends with varying geometry at different temperatures for important quantities in circuit design, such as the transconductance, the conductance, and the transconductance over drain current ratio of individual transistors.Secondly, we explore the low-temperature co-integration and the full on-chip integration of semiconductor quantum devices with classical electronics aimed at specific measurements down to the millikelvin range.We first focus on the sub-nanoampere current measurement of quantum dot devices by designing and characterizing a low-power transimpedance amplifier (TIA). The high-gain amplifier is successfully applied to measure the current across single- and double quantum-dot devices, respectively wire-bonded a few mm away or on-chip integrated a few micrometers-away. To further leverage the integration into the same substrate, we connected GHz-range voltage-controlled oscillators to one of the gates of the double dot in an attempt to observe discrete charge pumping in a fully-integrated device.Lastly, we tackled the measurement of the gate capacitance of single quantum devices by proposing a new measurement scheme making use of the cryogenic electronics capabilities as an alternative to the well-known reflectometry. By integrating a voltage-controlled current excitation and a voltage-sensing amplifier in the 200 MHz range, both in close proximity to the quantum device connected to an LC tank, the read-out circuitry of a variation in the device capacitance becomes a purely lumped-element system with impedance measurement of the resonant circuit without any wave propagation like in reflectometry. This approach increases simplicity and compactness of the measurement set-up. We even replace the bulky passive inductor used in reflectometry by an active inductor made of transistors and capacitors, offering improved scalability with a 3-orders of magnitude lower area for the same inductance. The resulting circuit successfully measured aF-capacitance variations of nanometric transistors at 4.2K revealing oscillatory quantum effects in the gate capacitance as a function of the gate and back-gate voltages.At the end of this dissertation, a picture is given with the challenges laying ahead related to circuit architecture and design for the ultimate goal of entering into the era of large-scale quantum processing.

Jan 13, 20230 citations