We investigate a quantum Otto engine (QOE) constructed from the two-qubit quantum Rabi model, operating within a cavity quantum electrodynamics (QED) architecture. The engine operates with two qubits as the working substance and a single non-Markovian hot thermal bath, modeled via the hierarchical equations of motion (HEOM) formalism. In place of a conventional cold thermal reservoir, the cooling stroke is realized through a projective measurement protocol on the cavity mode, which acts as an ancillary subsystem and effectively mimics a cold bath for the qubit working medium via measurement back-action. A squeezing drive applied to the cavity mode serves as a quantum fuel. We demonstrate that cavity squeezing systematically enhances both the power output and operational efficiency of the engine - the work extracted per unit of heat drawn from the hot bath-driving it above the standard quantum Otto limit. In the limit-cycle regime, the efficiency, while remaining above the Otto bound throughout, asymptotically converges to it from above. This identifies squeezing as a controllable quantum resource for thermodynamic optimization. Our results reveal that the interplay between qubit-cavity coupling, measurement-induced cooling, and non-equilibrium squeezing gives rise to a multi-resource thermodynamic architecture with performance characteristics inaccessible to conventional two-bath quantum Otto engines, thereby providing a concrete route toward experimentally realizable quantum heat engines in cavity QED platforms.
We investigate a quantum Otto engine (QOE) constructed from the two-qubit quantum Rabi model, operating within a cavity quantum electrodynamics (QED) architecture. The engine operates with two qubits as the working substance and a single non-Markovian hot thermal bath, modeled via the hierarchical equations of motion (HEOM) formalism. In place of a conventional cold thermal reservoir, the cooling stroke is realized through a projective measurement protocol on the cavity mode, which acts as an ancillary subsystem and effectively mimics a cold bath for the qubit working medium via measurement back-action. A squeezing drive applied to the cavity mode serves as a quantum fuel. We demonstrate that cavity squeezing systematically enhances both the power output and operational efficiency of the engine - the work extracted per unit of heat drawn from the hot bath-driving it above the standard quantum Otto limit. In the limit-cycle regime, the efficiency, while remaining above the Otto bound throughout, asymptotically converges to it from above. This identifies squeezing as a controllable quantum resource for thermodynamic optimization. Our results reveal that the interplay between qubit-cavity coupling, measurement-induced cooling, and non-equilibrium squeezing gives rise to a multi-resource thermodynamic architecture with performance characteristics inaccessible to conventional two-bath quantum Otto engines, thereby providing a concrete route toward experimentally realizable quantum heat engines in cavity QED platforms.
We present a quantum-heat engine model utilizing a dual spin-pair architecture, wherein an Otto-like cycle is implemented using a single heat bath. The conventional cold bath is replaced by a measurement protocol, enabling engine operation without the need for a second thermal reservoir. Unlike standard quantum-heat engines, our framework employs an ancillary spin pair in a two-dimensional configuration to regulate performance. Operating in finite time, the engine attains finite power, which is enhanced through quantum correlations, specifically correlation between spin pairs and projective measurements on the ancillary pair. The system consists of dual-qubit pairs, where one pair serves as the working medium and the other as an ancillary system facilitating measurement-induced heat exchange. We demonstrate that the engine efficiency can exceed the standard quantum Otto limit through local control of the ancillary pair while maintaining nonzero power output. Moreover, correlation between spin pairs enables efficiency modulation via the measurement basis, underscoring the role of quantum resources in optimizing quantum thermal machines.
Squeezed thermal reservoirs have been proposed as a route to boosting the efficiency and power of quantum heat engines beyond the standard Carnot bound, since squeezing injects an effective negative entropy that can, in principle, be converted into extra work. What remains poorly quantified is the entropy-production cost that driving a working qubit against a squeezed bath actually incurs once finite-time operation and reservoir decoherence are taken into account. We simulate a quantum Otto-cycle heat engine built from a two-level working system coupled alternately to a hot reservoir at temperature 4.2 K, squeezed with squeezing parameter r ranging from 0 to 1.2, and an unsqueezed cold reservoir at 0.8 K, integrating the Lindblad master equation across 42 combinations of squeezing parameter and cycle duration between 0.05 and 2.0 (in units of the inverse qubit gap). At r = 0, mean entropy production per cycle was 0.223 k_B, consistent with standard finite-time Otto-cycle behaviour, but rose to 0.361 k_B at r = 1.2, a 62% increase, even as extractable work per cycle increased by 41%, from 0.184 to 0.259 (in units of the qubit gap). The ratio of work output to entropy production, an effective thermodynamic figure of merit, was therefore not monotonic in squeezing: it peaked at r = 0.6, where work per unit entropy produced reached 0.98, 15% above the unsqueezed value of 0.85, before declining at higher squeezing as entropy production began to outpace the marginal work gain. Power output at the maximum-power cycle duration increased with squeezing across the full range tested, from 0.31 (gap units) at r = 0 to 0.52 at r = 1.2, a 68% gain, but efficiency at maximum power fell from 0.41 to 0.33 over the same range, a trade-off traced out in detail in Table 1. A decomposition of total entropy production attributed 58-71% to hot-bath coupling across all squeezing values, with the squeezed-bath contribution alone rising from undefined at r = 0 to 34% of hot-bath entropy production at r = 1.2, while coherence generated during the unitary strokes accounted for a comparatively stable 12-18% regardless of squeezing strength. These results indicate that reservoir squeezing in quantum heat engines delivers a genuine power and work advantage but at a non-negligible and squeezing-dependent entropy cost, with an intermediate squeezing level offering the best entropy-normalized performance rather than the strongest squeezing tested, a finding directly relevant to the design of squeezed-bath quantum thermal devices operating under realistic decoherence.
Measurement-based quantum heat engines have attracted significant interest as alternatives to conventional thermal engines, as they replace the hot thermal reservoir with quantum measurements, thereby offering greater controllability and simpler implementation. Motivated by these advantages, we investigate a measurement-driven quantum Otto engine with a qubit working substance and study the optimal work extractable from such engines, including whether their performance can surpass that of conventional quantum Otto cycles. We analyze the engine in both the infinite-time (adiabatic) and finite-time (non-adiabatic) regimes, considering two distinct implementations obtained through optimization over all projection-valued measurements (PVMs) and over all two-outcome positive operator-valued measurements (POVMs). We show that measurement-based engines can outperform conventional quantum Otto engines within specific parameter regimes and that POVM-based engines can yield higher optimal work extraction than PVM-based ones. Furthermore, by incorporating the thermodynamic cost associated with resetting the auxiliary system required for POVM implementation, we demonstrate that the resulting net work output can still exceed that of PVM-based engines under suitable conditions on the spectral gaps and cold bath temperature. We also identify regimes in which non-adiabatic implementations can yield higher work output and efficiency than their adiabatic counterparts. Our study provides operational guidelines for designing improved measurement-driven quantum Otto engines.
We establish a quantum Otto engine cycle in which the working substance contacts with squeezed reservoirs during the two quantum isochoric processes. We consider two working substances: (1) a qubit and (2) two coupled qubits. Due to the effects of squeezing, the working substance can be heated to a higher effective temperature, which leads to many interesting features different from the ordinary ones, such as (1) for the qubit as working substance, if we choose the squeezed parameters properly, the positive work can be exported even when T(H) <T(L), where T(H) and T(L) are the temperatures of the hot and cool reservoirs, respectively; (2) the efficiency can be higher than classical Carnot efficiency. These results do not violate the second law of thermodynamics and it can be understood as quantum fuel is more efficient than the classical one.
We analyze the performance of a quantum Otto cycle, employing a time-dependent harmonic oscillator as the working fluid undergoing sudden expansion and compression strokes during the adiabatic stages, coupled to a squeezed reservoir. First, we show that the maximum efficiency that our engine can achieve is 1/2 only, which is in contrast with earlier studies claiming unit efficiency under the effect of a squeezed reservoir. Then, in the high-temperature limit, we obtain analytic expressions for the upper bound on the efficiency as well as on the coefficient of performance of the Otto cycle. The obtained bounds are independent of the parameters of the system and depend on the reservoir parameters only. Additionally, with a hot squeezed thermal bath, we obtain an analytic expression for the efficiency at maximum work which satisfies the derived upper bound. Further, in the presence of squeezing in the cold reservoir, we specify an operational regime for the Otto refrigerator otherwise forbidden in the standard case. Finally, we find the cost of creating a squeezed state from the thermal state and show that in order to harvest the benefits of squeezing, it is sufficient to squeeze only one mode of the reservoir in resonance with the transition frequency of the working fluid. Further, we show that when the cost of squeezing is included in the definition of the operational efficiency of the engine, the advantages of squeezing fade away. Still, being purely quantum mechanical fuel in nature, squeezed reservoirs are beneficial in their own way by providing us with more compact energy storage medium or offering effectively high-temperature baths without being actually too hot.
Abstract Recent theoretical and experimental studies in quantum heat engines show that, in the quasi-static regime, it is possible to have higher efficiency than the limit imposed by Carnot, provided that engineered reservoirs are used. The quasi-static regime, however, is a strong limitation to the operation of heat engines, since an infinitely long time is required to complete a cycle. In this paper we propose a two-level model as the working substance to perform a quantum Otto heat engine surrounded by a cold thermal reservoir and a squeezed hot thermal reservoir. Taking advantage of this model we show a striking achievement, that is to attain unity efficiency even at non-null power.