arXiv:2604.03116 · Quantum Engineering

Novel permanent magnet array geometries for scalable trapped-ion quantum computing in a laser-free entanglement architecture

Mitchell G. Peaks

quant-phSubmitted Apr 3, 2026• Announced Apr 6, 2026• 0 citations

Abstract

A novel design is presented for a permanent magnet array to address specific challenges with scalable trapped-ion quantum computing systems. Design and optimization of this magnet geometry is motivated by concepts for large-scale Quantum Charge-Coupled Device (QCCD) architectures. This proposal is relevant to magnetic field gradient schemes for laser-free entanglement using long-wavelength radiation, and individual addressing based on spatially dependent, magnetic field sensitive qubits. This configuration generates a localized, asymmetric magnetic field, yielding a region for ion transport into and out of a strong magnetic field gradient, while minimizing the absolute field experienced by the ion. This is a distinct improvement for scalability over dipolar magnet geometries where a strong magnetic field surrounds a magnetic field nil in three dimensions, which is problematic for ion transport applications. The design also relaxes the alignment constraints for experimental setup by allowing greater tolerance to misalignment in two dimensions. Additionally, the potential to scale a permanent magnet scheme in QCCD systems circumvents engineering challenges associated with using large electrical currents to generate the field gradient. Finally, a conceptual discussion is given for incorporating the design into a scalable QCCD type architecture.

Journal reference: 2026, Issue 1
DOI: 10.1155/que2/8619391
Comments: 28 pages, 13 figures

Related papers

Design and fabrication of high magnetic field gradients towards fault tolerant two-qubit gates with trapped ions using long-wavelength radiation

Eamon Standing

In this thesis, I discuss coherent manipulation of a trapped ytterbium ion using long wavelength radiation and the results of experiments towards the performance of a two-ion entanglement gate using a static magnetic field gradient of 23.3(6) T/m to create coupling between an ion's internal state and its motion. After using these experiments to explain the requirements for high-fidelity entanglement operations, I continue by examining existing methods for creating this gradient, the current limiting factor in producing the highest fidelity operations. This includes a full characterisation of the gradients produced by symmetric scheme permanent magnets and buried current carrying wires including development of scaling laws in order to create optimum gradients for a given trap geometry. I continue by proposing a new method by which extremely high gradients over 100 T/m can be created for planar chip traps with minimal modification to an existing experiment. These gradients are tailored for axial as well as radial entanglement schemes and aim to show that the technology exists in order to produce a two-qubit gate over the fault tolerant threshold. Subsequently, I discuss the implementation of this new scheme in an experiment before constructing the apparatus to accurately align a chip with these magnets and documenting their installation into two new experimental setups. This includes a preliminary measurement of the gradient produced by an imperfect setup outside of vacuum which verifies those simulated at ~ 110 T/m. Lastly, I discuss the prospects of on-chip magnetic materials and propose a new method which when sufficiently developed should allow for high magnetic field gradients to be produced on-chip at higher ion heights than when solely using current carrying wires. Additionally this scheme should allow for switchable gradients with maximised stability in geometries previously not possible to create.

Jul 12, 20170 citations

Towards scalable quantum technologies

Christopher Knapp (7143212)

In the current landscape of quantum technologies, great efforts are being made to overcome the technical challenges of realising robust and scalable devices for use in a wide variety of potentially impactful applications. This thesis therefore describes the design considerations and assembly of a purpose-built vacuum system for the realisation of high-fidelity quantum logic operations on a microfabricated surface ion trap device. The device consists of an X-junction structure with embedded current-carrying wires, which will allow for the demonstration of scalable, laser-free, magnetic field gradient-based quantum logic. Initial characterisation experiments and observations pertaining to this novel microchip design are presented, as well as demonstrations of coherent quantum operations using the 171Yb+ qubit both with and without the current-carrying wire generated magnetic field gradient. In addition, this work also shows how this static magnetic field gradient design for scalable quantum computing may be leveraged for use in metrology. By utilising the inherent gradient-induced coupling of the trapped ion qubit’s transition frequency to it’s position in this architecture, the ion becomes extremely sensitive to electric field perturbations, enabling the implementation of many well-established quantum electric and magnetic field sensing techniques. Furthermore, the nature of this novel sensing scheme permits high sensitivities within the unique DC − kHz bandwidth, which many current quantum electrometers are unable to reach. Measurements of DC and AC electric fields yield unprecedented sensitivities for the sensing of phase coherent electric fields in a linear Paul trap. In addition, an implementation of a common magnetometry technique to measure electric field noise is also exhibited. Finally, it is shown that a purpose built system for the implementation of this scheme has the potential to improve sensitivities by up to six orders of magnitude, enabling the possibility of utilising this scheme for a wide variety of applications'

Aug 15, 20250 citations

Design and fabrication of ion traps for a scalable microwave quantum computer

Weikang Fan

This thesis describes the experimental work towards the development of a scalable quantum computer based on microfabricated ion trap using long-wavelength radiation and magnetic field gradient. There are three key elements in implementing such a quantum computer: the junction trap to shuttle ions, the structure to generate high gradient magnetic field and the structure to induce strong microwave coupling to the ions. A new dynamic simulation tool was developed addressing the problems faced by static solvers. This tool was used to aid the design and optimisation of an X junction geometry allowing the ions to be shuttled with minimised motional heating gain. The design and fabrication techniques were reported on the structure to generate a high gradient magnetic field. A discussion was given on the design of producing microwave and maximise the coupling to the cold ions. A review was given on the far-field methods and near-field methods. A novel design was reported where the single-qubit gate is predicted to be 45 times faster than a conventional setup. Two essential topics on the microfabrication of a reliable scalable quantum computer unit were discussed: breakdown and RF loss. Investigation using numerical simulations showed that dielectric can breakdown due to high voltage and local heating which are results of impedance mismatch. Microfabrication processes were improved, high-quality films were reported to have twice as much breakdown voltages. The mechanisms of RF loss were reviewed. Novel structures and smooth electroplating technique were developed to minimise the loss. A low loss ion trap was produced and tested. An experimentally observed anomalous glow discharge phenomenon was reported and investigated.

Jan 28, 20200 citations

Microchip ion traps with high magnetic field gradients for microwave quantum logic

David Murgia

This thesis describes experimental work towards the development of a trapped-ion quantum computer based on microchip ion traps and long-wavelength radiation, using magnetic field gradients. The relationship between experimental parameters and two-qubit gate fidelity is investigated for microchips with two different static magnetic field gradient generation methods. For current-carrying wires and under-chip permanent magnets, optimum ion heights of 110 μm and 200 μm are found respectively. Construction of an experiment capable of demonstrating high-fidelity gates is reported, including innovations for the use of microchip ion traps with permanent magnets. The development of a vacuum system for versatile microchip experiments is described, including new methods for impedance-matched RF delivery, in-vacuum filtering and liquid nitrogen microchip cooling. Protection of both the microchip surface from atomic flux and of ions from the charged imaging viewport are both investigated in detail. A new preparation framework for microchip ion traps before their use in experiments is developed. In order to remove unwanted deposited layers on the microchips, a process of multiple chemical treatments is used. In addition, these characterisation efforts lead to refinement of the microfabrication process for future microchips. The application of large currents to microchips is of fundamental importance to scalable trapped-ion quantum computing using static magnetic field gradients. As part of the characterisation process, currents of ≈ 10A are successfully applied to microfabricated current-carrying wires, demonstrating the viability of these structures for generation of local magnetic fields and gradients in a quantum computing device. The operation of a microchip ion trap experiment with under-chip permanent magnets for a high magnetic field gradient (≈ 140Tm−1) is described. The successful trapping of ytterbium-174 and -171 ions is reported, as well as their use to measure and optimise the ion trap parameters. The thesis concludes with consideration of the expected future results from the ongoing operation of the experiment.

Nov 1, 20160 citations

Scaling and Assigning Resources on ION Trap QCCD Architectures

Anabel Ovide, Daniele Cuomo, Carmen G. Almudéver

Ion trap technologies have earned significant attention as potential candidates for quantum information processing due to their long decoherence times and precise manipulation of individual qubits, distinguishing them from other candidates in the field of quantum technologies. However, scalability remains a challenge, as introducing additional qubits into a trap increases noise and heating effects, consequently decreasing operational fidelity. Trapped-ion Quantum Charge-Coupled Device (QCCD) architectures have addressed this limitation by interconnecting multiple traps and employing ion shuttling mechanisms to transfer ions among traps. This new architectural design requires the development of novel compilation techniques for quantum algorithms, which efficiently allocate and route qubits, and schedule operations. The aim of a compiler is to minimize ion movements and, therefore, reduce the execution time of the circuit to achieve a higher fidelity. In this paper, we propose a novel approach for initial qubit placement, demonstrating enhancements of up to 50% compared to prior methods. Furthermore, we conduct a scalability analysis on two distinct QCCD topologies: a 1D-linear array and a ring structure. Additionally, we evaluate the impact of the excess capacity - i.e. the number of free spaces within a trap - on the algorithm performance.

arXiv:2408.00225IEEE International Conference on Quantum Computing and Engineering (QCE)Sep 15, 20248 citations

Feasibility Study of 3D-Printed Micro Junction Array for Ion Trap Quantum Processor

Kento Taniguchi, Ke Sun, Shuqi Xu +6 more

We introduce an ion trap platform based on a 3D-printed micro-junction array, designed to implement quantum charge-coupled device (QCCD) architectures for large-scale quantum information processing (QIP). The integration of three-dimensionally structured micro Radio-Frequency (RF) electrodes above a surface-electrode trap enables flexible control of electric field profiles across both linear and junction regions. Through simulations, we demonstrate that the linear region exhibits deeper and more harmonic ion confinement with reduced RF drive power compared to conventional planar traps. Crucially, we identify a junction geometry that maintains uniform ion confinement during transport while substantially reducing the pseudopotential barrier. This reduction facilitates low-heating, high-fidelity transport of single- and multi-species ion crystals. Our results establish a viable route toward fault-tolerant quantum computing by enabling modular and scalable QCCD systems based on the state-of-the-art 3D-printing technologies.

arXiv:2509.17275Sep 21, 20250 citations