An efficient three-color (3C) laser excitation-based Rydberg atomic quantum receiver (RAQR) architecture is investigated for wireless communications, utilizing a five-level (5L) electronic transition mechanism. Specifically, the conventional two-color (2C) RAQR with the four-level (4L) excitation faces three fundamental obstacles: 1) high cost and engineering challenges due to the reliance on unstable short-wavelength lasers; 2) a fundamental sensitivity limit in thermal atoms caused by residual Doppler broadening; and 3) the inability to detect low-frequency bands due to the energy-level constraint of two-photon resonance. To address these challenges, this paper analyzes a 3C5L-RAQR architecture with all-red/infrared lasers, which not only solves the engineering cost issues but also enables effective Doppler cancellation and low-frequency detection by exploiting the three-photon resonance. Bridging atomic physics and communication theory, an end-to-end equivalent baseband signal model is derived. Furthermore, the performance of different RAQR architectures is evaluated in terms of sensitivity, achievable rate and spectrum access range. Moreover, we provide an exact numerical solution for practical RAQRs by employing the Liouvillian superoperator formalism. Numerical results demonstrate that the exhibited 3C5L-RAQR achieves superior sensitivity compared to the conventional 2C4L-RAQR and a classical antenna-based radio frequency receiver for weak-signal detection. Finally, the inherent sensitivity-rate trade-off is revealed, showing that the 3C5L-RAQR is more suitable for deployment in power-limited communication scenarios demanding broad spectrum access.
An efficient three-color (3C) laser excitation-based Rydberg atomic quantum receiver (RAQR) architecture is investigated for wireless communications, utilizing a five-level (5L) electronic transition mechanism. Specifically, the conventional two-color (2C) RAQR with the four-level (4L) excitation faces three fundamental obstacles: 1) high cost and engineering challenges due to the reliance on unstable short-wavelength lasers; 2) a fundamental sensitivity limit in thermal atoms caused by residual Doppler broadening; and 3) the inability to detect low-frequency bands due to the energy-level constraint of two-photon resonance. To address these challenges, this paper analyzes a 3C5L-RAQR architecture with all-red/infrared lasers, which not only solves the engineering cost issues but also enables effective Doppler cancellation and low-frequency detection by exploiting the three-photon resonance. Bridging atomic physics and communication theory, an end-to-end equivalent baseband signal model is derived. Furthermore, the performance of different RAQR architectures is evaluated in terms of sensitivity, achievable rate and spectrum access range. Moreover, we provide an exact numerical solution for practical RAQRs by employing the Liouvillian superoperator formalism. Numerical results demonstrate that the exhibited 3C5L-RAQR achieves superior sensitivity compared to the conventional 2C4L-RAQR and a classical antenna-based radio frequency receiver for weak-signal detection. Finally, the inherent sensitivity-rate trade-off is revealed, showing that the 3C5L-RAQR is more suitable for deployment in power-limited communication scenarios demanding broad spectrum access.
The significant progress of quantum sensing technologies offer numerous radical solutions for measuring a multitude of physical quantities at an unprecedented precision. Among them, Rydberg atomic quantum receivers (RAQRs) emerge as an eminent solution for detecting the electric field of radio frequency (RF) signals, exhibiting great potential in assisting classical wireless communications and sensing. So far, most experimental studies have aimed for the proof of physical concepts to reveal its promise, while the practical signal model of RAQR-aided wireless communications and sensing remained under-explored. Furthermore, the performance of RAQR-based wireless receivers and their advantages over classical RF receivers have not been fully characterized. To fill these gaps, we introduce the RAQR to the wireless community by presenting an end-to-end reception scheme. We then develop a corresponding equivalent baseband signal model relying on a realistic reception flow. Our scheme and model provide explicit design guidance to RAQR-aided wireless systems. We next study the performance of RAQR-aided wireless systems based on our model, and compare them to classical RF receivers. The results show that Doppler broadening-free RAQRs are capable of achieving a substantial received signal-to-noise ratio (SNR) gain of over 27 decibel (dB) and 40 dB in the photon shot limit and standard quantum limit regimes, respectively.
Rydberg atomic quantum receivers (RAQRs) emerge as a radical solution for detecting radio frequency (RF) signals, showing great potential in assisting classical wireless communications and sensing. However, the current studies of RAQRs mainly focus on realizing fundamental functionalities via experiments, where the results cannot be readily harnessed for assisting wireless communications and sensing. Moreover, the advantages of RAQR-based wireless receivers have not been fully characterized. To fill the gap, we introduce the superheterodyne version of RAQRs and present the associated end-to-end transmission scheme. We then develop a corresponding end-to-end equivalent baseband signal model relying on a realistic transmission flow. Our scheme and model provide explicit design guidance for RAQR-aided wireless systems. We finally verify the effectiveness of the proposed signal model with respect to the waveform of the photodetector, input-output relationship (transfer function), and the normalized mean-squared error between the nonlinear transfer function and its linear approximation.
Rydberg atomic quantum receivers (RAQRs) have recently emerged as a promising technology for radio-frequency (RF) reception by directly transducing incident RF fields into optical signals. Existing receiver architectures, however, exploit only subsets of the dipole-allowed transitions within a given atomic manifold, limiting the number of simultaneously accessible RF channels. In this paper, a hybrid six-level Rydberg atomic quantum receiver (H-RAQR) is proposed by integrating parallel and cascaded RF coupling pathways within a single vapor-cell receiver. A communication-oriented analytical framework is developed by deriving a closed-form steady-state atom--field interaction model and establishing an equivalent baseband signal representation. The achievable ergodic sum rate is analyzed, and a resource-efficiency metric is introduced to quantify throughput per unit optical receiver resource. The analytical model is validated against full Lindblad master-equation simulations over its identified operating region. Numerical results show that the proposed H-RAQR supports four simultaneous RF channels within a single atomic system, achieves higher ergodic sum rate than conventional parallel Rydberg state (PRS) and cascade Rydberg state (CRS) receivers, and provides about 29% higher resource efficiency than a combined PRS-CRS deployment with equivalent four-band coverage. The proposed framework provides a scalable foundation for multi-band atomic wireless receivers.
Next-generation space-air-ground-sea integrated networks (SAGSIN) impose unprecedented demands on advanced radio frequency (RF) receivers for full-spectrum agility, ultra-high sensitivity, and anti-jamming resilience, pushing conventional electronic receivers to their physical limits. To address these challenges, the Rydberg atomic quantum (RAQ) radio has emerged as a promising quantum-enabled receiver paradigm that directly maps electromagnetic fields onto atomic quantum states, offering an alternative to alleviate bottlenecks of conventional RF front ends. To provide a clear research roadmap, this survey presents a comprehensive review of RAQ radios by bridging atomic physics and wireless communications. Specifically, we first introduce the underlying quantum mechanisms, representative architectures, and atomic response models of RAQ radio. On this basis, state-of-the-art techniques for enhancing sensitivity, instantaneous bandwidth, and operating frequency are systematically reviewed, with particular emphasis on the inherent trade-offs among these key metrics. To connect quantum response with communication theory, we further analyze equivalent channel modeling frameworks for characterizing systematic performance limits. From the wireless communication perspective, some RAQ-enabled advanced technologies including cognitive, interference-resilient, low-frequency and multiple-input multiple-output (MIMO) communications are reviewed, alongside emerging deployment scenarios such as satellite networks, integrated sensing and communications, and reconfigurable intelligent surface-assisted systems. Finally, we identify open challenges and provide potential future directions of RAQ radio to inspire the further exploration.
Rydberg atomic quantum receivers (RAQRs) have emerged as highly sensitive receivers for future communication and sensing systems. However, conventional RAQRs are primarily effective for single-carrier and narrowband reception, typically with an operational bandwidth of only a few hundred kilohertz. To enable the reception of multi-carrier signals with larger bandwidth, we propose a multi-carrier Rydberg atomic quantum receiver (MC-RAQR) architecture based on a five-level quantum system model. We analyze the amplitude and phase of the output laser in MC-RAQR and extract the baseband electrical signal for signal processing. Furthermore, we quantify the performance of MC-RAQR in multi-carrier communication and sensing by studying the channel capacity and distance estimation, respectively. Numerical results show that the MC-RAQR is capable of achieving a bandwidth of 7.2 MHz, which is an order of magnitude larger than conventional RAQRs. Besides, compared to conventional receivers, MC-RAQR can improve the capacity and distance estimation by 18-fold and 103-fold, respectively. This validates the superiority of MC-RAQR in receiving multi-carrier signal, and demonstrates its compatibility in detecting waveforms such as orthogonal frequency‐division multiplexing.
As a key enabler for next-generation wireless systems, integrated sensing and communication (ISAC) requires significantly higher receiver sensitivity than conventional architectures to achieve long-range target detection, thereby introducing new challenges in receiver design. Among potential solutions, Rydberg atomic quantum receivers (RAQRs) have attracted growing attention for their unique quantum sensing capabilities. By exploiting the exceptional responsiveness of Rydberg atoms to electromagnetic fields, RAQRs enable direct and highly sensitive measurement of radio-frequency (RF) signals without relying on traditional antenna-based front ends. However, this enhanced sensitivity also renders them more vulnerable to interference, particularly from undesired targets and long-delay multipath components. To address this limitation, this article presents practical strategies for improving the interference robustness and selective reception performance of RAQRs in ISAC scenarios. Specifically, we begin with a comprehensive overview of RAQR principles and identify the interference-related challenges encountered in ISAC applications. Building on this foundation, we introduce the Actively Selective RAQR (AS-RAQR) architecture, which integrates tunable gating mechanisms to actively suppress unwanted signals. The proposed design is validated through representative case studies, followed by a discussion of open challenges and future research directions.