The ability to perform high-fidelity quantum nondemolition qubit readout is pivotal for the realization of large and powerful quantum computers. Such readout of superconducting qubits is generally enabled by amplifying the weak dispersive measurement signals using phase-preserving quantum-limited Josephson amplifiers with sufficient gain to dilute the contribution of the added noise by the output chain. Here, we further enhance the qubit readout fidelity by (1) simultaneously measuring the two-mode squeezed states of the amplified readout signals at the signal and idler frequencies of the nondegenerate amplifier and (2) coherently combining them at the classical processing stage following a relative rotation that maximizes the signal to noise ratio of the qubit-encoded readout quadrature. Such readout scheme exhibits enhancement in the readout fidelity for all practical values of amplifier gain and noise added by the output chain and is fully compatible with frequency multiplexed setups used in large quantum processors.
The ability to perform high-fidelity quantum nondemolition qubit readout is pivotal for the realization of large and powerful quantum computers. Such readout of superconducting qubits is generally enabled by amplifying the weak dispersive measurement signals using phase-preserving quantum-limited Josephson amplifiers with sufficient gain to dilute the contribution of the added noise by the output chain. Here, we further enhance the qubit readout fidelity by (1) simultaneously measuring the two-mode squeezed states of the amplified readout signals at the signal and idler frequencies of the nondegenerate amplifier and (2) coherently combining them at the classical processing stage following a relative rotation that maximizes the signal to noise ratio of the qubit-encoded readout quadrature. Such readout scheme exhibits enhancement in the readout fidelity for all practical values of amplifier gain and noise added by the output chain and is fully compatible with frequency multiplexed setups used in large quantum processors.
Fault-tolerant quantum information processing with flawed qubits and gates requires highly efficient, quantum nondemolition qubit readout. In superconducting circuits, qubit readout using coherent light with fidelity above 99% has been achieved by using quantum limited parametric amplifiers such as the Josephson parametric converter (JPC). However, further improvement of such measurement faces many challenges, including the vacuum fluctuation of the coherent light that limits measurement fidelity. In this work we demonstrate dispersive qubit readout with a two-mode squeezed light interferometer formed by two JPCs. The first JPC generates two-mode squeezed vacuum at its output, which is coherently recombined by the second JPC after one branch is phase shifted and displaced by its interaction with the qubit-cavity system on that arm of the interferometer. We observe a 31% improvement in the power signal-to-noise ratio (SNR) of projective readout after replacing vacuum fluctuation in the readout cavity with two-mode squeezed vacuum containing on average one photon. This demonstrates a more efficient way of improving SNR than by increasing readout power. Furthermore, we investigate the quantum properties of the two-mode squeezed light in the system through weak measurement. Surprisingly, we find that tuning the interferometer to be less projective increases the measurement efficiency relative to the optimum setting for projective measurement. These enhancements may enable remote entanglement with lower efficiency components in a system with qubits in both arms of the interferometer.
Nonreciprocal microwave devices, such as circulators and isolators, are needed in high-fidelity qubit readout schemes to unidirectionally route the readout signals and protect the qubits against noise coming from the output chain.However, cryogenic circulators and isolators are prohibitive in scalable superconducting architectures because they rely on magnetic materials.Here we report a fast (750 ns) high-fidelity (95%) quantum nondemolition readout of a coherent superconducting qubit (T 1 = 52 μs, T 2E = 35 μs) without any nonreciprocal magnetic devices.We use in our readout chain a microwave-controlled qubit readout multichip module (QRMCM) that integrates interferometric directional Josephson devices consisting of an isolator and a reconfigurable isolator or amplifier device, and an off-chip low-pass filter.Using the QRMCM, we demonstrate isolation up to 45 dB within 13 MHz, when both directional devices are operated as isolators, and low-noise amplification in excess of 10 dB within a dynamical bandwidth of 10 MHz, when the reconfigurable device is operated as an amplifier.We also investigate the dependence of the qubit coherence times T ϕ and T 2E on the isolation response of the QRMCM, which we control in situ using the microwave drives feeding the isolators.Furthermore, by directly comparing the QRMCM performance with that of a state-of-art configuration (with T 2E ≈ 2T 1 ) that uses a pair of wideband magnetic isolators, we find that the excess pure dephasing measured with the QRMCM (for which T 2E ≈ T 1 ) is likely limited by the residual thermal photon population in the readout resonator.Improved versions of the QRMCM could replace magnetic circulators and isolators in large superconducting quantum processors.
We investigate the quantum measurement physics of a system in which a phase-sensitive parametric amplifier is used to directly measure a qubit to which it is coupled dispersively. By analytic calculation of the signal-to-noise ratio, we show that the amplification properties of the paramp can be exploited to achieve on-chip gain of the qubit readout signal, mitigating the damage done to the measurement rate by circulator added noise and losses in between the readout cavity and any following amplification chain. With a different choice of drive phase, we show that when added noise is not a concern, the squeezing properties of the paramp can be used to enhance the measurement rate relative to a standard dispersive readout by reducing the readout noise without corresponding reduction of qubit signal. We then proceed to calculate the back-action dephasing of the qubit by way of a phase-space technique, and find analytic results valid in the long-time limit while numerically handling the finite-time case. We show how in both operating modes, in the long-time limit, the back-action dephasing of the qubit can be made as small as is allowed by quantum mechanics by using using sufficiently many photons in the measurement, i.e.\@ by using a sufficiently strong coherent measurement drive. Crucially, we find that in the presence of experimentally realistic amounts of added noise, the on-chip gain afforded by such a device can be used to come significantly closer to the quantum limit than is possible with a standard dispersive measurement setup, allowing for efficiencies of ~ 75% under conditions that would yield efficiencies <~ 1 % when applying the usual scheme.
Coherent circuits based on superconducting elements hold tremendous promise for the practical implementation of quantum information technology: advanced computation, cryptography, and hardware simulation of complex materials systems are envisioned applications. Such circuits are essentially engineered atoms with level transitions in the 4-8 GHz regime; as such “read” and “write” operations are performed with the aid of fast microwave pulses and low-noise amplifiers, respectively. Recent advances in cavity-based superconducting parametric amplifiers have enabled real-time measurement and feedback in one and two qubits. We demonstrate a novel Josephson junction transmission-line based traveling-wave amplifier which employs sub-wavelength phase matching resonators to achieve high gain, several GHz of bandwidth, and near quantum-noise limited performance. Such devices will enable multiplexed qubit readout in integrated architectures comprised of a variety of microwave frequency analog and digital superconducting technologies: signal sources, multiplexers, ADCs, DACs, mixers, and amplifiers.
Single-shot readout of a quantum state is an essential component in building a large-scale quantum processor, and reducing the readout error is the key challenge. To achieve a high signal-to-noise ratio, quantum-limited low-noise amplifiers such as Josephson parametric amplifiers are typically used. However, a high-fidelity single-shot readout method without a parametric amplifier would be advantageous, as it would reduce system complexity. In this paper, we present a high-fidelity result of frequency-multiplexed, high-power single-shot readout for superconducting qubitswithoutusing a parametric amplifier. We achieved a high readout fidelity of 98.3% with a 400 ns pulse and confirmed that the high-power readout can be used in tomography of an entangled state. We have demonstrated the potential usefulness of this technique in characterizing the final quantum state at the end of quantum operations in a superconducting quantum processor.
We introduce and analyze a dispersive qubit readout scheme where two-mode squeezing is generated directly in the measurement cavities. The resulting suppression of noise enables fast, high-fidelity readout of naturally weakly coupled qubits, and the possibility to protect strongly coupled qubits from decoherence by weakening their coupling. Unlike other approaches exploiting squeezing, our setup avoids the difficult task of transporting and injecting with high fidelity an externally generated squeezed state. Our setup is also surprisingly robust against unwanted non-QND backaction effects, as interference naturally suppresses Purcell decay: the system acts as its own Purcell filter. Our setup is compatible with the experimental state-of-the-art in circuit QED systems, but the basic idea could also be realized in other systems.