Impurity spins randomly distributed at the surfaces and interfaces of superconducting wires are known to cause flux noise in superconducting quantum interference devices (SQUIDs), providing a dominant mechanism for decoherence in flux-tunable superconducting qubits. While flux noise is well characterized experimentally, the microscopic model underlying spin dynamics remains a great puzzle. The main problem is that first-principles theories based on an integration of the quantum Heisenberg equations of motion for interacting spins are too computationally expensive to capture spin diffusion over large length scales, hindering comparisons between microscopic models and experimental data. In contrast, third-principles approaches lump spin dynamics into a single phenomenological spin-diffusion operator $D{\ensuremath{\nabla}}^{2}$ that is not able to describe the quantum noise regime and connect to microscopic models and different disorder scenarios such as spin clusters. Here we propose an intermediate ``second-principles'' method to describe general spin dissipation and flux noise in the quantum regime. It leads to the interpretation that flux noise arises from the density of paramagnon excitations at the edge of the superconducting wire, with paramagnon-paramagnon interactions leading to spin diffusion, and interactions between paramagnons and other degrees of freedom such as phonons, electrons, and two-level systems leading to spin energy relaxation. At high frequency $\ensuremath{\omega}$, we obtain an upper bound for flux noise, showing that the (super)Ohmic noise observed in experiments is not originating from interacting spin impurities. We apply the method to Heisenberg models in two-dimensional square lattices with a random distribution of vacancies, with nearest-neighbor spins coupled by a constant exchange. Explicit numerical calculations of flux noise show that it follows the observed power law $A/{\ensuremath{\omega}}^{\ensuremath{\alpha}}$, with amplitude
A and exponent $\ensuremath{\alpha}$ depending on temperature and inhomogeneities such as spatial confinement and disorder. These results are compared to experiments in niobium and aluminum devices. The method establishes a connection between flux noise experiments and microscopic Hamiltonians with the goal of identifying relevant microscopic mechanisms and guiding strategies for reducing flux noise.
Effective methods for decoupling superconducting qubits (SQs) from parasitic environmental noise sources are critical for increasing their lifetime and phase fidelity. While considerable progress has been made in this area, the microscopic origin of noise remains largely unknown. In this work, first principles density functional theory calculations are employed to identify the microscopic origins of magnetic noise sources in SQs on an α-Al2O3 substrate. The results indicate that it is unlikely that the existence of intrinsic point defects and defect complexes in the substrate are responsible for low frequency noise in these systems. Rather, a comprehensive analysis of extrinsic defects shows that surface aluminum ions interacting with ambient molecules will form a bath of magnetic moments that can couple to the SQ paramagnetically. The microscopic origin of this magnetic noise source is discussed and strategies for ameliorating the effects of these magnetic defects are proposed.
The magnetic flux noise caused by surface spin fluctuations in superconducting quantum interference devices (SQUIDs) limits their development. In this work, we report that different adsorbents such as H, O 2, NO, and NO 2 that adsorb on the surfaces of Mg-based and Pb-based SQUIDs, respectively, producing large local magnetic moments ranging from 0.7–1.6 μ B, with energy barriers for thermal spin fluctuation as low as 10–30 mK. Moreover, we observe that the presence of H atoms on the surface of MgO can cause the coadsorption of other molecules, which generates additional spin sources. Monte Carlo simulations of the weakly coupled spin on a two-dimensional square lattice produce a low-frequency flux noise spectrum. We suggest eliminating the surface magnetism by coating the surface with monolayer indium phosphide or protecting the surface from other molecules by nonmagnetic preoccupants with a larger adsorption energy. The work provides important physical insights and feasible strategies for reducing magnetic noise sources in superconducting circuits.
Low-frequency magnetic flux noise remains a persistent performance bottleneck in dc Superconducting Quantum Interference Devices (SQUIDs) and flux-tunable superconducting qubits across dilution refrigerator base temperatures. Traditional models treat surface paramagnetic spins as independent, non-interacting fluctuators, failing to explain strong exchange interactions, sub-Kelvin temperature insensitivity, and the universal Clarke R/W perimeter scaling law. Here, we resolve these empirical anomalies from first principles by embedding surface spins into a continuous inter-site electrostatic and magnetic potential manifold. Applying the Lindeberg-Feller Vector Central Limit Theorem to random surface dipolar fields yields an emergent Gaussian Density of States (GDOS) for spin inversion barriers. Integrating this disordered manifold across the SQUID washer geometry via magnetostatic reciprocity reproduces the universal R/W scaling law and predicts an absolute spectral amplitude of approximately 1.4 to 1.7 micro-Phi-0 per square root of Hz at 100 mK. Furthermore, accounting for non-cancellation phase agitation within the open spin saddles proves that soft-magnon and phonon bremsstrahlung sustain an irreducible millikelvin quantum flux noise floor down to absolute zero. In order to bridge microscopic theory with practical engineering, the manuscript includes a complete, modular MATLAB simulation toolbox (compatible with MATLAB R2016a/b and later) that computes closed-form classical flux noise spectral densities, frequency sweeps, and absolute spectral amplitudes for device optimization.
For over three decades, the presence of magnetic flux noise with a power spectral density scaling roughly as
SPhi(f)propto1/falpha, where
alphalesssim1, has been known to limit the low-frequency performance of dc superconducting quantum interference devices (SQUIDs). In recent years, experiments indicate that this same noise persists to frequencies up to 1~GHz and is a dominant source of dephasing in flux-sensitive superconducting quantum bits (qubits). Thus, the reduction of flux noise presents a major hurdle towards the successful realization of scalable quantum computers that are based on flux-based qubits. In this thesis, we present experimental measurements, theoretical analyses, and numerical simulations that support a more detailed understanding of both the microscopic and macroscopic properties of flux noise.Our experimental work begins with flux noise measurements of a large number of SQUIDs in the temperature range from 0.1~K to 4~K. We report on measurements of ten SQUIDs with systematically varied geometries and show that
alpha increases as the temperature is lowered; in so doing, each spectrum pivots about a nearly constant frequency. The mean square flux noise, inferred by integrating the power spectra, grows rapidly with temperature and at a given temperature is approximately independent of the outer dimension of a given SQUID washer. We show that these results are incompatible with a model based on the random reversal of independent, spins that are located at the surface of the SQUID washer.In the course of our flux noise measurements, we became aware of a spurious contribution to low-frequency critical current noise in Josephson junctions---normally attributed to charge trapping in the barrier---arising from temperature instabilities inherent in cryogenic systems. These temperature fluctuations modify the critical current via its temperature dependence. By computing cross-correlations between measured temperature and critical current noise in Al-AlOx-Al junctions, we show that, despite excellent temperature stability, temperature fluctuations induce observable critical current fluctuations. Particularly, because
1/f critical current noise has decreased with improved fabrication techniques in recent years, it is important to understand and eliminate this additional noise source.Next, we introduce a numerical method of calculating the mean square flux noise
Phisq from independently fluctuating spins on the surface of thin-film loops of arbitrary geometry. By reciprocity,
Phisq is proportional to
langleBbf(rbf)2rangle, where
Bbf(rbf) is the magnetic field generated by a circulating current around the loop and
rbf varies over the loop surface. By discretizing the loop nonuniformly, we efficiently and accurately compute the current distribution and resulting magnetic field, which may vary rapidly across the loop. We use this method to compute
Phisq in a number of scenarios in which we systematically vary physical parameters of the loop. We compare our simulations to an earlier analytic result predicting that
PhisqproptoR/W in the limit where the loop radius
R is much greater than the linewidth
W. We further show that the previously neglected contribution of edge spins to
Phisq is significant---even dominant---in narrow-linewidth loops.To calculate theoretical dephasing rates in qubits, we consider flux noise with a spectral density
SPhi(f)=A2/(f/1 hboxHz)alpha, where
A is of the order of 1~
muPhi0,hboxHz−1/2 and
0.6leqalphaleq1.2;
Phi0 is the flux quantum. For a qubit with an energy level splitting linearly coupled to the applied flux, our calculations of the dependence of the pure dephasing time
tauphi of Ramsey and echo pulse sequences on
alpha for fixed
A show that
tauphi decreases rapidly as
alpha is reduced. We find that
tauphi is relatively insensitive to the noise bandwidth,
f1leqfleqf2, for all
alpha provided the ultraviolet cutoff frequency
f2>1/tauphi. We calculate the ratio
tauphi,E/tauphi,R of the echo (
E) and Ramsey (
R) sequences, and the dependence of the decay function on
alpha and
f2. We investigate the case in which
SPhi(f0) is fixed at the ``pivot frequency''
f0neq1~Hz while
alpha is varied, and find that the choice of
f0 can greatly influence the sensitivity of
tauphi,E and
tauphi,R to the value of
alpha.Finally, we conclude with a brief review of our principal results and conclusions. We also comment on promising avenues of future research.
The microscopic description of 1/f magnetic flux noise in superconducting circuits has remained an open question for several decades despite extensive experimental and theoretical investigation. Recent progress in superconducting devices for quantum information has highlighted the need to mitigate sources of qubit decoherence, driving a renewed interest in understanding the underlying noise mechanism(s). Though a consensus has emerged attributing flux noise to surface spins, their identity and interaction mechanisms remain unclear, prompting further study. Here, we apply weak in-plane magnetic fields to a capacitively shunted flux qubit (where the Zeeman splitting of surface spins lies below the device temperature) and study the flux-noise-limited qubit dephasing, revealing previously unexplored trends that may shed light on the dynamics behind the emergent 1/f noise. Notably, we observe an enhancement (suppression) of the spin-echo (Ramsey) pure-dephasing time in fields up to B=100 G. With direct noise spectroscopy, we further observe a transition from a 1/f to approximately Lorentzian frequency dependence below 10 Hz and a reduction of the noise above 1 MHz with increasing magnetic field. We suggest that these trends are qualitatively consistent with an increase of spin cluster sizes with magnetic field. These results should help to inform a complete microscopic theory of 1/f flux noise in superconducting circuits.