Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2407.20682 · APL Quantum

Nonlinear response of telecom-wavelength superconducting single-photon detectors

Patrick Mark, Sebastian Gstir, Julian Münzberg, Gregor Weihs, Robert Keil

Published Nov 14, 2024• 0 citations
arXivHTMLPDF

Abstract

We measure the nonlinearity of a telecom-wavelength superconducting nanowire single-photon detector via incoherent beam combination. At typical photon count rates and detector bias current, the observed relative deviation from a perfectly linear response is in the order of 0.1% when the flux is doubled. This arises from a balance between the counteracting nonlinearities of dead time-induced detector saturation and of multi-photon detections. The observed behavior is modeled empirically, which suffices for a correction of measured data. In addition, statistical simulations, taking into account the measured recovery of the detection efficiency (90%-recovery after about 100 ns), provide insight into possible mechanisms of multi-photon detection.

DOI
10.1063/5.0231297

Related papers

Accurately modeling the recovery time of superconducting nanowire single-photon detectors as a function of bias current

Leo Oshiro, Hudson Jones, Timothy M. Rambo +3 more

Superconducting nanowire single-photon detectors (SNSPDs) are an attractive technology for applications which benefit from high-count rate photon detection such as quantum communication protocols, photon-starved classical communications, metrology of single-emitters, and photonic quantum computing. However, at high-count rates, a significant portion of photons may be incident during recovery intervals following prior detection events. After detection, the device efficiency recovers over nanoseconds to tens of nanoseconds before reaching a steadystate value. Therefore, for a given SNSPD bias current setpoint, a single efficiency and recovery time specification may not be sufficient to characterize the performance of a device at high count rates. Here we present and experimentally validate a model of the recovery time as a function of bias current for any given system efficiency. These results may be used to improve analysis of measurements performed using SNSPDs operating in the high count rate regime.

Quantum Computing, Communication, and Simulation•Mar 19, 2025•2 citations

Readout of superconducting nanowire single-photon detectors at high count rates

Andrew J. Kerman, Danna Rosenberg, R. J. Molnar +1 more

Superconducting nanowire single-photon detectors are set apart from other photon counting technologies above all else by their extremely high speed, with few-ten-ps timing resolution, and recovery times τR ≲ 10 ns after a detection event. In this work, however, we identify in the conventional electrical readout scheme a nonlinear interaction between the detector and its readout which can make stable, high-efficiency operation impossible at count rates even an order-of-magnitude less than τR−1. We present detailed experimental confirmation of this, and a theoretical model which quantitatively explains our observations. Finally, we describe an improved readout which circumvents this problem, allowing these detectors to be operated stably at high count rates, with a detection efficiency penalty determined purely by their inductive reset time.

arXiv:1302.2852•Journal of Applied Physics•Apr 11, 2013•109 citations

Investigations of afterpulsing and detection efficiency recovery in superconducting nanowire single-photon detectors

Viacheslav Burenkov, He Xu, Bing Qi +2 more

We report on the observation of a non-uniform dark count rate in Superconducting Nanowire Single Photon Detectors (SNSPDs), specifically focusing on an afterpulsing effect present when the SNSPD is operated at a high bias current regime. The afterpulsing exists for real detection events (triggered by input photons) as well as for dark counts (no laser input). In our standard set-up, the afterpulsing is most likely to occur at around 180 ns following a detection event, for both real counts and dark counts. We characterize the afterpulsing behavior and speculate that it is not due to the SNSPD itself but rather the amplifiers used to boost the electrical output signal from the SNSPD. We show that the afterpulsing indeed disappears when we use a different amplifier with a better low frequency response. We also examine the short-lived enhancement of detection efficiency during the recovery of the SNSPD due to temporary perturbation of the bias and grounding conditions.

arXiv:1306.3749•Journal of Applied Physics•Jun 3, 2013•22 citations

Direct measurement of the recovery time of superconducting nanowire single-photon detectors

Claire Autebert, Gaëtan Gras, Emna Amri +4 more

One of the key properties of single-photon detectors is their recovery time, i.e., the time required for the detector to recover its nominal efficiency. In the case of superconducting nanowire single-photon detectors (SNSPDs), which can feature extremely short recovery times in free-running mode, a precise characterization of this recovery time and its time dynamics is essential for many quantum optics or quantum communication experiments. We introduce a fast and simple method to characterize precisely the recovery time of SNSPDs. It provides full information about the recovery of the efficiency in time for a single or several consecutive detections. We also show how the method can be used to gain insight into the behavior of the bias current inside the nanowire after a detection, which allows predicting the behavior of the detector and its efficiency in any practical experiment using these detectors.

arXiv:2003.06290•Journal of Applied Physics•Aug 20, 2020•28 citations

Direct measurement of the recovery time of superconducting nanowire single-photon detectors

Claire Autebert, Gaëtan Gras, Emna Amri +4 more

One of the key properties of single-photon detectors is their recovery time, i.e. the time required for the detector to recover its nominal efficiency. In the case of superconducting nanowire single-photon detectors (SNSPDs), which can feature extremely short recovery times in free-running mode, a precise characterization of this recovery time and its time dynamics is essential for many quantum optics or quantum communication experiments. We introduce a fast and simple method to characterize precisely the recovery time of SNSPDs. It provides full information about the recovery of the efficiency in time for a single or several consecutive detections. We also show how the method can be used to gain insight into the behavior of the bias current inside the nanowire after a detection, which allows predicting the behavior of the detector and its efficiency in any practical experiment using these detectors.

•Jan 1, 2020•21 citations

Waveguide-integrated single- and multi-photon detection at telecom wavelengths using superconducting nanowires

Simone Ferrari, Oliver Kahl, Vadim V. Kovalyuk +3 more

We investigate single- and multi-photon detection regimes of superconducting nanowire detectors embedded in silicon nitride nanophotonic circuits. At near-infrared wavelengths, simultaneous detection of up to three photons is observed for 120 nm wide nanowires biased far from the critical current, while narrow nanowires below 100 nm provide efficient single photon detection. A theoretical model is proposed to determine the different detection regimes and to calculate the corresponding internal quantum efficiency. The predicted saturation of the internal quantum efficiency in the single photon regime agrees well with plateau behavior observed at high bias currents.

Applied Physics Letters•Apr 13, 2015•47 citations
We measure the nonlinearity of a telecom-wavelength superconducting nanowire single-photon detector via incoherent beam combination. At typical photon count rates and detector bias current, the observed relative deviation from a perfectly linear response is in the order of 0.1% when the flux is doubled. This arises from a balance between the counteracting nonlinearities of dead time-induced detector saturation and of multi-photon detections. The observed behavior is modeled empirically, which suffices for a correction of measured data. In addition, statistical simulations, taking into account the measured recovery of the detection efficiency (90%-recovery after about 100 ns), provide insight into possible mechanisms of multi-photon detection.
Superconducting nanowire single-photon detectors (SNSPDs) are an attractive technology for applications which benefit from high-count rate photon detection such as quantum communication protocols, photon-starved classical communications, metrology of single-emitters, and photonic quantum computing. However, at high-count rates, a significant portion of photons may be incident during recovery intervals following prior detection events. After detection, the device efficiency recovers over nanoseconds to tens of nanoseconds before reaching a steadystate value. Therefore, for a given SNSPD bias current setpoint, a single efficiency and recovery time specification may not be sufficient to characterize the performance of a device at high count rates. Here we present and experimentally validate a model of the recovery time as a function of bias current for any given system efficiency. These results may be used to improve analysis of measurements performed using SNSPDs operating in the high count rate regime.
Superconducting nanowire single-photon detectors are set apart from other photon counting technologies above all else by their extremely high speed, with few-ten-ps timing resolution, and recovery times τR ≲ 10 ns after a detection event. In this work, however, we identify in the conventional electrical readout scheme a nonlinear interaction between the detector and its readout which can make stable, high-efficiency operation impossible at count rates even an order-of-magnitude less than τR−1. We present detailed experimental confirmation of this, and a theoretical model which quantitatively explains our observations. Finally, we describe an improved readout which circumvents this problem, allowing these detectors to be operated stably at high count rates, with a detection efficiency penalty determined purely by their inductive reset time.
We report on the observation of a non-uniform dark count rate in Superconducting Nanowire Single Photon Detectors (SNSPDs), specifically focusing on an afterpulsing effect present when the SNSPD is operated at a high bias current regime. The afterpulsing exists for real detection events (triggered by input photons) as well as for dark counts (no laser input). In our standard set-up, the afterpulsing is most likely to occur at around 180 ns following a detection event, for both real counts and dark counts. We characterize the afterpulsing behavior and speculate that it is not due to the SNSPD itself but rather the amplifiers used to boost the electrical output signal from the SNSPD. We show that the afterpulsing indeed disappears when we use a different amplifier with a better low frequency response. We also examine the short-lived enhancement of detection efficiency during the recovery of the SNSPD due to temporary perturbation of the bias and grounding conditions.
One of the key properties of single-photon detectors is their recovery time, i.e., the time required for the detector to recover its nominal efficiency. In the case of superconducting nanowire single-photon detectors (SNSPDs), which can feature extremely short recovery times in free-running mode, a precise characterization of this recovery time and its time dynamics is essential for many quantum optics or quantum communication experiments. We introduce a fast and simple method to characterize precisely the recovery time of SNSPDs. It provides full information about the recovery of the efficiency in time for a single or several consecutive detections. We also show how the method can be used to gain insight into the behavior of the bias current inside the nanowire after a detection, which allows predicting the behavior of the detector and its efficiency in any practical experiment using these detectors.
One of the key properties of single-photon detectors is their recovery time, i.e. the time required for the detector to recover its nominal efficiency. In the case of superconducting nanowire single-photon detectors (SNSPDs), which can feature extremely short recovery times in free-running mode, a precise characterization of this recovery time and its time dynamics is essential for many quantum optics or quantum communication experiments. We introduce a fast and simple method to characterize precisely the recovery time of SNSPDs. It provides full information about the recovery of the efficiency in time for a single or several consecutive detections. We also show how the method can be used to gain insight into the behavior of the bias current inside the nanowire after a detection, which allows predicting the behavior of the detector and its efficiency in any practical experiment using these detectors.
We investigate single- and multi-photon detection regimes of superconducting nanowire detectors embedded in silicon nitride nanophotonic circuits. At near-infrared wavelengths, simultaneous detection of up to three photons is observed for 120 nm wide nanowires biased far from the critical current, while narrow nanowires below 100 nm provide efficient single photon detection. A theoretical model is proposed to determine the different detection regimes and to calculate the corresponding internal quantum efficiency. The predicted saturation of the internal quantum efficiency in the single photon regime agrees well with plateau behavior observed at high bias currents.