Atoms form the basis of precise measurement for many quantities (time, acceleration, rotation, magnetic field, etc.). Measurements of microwave frequency electric fields by traditional methods (i.e. engineered antennas) have limited sensitivity and can be difficult to calibrate properly. Highly-excited (Rydberg) neutral atoms have very large electric-dipole moments and many dipole allowed transitions in the range of 1 - 500 GHz. It is possible to sensitively probe the electric field in this range using the combination of two quantum interference phenomena: electromagnetically induced transparency and the Autler-Townes effect. This technique allows for very sensitive field amplitude, polarization, and sub-wavelength imaging measurements. These quantities can be extracted by measuring properties of a probe laser beam as it passes through a warm rubidium vapor cell. Thus far, Rydberg microwave electrometry has relied upon the absorption of the probe laser. We report on our use of polarization rotation, which corresponds to the real part of the susceptibility, for measuring the properties of microwave frequency electric fields. Our simulations show that when a magnetic field is present and directed along the optical propagation direction a polarization rotation signal exists and can be used for microwave electrometry. One central advantage in using the polarization rotation signal rather than the absorption signal is that common mode laser noise is naturally eliminated leading to a potentially dramatic increase in signal-to-noise ratio.
An atom-based approach is presented to detect absolute microwave (MW) electric fields (E-fields). The approach uses Rydberg atoms in vapor cells at room temperature. The MW E-field measurements utilize a bright resonance prepared within an electromagnetically induced transparency (EIT) window. The large transition dipole moments between energetically adjacent Rydberg states enable this method to make traceable E-field measurements with a sensitivity that is several orders of magnitude higher than the current standard for MW E-field measurements. The method can be used to image MW E-field in the near field regime with a subwavelength resolution of
mathrmlambdaMW/650, where
mathrmlambdaMW is the wavelength of the MW E-field. A high accuracy of $\\mathrm{1\\%}$ has been reached by minimizing the effects of the vapor cell geometry on the measured MW E-field. The dissertation also presents an alternative technique to perform the MW E-field measurement using dispersive properties of the EIT spectrum with a prism vapor cell. Recently, we applied a homodyne detection technique with a Mach Zehnder interferometer to achieve a new sensitivity limit for the MW E-field measurement,
mathrmsim3 muVcm−1Hz−1/2. The new sensitivity is one order of magnitude better than our prior best sensitivity presented in Ref. [Nat. Phys. 8, 819 (2012)]. The Rydberg atom-based method is promising to be a new standard for MW E-field measurements and to develop into portable devices in the field of MW technologies.
Significant progress has been made in atom-based measurements of length, time, gravity and electromagnetic fields in recently years. Rydberg atom-based microwave electric field measurement, using electromagnetically induced transparency (EIT) in room temperature alkali-metal vapors, has been extensively investigated and aroused the broad interest. This approach may establish a new standard for the measurements of microwave (MW) and radio frequency (RF) electric fields.In this review, we describe the work on a new method of measuring electric fields based on quantum interference by using either cesium or rubidium atoms contained in a dielectric vapor cell. Rydberg atoms with principal quantum number n >>1 have large direct current (DC) polarizabilities and microwave transition dipole moments, thereby making them extremely sensitive to external electric fields. Using the Rydberg three-level EIT to detect the level splitting and shift that is induced by the external field, we can realize a rapid and robust self-calibration method of measuring the electric field in a frequency range from 0.01 GHz to 1000 GHz. For the MW electric field (frequency range > 1 GHz), the MW field causes the Rydberg states to split, known as an Autler-Townes splitting (A-T) effect when the applied microwave can resonate with adjacent Rydberg states. The MW coupled A-T splitting is proportional to the applied electric field strength, from which the field strength is measured. Using the EIT window, a high sensitivity of 3 μV·cm-1·Hz-1/2 and small electric field of 1 μV/cm are expected to be achieved with a modest setup, and the limitations of the sensitivity are also addressed in the review. For the RF field at frequency mj EIT lines, and avoided crossings formed with the fine-structure levels of equal mj and different J's, which is used to calibrate and measure the RF field amplitude. On the other hand, the dependence of the EIT-line strength on the RF field polarization provides a fast and robust polarization measurement of RF fields based on matching experimental data with a theoretical simulation. The measurements of minimum strengths and sensitivity of RF fields based on Rydberg atoms are one order magnitude below the values obtained by traditional antenna methods. The atom-based field measurement paves the way for determining fields through calibration-free, invariable atomic properties and miniaturization. We also propose its various potential applications in the future.
The Rydberg atom-based microwave electric field sensor has high sensitivity for weak RF-field detection. Selection of Rydberg states with larger electric dipole moment is beneficial to enhance the sensitivity, and we choose Rydberg states with its principal quantum number up to n ∼ 80. We study the probe laser transmission response to a microwave field for these chosen high Rydberg states at room temperature. It agrees well with theoretical simulation based on an optical Bloch equation with considered microwave-atom interaction and Doppler broadening effect. In our experiment, the microwave sensing sensitivity based on 85 Rb transition | 78 S 1 / 2 ⟩ → | 78 P 3 / 2 ⟩ arrives at 5.102(49) nV cm − 1 Hz − 1 / 2 at 1 kHz.
Research of hot atomic vapor systems has a long history. Recently, much-improved technologies, such as lasers, microwaves and digital/analog control systems, have led to exciting progress in this reviving field. Due to its cryogenic-free and vacuum-free deployment potential, room-temperature and quantum-enabled sensing devices using gaseous atoms have become a popular research topic, and engineering such devices has received considerable attention. Proof-of-principle experiments have been performed demonstrating new ideas such as quantum-enhanced motion sensors, next-generation magnetometers, Rydberg enabled microwave sensors, etc. This thesis focuses on my work related to electromagnetic-field sensing using Rydberg atoms in vapor cells, where Rydberg atoms are excited and detected by electromagnetically induced transparency (EIT) spectroscopy. I first investigate the detection of strong magnetic fields (
sim 1~T) in the Paschen-Back regime. The diamagnetic (quadratic) response of the Rydberg levels makes the atoms sensitive to small fluctuations in field strength on a large background. By implementing an isotope-mixed cell, we demonstrate that accurate measurement, within a relative uncertainty of
pm0.12%. Many Rydberg-enabled radio frequency and microwave sensing applications require a capability of zeroing or intentional tuning of small DC electric fields inside the vapor cell. For this purpose, I explore an in-situ DC electric-field sensing and tuning method without using any bulk or thin film electrodes. I find that the photoelectric effect on the vapor cell walls (with invisible, atomic Rb aggregate layers covering the surfaces) can generate tuning fields up to 0.8~V/cm, with an inhomogeneity of about 2%. The spatial distribution of these fields can be directly monitored by quadratic Stark shifts of the Rydberg atoms. This work may inspire new approaches for DC-field control in miniaturized, metal-free atomic vapor-cell devices. Like many other quantum measurements on hot gaseous samples, short interaction time and other technical decoherence processes are the major factors which limit the precision and, in certain cases, the accuracy of the metrological results. In order to study these effects in the context of EIT, I performed an EIT experiment using a
Lambda-type quantum system consisting of the hyperfine ground states and the first excited electronic state of the Rb atoms contained in a buffer-gas-free thermal vapor cell without anti-relaxation coating. Technical line-broadening effects due to inhomogeneity of stray magnetic fields, laser frequency jitter, transverse beam intensity distribution, interaction time distribution, and atom-wall/impurity gas collisions are studied. Experimental results and numerical simulations are compared. These results provide crucial information and quantitative insights for vapor cell sensor design. The development of compact and multi-functional spectroscopy vapor cells is widely considered to be a critical engineering step towards manufacturing field-deployable sensors for real life applications. My R&D efforts towards fabrication of glass spectroscopy cells with integrated, highly-conductive silicon components are presented in the last part of my thesis. I explored various technical challenges and successfully developed a proof-of-principle prototype from scratch. The device allows the application of electric fields inside the cell for particle trapping and for tuning Rydberg transitions. Further, the highly-conductive silicon components enable microwave polarization filtering for microwave sensing applications, plasma-physics studies, etc. Preliminary experimental/technical data and simulations are presented. In summary, in my thesis I report on a comprehensive study of several spectroscopic and field sensing applications of Rydberg and ground-state atoms in vapor cells, as well as forays into novel methods to engineer vapor cells with embedded electrodes.
We recently proposed a method to detect weak microwave electric field ~8µV/cm with sensitivity ~ 30 µV cm−1Hz−1/2 [Nat. Phys. 8, 819 (2012)]. This technique is based on Rydberg atoms using the concept of electromagnetically induced transparency in room temperature vapor cells. Here we show that frequency modulation spectroscopy with active control of residual amplitude modulation improves the read out signal-to-noise. The method has the potential for high sensitivity and can be self-calibrated.