Broadband parametric amplification for multiplexed SiMOS quantum dot signals
Victor El-Homsy, Luca Planat, David J. Niegemann, Bruna Cardoso Paz, Ali Badreldin, Bernhard Klemt, Vivien Thiney, Renan Lethiecq, Eric Eyraud, Matthieu Dartiailh, Benoît Bertrand, Heimanu Niebojewski, Christopher Bäuerle, M. Vinet, Tristan Meunier, Nicolas Roch, Matias Urdampilleta
Spins in semiconductor quantum dots hold great promise as building blocks of quantum processors. Trapping them in SiMOS transistor-like devices eases future industrial scale fabrication. Among the potentially scalable readout solutions, gate-based dispersive radiofrequency reflectometry only requires the already existing transistor gates to readout a quantum dot state, relieving the need for additional elements. In this effort towards scalability, traveling-wave superconducting parametric amplifiers significantly enhance the readout signal-to-noise ratio (SNR) by reducing the noise below typical cryogenic low-noise amplifiers, while offering a broad amplification band, essential to multiplex the readout of multiple resonators. In this work, we demonstrate a 3GHz gate-based reflectometry readout of electron charge states trapped in quantum dots formed in SiMOS multi-gate devices, with SNR enhanced thanks to a Josephson traveling-wave parametric amplifier (JTWPA). The broad, tunable 2GHz amplification bandwidth combined with more than 10dB ON/OFF SNR improvement of the JTWPA enables frequency and time division multiplexed readout of interdot transitions, and noise performance near the quantum limit. In addition, owing to a design without superconducting loops and with a metallic ground plane, the JTWPA is flux insensitive and shows stable performances up to a magnetic field of 1.2T at the quantum dot device, compatible with standard SiMOS spin qubit experiments.
Spins in semiconductor quantum dots hold great promise as building blocks of quantum processors. Trapping them in SiMOS transistor-like devices eases future industrial scale fabrication. Among the potentially scalable readout solutions, gate-based dispersive radiofrequency reflectometry only requires the already existing transistor gates to readout a quantum dot state, relieving the need for additional elements. In this effort towards scalability, traveling-wave superconducting parametric amplifiers significantly enhance the readout signal-to-noise ratio (SNR) by reducing the noise below typical cryogenic low-noise amplifiers, while offering a broad amplification band, essential to multiplex the readout of multiple resonators. In this work, we demonstrate a 3GHz gate-based reflectometry readout of electron charge states trapped in quantum dots formed in SiMOS multi-gate devices, with SNR enhanced thanks to a Josephson traveling-wave parametric amplifier (JTWPA). The broad, tunable 2GHz amplification bandwidth combined with more than 10dB ON/OFF SNR improvement of the JTWPA enables frequency and time division multiplexed readout of interdot transitions, and noise performance near the quantum limit. In addition, owing to a design without superconducting loops and with a metallic ground plane, the JTWPA is flux insensitive and shows stable performances up to a magnetic field of 1.2T at the quantum dot device, compatible with standard SiMOS spin qubit experiments.
Spins in semiconductor quantum dots hold great promise as building blocks of quantum processors. Trapping them in Si MOS transistorlike devices eases future industrial-scale fabrication. Among the potentially scalable readout solutions, gate-based dispersive radio-frequency reflectometry only requires the already existing transistor gates to read a quantum dot state, which alleviates the need for additional elements. In this effort toward scalability, traveling-wave superconducting parametric amplifiers significantly enhance the readout signal-to-noise ratio (SNR) by reducing the noise below that of typical cryogenic low-noise amplifiers, while offering a broad amplification band, essential to multiplex the readout of multiple resonators. In this work, we demonstrate a 3-GHz gate-based reflectometry readout of electron charge states trapped in quantum dots formed in Si MOS multigate devices, with SNR enhanced due to a Josephson traveling-wave parametric amplifier (JTWPA). The broad tunable 2-GHz amplification bandwidth combined with more than 10-dB ON-OFF SNR improvement of the JTWPA enables frequency and time-division-multiplexed readout of interdot transitions, and noise performance consistent with JTWPA characteristics at higher frequencies. In addition, owing to a design without superconducting loops and with a metallic ground plane, the JTWPA is flux insensitive and shows stable performance up to a magnetic field of 1.1 T at the quantum dot device, compatible with standard Si MOS spin-qubit experiments.
Spins in silicon quantum devices are promising candidates for large-scale quantum computing. Gate-based sensing of spin qubits offers a compact and scalable readout with high fidelity, however, further improvements in sensitivity are required to meet the fidelity thresholds and measurement timescales needed for the implementation of fast feedback in error correction protocols. Here, we combine radio-frequency gate-based sensing at 622 MHz with a Josephson parametric amplifier, that operates in the 500-800 MHz band, to reduce the integration time required to read the state of a silicon double quantum dot formed in a nanowire transistor. Based on our achieved signal-to-noise ratio, we estimate that singlet-triplet single-shot readout with an average fidelity of 99.7% could be performed in 1 μs, well below the requirements for fault-tolerant readout and 30 times faster than without the Josephson parametric amplifier. Additionally, the Josephson parametric amplifier allows operation at a lower radio-frequency power while maintaining identical signal-to-noise ratio. We determine a noise temperature of 200 mK with a contribution from the Josephson parametric amplifier (25%), cryogenic amplifier (25%) and the resonator (50%), showing routes to further increase the readout speed.
Abstract A Josephson traveling-wave parametric amplifier (JTWPA) is indispensable for the high-fidelity readout of superconducting qubits, owing to its broadband gain and near-quantum-limited noise performance. Conventional JTWPAs implemented with 0-Josephson junctions (0-JTWPAs) avoid magnetic-flux bias but rely on Kerr nonlinearity, which leads to pump-power-dependent phase mismatch, gain ripple, and a limited dynamic range. More recently, three-wave-mixing (3WM) JTWPAs employing flux-biased rf-SQUIDs have been proposed to suppress Kerr effects. However, these designs require a significant external flux bias per unit cell, which complicates cryogenic hardware, introduces sensitivity to flux noise, and limits scalability in large arrays. In this study, we propose and analyze a π -junction-based JTWPA ( π -JTWPA) in which the intrinsic π phase shift of the junction effectively displaces the operating point of the current–phase relation. This approach aims to realize 3WM-type nonlinearity with reduced flux bias while preserving broadband amplification, thereby simplifying flux-bias distribution, enhancing robustness against flux noise, and providing a pathway toward scalable, multiplexed quantum readout architectures. In addition, we examine the potential applicability of the π -JTWPA in four-wave-mixing (4WM) operation.
Recent progress in physics has increased the necessity for ultra-low noise amplifiers capable of operating at the quantum limit performance. These amplifiers are essential to enhance astronomical detection, dark-matter search, and qubit readout in quantum computing, among other applications. Superconducting Josephson junction Travelling Wave Parametric Amplifiers (JTWPAs) operated in the microwave range, have demonstrated high gain over several gigahertz (GHz) bandwidth, with quantum-limited noise performance and minimal heat dissipation. These excellent properties make JTWPAs an ideal solution for ultra-low noise amplification. This thesis delves into the design, fabrication and characterisation of JTWPAs operated in the microwave (1-16 GHz) and the W-band (70-115GHz) regimes. A generalised coupled-mode equations (CME) framework describing JTWPAs based on Josephson junctions and DC superconducting quantum interference devices (SQUIDs) is introduced. This framework can be combined with electromagnetic (EM) simulation softwares to model the JTWPAs, facilitating their design. It is therefore used to model two microwave JTWPA designs, using parallel plate capacitors (PPCs) and interdigitated capacitors (IDCs). The fabrication and characterisation of both designs are presented, and possible fabrication and design issues are carefully discussed. Despite these issues, we observed broadband gain in the JTWPA with PPCs, achieving > 20 dB gain at several frequency points, and a measured P1dB = −95.8dBm when operated at 17.3 dB. The RF properties of a 500-junction Josephson array are also presented in this manuscript. The device creates a Fabry-Perot cavity, leading to non-travelling wave parametric effects, such as narrow-band gain. We also observed indications of efficient phase-sensitive amplification. The thesis is concluded with the first — to the best of our knowledge — experimental attempt to extend the operational frequency of a JTWPA to the W-band. The novel design, fabrication techniques and characterisation of the W-band JTWPA are discussed in detail in this manuscript, leading to promising results suggesting that JTWPA could operate at high frequencies.
Abstract Superconducting Parametric Amplifiers (SPAs) with near-quantum-limited added noise are crucial for weak signal detection applications such as astronomical receivers, quantum computation, and fundamental physics experiments. Commercially available SPAs include Josephson Parametric Amplifiers (JPAs), which offer high gain but narrow bandwidth performance; and Josephson-junction Travelling Wave Parametric Amplifiers (JTWPAs), which provide broader bandwidth at the cost of a complicated fabrication procedure, lower fabrication yield, and larger footprint area. In this paper, we investigate the parametric amplification of microwave signals in a Josephson array embedded in a low-Q Fabry-Pérot cavity. We fabricated a 500-junction array device and measured >15 dB phase-preserving gain over a ∼350 MHz bandwidth, while offering almost two orders of magnitude improvement in compression point (P 1dB = −106.2 dBm) compared to standard JPAs. Furthermore, using a novel measurement technique, we configured our device to operate in the phase-sensitive mode, measuring a phase-sensitive extinction ratio (PSER) of 42.3 ± 2.81 dB, in line with state-of-the-art values for JPAs. These promising performances, combined with the ease of fabrication and improved yield compared with JTWPAs, underscore the potential of these devices for applications in advanced detection schemes.
In order to build a large-scale quantum computer, one of the requirements is high-fidelity
multiplexed qubit readout, which in turn relies on the use of ultralow-noise
amplifiers. While Josephson Parametric Amplifiers (JPAs), using a cavity with
few Josephson junctions, have shown promising results for single qubit readout,
they have limitations such as low saturation power and a gain-bandwidth product
restriction. This makes them less suited for frequency multiplexed qubit readout. A
current-pumped Josephson Travelling-Wave Parametric Amplifier (JTWPA), using
4-wave mixing in a lumped-element transmission line, features both high saturation
power as well as no restriction on large bandwidth and high gain. This is possible
due to multiple junctions and the lack of a cavity. However, also this current pumped
JTWPA has an inherent problem, namely phase mismatch between the pump and
the signal. This prevents exponential gain. In this thesis, a current pumped JTWPA
using the resonant phase matching (RPM) technique to reduce the phase mismatch
problem is studied and characterised. The JTWPA shows high gain, high saturation
power and a large signal-to-noise ratio improvement. The JTWPA is also used for
qubit readout, for which it clearly improves the readout fidelity.