Abstract Superconducting Parametric Amplifiers (SPAs) with near-quantum-limited added noise are crucial for weak signal detection applications such as astronomical receivers, quantum computation, and fundamental physics experiments. Commercially available SPAs include Josephson Parametric Amplifiers (JPAs), which offer high gain but narrow bandwidth performance; and Josephson-junction Travelling Wave Parametric Amplifiers (JTWPAs), which provide broader bandwidth at the cost of a complicated fabrication procedure, lower fabrication yield, and larger footprint area. In this paper, we investigate the parametric amplification of microwave signals in a Josephson array embedded in a low-Q Fabry-Pérot cavity. We fabricated a 500-junction array device and measured >15 dB phase-preserving gain over a ∼350 MHz bandwidth, while offering almost two orders of magnitude improvement in compression point (P 1dB = −106.2 dBm) compared to standard JPAs. Furthermore, using a novel measurement technique, we configured our device to operate in the phase-sensitive mode, measuring a phase-sensitive extinction ratio (PSER) of 42.3 ± 2.81 dB, in line with state-of-the-art values for JPAs. These promising performances, combined with the ease of fabrication and improved yield compared with JTWPAs, underscore the potential of these devices for applications in advanced detection schemes.
Abstract Superconducting Parametric Amplifiers (SPAs) with near-quantum-limited added noise are crucial for weak signal detection applications such as astronomical receivers, quantum computation, and fundamental physics experiments. Commercially available SPAs include Josephson Parametric Amplifiers (JPAs), which offer high gain but narrow bandwidth performance; and Josephson-junction Travelling Wave Parametric Amplifiers (JTWPAs), which provide broader bandwidth at the cost of a complicated fabrication procedure, lower fabrication yield, and larger footprint area. In this paper, we investigate the parametric amplification of microwave signals in a Josephson array embedded in a low-Q Fabry-Pérot cavity. We fabricated a 500-junction array device and measured >15 dB phase-preserving gain over a ∼350 MHz bandwidth, while offering almost two orders of magnitude improvement in compression point (P 1dB = −106.2 dBm) compared to standard JPAs. Furthermore, using a novel measurement technique, we configured our device to operate in the phase-sensitive mode, measuring a phase-sensitive extinction ratio (PSER) of 42.3 ± 2.81 dB, in line with state-of-the-art values for JPAs. These promising performances, combined with the ease of fabrication and improved yield compared with JTWPAs, underscore the potential of these devices for applications in advanced detection schemes.
Recent progress in physics has increased the necessity for ultra-low noise amplifiers capable of operating at the quantum limit performance. These amplifiers are essential to enhance astronomical detection, dark-matter search, and qubit readout in quantum computing, among other applications. Superconducting Josephson junction Travelling Wave Parametric Amplifiers (JTWPAs) operated in the microwave range, have demonstrated high gain over several gigahertz (GHz) bandwidth, with quantum-limited noise performance and minimal heat dissipation. These excellent properties make JTWPAs an ideal solution for ultra-low noise amplification. This thesis delves into the design, fabrication and characterisation of JTWPAs operated in the microwave (1-16 GHz) and the W-band (70-115GHz) regimes. A generalised coupled-mode equations (CME) framework describing JTWPAs based on Josephson junctions and DC superconducting quantum interference devices (SQUIDs) is introduced. This framework can be combined with electromagnetic (EM) simulation softwares to model the JTWPAs, facilitating their design. It is therefore used to model two microwave JTWPA designs, using parallel plate capacitors (PPCs) and interdigitated capacitors (IDCs). The fabrication and characterisation of both designs are presented, and possible fabrication and design issues are carefully discussed. Despite these issues, we observed broadband gain in the JTWPA with PPCs, achieving > 20 dB gain at several frequency points, and a measured P1dB = −95.8dBm when operated at 17.3 dB. The RF properties of a 500-junction Josephson array are also presented in this manuscript. The device creates a Fabry-Perot cavity, leading to non-travelling wave parametric effects, such as narrow-band gain. We also observed indications of efficient phase-sensitive amplification. The thesis is concluded with the first — to the best of our knowledge — experimental attempt to extend the operational frequency of a JTWPA to the W-band. The novel design, fabrication techniques and characterisation of the W-band JTWPA are discussed in detail in this manuscript, leading to promising results suggesting that JTWPA could operate at high frequencies.
Ultralow-noise microwave amplification and detection play a central role in different applications, going from fundamental physics experiments to the deployment of quantum technologies. In many applications the necessity of reading multiple detectors, or cavities or qubits, calls for large bandwidth amplifiers with the lowest possible noise. Current technologies are based on High Electron Mobility Transistors and Josephson Parametric Amplifiers. Both have limitations, the former in terms of the minimum noise, the latter in terms of bandwidth. Superconducting Traveling Wave Parametric Amplifiers (TWPAs) have the potential of offering quantum limited noise and large bandwidth. These amplifiers are based on the parametric amplification of microwaves traveling along a transmission line with embedded nonlinear elements. We are developing superconducting TWPAs based both on Josephson junction arrays (Traveling Wave Josephson Parametric Amplifiers) and on nonlinear kinetic inductance (Dispersion Engineered Traveling Wave Kinetic Inductance Amplifiers). Our goal is to achieve large bandwidth (in the 5 to 10 GHz range), large gain (more than 20 dB), large saturation power (more than −50 dBm), and near quantum limited noise (noise temperature less than 600 mK). Current achievements in the design and development of the high performance TWPAs are here reported and discussed, together with current limitations and possible future developments.
Bringing signals from quantum to classical, from few-photon to many-photon levels for further processing, is a common challenge in rising quantum technologies. These include quantum computing, quantum communication, quantum sensing, radio astronomy, and dark matter searches, typically operating at microwave frequencies and millikelvin temperatures. Superconducting parametric amplifiers, as the first piece in the readout chain, have become a cornerstone of these technologies, since they offer unrivaled noise performance near the quantum-mechanical limit and high gain to surpass the noise of subsequent amplifiers. A notable implementation is the Josephson traveling-wave parametric amplifier (TWPA), which stands out due to its bandwidth of several Gigahertz and high saturation power, often larger than -100 dBm. These key properties come at the cost of complexity in design and fabrication: TWPA metamaterials often contain several thousands of Josephson junctions. Designing high-gain TWPAs involves three major challenges: ensuring impedance-matching, phase-matching of parametric amplification, and suppressing unwanted processes, all achievable through sub-wavelength dispersion engineering. This thesis covers the circuit design and analysis, implementation, and experimental characterization of a dispersion-engineered TWPA based on radio-frequency superconducting interference devices (rf-SQUIDs). It focuses on a detailed investigation of dispersion-engineering techniques and their effects on amplifier performance, particularly through the use of time-domain circuit simulations to analyze the multimode dynamics of the circuit. The experimentally realized device features 18 dB of gain, an instantaneous bandwidth spanning from 2.2 to 6.7 GHz, a system noise of 2.5 quanta, and a saturation power of (−86.5 ± 4.0) dBm. With these characteristics, it is suitable for frequency-multiplexed readout of detector arrays or qubits. Its high saturation power, about 10 dB higher than other reported Josephson-junction-based TWPAs, allows increasing the number of qubits per readout line, or decreasing the intermodulation between frequency-multiplexed qubits, both crucial for scaling up quantum computation.
Advancing error-corrected quantum computing and fundamental science necessitates quantum-limited amplifiers with near-ideal quantum efficiency and multiplexing capability. However, existing solutions achieve one at the expense of the other; for example, Josephson traveling wave parametric amplifiers (JTWPAs) are highgain, broadband, and chip-based quantum amplifiers that conventionally incur a bandwidth-noise tradeoff. When operated at 20-dB gain and instantaneous bandwidths of a few GHz, JTWPAs typically reach near-quantum limited intrinsic efficiencies of 70% - 85% relative to that of an ideal phase-preserving quantum amplifier. This is due to information leakage to the sidebands of the JTWPA, which can be recovered by adiabatically transforming the input modes to Floquet modes of the system within the device. In this thesis, we experimentally demonstrate the first Floquet-mode travelingwave parametric amplifier (Floquet TWPA). Fabricated in a superconducting qubit process, this Floquet TWPA achieves minimal dissipation, quantum-limited noise performance, and broadband operation. Our device exhibits > 20-dB amplification over a 3-GHz instantaneous bandwidth, <0.5 -dB average in-band insertion loss, and the highest-reported intrinsic quantum efficiency for a TWPA of 92.1±7.6%, relative to an ideal phase-preserving amplifier. When measuring a superconducting qubit, our Floquet TWPA enables a system measurement efficiency of 65.1 ± 5.8%, the highest-reported in a superconducting qubit readout experiment utilizing phase-preserving amplifiers to the best of our knowledge. Finally, we discuss the noise limitations of our current experimental setup, as well as impedance matching strategies that will enable us to push towards ideal JTWPA performance. These general-purpose Floquet TWPAs are suitable for fast, high-fidelity multiplexed readout in large-scale quantum systems and future monolithic integration with quantum processors.
Phase-sensitive parametric devices enable quadrature-selective amplification with the potential for sub-quantum-limited noise performance. In this work, we investigate the operation of a SQUID-based Josephson Parametric Amplifier (JPA), comparing its performance in the phase-preserving and phase-sensitive regimes. The device, fabricated using VTT SWAPS technology, is driven in a three-wave mixing configuration and characterized in a reflection-based measurement setup at millikelvin temperatures. To directly probe the noise performance at low JPA gains, we employ a cascaded amplification scheme in which a Traveling-Wave Parametric Amplifier (TWPA) provides low-noise pre-amplification of the JPA output. In a phase-preserving operation, the JPA exhibits near-quantum-limited performance with a system noise temperature of 351±53 mK at 6 GHz. In contrast, phase-sensitive operation yields a minimum system noise temperature of 94±12 mK, well below the standard quantum limit of 288 mK. Our results demonstrate that a JPA-TWPA amplifier cascade opens the door to direct, high-fidelity probing of quantum devices without the need for background noise subtraction.
Quantum-limited parametric amplifiers have become increasingly interesting and relevant with the progressing field of quantum computing. However, currently it is still challenging to fabricate these complex devices. In this thesis, we developed cross type Josephson junctions (JJs), lumped element LC resonators, lumped element Josephson parametric amplifiers (JPAs) and Josephson traveling wave parametric amplifiers (JTWPAs). We found and resolved several fabrication issues however we suspect that both the JPA and JTWPA suffered from microshorts in the circuits during the cryogenic measurements. Nevertheless, we managed to measure the resonance frequency of the JPA and have noticed the flux focusing effect when we flux tune it. We preformed room temperature measurements on over 300 JJs and calculated the relative standard deviation (RSD) for various JJ sizes. We found the spread of 30 fabricated resonators and a rough estimate of their Q factors. The JTWPAs developed are non-degenerate four wave mixing amplifiers that use the resonant phase matching (RPM) technique to reduce the phase mismatch problem. The transmission through the measured JTWPA showed 50 dB loss probably caused by presumably a short from the transmission line to ground. However, when the JTWPA was driven with a pump we observed 20 dB increase in transmission in some frequency bands.