This paper presents a computational analysis of a superconducting transmon qubit design, in which the superconductor-insulator-superconductor (SIS) Josephson junction is replaced by a coplanar, superconductor-constriction-superconductor (ScS) nanobridge junction. Within the scope of Ginzburg-Landau theory, we find that the nanobridge ScS transmon has an improved charge dispersion compared to the SIS transmon, with a tradeoff of smaller anharmonicity. These calculations provide a framework for estimating the superconductor material properties and junction dimensions compatible with gigahertz frequency ScS transmon operation.
This paper presents a computational analysis of a superconducting transmon qubit design, in which the superconductor-insulator-superconductor (SIS) Josephson junction is replaced by a coplanar, superconductor-constriction-superconductor (ScS) nanobridge junction. Within the scope of Ginzburg-Landau theory, we find that the nanobridge ScS transmon has an improved charge dispersion compared to the SIS transmon, with a tradeoff of smaller anharmonicity. These calculations provide a framework for estimating the superconductor material properties and junction dimensions compatible with gigahertz frequency ScS transmon operation.
The development of quantum circuits based on hybrid superconductor-semiconductor Josephson junctions holds promise for exploring their mesoscopic physics and for building innovative superconducting devices. The gate-tunable superconducting transmon qubit (gatemon) is the paradigmatic example of such a superconducting circuit; however, gatemons typically suffer from unstable and hysteretic qubit frequencies with respect to the applied gate voltage and reduced coherence times compared to conventional transmons fabricated from aluminum-oxide-based Josephson junctions. Here, we develop methods for characterizing these challenges in gatemons and deploy these methods to compare the impact of shunt-capacitor designs on gatemon performance. Our results indicate a strong frequency- and design-dependent behavior of the qubit stability, hysteresis, and dephasing times. Moreover, we achieve highly reliable tuning of the qubit frequency with 1-MHz precision over a range of several gigahertz, along with improved stability in grounded gatemons compared to gatemons with a floating capacitor design.
Superconductor qubits typically use aluminum–aluminum oxide tunnel junctions to provide the nonlinear inductance. Junctions with semiconductor barriers make it possible to vary the superconductor material and explore beyond aluminum. We use InAs semiconductor nanowires coated with thin superconducting shells of β-Sn to realize transmon qubits. By tuning the Josephson energy with a gate voltage, we adjust the qubit frequency over a range of 3 GHz. The longest energy relaxation time, T 1 = 27 μs, is obtained at the lowest qubit frequencies, while the longest echo dephasing time, T 2 = 1.8 μs, is achieved at higher frequencies. We assess the possible factors limiting coherence times in these devices and discuss steps to enhance performance through improvements in materials fabrication and circuit design.
Flux tuning of qubit frequencies in superconducting quantum processors is fundamental for implementing single and multi-qubit gates in quantum algorithms. Typical architectures involve the use of DC or fast RF lines. However, these lines introduce significant heat dissipation and undesirable decoherence mechanisms, leading to a severe bottleneck for scalability. Among different solutions to overcome this issue, we propose integrating tunnel Superconductor-Insulating-thin superconducting interlayer-Ferromagnet-Superconductor Josephson junctions (SIsFS JJs) into a novel transmon qubit design, the so-called ferrotransmon. SIsFS JJs provide memory properties due to the presence of ferromagnetic barriers and preserve at the same time the low-dissipative behavior of tunnel-insulating JJs, thus promoting an alternative tuning of the qubit frequency. In this work, we discuss the fundamental steps towards the implementation of this hybrid ferromagnetic transmon. We will give a special focus on the design, simulations, and preliminary experimental characterization of superconducting lines to provide in-plane magnetic fields, fundamental for an on-chip control of the qubit frequencies in the ferrotransmon.
Superconducting transmon qubits based on hybrid superconductor-semiconductor Josephson junctions (gatemons) offer gate tunability, but their relaxation times remain well below those of state-of-the-art transmons, and the origin of this discrepancy is not fully understood. Here, we co-fabricate gatemons and SIS-junction transmons with nominally identical circuit layouts, gate dielectrics, and control lines, so that the Josephson element is the only intentional distinction. Across multiple chips, transmons in this architecture reach relaxation times in the tens of microseconds, whereas gatemons saturate in the few-microsecond range. Using the transmons as on-chip references, we construct a loss budget including Purcell decay, spontaneous emission through the control line, and internal dielectric loss, and find that the corresponding T1 limits exceed all measured gatemon values by more than an order of magnitude. Temperature-dependent T1 measurements follow a common quasiparticle-activation model and yield similar superconducting gaps for S-Sm-S and SIS junctions, indicating that the reduced gatemon coherence is dominated by additional temperature-independent, junction-intrinsic dissipation.
Superconducting qubits are among the most promising platforms for realizing practical quantum computers. One requirement to create a quantum processor is nonlinearity, which in superconducting circuits is typically achieved by sandwiching a layer of aluminum oxide between two aluminum electrodes to form a Josephson junction. These junctions, however, face several limitations that hinder their scalability: the small superconducting gap of aluminum necessitates millikelvin operating temperatures, the material interfaces lead to dissipation, and the sandwich geometry adds unwelcome capacitance for high-frequency applications. In this work, we address all three limitations using a novel superconducting weak link based on the superconductor-insulator transition. By locally thinning a single film of niobium nitride, we exploit its thickness-driven superconductor-insulator transition to form a weak link employing only atomic layer deposition and atomic layer etching. We utilize our weak links to produce a transmon qubit, 'planaron', with a measured anharmonicity of α/2π=235 MHz; at present, the linewidth is κ/2π=15MHz. The high superconducting gap of niobium nitride can enable operation at elevated temperatures in future devices, and the fully planar geometry of the weak link eliminates superfluous material interfaces and capacitances. The investigation of small patches of material near the SIT can shed new light on the nature of the transition, including the role of dissipation and finite-size effects.
Quantum computing has advantages over conventional computing in performing algorithms such as factorization and search. Quantum processors, as a tool for quantum computing, are computing units that consist of qubits as basic elements. There are different approaches toward the implementation of the qubits. The most renowned and applicable of these implementations is based on superconducting qubits. Among various types of superconducting qubits, charge qubits in form of transmons are chosen in this work because of their straightforward fabrication methods and better interfacing and scalability. In this paper, utilizing EPR (Energy Participation Ratio) method, one of the main transmon structures made of High Tcsuperconductor materials, are designed and simulated. Additionally, the effects of some geometry-based parameters of the qubit structure on qubit characteristics such as frequency and anharmonicity are explored. Moreover, the single transmon qubit structure with High Tcsuperconductor transmission lines as readout and control sections are designed and simulated. In addition, due to the Purcell effect, the Purcell filter is added to the designed single qubit structure to reduce the spontaneous emission of the qubit. The results of our simulations are compared with that of the conventional superconductor based transmons.