Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2207.02497 · Journal of Low Temperature Physics

Investigation of Optical Coupling in Microwave Kinetic Inductance Detectors Using Superconducting Reflective Plates

Paul Nicaise, Jie Hu, Jean-Marc Martin, Samir Beldi, Christine Chaumont, P. Bonifacio, M. Piat, Hervé Geoffray, Faouzi M. Boussaha

Published Jul 9, 2022• 7 citations
arXivHTMLPDF
DOI
10.1007/s10909-022-02789-7

Related papers

Antenna-coupled microwave kinetic inductance detectors

Peter K. Day, Henry George LeDuc, Alexey Goldin +5 more

Nuclear Instruments and Methods in Physics Research Section A Accelerators Spectrometers Detectors and Associated Equipment•Jan 5, 2006•47 citations

Investigation of Single-Crystal Niobium for Microwave Kinetic Inductance Detectors

Agnès Dominjon, S. Shu, M. Kroug +5 more

Journal of Low Temperature Physics•Dec 5, 2018•5 citations

Superconductor Microwave Kinetic Inductance Detectors: System Model of the Readout Electronics

Valeria Palazzari, Federico Alimenti, L. Roselli +1 more

•Jun 1, 2009•0 citations

Investigation of reflection-based measurements of microwave kinetic inductance detectors in the optical bands

Jie Hu, Faouzi M. Boussaha, Paul Nicaise +4 more

In this paper, we investigate the single photon response from the reflection of the microwave kinetic inductance detector (MKID) array. Reflection measurements are carried out using two configurations: one is measured simultaneously with the transmission, and the other is obtained with a single-ended MKID array terminated with an open load. Compared with the transmission, reflection measurements significantly reduce the readout noise of the single-ended MKID array. This is also reflected in the improvement of the median energy resolving power by around 20%–30% under pulsed photon illumination at λ = 405 nm, mainly due to an increase in the size of the resonance circle on the IQ plane. This method has the potential to be used to read out large MKID arrays.

arXiv:2406.09436•Applied Physics Letters•Jun 10, 2024•3 citations

Noise analysis and optical response of microwave kinetic inductance detectors with an optical stack

Paul Nicaise, Jie Hu, Christine Chaumont +4 more

Abstract We report on the experimental investigation of optical coupling for superconducting microresonators known as microwave kinetic inductance detectors (MKIDs) in the visible and near-infrared bands. MKIDs are photon-counting, time and energy-resolving detectors that still suffer from a poor quantum efficiency. To improve this efficiency, we propose to add a superconducting reflective layer below the absorbing part of the detector separated by a transparent Al2O3 layer with a quarter-wavelength thickness optimized around a single wavelength λ = 405 nm. We have first fabricated samples patterned from stoichiometric TiN ( T c ∼ 4 K), one with the full optical stack, one without for reference and one with a partial optical stack in order to characterize the noise influence of each layer individually. We observe that the full optical stack geometry has the most impact on the resonator’s noise and quality factors. A second design was fabricated to characterize the optical response to short pulses of the optical stack and we show from both the frequential noise and optical response that a strong signature of TLS is still present in the optical stack sample. We have finally obtained single-photon response with the optical stack using a more sensitive tri-layer TiN/Ti/TiN absorber ( T c ∼ 1.3 K) for which a maximum energy resolving power of R = E / Δ E ∼ 1.3 was achieved using 405 nm laser pulses at 225 mK. The quality factors of both the reference and optical stack samples are similar but the frequency noise is still a tenfold higher for the optical stack sample which degrades the energy-resolving power of the detector.

Superconductor Science and Technology•Jun 24, 2024•0 citations

Superconducting Microwave Circuits with High Kinetic Inductance Materials in High Magnetic Fields

Azarin Zarassi, Jen‐Feng Hsu, Tzu-Chiao Chien +3 more

Bulletin of the American Physical Society•Mar 8, 2019•0 citations
In this paper, we investigate the single photon response from the reflection of the microwave kinetic inductance detector (MKID) array. Reflection measurements are carried out using two configurations: one is measured simultaneously with the transmission, and the other is obtained with a single-ended MKID array terminated with an open load. Compared with the transmission, reflection measurements significantly reduce the readout noise of the single-ended MKID array. This is also reflected in the improvement of the median energy resolving power by around 20%–30% under pulsed photon illumination at λ = 405 nm, mainly due to an increase in the size of the resonance circle on the IQ plane. This method has the potential to be used to read out large MKID arrays.
Abstract We report on the experimental investigation of optical coupling for superconducting microresonators known as microwave kinetic inductance detectors (MKIDs) in the visible and near-infrared bands. MKIDs are photon-counting, time and energy-resolving detectors that still suffer from a poor quantum efficiency. To improve this efficiency, we propose to add a superconducting reflective layer below the absorbing part of the detector separated by a transparent Al2O3 layer with a quarter-wavelength thickness optimized around a single wavelength λ = 405 nm. We have first fabricated samples patterned from stoichiometric TiN ( T c ∼ 4 K), one with the full optical stack, one without for reference and one with a partial optical stack in order to characterize the noise influence of each layer individually. We observe that the full optical stack geometry has the most impact on the resonator’s noise and quality factors. A second design was fabricated to characterize the optical response to short pulses of the optical stack and we show from both the frequential noise and optical response that a strong signature of TLS is still present in the optical stack sample. We have finally obtained single-photon response with the optical stack using a more sensitive tri-layer TiN/Ti/TiN absorber ( T c ∼ 1.3 K) for which a maximum energy resolving power of R = E / Δ E ∼ 1.3 was achieved using 405 nm laser pulses at 225 mK. The quality factors of both the reference and optical stack samples are similar but the frequency noise is still a tenfold higher for the optical stack sample which degrades the energy-resolving power of the detector.